• Journal of the Korean Chemical Society
• /
• 제57권2호
• /
• pp.272-278
• /
• 2013

Extract of ginger has been evaluated as a green inhibitor for the corrosion of steel in sulfide polluted NaCl solution using potentiodynamic polarization, electrochemical impedance spectroscopy (EIS) and electrochemical frequency modulation (EFM) techniques. Potentiodynamic polarization measurements showed that this extract acts as a mixed type inhibitor but mainly inhibits the cathodic reaction. The inhibition efficiency was found to increase with inhibitor concentration reaching to approximately 83.9% using 250 ppm of ginger. Nyquist plots show a single capacitive loop in uninhibited and inhibited solutions. From EFM the causality factors are very close to theoretical values which indicate that the measured data are of good quality. The adsorption process of the studied extract on steel surface obeys Temkin adsorption isotherm. The results obtained from the different electrochemical techniques were in good agreement which prove the validity of these tools in measurement of corrosion rate. Ginger extract has no effect on Escherichia Coli and can be applied safely on waste water treatment plants.

• Journal of Veterinary Clinics
• /
• 제15권1호
• /
• pp.156-161
• /
• 1998

This study investigated the microbiological changes and distribution of bacteria producing enzyme in order to change food wastes to animal feed during 6 days at room temperature. Food wastes were divided as follows: one is untreated food wastes containing 80% water content and another wastes containing 40% water content adiusted by wheat bran. During the fermentation of food wastes, Lactobacillus sp. and Streptococcus sp. were grown the top position among investigated microorganisms in both of food wastes. Numbers of total microorganisms were much more than untreated wastes during fermentation of flood wastes with 40% water content. But, Streptococcus sp. and Enterobacteriaceae from 4 to 6 days were not detected in treated wastes with 40% water contents. This fact indicated that the adiustment of water content in food waste was effective in fermentation. However, the numbers of microorganisms producing pretense were low in both treated and untreated food wastes. These results suggested that flood wastes should be treated as food wastes with 40% water content to maintain a lot of fermentative microorganisms such as Lactobacillus sp., Streptococcus sp. and yeasts together with pretense to make final animal feed.

• Journal of the Korean GEO-environmental Society
• /
• 제6권2호
• /
• pp.51-60
• /
• 2005

The disposal problem of waste lime which is a residual product of lime industry have caused a lots of arguments in the past few years. Further more, waste lime contains a high moisture content which causes the disposal of waste lime is a great difficulty. The purpose of this study is to investigate for the effective dewatering solutions by placing various prefabricated vertical drains. The moisture content and degree of consolidation, pore water pressure, changes of settlement, bearing capacity with various vertical drains in waste lime were analyzed. The laboratory test results indicate that PBD is 2 times higher than circular drain in coefficient of consolidation. Based on the laboratory test results, settlement, pore water pressure, and dewatering measurements are shown in similar tendency. It is considered that PBD can drain primitive pore water much efficiently. The picture of SEM shows that circular drain filter has a serious clogging problem in comparison with PBD. In conclusion, PBD holds a superiority in waste lime's ground improvement and dewatering pore water pressure from the waste lime sludge. Also, circular drain is desired for some modification in its filtering system.

• Journal of ILASS-Korea
• /
• 제28권1호
• /
• pp.43-48
• /
• 2023

The waste-heat-recovery boiler with water spray (HR-B/WS) applies the heat exchange between the inlet air and exhaust gas with the water spray into the inlet air. The evaporation of water in the inlet air promotes heat recovery from the exhaust gas so that thermal efficiency can be improved by the enhanced condensing effect. The NOx emission can also be reduced by lowering the flame temperature due to the dilution effect of the water. In this study, the validity of this concept is examined by the practical boiler test performed with a 24 kW condensing boiler under the full load condition according to the water injection amount. The theoretical amount of water injection is calculated under the assumption of full evaporation of the sprayed water, which is calculated as 50 g/min. Since the injected water cannot evaporate fully in the actual system, the maximum water spray amount is set as 100 g/min. The results showed that the water injection can increase the thermal efficiency up to 95.59% and reduce NOx and CO emissions simultaneously to 8.9 ppm and 35 ppm at 0% of O₂. Although the heat energy loss increased due to the unevaporated water, the increase in water injection amount caused higher thermal efficiency due to the increased amount of the evaporated water.

• Journal of the Korean Society of Food Culture
• /
• 제12권4호
• /
• pp.419-421
• /
• 1997

Washing water volume of rice for cooking and rice weight for one person per meal in one household were surveyed for confirming pollution by the washing water and total losses by rice washing procedures. The mean size of a family was 4.64 persons and the mean consumption weight of rice per capital per meal was 138.43g. It is used 0.782 L of water for washing the rice per capital share. The washing water of rice was composed of 0.32% of total solid, 0.11% of soluble solid and 1.65% of solid loss to rice, and COD and BOD of it were 2.400 and 3.564 ppm respectively. Based on total population in Korea, 41 miliion, excepting age below 4, total cost for washing water of rice summed up about 1,495 billion won including 8.8 billion won for tap water cost, 11.7 billion won for waste water treatment, and 129 billion for solid loss of rice.

• Proceedings of the SAREK Conference
• /
• 대한설비공학회 2006년도 하계학술발표대회 논문집
• /
• pp.1119-1124
• /
• 2006

The objectives of this paper are to investigate the performance of silica gel-water adsorption refrigeration system with heat recovery process from the system experiment. This system can be driven by waste heat at near ambient temperature from $60^{\circ}C$ to $90^{\circ}C$. The cooling capacity and coefficient of performance(COP) were measured from various experimental conditions. An experimental results revealed the influence of operating temperatures(hot, cooling and chilled water), water flow rates, and adsorption-desorption cycle times on cooling capacity and COP. Under the standard conditions of $80^{\circ}C$ hot water, $25^{\circ}C$ cooling water, $14^{\circ}C$ chilled water inlet temperatures and 420sec cycle time, a cooling capacity of 1.14kW and a COP for cooling of 0.55 can be achieved.

• Journal of the Korean GEO-environmental Society
• /
• 제4권4호
• /
• pp.5-16
• /
• 2003

The aggregate out of waste polyethylene was made in order to recycle waste polyethylene wasted in the country side. Many physical and mechanical experiments which include leaching test, specific gravity test, compaction test, LA abrasion test, large-scaled shear test, and permeability test were performed for the waste polyethylene aggregate. The thermal conductivity test, unfrozen water content test and frost heave test were also performed. The temperature distribution for both gravels and waste polyethylene aggregate, which were constructed in the frost heave layer in the field, was measured in winter season of continuous 2 years and compared.

• Resources Recycling
• /
• 제16권5호
• /
• pp.3-7
• /
• 2007

Waste aluminum dross was processed to prepare alum with sulfuric acid, and poly aluminum chloride(PAC) with hydrochloric acid. Metallic aluminum remained in the waste dross was dissolved into the sulfuric acid solution, and the solution could be used as alum for water treatment chemicals after adjusting the required alumina concentration and pH of the solution. Also, it was dissolved into the hydrochloric acid solution and processed to make PAC solution. Compared with the conventional method for preparation of alum and PAC using aluminum hydroxide, material cost could be saved in this method. Also, there is an additional merit in view of recycling of the waste aluminum dross by reducing the amount of waste disposed to landfill.

• Advances in concrete construction
• /
• 제4권2호
• /
• pp.145-160
• /
• 2016

Marble is a metamorphic rock used widely in construction which increases amount of marble powder obtained from it. Marble powder is a waste product obtained from marble during its processing. Marble waste is high in calcium oxide content which is cementing property but it creates many environmental hazards too if left in environment or in water. In this research, partial replacement of cement and sand by waste marble powder (WMP) has been investigated. Seven concrete mixtures were prepared for this investigation by partially replacing cement, sand with WMP at proportions of 0%, 10% and 15% by weight separately and in combined form. To determine compressive strength, flexural strength and split tensile strength of concrete made with waste marble powder, the samples at the curing ages of 7, 28 and 90 days was recorded. Different tests of durability were applied on samples like ultrasonic pulse wave test, absorption and sorptivity. For further investigation all the results were compared and noticed that WMP has shown good results and enhancing mechanical properties of concrete mix on partially replacing with sand and cement in set proportions. Moreover, it will solve the problem of environmental health hazard.

• Journal of Soil and Groundwater Environment
• /
• 제21권1호
• /
• pp.22-27
• /
• 2016

Hydrothermal carbonization (HTC) is a carbonization method of thermochemical process at a relatively low temperature (180-250℃). It is reacted by water containing raw material. In this study, it was selected for effective disposal method of food waste because food waste in Korea has large amount water. 5 kg, 10 kg, 15 kg of food waste were reacted for 6 hours at 200℃ for selecting the optimum amount of raw material. Since the derived optimum amount, food waste was reacted for 2 hours, 4 hours and 6 hours at 200℃ and 1.5 MPa. After carbonization, it was analyzed to evaluated the properties by ultimate analysis, iodine adsorption, BET surface area and SEM. After analyzing the characteristics, it can be utilized as a basic data for applied.