• Proceedings of the Korean Society of Crop Science Conference
• /
• 2000.11a
• /
• pp.169-170
• /
• 2000

• Proceedings of the Korean Society of Crop Science Conference
• /
• 1998.04a
• /
• pp.101-102
• /
• 1998

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2001.05a
• /
• pp.48-49
• /
• 2001

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.50 no.4
• /
• pp.247-255
• /
• 2005

ice yield and plant growth response to nitrogen (N) fertilizer may vary within a field, probably due to spatially variable soil conditions. An experiment designed for studying the response of rice yield to different rates of N in combination with variable soil conditions was carried out at a field where spatial variation in soil properties, plant growth, and yield across the field was documented from our previous studies for two years. The field with area of 6,600 m2 was divided into six strips running east-west so that variable soil conditions could be included in each strip. Each strip was subjected to different N application level (six levels from 0 to 165kg/ha), and schematically divided into 12 grids $(10m \times10m\;for\;each\;grid)$ for sampling and measurement of plant growth and rice grain yield. Most of plant growth parameters and rice yield showed high variations even at the same N fertilizer level due to the spatially variable soil condition. However, the maximum plant growth and yield response to N fertilizer rate that was analyzed using boundary line analysis followed the Mitcherlich equation (negative exponential function), approaching a maximum value with increasing N fertilizer rate. Assuming the obtainable maximum rice yield is constrained by a limiting soil property, the following model to predict rice grain yield was obtained: $Y=10765{1-0.4704^*EXP(-0.0117^*FN)}^*MIN(I-{clay},\;I_{om},\;I_{cec},\;I_{TN},\; I_{Si})$ where FN is N fertilizer rate (kg/ha), I is index for subscripted soil properties, and MIN is an operator for selecting the minimum value. The observed and predicted yield was well fitted to 1:1 line (Y=X) with determination coefficient of 0.564. As this result was obtained in a very limited condition and did not explain the yield variability so high, this result may not be applied to practical N management. However, this approach has potential for quantifying the grain yield response to N fertilizer rate under variable soil conditions and formulating the site-specific N prescription for the management of spatial yield variability in a field if sufficient data set is acquired for boundary line analysis.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.63 no.2
• /
• pp.158-163
• /
• 2018

Perilla (Perilla frutescens var.frutescens) is an annual plant of the Lamiaceae family, mainly grown for obtaining oil by press extraction after roasting the seeds. Oil yield is one of its important traits, but evaluating this yield is time-consuming, requires many seeds, and is hard to adjust to pedigrees in a breeding field. The objective of this study was to develop a method for selecting high-oil-yield lines in a breeding population without oil extraction. Twenty-three perilla cultivars were used for evaluating the oil yield and seed traits such as seed hardness, seed coat thickness, seed coat proportion and crude fat. After evaluation of the seed traits of 23 perilla cultivars, the ranges of oil yields, seed hardness, seed coat thickness, seed coat proportion, 100-seed weight, and crude fat were 24.68-38.75%, 157-1166 gf, $24-399{\mu}m$, 15.4-41.5%, 2.79-6.69 g, and 33.0-47.8%, respectively. In an analysis of correlation coefficients, the oil yield negatively correlated with seed length, seed width, the proportion of seed coat, seed hardness, and 1000-seed weight, but positively correlated with crude fat content. It was observed that as the seed coat proportion increased, the seed coat thickness, hardness, and 1000-seed weight also increased. Multiple linear regression (MLR) was employed to find major variables affecting the oil yield. Among the variables, traits crude fat content and seed coat proportion were assumed to be indirect parameters for estimating the potential oil yield, with respect to a significant positive correlation with the observed oil yield ($R^2=0.791$). Using these two parameters, an equation was derived to predict the oil yield. The results of this study show that various seed traits in 23 perilla cultivars positively or negatively correlated with the oil yield. In particular, crude fat and the seed coat proportion can be used for predicting the oil yield with the newly developed equation, and this approach will improve the efficiency of selecting prominent lines for the oil yield.

• Ocean and Polar Research
• /
• v.27 no.3
• /
• pp.311-322
• /
• 2005

Fisheries buyback programs in Korea have been implemented since 1994, and their scales are estimated to be the present value of 930 billion won for the last 9 yens since 1994. The paper attempts to identify the patterns of each fish species, of which their yields can be steadily increased or significant]y decreased, and to evaluate its effective level and the optimal level for buyback programs by means of fishing capacity analysis. The paper distinguishes fish species, that there is no need to reduce the fishing efforts, such as anchovies, mackerels, squids, Spanish mackerels, and herrings, because MSY exceeds yields, from fish species to control overfishing such as file fish, yellow corvenias, young pollack, hair tail, snow crab, and pollack. The paper also suggests that 65% of the fishing efforts (total tonnages) should be cut back at the national aggregate level in order to restore fish stocks.

• Journal of Korean Society of Forest Science
• /
• v.84 no.2
• /
• pp.207-217
• /
• 1995

Various factors reducing seed yield in 4 Larix species throughout the whole reproductive cycle were investigated and partitionate losses attributed to them were determined. Pollen quality, lack of pollination, and degeneration of female gametophyte played minor roles in reducing seed yield. Failure of pollinated ovules to be fertilized was an important factor causing seed loss. Embryo degeneration was also a major factor causing seed loss in all 4 species. Strobili abortion, which causes loss of all potential seeds in a cone, was the most important factor in reducing seed loss in this study. Based on the results obtained from this studs, hybridizations in either direction between European larch and Japanese larch are likely to resulting viable seed. However, hybridization between tamarack as a mother tree and European larch are not likely to result in viable seeds being produced.

• Asian-Australasian Journal of Animal Sciences
• /
• v.15 no.5
• /
• pp.695-698
• /
• 2002

Performance data (from 1985 to 2000) of Jersey cattle imported from USA and maintained at Islamabad, Pakistan were evaluated. The purpose of this study was to assess the genetic merit of Jersey breed under Pakistani environment for further propagation. Cows with at least two calvings were considered for this study; records on 50 daughter-dam pairs were available on production and reproduction performance traits for genetic evaluation. The average age at first calving in parents was $25.2{\pm}2.4$ m as compared to $23.9{\pm}6.6$ m in progeny. Calving interval in parents and progeny was $416{\pm}74$ and $446{\pm}105$ d; lactation length $301{\pm}51$ and $325{\pm}73$ d; lactation milk yield $2,908{\pm}669$ and $2,707{\pm}903$ lit respectively. All these differences were found to be statistically significant except lactation length. The correlations between age at first calving and total lactation milk was -0.25, between calving interval and total lactation milk yield was 0.14, and between lactation length and total lactation milk yield was 0.79. The $h^2$ of these traits were low indicating important role of environment in expressing the genetic potential of animals. The S.E of $h^2$ of all the traits was high due to large variation in data.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.44 no.2
• /
• pp.166-170
• /
• 1999

The identification of quantitative trait loci (QTL) has the potential to enhance the efficiency of im- proving food processing traits of soybean. In this study, 92 restriction fragment length polymorphism (RFLP) loci and two morphological markers (W$_1$ and T) were used to identify QTL associated with food processing traits of soybean for sprout in 83 F$_2$-derived lines from a cross of ＇Pureun＇ x ＇Jinpum 2＇. The genetic map consisted of 76 loci which covered about 760 cM and converged into 20 linkage groups. Eighteen markers remained unlinked. Phenotypic data were collected for hypocotyl length, abnormal seedling rate, and sprout yield seven days after seed germination at 2$0^{\circ}C$. Based on the single-factor analysis of variance, eight independent markers were associated with hypocotyl length. Four of seven markers associated with abnormal seedling rate were identified as independent. Seven loci were associated with sprout yield. For three different traits, much of genetic variation was explained by the identified QTL in this population. Several RFLP markers in linkage group (LG) Bl were detected as being associated with three traits, providing a genetic explanation for the biological correlation of sprout yield with hypocotyl length (r=OA07＊＊＊) and with abnormal seedling rate (r=-406＊＊＊).

• Corrosion Science and Technology
• /
• v.2 no.6
• /
• pp.266-271
• /
• 2003

Safety diagnosis of various structural components and facilities is indispensable for preventing catastrophic failure of material by time-dependent and environment accelerating degradation. Also, this diagnosis of operating components should be done periodically for safe maintenance and economical repair. However, conventional standard methods for mechanical properties have the problems of bulky specimen, destructive procedure and complex procedure of specimen sampling. So, a non-destructive and simple mechanical testing method using small specimen is needed. Therefore, an advanced indentation technique was developed as a potential method for non-destructive testing of in-field structures. This technique measures indentation load-depth curve during indentation and analyzes the mechanical properties related to deformation such as yield strength, tensile strength and work-hardening index. In this paper, we characterized the tensile properties including yield and tensile strengths of the V-modified Cr-Mo steels in petro-chemical and thermo-electrical plants. And also, the effects of hydrogen-assisted degradation of the V-modified Cr-Mo steels were analyzed in terms of work-hardening index and yield ratio.