• Steel and Composite Structures
• /
• 제43권2호
• /
• pp.153-164
• /
• 2022

In this study, a series of cyclic loading tests were performed on viscoelastic dampers (VED) composed of viscoelastic polymer composite material and thin steel plates to observe the variation of the mechanical properties under different loading conditions. A mathematical model was developed based on the Kelvin-Voigt and Bouc-Wen models to formulate the nonlinear force-displacement relationship of the viscoelastic damper. The accuracy of the proposed mathematical model was verified using the data obtained from the tests. The mathematical model was applied to analyze a reinforced concrete framed structure retrofitted with viscoelastic dampers. Nonlinear dynamic analysis results showed that the average maximum inter-story drift ratios of the retrofitted structure met the target limit state after installing the VED. In addition, both the maximum and residual displacements were significantly reduced after the installation of the VED.

• 한국지진공학회논문집
• /
• 제7권3호
• /
• pp.1-7
• /
• 2003

점탄성 감쇠기의 설계를 위한 자료를 얻기 위해 실물크기 5층 건물에 대해 가진과 시스템 식별을 수행하였다. 5층 바닥에 설치된 HWD는 건물을 움직이는 외부 가진력으로 작용하였고, 각 층의 응답을 측정하여 점탄성 감쇠기의 용량과 최적위치에 필요한 자료를 확보하였다. 고유진동수, 감쇠비, 모드와 같은 동적특성을 파악하기 위해 건물에 HMD로 조화하중과 백색잡음 하중을 주어 실험을 수행하였다. 동반논문에서는 건물의 층간에 설계된 점탄성 감쇠기를 설치한 후 응답 거동을 얻기 위한 실험 연구를 수행하였다.

• 한국감성과학회:학술대회논문집
• /
• 한국감성과학회 1999년도 춘계학술발표논문집 논문집
• /
• pp.147-152
• /
• 1999

We have measured viscoelastic properties of fabrics in thickness direction. We assume that Maxwell model is very useful in stress relaxation of viscoelastic theories and appropriate formulas for fabric are calculated. Measurement system constitute of high precession load cell, translator and laser displacement sensor for viscoelastic properties was designed and elastic coefficients and damping coefficients were measured for 10 fabric samples. Elastic coefficients measured were 19~25 kN/㎡ and Damping coefficients measured were 4.8~8.7 MN$.$s/㎡. We concluded that these coefficients are good related with FUKURAMI collected from KESF system

• Structural Engineering and Mechanics
• /
• 제61권2호
• /
• pp.193-207
• /
• 2017

In this study, the vibration of an electrostatically actuated micro cantilever beam is analyzed in which a viscoelastic layer covers a portion of the micro beam length. This proposed model is considered as the main element of mass and pollutant micro sensors. The nonlinear motion equation is extracted by means of Hamilton principle, considering nonlinear shortening effect for Euler-Bernoulli beam. The non-linear effects of electrostatic excitation, geometry and inertia have been taken into account. The viscoelastic model is assumed as Kelvin-Voigt model. The motion equation is discretized by Galerkin approach. The linear free vibration mode shapes of non-uniform micro beam i.e. the linear mode shape of the system by considering the geometric and inertia effects of viscoelastic layer, have been employed as comparison function in the process of the motion equation discretization. The discretized equation of motion is solved by the use of multiple scale method of perturbation theory and the results are compared with the results of numerical Runge-Kutta approach. The frequency response variations for different lengths and thicknesses of the viscoelastic layer have been founded. The results indicate that if a constant volume of viscoelastic layer is to be deposited on the micro beam for mass or gas sensor applications, then a modified configuration may be found by using the analysis of this paper.

• Advances in concrete construction
• /
• 제10권2호
• /
• pp.141-149
• /
• 2020

In the present study, a mechanical model is applied to account the effects of the surrounding viscoelastic media on the buckling behavior of single microfilament within the cell. The model immeasurably associates filament's bending rigidity, neighboring system elasticity, and cytosol viscosity with buckling wavelengths, buckling growth rates and buckling amplitudes of the filament. Cytoskeleton components in living cell bear large compressive force and are responsible in maintaining the cell shape. Actually these filaments are surrounded by viscoelastic media consisting of other filaments network and viscous cytosole within the cell. This surrounding, viscoelastic media affects the buckling behavior of these filaments when external force is applied on these filaments. The obtained results, indicate that the coupling of viscoelastic media with the viscous cytosol greatly affect the buckling behavior of microfilament. The buckling forces increased with the increase in the intensity of surrounding viscoelastic media.

• Structural Engineering and Mechanics
• /
• 제35권4호
• /
• pp.387-407
• /
• 2010

In this paper, using perturbation and Galerkin method, the response of a resonant viscoelastic microbeam to an electric actuation is obtained. The microbeam is under axial load and electrical load. It is assumed that midplane is stretched, when the beam is deflected. The equation of motion is derived using the Newton's second law. The viscoelastic model is taken to be the Kelvin-Voigt model. In the first section, the static deflection is obtained using the Galerkin method. Exact linear symmetric mode shape of a straight beam and its deflection function under constant transverse load are used as admissible functions. So, an analytical expression that describes the static deflection at all points is obtained. Comparing the result with previous research show that using deflection function as admissible function decreases the computation errors and previous calculations volume. In the second section, the response of a microbeam resonator system under primary and secondary resonance excitation has been obtained by analytical multiple scale perturbation method combined with the Galerkin method. It is shown, that a small amount of viscoelastic damping has an important effect and causes to decrease the maximum amplitude of response, and to shift the resonance frequency. Also, it shown, that an increase of the DC voltage, ratio of the air gap to the microbeam thickness, tensile axial load, would increase the effect of viscoelastic damping, and an increase of the compressive axial load would decrease the effect of viscoelastic damping.

• Journal of Mechanical Science and Technology
• /
• 제18권1호
• /
• pp.12-19
• /
• 2004

Using LSM (laser scanning method) , the radius of curvature due to thermal deformation in polyimide film coated on Si substrate is measured. Since the polyimide film shows viscoelastic behavior, i.e., the modulus and deformation of the film vary with time and temperature, we estimate the relaxation modulus and the residual stresses of the polyimide film by measuring the radius of curvature and subsequently by performing viscoelastic analysis. The residual stresses relax by an amount of 10％ at 100$^{\circ}C$ and 20% at 150$^{\circ}C$ for two hours.

• Steel and Composite Structures
• /
• 제50권4호
• /
• pp.429-441
• /
• 2024

This paper studies the free vibration behavior of trapezoidal shaped coupled double-layered graphene sheets (DLGS) system using first-order shear deformation theory (FSDT) and incorporating nonlocal elasticity theory. Two nanoplates are assumed to be bonded by an interlayer van der walls force and surrounded by an external kelvin-voight viscoelastic medium. The governing equations together with related boundary condition are discretized using a mapping-differential quadrature method (DQM) in the spatial domain. Then the natural frequency of the system is obtained by solving the eigen value matrix equation. The validity of the current study is evaluated by comparing its numerical results with those available in the literature and then a parametric study is thoroughly performed, concentrating on the series effects of angles and aspect ratio of GS, viscoelastic medium, and nonlocal parameter. The model is used to study the vibration of DLGS for two typical deformation modes, the in-phase and out-of-phase vibrations, which are investigated. Numerical results indicate that due to Increasing the damping parameter of the viscoelastic medium has reduced the frequency of both modes and this medium has been able to overdamped the oscillations and by increasing stiffness parameters both in-phase and out-of-phase vibration frequencies increased.

• Steel and Composite Structures
• /
• 제25권2호
• /
• pp.141-155
• /
• 2017

This paper presents an investigation into the magneto-thermo-mechanical vibration and damping of a viscoelastic functionally graded-carbon nanotubes (FG-CNTs)-reinforced curved microbeam based on Timoshenko beam and strain gradient theories. The structure is surrounded by a viscoelastic medium which is simulated with spring, damper and shear elements. The effective temperature-dependent material properties of the CNTs-reinforced composite beam are obtained using the extended rule of mixture. The structure is assumed to be subjected to a longitudinal magnetic field. The governing equations of motion are derived using Hamilton's principle and solved by employing differential quadrature method (DQM). The effect of various parameter like volume percent and distribution type of CNTs, temperature change, magnetic field, boundary conditions, material length scale parameter, central angle, viscoelastic medium and structural damping on the vibration and damping behaviors of the nanocomposite curved microbeam is examined. The results show that with increasing volume percent of CNTs and considering magnetic field, material length scale parameter and viscoelastic medium, the frequency of the system increases and critically damped situation occurs at higher values of damper constant. In addition, the structure with FGX distribution type of CNTs has the highest stiffness. It is also observed that increasing temperature, structural damping and central angle of curved microbeam decreases the frequency of the system.

• 전산구조공학
• /
• 제11권1호
• /
• pp.171-178
• /
• 1998

점탄성감쇠기가 장치된 건물은 감쇠력과 강성이 증가하며 부가되는 감쇠력에 의하여 비고전적 감쇠시스템이 된다. 이러한 경우 비감쇠시스템에서 구한 고유값을 이용하여 감쇠행렬을 대각행렬로 변환할 수 없으므로 일반적으로 운동방정식을 2n크기 행렬의 1차 미분방정식 형태로 변환하여 해석하게 된다. 이러한 방법은 일반적인 고전적 감쇠시스템에 비해 복잡하므로 감쇠행렬의 비대각항을 무시하고 해석하는 방법이 이용되기도 한다. 본 논문에서는 이러한 근사적인 방법의 타당성과 이론적 근거를 검증하고 정해와 근사해법을 이용하여 3층 전단건물의 진동특성을 구하여 비교하였다. 결과에 따르면 부가되는 감쇠력이 작을 때는 근사해와 정해가 매우 근접하나 감쇠력이 커질수록 그 오차가 커지는 것으로 나타났다.