• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.9
• /
• pp.3094-3109
• /
• 2014

This paper proposes a load balanced reliable routing protocol called LBR (Load Balanced Reliable routing) in wireless networks. The LBR protocol transmits messages through a reliable path considering the balancing of the traffic load. Recently, the authors have proposed a multipath-based reliable routing protocol called MRFR, which is an appealing protocol for fault tolerant reliable data transmission. However, However, MRFR has no concern with the problem of load balancing, which results in increasing congestion and consuming high energy at some network nodes. As a result, the problem affects negatively the performance of the network. Taking account of load balancing as a route selection criteria can avoid routing through the congested nodes and allows to find better routes. In this paper, we extend MRFR by considering load balancing in the route discovery process of reliable communication. The simulation results showed that the proposed protocol outperforms AODV in terms of end-to-end delay, packet delivery radio, and average jitter. Compared to MRFR, the LBR protocol has the same packet delivery ratio, and obtains a better efficiency of load balancing.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.4 no.1 s.6
• /
• pp.107-115
• /
• 2005

For effective IP based service implementation on the wireless network environments, wireless network including the ITS network have to support QoS guaranteed protocol such as a RSVP. RSVP is a resource reservation protocol for Internet environment, and its scalability makes easy to implement RSVP over the various IP transport technologies. But for the If based ITS wireless network environment, RSVP is not suitable, since by its path setup procedure characteristic. In the wireless access network for ITS service, when a mobile node moves to other domain it must perform registration procedure. But the registration procedure is time consuming steps, so if a RSVP session was already established in the previous domain, the RSYP session may be disconnected and the time to re establish a new RSVP session is long enough to cause serious packet loss. In this paper, we propose a pre-path reservation mechanism for applying the RSVP in wireless access networks for ITS. In the pre-path reservation mechanism, the resource reservation procedure occurred during a mobile node's handoff time. An access point in wireless access network performs this procedure when the mobile node attempts handoff The access point executes pre-path reservation procedure as a proxy, since the mobile node does not have IP address until the address allocation procedure is finished in a new domain.

• Journal of the Korea Society of Computer and Information
• /
• v.15 no.11
• /
• pp.117-124
• /
• 2010

Appling centralized network management architecture SNMP(Simple Network Management Protocol) to wireless networks causes the network overhead, NAT(Network Address Translation) problem on AP, and performance degradation of mobile nodes. In this paper, we propose an integrated management scheme for wired and wireless networks using mobile agents in order to solve above problems. In our proposed scheme, SNMP is applied to manage wired networks and MAs of SNMP are implemented in APs or wireless nodes to manage wireless networks. In addition, we propose a method to reduce the redundant OID information within SNMP response messages. Through the analysis, we show that our proposal resolves the given problems and reduces the processing delay of the wireless nodes.

• Journal of Communications and Networks
• /
• v.11 no.3
• /
• pp.287-296
• /
• 2009

Although asymptotic bounds of wireless network capacity have been heavily pursued, the answers to the following questions are still critical for network planning, protocol and architecture design: Given a three-dimensional (3D) network space with the number of active users randomly located in the space and using the wireless communication technology, what are the expected per-flow throughput, network capacity, and network transport capacity? In addition, how can the protocol parameters be tuned to enhance network performance? In this paper, we focus on the ultra wideband (UWB) based wireless personal area networks (WPANs) and provide answers to these questions, considering the salient features of UWB communications, i.e., low transmission/interference power level, accurate ranging capability, etc. Specifically, we demonstrate how to explore the spatial multiplexing gain of UWB networks by allowing appropriate concurrent transmissions. Given 3D space and the number of active users, we derive the expected number of concurrent transmissions, network capacity and transport capacity of the UWB network. The results reveal the main factors affecting network (transport) capacity, and how to determine the best protocol parameters, e.g., exclusive region size, in order to maximize the capacity. Extensive simulation results are given to validate the analytical results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.6B
• /
• pp.396-405
• /
• 2005

Snoop protocol is one of the efficient schemes to compensate TCP packet loss and enhance TCP throughput in wired-cum-wireless networks. However, Snoop protocol has a problem; it cannot perform local retransmission efficiently under the bursty-error prone wireless link. In this paper, we propose Enhanced Snoop(E-Snoop) protocol to solve this problem of Snoop protocol. With E-Snoop protocol, packet losses can be noticed by receiving new ACK packets as well as by receiving duplicate ACK packets or local retransmission timeout. Therefore, TCP throughput can be enhanced by fast recognition of bursty packet losses and fast local retransmissions. From the simulation results, E-Snoop protocol can improve TCP throughput more efficiently than Snoop protocol and can yield more TCP improvement especially in the channel with high packet loss rates.

• Journal of KIISE:Information Networking
• /
• v.34 no.4
• /
• pp.269-275
• /
• 2007

Since being constructed without any infrastructure-based network, ad hoc network has been received much attention as a key technology for ubiquitous networks. Due to high bit error rate and dynamically changing network topology in ad hoc network, the routing protocol that provides stable multi-hop communication path is the one of the key issues to address. The previously proposed ad hoc routing protocols have their limitations on network overhead, stability, and scalability. In this paper, we consider hybrid wireless network, which can overcome shortcomings of ad hoc network, and propose a novel routing protocol called zone master-based routing protocol. We verify with computer simulations that the proposed routing protocol outperforms other existing routing protocols in the various wireless environments.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.05a
• /
• pp.435-438
• /
• 2003

The MS card data transfer system using blue-tooth protocol ran communicate the MS card data wirelessly and does not take an extra communication expense which is a weakness point of existing wireless communication system. This Blue-tooth system, which has excellent security and no extra communication expense, can efficiently communicate data of the place ,where can be solved with small scale wireless network, such as the theme-park or gasoline-station. Existing wireless communication system compose network using wireless-LAN protocol which has extra communication expense, or with RF protocol which has poor security. But this system suitable for LAN because it has not extra communication expense and it has excellent security cause frequency-hopping of Blue-tooth protocol. The MS card data transfer system using blue-tooth protocol has low power, high performance RISC processor and large scale 16-gray graphic LCD which is suitable for portable unit. The MS card data transfer system can efficiently control depot for a long time because it has low power, excellent security and no extra communication expense.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.4B
• /
• pp.207-214
• /
• 2008

Under future internet environment, wireless sensor networks will be used in a wide range of applications. A major problem for designing sensor protocol is developing the most energy efficient technique to monitor an area of interest for a long time since sensors have some constraints such as small and a limited energy level. In addition, data latency is often a critical issue since sensory data is transmitted via multi hop fashion and need to be delivered timely for taking an appropriate action. Our motivation for designing a data forwarding protocol is to minimize energy consumption while keeping data latency bound in wireless sensor networks. In this paper, we propose a data forwarding protocol that consists of wakeup scheduling and MAC protocols, the latter of which is designed to achieve load balancing. Simulation results show that the proposed framework provides more energy-efficient delivery than other protocol.

• Journal of KIISE:Information Networking
• /
• v.34 no.4
• /
• pp.262-268
• /
• 2007

The efficient node-energy utilization in wireless sensor networks has been studied because sensor nodes operate with limited power based on battery. To extend the lifetime of the wireless sensor networks, maintaining balanced power consumption between sensor nodes is more important than reducing total energy consumption of the overall network. Since a large number of sensor nodes are densely deployed and collect data by cooperation in wireless sensor network, keeping more sensor nodes alive as possible is important to extend the lifetime of the sensor network. In this paper, we submit an efficient energy aware routing protocol based on AODV ad hoc routing protocol for wireless sensor networks to increase its lifetime without degrading network performance. The proposed protocol is designed to avoid traffic congestion on minor specific nodes at data transfer and to make the node power consumption be widely distributed to increase the lifetime of the network. The performance of the proposed protocol has been examined and evaluated with the NS-2 simulator in terms of network lifetime and end-to-end delay.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.10A
• /
• pp.1532-1538
• /
• 1999

In general, because error rate of wireless link is higher than that of wired link, DLC layer protocol for wired network with low error rate is not proper for wireless environments. In addition, the conventional DLC layer protocol for wireless network is optimized for the low-speed data service, so it is difficult to use conventional DLC protocol in the current mobile communication environments handing high-speed and multimedia services. Therefore, a DLC layer protocol that is suitable to current wireless communication environments is required. In this paper, we propose a novel error control scheme that supports a variety of traffic attribute and is applicable to high-speed and multimedia data service in WATM. The proposed scheme provides enhanced throughput performance for real-time traffic by using modified ASR ARQ without ACK and reduces loss rate by using FEC in the case of high error condition. Also, for non real-time traffic, the use of ASR ARQ without ACK enhances throughput performance and delay time is decreased by using FEC in the case of high error rate channel. As a result of simulation, the proposed scheme has better performance than conventional ASR ARQ protocol in view of delay and throughput.