• Journal of Power Electronics
• /
• v.14 no.3
• /
• pp.413-420
• /
• 2014

The conventional Phase-Shift Full-Bridge (PSFB) converter has a serious voltage spike because of the ringing between the leakage inductance of the transformer and the parasitic output capacitance of the secondary side rectifier switches. To overcome this problem, an asynchronous active clamp technique employing an auxiliary DC/DC converter has been proposed. However, an exact analyses for designing the auxiliary DC/DC converter has not been presented. Therefore, the amount of power that is supposed to be handled in the auxiliary DC/DC converter is calculated through a precise mode analyses in this paper. In addition, this paper proposes a lossy snubber circuit with hysteresis characteristics to reduce the burden that the auxiliary DC/DC converter should take during the starting interval. This technique results in optimizing the size of the magnetic component of the auxiliary DC/DC converter. The operational principles and the theoretical analyses are validated through experiments with a 48V-to-30V/15A prototype.

• The Korean Journal of Physiology and Pharmacology
• /
• v.10 no.2
• /
• pp.59-64
• /
• 2006

The effects of $Zn^{2+}$ on spontaneous glutamate and GABA release were tested in mechanically dissociated rat CA3 pyramidal neurons which retained functional presynaptic nerve terminals. The spontaneous miniature excitatory and inhibitory postsynaptic currents (mEPSCs and mIPSCs, respectively) were pharmacologically isolated and recorded using whole-cell patch clamp technique under voltage-clamp conditions. $Zn^{2+}$ at a lower concentration $(30{\mu}M)$ increased GABAergic mIPSC frequency without affecting mIPSC amplitude, but it decreased both mIPSC frequency and amplitude at higher concentrations $({\ge}300{\mu}M)$. In contrast, $Zn^{2+}$ (3 to $100{\mu}M$) did not affect glutamatergic mEPSCs, although it slightly decreased both mIPSC frequency and amplitude at $300{\mu}M$ concentration. Facilitatory effect of $Zn^{2+}$ on GABAergic mIPSC frequency was occluded either in $Ca^{2+}$-free external solution or in the presence of $100{\mu}M$ 4-aminopyridine, a non-selective $K^{+}$ channel blocker. The results suggest that $Zn^{2+}$ at lower concentrations depolarizes GABAergic nerve terminals by blocking $K^{+}$ channels and increases the probability of spontaneous GABA release. This $Zn^{2+}$-mediated modulation of spontaneous GABAergic transmission is likely to play an important role in the regulation of neuronal excitability within the hippocampal CA3 area.

• The Korean Journal of Physiology and Pharmacology
• /
• v.4 no.1
• /
• pp.9-14
• /
• 2000

$K^+$ currents play multiple roles in the excitability of dorsal root ganglion (DRG) neurons. Influences on these currents change the shape of the action potential, its firing threshold and the resting membrane potential. In this study, whole cell configuration of patch clamp technique had been applied to record the blocking effect of capsaicin, a lipophilic alkaloid, on the delayed rectifier $K^+$ current in cultured small diameter DRG neurons of adult rat. Capsaicin reduced the amplitude of $K^+$ current in dose dependent manner, and the concentration-dependence curve was well described by the Hill equation with $K_D$ value of $19.1{\mu}M.$ The blocking effect of capsaicin was reversible. Capsaicin $(10 {\mu}M)$ shifted the steady-state inactivation curve in the hyperpolarizing direction by about 15 mV and increased the rate of inactivation. The voltage dependence of activation was not affected by capsaicin. These multiple effects of capsaicin may suggest that capsaicin bind to the region of $K^+$ channel, participating in inactivation process.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.11 no.6
• /
• pp.543-550
• /
• 2006

A three-level sustain circuit with six-switches for an ac plasma display panel (AC-PDP) drive is proposed. The proposed circuit features half the voltage stresses of sustain switches and clamp diodes and significantly reduced power losses compared with those of the conventional ones. This circuit, realizable with reduced cost of the semiconductor devices, gives a significant improvement in the power efficiency, essential for the design of a drive circuit for the AC-PDP. A comparative analysis and experimental results we presented to show the validity of the proposed sustainer circuit.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.11a
• /
• pp.744-749
• /
• 2005

In this paper, a lens actuator for mobile devices is proposed using stack type piezoelectric materials. In general, the deformation of PZT actuators is not enough for lens motion when the allowed voltage is applied. The small stroke problem can be solved by accumulating a lot of small displacements in high frequency. In this paper, a new inch-worm type model for focusing actuator is suggested based on the interaction of inertial and frictional forces. Theoretical analysis and simulation using ANSYS are performed to verify the feasibility of the inch-worm PZT actuator model. Various types of clamps are considered to determine the effect of frictional force on the motion, and appropriate clamp-actuator models are proposed. The proposed models are experimentally verified and the experimental results show high correspondence with theoretical and simulated values. The inch-worm type focusing actuator enable a large stroke with 7.79 mm/sec with 10kHz and 10V.

• Proceedings of the KIPE Conference
• /
• 2011.07a
• /
• pp.348-349
• /
• 2011

본 논문에서는 새로운 구조의 능동 클램프 ac-dc 컨버터를 제안한다. 제안된 컨버터는 강압형 ac 쵸퍼와 voltage doubler로 구성되며, 직접전력변환을 함으로써 간단한 구조와 고효율을 가진다. 강압형 ac 쵸퍼는 ac-ac 전력변환과 능동 클램프역할을 하며, 스위치의 전압 스트레스와 스위칭 손실을 최소화 한다. 또한, voltage doubler의 공진 커패시터와 변압기의 누설 인덕턴스는 공진회로를 형성하여 출력 다이오드의 역회복 문제를 해결한다. 본 논문에서는 제안된 회로의 이론적 해석을 실험을 통해 검증한다.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.27 no.11
• /
• pp.686-689
• /
• 2014

Electrostatic discharge has been considered as a major reliability problem in the semiconductor industry. ESD reliability is an important issue for these products. Therefore, each I/O (Input/Output) PAD must be designed with a protection circuitry that creates a low impedance discharge path for ESD current. This paper presents a novel Lateral Insulated Gate Bipolar (LIGBT)-based ESD protection circuit with latch-up immunity and high robustness. The proposed circuit is fabricated by using 0.18 um BCD (bipolar-CMOS-DMOS) process. Also, TLP (transmission line pulse) I-V characteristic of proposed circuit is measured. In the result, the proposed ESD protection circuit has latch-up immunity and high robustness. These characteristics permit the proposed circuit to apply to power clamp circuit. Consequently, the proposed LIGBT-based ESD protection circuit with a latch-up immune characteristic can be applied to analog integrated circuits.

• Proceedings of the KIPE Conference
• /
• 2006.06a
• /
• pp.356-359
• /
• 2006

This paper presented the power losses comparison results with the Active clamp Forward, the Asymmetrical half bridge and the Two transistor forward converters. To estimate for conduction losses in the converters, the steady state analysis regard to parasitic resistance and current effective values for main parts of converters was derived. In addition, the theoretical efficiency for the converters with input voltage 400V, output voltage 12V and maximum power 480W was discussed.

• Proceedings of the KIPE Conference
• /
• 2003.11a
• /
• pp.99-103
• /
• 2003

Recently, a fuel cell with low voltage and high current of electronic output characteristics is remarkable for new generation system. It needs both a dc-dc boost converter and do-ac inverter to be used in domestic power. Therefore, this paper presents do-dc boost converter with ZVS for fuel cell generation system This topology has several advantages, which are ZVS characteristics of all of main and auxiliary switches, reduction of reactor component size because of high frequency switching, and low rated voltage stress of the switches. In this paper, theoretical analysis, operation principle, and design procedures are presented. And simulation results from Pspice are presented to validate the theoretical analysis.

• Proceedings of the KIEE Conference
• /
• 2006.07b
• /
• pp.1057-1058
• /
• 2006

In this paper, the proposed power supply is based on a modified version of the zero-voltage switching(ZVS) full-bridge phase-shift DC-DC converter, which incorporates commutation auxiliary inductors to provide ZVS for the entire load range as well as a commutation aid circuit to clamp the output diode voltage. The control strategy is based on two control loops operating in cascade mode. The complete operating principles and simulation results in presented.