• Bulletin of the Korean Chemical Society
• /
• v.22 no.12
• /
• pp.1345-1349
• /
• 2001

New quadruply-bridged calix[6]arenes (I-V) have been studied as cesium selective ionophores in poly(vinyl chloride) (PVC) membrane electrodes. PVC membranes were prepared with dioctyl sebacate (DOS) or 2-nitrophenyl octyl ether (o-NPOE) as the sol vent mediator and potassium tetrakis(p-chlorophenyl)borate as the lipophilic salt additive. These ionophores produced electrodes with near-Nernstian slope. The selectivity coefficients for cesium ion with respect to alkali, alkaline earth and ammonium ions have been determined. The lowest detection limit (logaCs+ = -6.3) and the higher selectivity coefficient (logkpotCs+,Rb+ = -2.1 by SSM, -2.3 by FIM for calix[6]arene I) for Cs+ have been obtained for membranes containing quadruply-bridged calix[6]arenes (I, Ⅱ, Ⅲ), which have no para t-butyl substituents on the bridging benzene ring.

• Bulletin of the Korean Chemical Society
• /
• v.20 no.6
• /
• pp.672-676
• /
• 1999

Gas-Permeable polymeric membranes containing carboxyl groups which are suitable for enzyme immobilization were investigated in order to use them as gas electrode membranes in biosensors. Carboxylated polyurethane (CPU) was synthesized via a reaciton between 2,2-bis(hydroxymethyl)propionic acid as a chain extender and prepolymers prepared from polycarprolactone(Mn=2,000) and 4,4'-diphenylmethane diisocynate. It was difficult to prepared membranes from the pure CPU because of its high elasticity and cohesion. However, transparent free-standing membranes were easily prepared from the blend solution of CPU and carboxylated poly(vinyl chloride)(CPVC) in tetrahydrofuran. Both elasticity and cohesion of the CPU/CPVC membranes were decreased with increasing the content of CPVC. DSC experiment suggests that CPU and CPVC may be well mixed. Permeability coefficients for O₂and CO₂(Po₂and Pco₂)in the membranes increased as the proportion of CPU increased. The addition of dioxtyl phthalate(DOP), a plasticizer, significantly enhanced the Po₂and Pco₂which were 4,4 and 30 barrer, respectively, in the CPU/CPVC(80/20 wt/wt) membranes containing 20% of DOP at 25℃ and 100psi. Thus this type of membranes may have a potential for the use as gas electrode membranes in biosensors.

• Proceedings of the Korean Fiber Society Conference
• /
• 2002.04a
• /
• pp.191-194
• /
• 2002

완전히 가수분해 된 폴리비닐알콜(PVA)는 쉽게 결정화되기 때문에 일부 가수분해된 PVA보다 에멜전 안정화와 계면활성이 약하다$^{1)}$ . 이러한 성질을 개선하려면 폴리비닐알콜분자에 hydrophobic한 알킬기를 도입하는 것이 주요한 방법이다. 폴리비닐알콜 분자에 긴 알킬기를 도입하는 방법에는 chain transfer 반응을 통하여 폴리비닐아세테이트(PVAc)분자의 말단에 긴 알킬기를 도입한 후 가수분해하는 방법$^{1)}$ ; 비닐아세테이트 (VAc)가 긴 알킬리를 가진 비닐 단량체와 copolymerization 한 후 가수분해하는 방법 $^{2),3)}$ ; 합성된 PVA가 긴 알킬리를 긴 알킬리를 가진 acyl chloride와 직접 반응하여 얻는 방법$^{4)}$ 등이 있다. (중략)

• Elastomers and Composites
• /
• v.27 no.4
• /
• pp.267-274
• /
• 1992

Polydimethylsiloxane(PDMS)-containing polyurethane coating materials were synthesized because PDMS-based elastomers have unique properties including an extremely low glass transition temperature, good thermal and oxidative stability, and good dielectric properties. In this experiment a vinyl copolymer which consisted of vinyl chloride, vinyl acetate, vinyl alcohol, and maleic acid was used, and Coronate L was used as a polyisocyanate. PDMS-containing polyurethane was synthesized from polydimethylsiloxane, MDI, and 1,4-butanediol. Films were casted by reaction of viny copolymer, Coronate L, and PDMS-containing polyurethane. Thickness of tile films were $150-170{\mu}m$ and the films were characterized by IR, DSC, and Instron.

• Proceedings of the Korean Fiber Society Conference
• /
• 1991.06a
• /
• pp.39-39
• /
• 1991

• Macromolecular Research
• /
• v.17 no.7
• /
• pp.516-521
• /
• 2009

Techflex$^{(R)}$, a polypropylene-lined, multilayer infusion bag, was studied for its compatibility with diazepam, in comparison to the conventional infusion bag, Safeflex$^{(R)}$, which is comprised of poly(vinyl chloride) (PVC). Diazepam was diluted in 0.9% sodium chloride isotonic solution and stored in the infusion bags for 24 h. To evaluate the sorption of diazepam into the infusion bags during storage, the concentration of the drug remaining in the bag was measured using gas chromatography-mass spectroscopy. The PVC bags exhibited a marked sorption of diazepam, with a drug loss reaching up to 90% of the initial concentration after 24 h of contact, whereas Techflex$^{(R)}$ inhibited the drug sorption, showing approximately 10%, under the same conditions. The differences in the sorption behaviors of the bags are discussed in terms of solubility parameters and crystallinities of the polymers.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.11a
• /
• pp.537-540
• /
• 2003

The effects of substituting cement with fly ash(10%, 15%, 20%) and different fiber addition(polypropylene, cellulose, poly vinyl alcohol), on the control of microcrack and enhanced durability performance of face slab concrete in CFRD was studied experimentally It was conducted experiments of plastic shrinkage of mortar and concrete, and drying shrinkage of concrete. Also, durability test were carried out the chloride permeability, abrasion resistance and freeze-thaw repetition. Through the experimental results, it was concluded that ploy vinyl alcohol fiber containing concrete was the most effective mixture in control of cracking and durability.

• Bulletin of the Korean Chemical Society
• /
• v.7 no.2
• /
• pp.142-145
• /
• 1986

Vinylation of highly hindered ${\beta}$-acetoxyvinyl mercurials with olefins in acetonitrile at room temperature in the presence of cupric chloride, as a reoxidant for the palladium, and a catalytic amount of $LiPdCl_3$ gave the corresponding conjugated dienes in moderate to good yields. The (E) or (Z) geometry in vinyl mercurials was retained in the vinylated products. The reaction was tolerant of a wide variety of functional groups ($CO_2$R, CN, OR, OAc) on either the vinyl mercurial or olefin compounds.

• Textile Coloration and Finishing
• /
• v.20 no.6
• /
• pp.75-81
• /
• 2008

This paper dealt with the synthesis and characterization of the polymeric product by the reaction of the water-soluble poly(vinyl alcohol)[PVA] nonwoven fabrics and the phosphoryl chloride ($POCl_3$), which has been applied to prepare water-proofing materials or intermediates for increasing water-proofing or fire-proofing ability of commercially available water-soluble PVA support layer. $POCl_3$ was reacted with PVA nonwoven fabrics under non-aqueous condition, and their reactivity, and chemical structure were checked and discussed. PVA was reacted with $POCl_3$ under the reaction condition of 1:1, or 1:2 mole ratios at 70, 80 and $90^{\circ}C$, and the reaction products were further hydrolyzed. The structure of the resulting products from water soluble PVA nonwoven fabrics reacted with $POCl_3$ were identified by FT-IR or X-ray fluorescence spectrophotometer, and they indicated the PVA polymer chains to have phosphorous and chlorine moieties.

• Polymer(Korea)
• /
• v.39 no.2
• /
• pp.247-255
• /
• 2015

Poly(1,2-propylene glycol adipate) (PPA) was used as an environmentally friendly plasticizer in flexible poly(vinyl chloride) (PVC). Thermal, mechanical, and rheological properties of the PVC/PPA blends were characterized by differential scanning calorimetry, dynamic mechanical analysis, tensile test, scanning electron microscopy and small amplitude oscillatory shear rheometry. The results showed that PPA lowered the glass transition temperature of PVC. The introduction of PPA could decrease tensile strength and Young's modulus of the PVC/PPA blends; however, elongation-at-break was dramatically increased due to the plastic deformation. The plasticization effect of PPA was also manifested by the decrease of dynamic storage modulus and viscosity in the melt state of the blends. The results indicated that PPA had a good plasticizing effect on PVC.