• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.27 no.4
• /
• pp.274-279
• /
• 2015

Wave data acquired over eleven years near Sokcho Harbor located in the central area of the east coast were analyzed using spectral method and wave-by-wave analysis method and its major wave characteristics were examined. Significant wave heights were found to be high in winter and low in summer, and peak periods were also found to be long in winter and short in summer. The maximum significant wave height observed was 8.95 m caused by the East Sea twister. The distributional pattern of the significant wave heights and peak periods were both fitted better by Kernel distribution function than by Generalized Gamma distribution function and Generalized Extreme Value distribution function. The wave data were compiled to subdivide the wave height into intervals for each month, and the cumulative occurrence rates of wave heights were calculated to be utilized for the design and construction works in nearby construction works.

• Journal of the Korean Solar Energy Society
• /
• v.37 no.4
• /
• pp.13-22
• /
• 2017

In this study, long and short-wave radiations were observed in urban and suburban areas during the summer season, and frequency analysis was performed for each radiation intensity by a new analysis method. The following results were obtained. (1) Long-wave radiation values were found to be larger in the afternoon than in the morning, in both urban and suburban areas, unlike short-wave radiation values. (2) Short-wave radiation showed a right-skewed frequency distribution. In the high energy area greater than $900W/m^2$, the frequency was significantly higher in the suburbs than in the urban areas. (3) Long-wave radiation was in the range of $290{\sim}479W/m^2$, its frequency distribution resembled a normal distribution, and the frequency of 410, $420W/m^2$ was the highest.

• Journal of Electrical Engineering and information Science
• /
• v.1 no.2
• /
• pp.52-57
• /
• 1996

Detection of arcing high impedance faults has been a perplexing in the power distribution protection. Transient analysis of distribution disturbances for fault discrimination from other normal events is important for a secure protection of the power system. A simple parameter of wave form distortion quantification is used to analyze the behaviors of arcing faults and normal distribution disturbances. Theoretical perspectives of the transients were studied and actual disturbances were examined. From this investigation, a discrimination guideline based on the revised crest factor is developed. The discrimination method has a high potential to enhance the reliability and security for the distribution system protection.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.27 no.2
• /
• pp.142-147
• /
• 2015

Wave data acquired over seven years near Daejin Harbor located in the north central area of the east coast was analyzed using spectral method and wave-by-wave analysis method and its major wave characteristics were examined. Significant wave heights were found to be high in winter and low in summer, and peak periods were also found to be long in winter and short in summer. The maximum significant wave height observed was 6.59 m and was caused by Typhoon No. 1216, SANBA. The distributional pattern of the significant wave heights and peak periods were both reproduced better by Kernel distribution function than by Generalized Gamma distribution function and Generalized Extreme Value distribution function. Meanwhile, the wave data was subdivided by month and wave height level and the cumulative appearance rate was proposed to aid designing and constructing works in nearby coastal areas.

• Journal of Ocean Engineering and Technology
• /
• v.24 no.1
• /
• pp.39-46
• /
• 2010

The calmness inside a harbor plays an important role in the appropriate disposition of harbor structures. However, it is not easy to acquire accurate computational results because these are affected by many factors concerned with wave transformation. Recently, numerical model tests, which are quicker and more economical than hydraulic model experiments, were carried out for the purpose of analyzing wave height distributions in harbors. This paper presents a numerical model that is able to calculate wave heights inside a harbor. It is based on a time-dependent mild slope involving wave refraction, diffraction, shoaling effect, and reflection. In particular, arbitrary reflectivity is used at the boundary in order to simulate the real harbor reflection condition. The proposed numerical model is applied to Samcheon new-harbor in order to investigate harbor calmness.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.23 no.3
• /
• pp.258-264
• /
• 2011

A MCS technique is represented to stochastically analyze the uncertainties of wave forces exerted on the upright sections of composite breakwaters. A stochastical models for horizontal and uplift wave forces can be straightforwardly formulated as a function of the probabilistic characteristics of maximum wave height. Under the assumption of wave forces followed by extreme distribution, the behaviors of relative wave forces to Goda's wave forces are studied by the MCS technique. Double-truncated normal distribution is applied to take the effects of uncertainties of scale and shape parameters of extreme distribution into account properly. Averages and variances of relative wave forces are quantitatively calculated with respect to the exceedance probabilities of maximum design wave height. It is found that the averages of relative wave forces may be decreased consistently with the increases of the exceedance probabilities. In particular, the averages on uplift wave force are evaluated slightly larger than those on horizontal wave force, but the variations of coefficient of the former are adversely smaller than those of the latter. It means that the uncertainties of uplift wave forces are smaller than those of horizontal wave forces in the same condition of the exceedance probabilities. Therefore, the present results could be useful to the reliability based-design method that require the statistical properties about the uncertainties of wave forces.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.31 no.3
• /
• pp.115-128
• /
• 2019

In this study, a probabilistic model for the estimation of yearly workable wave condition period for offshore operations is developed. In doing so, we first hindcast the significant wave heights and peak periods off the Ulsan every hour from 2003.1.1 to 2017.12.31 based on the meteorological data by JMA (Japan Meterological Agency) and NOAA (National Oceanic and Atmospheric Administration), and SWAN. Then, we proceed to derive the long term significant wave height distribution from the simulated time series using a least square method. It was shown that the agreements are more remarkable in the distribution in line with the Modified Glukhovskiy Distribution than in the three parameters Weibull distribution which has been preferred in the literature. In an effort to develop a more comprehensive probabilistic model for the estimation of yearly workable wave condition period for offshore operations, wave height distribution over the 15 years with individual waves occurring within the unit simulation period (1 hour) being fully taken into account is also derived based on the Borgman Convolution Integral. It is shown that the coefficients of the Modified Glukhovskiy distribution are $A_p=15.92$, $H_p=4.374m$, ${\kappa}_p=1.824$, and the yearly workable wave condition period for offshore work is estimated to be 319 days when a threshold wave height for offshore work is $H_S=1.5m$. In search of a way to validate the probabilistic model derived in this study, we also carry out the wave by wave analysis of the entire time series of numerically simulated significant wave heights over the 15 years to collect every duration periods of waves the height of which are surpassing the threshold height which has been reported to be $H_S=1.5m$ in the field practice in South Korea. It turns out that the average duration period is 45.5 days from 2003 to 2017, which is very close to 46 days from the probabilistic model derived in this study.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.28 no.5
• /
• pp.700-711
• /
• 2022

In this study, deepwater design waves were estimated for 16 wave directions and various return periods based on statistical analysis of extreme waves observed for more than 20 years at three stations (Chilbal-do, Geomun-do, Donghae). These values were compared with design waves estimated based on the omni-directional wave data. The Weibull distribution was used as the probability distribution function whose parameters were determined by the least square method. The Kolmogorov-Smirnov test was applied for the goodness of fit test. Notably, the directional design waves were smaller than the omni-directional design wave for every wave direction. The maximum 50-year wave heights for directional sectors were 7.46 m (NNE), 12.05 m (S), and 9,59 m (SSW) at Chilbal-do, Geomun-do and Donghae whereas those for uni-directional wave data were 7.91 m, 13.82 m and 10.38 m, respectively. This implied possible under-estimation of the deepwater design waves for 16 wave directions being currently used in the design of offshore and coastal structures.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.51 no.4
• /
• pp.152-157
• /
• 2002

This paper describes an effect of a single- and a quadruple-lightning impulse currents on electrical characteristics of ZnO blocks, and an expert system to diagnose arrestor deterioration. To deduce the parameters needed for diagnosing arrester deterioration, an accelerate deterioration teat is carried out. In the experiment, leakage current components are measured. Also, wave height distribution of the leakage current according to the progress of arrester deterioration is analyzed. From the experimental results, the wave height distribution of the leakage current showed conspicuous difference even in an immaterial leakage current increase. Therefore, the use of wave height distribution of the leakage current in deterioration diagnostic technique makes more accurate diagnosis than the conventional method by using only a leakage currant value. Finally, the expert system based on the experimental results is developed and the system can diagnose arrestor deterioration by measuring the leakage current and its wade height distribution.

• Journal of Ocean Engineering and Technology
• /
• v.17 no.6
• /
• pp.32-37
• /
• 2003

In this paper, finite element method is applied for the numerical analysis of wave height distribution. The mild-slope equation is used as the basic equation. The key of this model is to impose the effect of nonlinear waves. Numerical results are presented and agreed well with the results from experimental measurements and other numerical analysis. The present method to determine wave height distribution can be broadly utilized for the analysis of new harbor and port designs in the future.