• Journal of The Korean Society of Agricultural Engineers
• /
• v.54 no.5
• /
• pp.69-77
• /
• 2012

Relative density, used to express dynamics condition of sand quantitatively, is measured by RI Test, Standard Penetration Test and Cone Penetration Test. Each measurement method has demerits, which is complicated or needs a specific analysis instrument and an analysis of expert. Also the ground is in wet condition commonly because of an unsaturated zone between a saturated zone and a surface, so the behaviour of the ground has different engineering properties unlike the dry ground and it diminishes accuracy of measuring relative density. In this study, the correlation between relative density and penetration of fall cone test in dry condition and wet condition with variation of water content was analyzed and a simple measuring method for relative density was suggested. As a result, there were difference of penetration between dry sands and wet sands, the correlation between relative density and penetration showed linear expression and relative density could be measured by the linear relation.

• Journal of Soil and Groundwater Environment
• /
• v.18 no.6
• /
• pp.18-31
• /
• 2013

This study was performed to examine use of the pump-and-treat method for remediation of TCE, CF and CT in groundwater contaminated by DNAPL. The Woosan industrial complex is located in Wonju, about 120 km east of Seoul, Korea. Two pumping wells (KDPW7 and KDPW8) and five monitoring wells (KDMW7, KDMW8, KDMW9, KDMW10, and SKW2) were installed for the test. An asphalt laboratory is a main source of the extensive subsurface contamination at this site. To evaluate change in the concentrations of TCE, CF, and CT in groundwater in the study area, three rounds of pump-and-treat pilot tests were performed (6 July to 6 August, 22 August to 6 September, and 19 September to 2 December in 2011). The groundwater levels and the concentrations of TCE, CF, and CT exhibited negative correlations in the wet season but positive correlations in the dry season, which suggests that the TCE concentrations were mainly controlled by dilution through rainfall during the wet season and by residual TCE, CF, and CT in the unsaturated zone during the dry season. These possibilities should be considered in the full-scale remediation plan.

• Nuclear Engineering and Technology
• /
• v.35 no.4
• /
• pp.299-308
• /
• 2003

Fabrication technique of $(Th,U)O_2$ pellets has been investigated. Powder mixtures of $ThO_2\;and\;UO_2$ were milled in two different ways-dry and wet milling. Milled powder was compacted and sintered to $(Th,U)O_2$ pellets. The wet-milled powder leads to a $(Th,U)O_2$ pellet having a high sintered density and uniform distribution of U and Th, compared to the dry-milled powder. The sintered density of a $(Th,U)O_2$ pellet tends to decrease by increasing the content of $ThO_2$. The thermal conductivity of $ThO_2\;and\;(Th,U)O_2$ pellets was measured by the laser flash method. The thermal conductivity of the $ThO_2$ pellet is higher than that of the $UO_2$ pellet, and the thermal conductivities of $(Th,U)O_2$ pellets containing $65wt\%\;and\;35wt\%\;ThO_2$ pellets are lower than that of the $UO_2$ pellet.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.29 no.3
• /
• pp.351-357
• /
• 2019

Objectives: The objectives of this study were to investigate fungal contamination in a 31-year old university building in Seoul, Korea, and to study the inactivation of fungi using cold atmospheric pressure plasma(CAP). Methods: To investigate the fungal contamination in a university building, air samples were collected from five locations in the building, including two study rooms, a storage room, a laboratory, and a basement. The sampling was performed in a dry season(February to April) and in a wet season(July). To study the inactivation efficacy of fungi by CAP, airborne fungal concentrations were measured before and after the operation of the CAP generator. Results: Humidity was an important factor affecting fungal growth. The airborne fungal concentrations determined in the wet season(July) were significantly higher than those determined in the dry season(February to April). In the basement, the values determined in the dry and wet season were 319 and $3,403CFU/m^3$, respectively. The inactivation efficiency of fungi by CAP was 83-90% over five to nine days of operation. Conclusions: The university building was highly contaminated by airborne fungi, especially in summer. It is concluded that humidity is an important factor affecting fungal growth and CAP is a highly useful technique for inactivation of indoor airborne fungi.

• Ocean and Polar Research
• /
• v.40 no.4
• /
• pp.191-202
• /
• 2018

In this study we conducted a weekly monitoring exercise at a fixed station in the saltwater zone during the dry season (Jan-Mar, 2013) and wet season (Jun-Aug, 2013) to understand the fluctuations in phytoplankton communities and environmental factors in the Youngsan River estuary altered by a dike constructed in the coastal area. Phytoplankton communities displayed seasonality; diatoms were dominant during the dry season whereas dinoflagellates were dominant during the wet season. T-test analysis showed that water temperature was significantly different between the seasons whereas freshwater discharge from the dike was not significantly different. This suggests that seasonal variations of phytoplankton are more likely affected by water temperature than freshwater discharge. However, a short-term fluctuation was also observed in response to freshwater discharge; freshwater species appeared during or after the discharge in the dry and wet seasons and blooms of harmful species developed after the discharge. Phytoplankton communities may be affected by changes in physical factors such as turbidity and salinity and nutrient supply resulting from freshwater discharge. Especially, the nutrient supply may directly contribute to the harmful algal blooms (HABs) composed of dinoflagellates which can adapt to low salinity after freshwater discharge.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.27 no.2
• /
• pp.70-74
• /
• 2017

Two milling methods, dry vibration milling and wet ball milling, were used to prepare $Na_{2/3}(Ni_{1/3}Mn_{2/3})O_2$ powders as a cathode material for sodium ion batteries. The morphology and electrochemical property of the two powders with different milling processes were compared to each other. The particle size is less than $1{\mu}m$ in the dry vibration milled powder, while lots of larger particles than $1{\mu}m$ were found in the wet ball milled one. The single phase of $Na_{2/3}(Ni_{1/3}Mn_{2/3})O_2$ was obtained in the temperature range of $875{\sim}900^{\circ}C$. The discharge capacity and discharge voltage of the powder prepared by the dry process were higher than those of one prepared by the wet process.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.45 no.6
• /
• pp.153-161
• /
• 2003

The purpose of this paper is to investigate the soil-water characteristic curves for an unsaturated soil. To this ends, a series of suction measured test was conducted on the selected 4 kinds of soils taken from different sites of Korea, using modified pressure plate apparatus. Form the test results, the water contents, degree of saturation and volumetric water contents were analyzed with the suction. And the soil-water characteristic curves of unsaturated soil were drawn from the test results for various factors. The characteristic curves drawn with water content vs matric suction were classified certainly the difference in wet side but were not classified in dry side. The characteristic curves drawn with degree of saturation vs matric suction for unsaturated soil were shown the opposite inclination as compared with the former curve. But the characteristic curve with volumetric water content vs matric suction was described suitably not only in wet side condition but also in dry side. And it was found that the volumetric water contents of loose soil was high at the initial condition but that of dense soil was high at final condition (dry side).

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 1999.10c
• /
• pp.289-293
• /
• 1999

This research was performed to evaluate the longitudinal length change ratio of concrete used the expansive admixture. As the results of this study, the compressive strength was shown the highest value at the used 10% expansive admixture both of the dry and wet curing condition. And the length change ration was shown higher 0.0316% and 0.0529 % than that of control in wet and dry curing condition. But this value was not enough to recover the shrinkage occuring by dry shrinkage. According to this study , we have obtained 10% on normal portland cement concrete as the optimum replacement ration of expansive admixture.

• Asian-Australasian Journal of Animal Sciences
• /
• v.7 no.3
• /
• pp.335-342
• /
• 1994

This study was undertaken at Gowa, South Sulawesi, Indonesia, as part of a larger forage genetic resource evaluation project. The experimental program consisted of a field experiment where grass and legume species were grown in monocultures and the dry matter yield, rumen bag digestibility (RBDMD) and N content of leaf and stem components were monitored in the wet and dry seasons. Eight species of grass (Brachiaria decwnbens cv. Basilisk. Panicum maximum cv. Riversdale, Urochloa pullulans CPI 41192, Imperata cylindrica from Maiwa, South Sulawesi, Digitaria milanjiana CPI 41193, Cenchrus ciliaris cv. Malopo, Heteropogon contorlus and Setaria sphacelata cv. Splenda) were studied. P. maximum was the highest yielding grass in the wet season and B. decumbens in the dry season. The highest RBDMD in the whole plants were U. pulluians, P. maximum, S. sphacelata and D. milanjiana after 2 weeks regrowth in cycle I and S. sphacelata, B. decumbens, D. milanjiana and C. ciliaris in cycle 2. When total digestible DM was calculated for the whole of cycle I, P. maximum, B. decumbens and S. sphacelata were superior, but B. decumbens produced over twice as much as the other species in the dry season (cycle 2). The leaf N concentration of all grasses exceeded 1.0% (6.25% crude protein) in the regrowth in cycle I but did not exceed 0.5% in the dry season regrowth (cycle 2).

• Elastomers and Composites
• /
• v.54 no.4
• /
• pp.299-307
• /
• 2019

Rubber friction properties include adhesion friction characteristics of the interface, hysteresis friction characteristics originating from repeated rubber deformations, and cohesion friction characteristics due to wear and tear. Cohesion friction is generally sufficiently small (< 3%) that it can be ignored, whereas adhesion friction has a relatively large contribution of 15%, but has not been investigated thoroughly. Therefore, through an adhesion friction study, the adhesion mechanism was examined and the relationship between friction characteristics and adhesion friction on dry surfaces was derived. The wet grip characteristics of tread rubber are fully described by the hysteresis characteristics of tires, but friction characteristics on dry roads are difficult to determine without adhesion factors. The results presented herein demonstrate that the combination of hysteresis and adhesion properties in the tread rubber sufficiently explained the characteristics of the dry grip. Based on the results of this study, technologies will be developed to determine the key factors governing adhesion friction characteristics and improve dry tire braking performance.