• 한국전자파학회논문지
• /
• 제11권3호
• /
• pp.464-473
• /
• 2000

The method is presented which predicts voltage waveforms at each nodes inter-connected arbitrarily on the coupled transmission lines by extracting the node connection condition to be included in the modal telegrapher's equation, hence analyzing the mechanism of waveform propagation on transmission lines. It is shown that it is also possible to analyze efficiently the coupled nonuniform lines. And then the nonuniformity of coupled lines is demonstrated for suppressing the crosstalk spikes using the one-dimensional inverse-scattering control theory. The predicted waveforms by presented method are analyzed and verified by comparison with those by the generalized S-parameter technique.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 추계학술대회 논문집 학회본부
• /
• pp.296-298
• /
• 1995

This paper proposes a new filter topology that suppresses the high voltage gradient(dv/dt) in ac motor terminals. The high voltage gradient(dv/dt) causes over voltages on the motor windings, the degradation or motor insulation, and the bearing failure. Moreover surge voltage with high voltage gradient(dv/dt) in the PWM inverter red drive system where long line cables are required causes more serious problem to the motor. Thus, the most advisable method is attaching output filter to the inverter output terminals. The conventional output filters have several problems such as bulky size, difficulty or parameter tuning. The proposed filter can be relatively smaller than the conventional filters. By the proposed filter, the shaping or PWM waveform can considerably suppress high dv/dt in motor feeding cable from the inverter. The effectiveness or the proposed filter is compared with that or the conventional one and is verified by the computer simulation.

• Journal of Welding and Joining
• /
• 제16권4호
• /
• pp.63-72
• /
• 1998

In this study, the effects of the current pulsing conditions, on the spatter generation rate during the $CO_2$ gas metal arc welding (GMAW) were investigated. Normally using the inverter type power supply, of which the welding current waveform was regulated to reduce the spatter generation rate, but in this study pulsing was imposed on the welding current. Observation of the metal transfer phenomena during the pulsed current GMAS indicated that the droplet transfer from the electrode via the short circuit transfer and the repelling transfer mode could be minimized by selecting optimum combinations of pulsing parameters, which include base and peak current, base and pak duration. It was also demonstrated in this study that proper combinations of the pulsing parameters led to reduce generation of spatters during GMAW shielded by $CO_2$ gas.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 E
• /
• pp.1746-1748
• /
• 1997

The surface discharge type ac plasma display panel(ac PDP) is a flat display devices using gas discharge. In ac PDP, parallel electrodes covered with dielectric layer are on a substrates. The discharge current characteristics are affected by cell structure. In this study, the relationship between the principal design factor and discharge characteristics is discussed, based on experiment, and the current waveform is measured by voltage detector and storage O.S.C. as a parameter of design factor, e.g., electrode gap and width.

• 한국음향학회:학술대회논문집
• /
• 한국음향학회 1991년도 학술발표회 논문집
• /
• pp.15-20
• /
• 1991

In a text-to-speech system, sound units (e. q., phonemes, words, or phrases) can be concatenated together to produce required utterance. The quality of the resulting speech is dependent on factors including the phonological/prosodic contour, the quality of basic concatenation units, and how well the units join together. Thus although the quality of each basic sound unit is high, if occur the discontinuity in the concatenation part then the quality of synthesis speech is decrease. To solve this problem, a smoothing operation should be carried out in concatenation parts. But a major problem is that, as yet, no method of parameter smoothing is availalbe for joining the segment together.

• 전기학회논문지
• /
• 제60권2호
• /
• pp.279-284
• /
• 2011

Harmonic distortions in current waveform may cause significant problems in electric power system facility and operation. This paper presents an adaptive parameter estimation method to detect harmonic current components caused by nonlinear loads. In addition, a coordination strategy for multiple inverter-interfaced distributed generators to compensate the harmonic currents is discussed. The coordination strategy is realized by distributing the harmonic compensation participation index to individual distributed generators. The harmonic compensation participation index can be determined by the amount of remaining power generation capacity of each distributed generator. Simulation results based on switching-level inverter models show that the proposed harmonic detection method has good performance and the coordination strategy can improve harmonic problems efficiently.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 B
• /
• pp.1046-1048
• /
• 2004

Inductance is an important parameter determining the characteristics of current waveform in electric motors. There are many kinds of inductances, however, self and mutual inductances are the major components. These inductances are changed under the variation of the magnetic circuit, current, frequency etc., even in the same winding distribution. Therefore this paper deals with the characteristics of inductance according to the shape of stator tooth. The analysis model is newly developed motor made of SMC(Soft Magnetic Composite) to reduce the core loss in high speed. the result of this paper gives the basic understandings of inductance to extend the applications of the motors.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2006년도 춘계학술대회 논문집
• /
• pp.222-224
• /
• 2006

Electronic ballast uses various resonant type filters, which perform many important functions such as filtering the high frequency harmonics, shaping the proper lamp current waveform and regulating the lamp power. In this paper, characteristics of resonant type filters are reviewed and the matching problem between inverter and resonant filter are described. Transfer function which is always necessary for the circuit parameter design is derived in case of LCC filter type as an example.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부A
• /
• pp.159-162
• /
• 1998

In this paper, an algorithm of the automatic commissioning for vector controlled induction motor using controller characteristics is proposed. The automation of commissioning sequence is carried out using Walsh function analysis. In the proposed method, the distortion of the controller output waveform is easily detected and can be automatically tuned by using Walsh function analysis. This tuning algorithm has the advantage such as less sensitivity to the variation of other parameters and high sensitivity to parameter error. Hence, the easy tuning of high performance drive system of the induction motor is possible. Some experiments are carried out to prove the validity of the proposed automatic commissioning algorithm.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2008년도 추계학술대회 논문집
• /
• pp.144-150
• /
• 2008

In this paper, the safety for passengers of composite car-body against lightning strikes was analyzed by the application of an impulse generator which can produce impulse current up to 50 [kA] with 8/20 [us] waveform. Potential difference on inside surface of the car-body was measured as a safety parameter for the passengers against lightning strikes. The potential difference between 20 [cm] distant was 175 [V] at 37.67 [kA], and it corresponded to 875 [V] between 1 [m] distant. The amount of charge flowing a passenger at 100 [kA] impulse current can be estimated to 0.31 [mA s]. This is much less than the limit amount of charge for human body, 30 [mA s] which is presented by Koeppen and Osypka.