• Journal of Fashion Business
• /
• v.20 no.6
• /
• pp.94-110
• /
• 2016

A necessity for infants, diapers are not only used over long durations, but are also in direct contact to the infants' skin, making the choice of diaper to be of utmost importance. Current interest in cloth diapers is rapidly increasing because of issues concerning the baby's health, green environment, and economy. However, previous researches on cloth diapers are limited to simply investigating the form and material of commercial cloth diapers. There are few in-depth researches for the optimal cloth diaper development. This is therefore a fundamental research for the development of optimized cloth diapers, and analyzes the difference in absorption depending on the placement of seam line (liner, darts, and I pattern), the locations of liquid spraying (1 cm and 8 cm ahead of the center), and the amount of liquid capacity (10 and 20 ml). Currently, the development of diaper patterns considers the crotch shape of the infants and the skin length deformation. As a result, in the case of the I-pattern, the horizontal seam line prevents water from spreading to the front and back, thus reducing the absorbed area. This result was more clearly visible when water was sprayed at the center. The effect of the seam line became more obvious when there was more water (20 ml); also, when water was sprayed at the center, more leakage was observed. Using the results of this research, implementation of horizontal seam is expected to prevent the upward spread of urine.

• Journal of Advanced Marine Engineering and Technology
• /
• v.27 no.6
• /
• pp.797-805
• /
• 2003

This paper describes experimental investigations of helium-air exchange flow through single opening and partitioned opening. Such exchange flows may occur following rupture accident of stand pipe in high temperature gas cooled reactor. A test vessel with a small opening on top of test cylinder is used for experiments. An estimation method of mass increment is developed and applied to measure the exchange flow rate. A technique of flow visualization by Mach-Zehnder interferometer is provided to recognize the exchange flows. Flow measurements are made with the opening, for partition ratios H_p/H$_1$$ in the range 0 to 1. where H_p$ and H$_1$ are partition length and height of the opening. respectively. In the case of H_p/H$_1$$ of 0, flow passages of upward flow of the helium and downward flow of the air within the opening are unseparated (bidirectional), and the two flows interfere within the opening. The unseparated flow increases strength of flow resistance and therefore, the exchange flow rate is minimum through range of the partition ratios. Two flow zones, i.e., separated (unidirectional) flow zone and unseparated (bidirectional) flow zone, exist with increasing the partition length. The exchange flow rate increases with increasing the separated flow zone. It is found that a maximum exchange flow rate exists at H_p/H$_1$$ of 1. As a result of comparison of the exchange flow rates by changing the partition ratio, the fluids Interference in the unseparated zone is found to be an important factor on the helium-air exchange flow rate.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.6
• /
• pp.1789-1793
• /
• 2014

Pseudo-first-order rate constants ($k_{obsd}$) have been measured spectrophotometrically for the reactions of 5-nitro-8-quinolyl nicotinate (4) and 5-nitro-8-quinolyl isonicotinate (5) with alkali metal ethoxides (EtOM; M = K, Na and Li) in anhydrous ethanol at $25.0{\pm}0.1^{\circ}C$. The plots of $k_{obsd}$ vs. [EtOM] curve slightly upward for the reactions with EtOK and EtONa but are linear for the reactions with EtOLi and for those with EtOK in the presence of 18-crown-6-ether. Dissection of $k_{obsd}$ into $k_{EtO^-}$ and $k_{EtOM}$ (i.e., the second-order rate constants for the reactions with the dissociated $EtO^-$ and ion-paired EtOM, respectively) has revealed that the reactivity increases in the order $EtO^-{\approx}EtOLi$ < EtOK < EtONa for the reactions of 4 and EtOLi < $EtO^-$ < EtOK < EtONa for the reactions of 5. Comparison of the kinetic results for the reactions of 4 and 5 with those reported previously for the corresponding reactions of 5-nitro-8-quinolyl benzoate (2) and picolinate (3) has revealed that the esters possessing a pyridine ring (i.e., 3-5) are significantly more reactive than the benzoate ester 2 due to the presence of the electronegative N atom (e.g., 2 << 3 < 4 < 5). It has been concluded that $M^+$ ion catalyzes the reactions of 3-5 by increasing the electrophilicity of the reaction center through a five-membered cyclic transition state (TS) for the reaction of 3 and via a four-membered cyclic TS for the reactions of 4 and 5.

• Journal of the Korea Concrete Institute
• /
• v.15 no.6
• /
• pp.894-901
• /
• 2003

The objective of this study is to clarify the seismic capacity and the characteristics in the hysteretic behavior of RC structures with non-seismic detailing. Interior and exterior beam-column subassemblages were selected from a ten-story RC building and six 1/3-scale specimens were constructed with three variables; (1) with and without slab, (2) with and without hoop bars in the joint region, (3) upward and downward direction of anchorage for the bottom bar in beams of exterior beam-column subassemblage. The test results have shown; (1) in case of interior beam-column subassemblage, there is no almost difference between nonseismic and seismic details in the strength and ductility capacity; (2) the Korean practice of anchorage (downward and 25 $d_{b}$ anchorage length) in the exterior joint caused the 10%∼20% reduction of strength and 27% reduction of ductility in comparison with the case of seismic details; and the existence of hoop bars in the joint region shows no effect in shear strain.

• Atmosphere
• /
• v.23 no.3
• /
• pp.245-264
• /
• 2013

Heavy rain over the Gangwon region has distinct characteristics in the temporal and spatial distribution of rainfall, most of which are concentrated on a very short period of time and either part of Yeongdong and Yeongseo regions. According to its regional distribution, heavy rain events over the Gangwon region may be classified into Yeongdong and Yeongseo heavy rain in which rainfalls of more than 110 mm $(6 hrs)^{-1}$ (heavy rain warning) have been observed in at least one of the weather stations over only Yeongdong or Yeongseo region, but over the other region the rainfalls are less than 70 mm $(6 hrs)^{-1}$ (heavy rain advisory). To differentiate between Yeongdong and Yeongseo heavy rain, 9 cases for Yeongdong heavy rain and 8 cases for Yeongseo heavy rain are examined on their synoptic and mesoscale environments using some meteorological parameters and ingredients. In addition, 8 cases are examined in which heavy rain warning or advisory are issued in both Yeongdong and Yeongseo regions. The cases for each heavy rain type have shown largely similar features in some meteorological parameters and ingredients. Based on an ingredient analysis, there are three common and basic ingredients for the three heavy rain types: instability, moisture, and lift. However, it is found that the distinct and important process producing strong upward vertical motions may discriminate among three heavy rain types very well. Yeongdong heavy rain is characterized by strong orographic lifting, Yeongseo heavy rain by high instability (high CAPE), and heavy rain over both regions by strong synoptic-scale ascent (strong 850 hPa Q-Vector convergence, diagnostics for ascent). These ingredients and diagnostics for the ingredients can be used to forecasting the potential for regional heavy rain. And also by knowing which of ingredients is important for each heavy rain type, forecasters can concentrate on only a few ingredients from numerous diagnostic and prognostic products for forecasting heavy rain events.

• Journal of the Korean Society of Tobacco Science
• /
• v.28 no.1
• /
• pp.58-66
• /
• 2006

Threshold limit value (TLV) test between expert and consumer panel was conducted about absolute, recognition and difference threshold respectively. And we tried to suggest appropriate and minimum acceptable menthol concentration level by consumer panel. Determination of threshold value was based on ASTM E 679-79 method by forced-choice ascending concentration series. In addition, a semi-ascending paired difference method was referred to conduct test. The group threshold value was determined as the value of geometric mean individual threshold. The smokers were dividend by two groups, trained and consumer panel. Trained panel was selected according to sensitivity to menthol discrimination. Consumer panel wasrecruited in proportion as population ratios including female smokers. They were all over twenty years old volunteers and summed up thirty four persons. In terms of sensor evaluation, overall difference test with seven-category scale by both trained and consumer panelists were done. On judging correct or incorrect answer, two by three cut-off levels applied to. Every test was conducted with two sessions, before smoking and during smoking period. And, only two samples served each paneI per test with regard to sensory fatigue and reliable results. All tests were replicated, and in total 32 times per panelist. In conclusion, the recognition threshold about consumer and expert panel was 358 ppm/cig. and 276 ppm/cig. in separately. Besides, absolute and difference thresholds were obtained also. And, we conduct difference threshold test with two different ways, upward and downward. And, The results of each method were 246, 195 ppm/cig., 1414, 1336 ppm/cig. and 1047, 972 ppm/cig.

• Journal of Fashion Business
• /
• v.12 no.6
• /
• pp.107-123
• /
• 2008

The purpose of this research is to compare and analyze the brassiere patterns sold in Shanghai and Korea and to present basic materials needed in developing the brassiere patterns in Chinese adult women market. The study subject which is to find the difference in brassiere patterns of Korea and China has been selected of 3 Korean brands and 4 Chinese brands. 1. For the brassiere patterns sold in Korea, it were using the same size for the width of Hook&Eye, space between the shoulder lace on the back, slope of wing and the location of the Keeper was similar. 2. For the cup supporting base, Chinese brassiere covers the lower part of the breast and as it is not comfortable and has a phenomenon of loosening up, there were severe puckering. For issues in the wearing experiment, amendments in patterns with the cup part was required. 3. Chinese brassieres were big differences in wing angles and for Aimer, it had the steepest trend in wings and thus the wings headed down and for Gujin, as the angle of the wing was smaller than $90^{\circ}$, it was heading upward. 4. Upon comparing the patterns of the Korean and Chinese brassiere, although most of the sizes excluding the wing angle had similar sizes, there was big differences in the wing angle. The reason why the brassiere patterns sold in China had bigger wing angle was due to the fact that more Chinese women had sway back body type than the Korean women and should reflect such difference in body size into making the brassiere patterns for each women.

• Nuclear Engineering and Technology
• /
• v.25 no.3
• /
• pp.381-393
• /
• 1993

This paper presents the experimental results on flooding of countercurrent flow in vertical multirod channels, which consists of falling water film and upward air flow. In particular, the effects of spacer grids, with and without mixing vane, and of blockage in the multirod bundle on the behaviour of flooding were investigated. The 5$\times$5 zircaloy tube bundle was used for the test section. The comparison of previous analytical models and empirical correlations with present data on flooding showed that the existing models and correlations predict much higher flooding curves. The spacer grid causes the lower flooding air flow rate to compare with the bare rod bundle. However, the mixing spacer grids need a higher flooding air flow rate for a constant liquid flow rate than the spacer grids without mixing vanes. The bundle containing blockages has the highest flooding air flow rate among the bundles with spacer grids and blockages. Empirical flooding correlations for the three types of test section have been made.

• Nuclear Engineering and Technology
• /
• v.20 no.2
• /
• pp.112-119
• /
• 1988

The purpose of this work is to obtain the experimental data for the forced How dryout heat flux in a heat generating stratified debris bed which simulates the degraded nuclear reactor core after severe accident. The present observations were mainly focused on the effect of coolant mass flux on the dryout heat flux in the stratified debris bed which consists of several layers with selected particle sizes under constant bed depth and temperature of inlet coolant flow conditions. The following results were obtained from this experimental work: (1) The dryout heat flux in the stratified debris bed increases with increase of upward forcing mass flux of coolant. The similar trend of increase rate of dryout heat flux in the stratified bed was observed in the uniform particle size bed. (2) For the comparison of theoretical values and experimental data, the use of surface area mean diameter as a particle diameter was suitable for the calculation of dryout heat flux.

• Journal of Advanced Marine Engineering and Technology
• /
• v.23 no.2
• /
• pp.192-200
• /
• 1999

This paper describes experimental investigations of helium-air exchange flow through parti-tioned opening. Such exchange flow may occur following rupture accident of stand pipe in high temperature gas cooled reactor. A test vessel with a opening on top of test cylinder is used for experiments. An estimation method of mass increment is developed and applied to measure the exchange flow rate. A technique of flow visualization by Mach-Zehnder interferometer is provided to recognize the exchange flows. Flow measurements are made with partitioned opening for parti-tion rations $H_p/H_1$ in the range 0 to 1 where $H_p$ and $H_1$ are partition length and height of the open-ing respecticely. In the case of $H_p/H_1$ of 0 flow passages of upward flow of the helium and down-ward flow of the air within the opening are unseparated (bidirectional) and the two flows interact exchange flow rate is minimum through range of the partition ratios, Two flow zones i.e. separat-ed(unidirectional)flow zone and unseparated(bidirectional) flow zone exist with increasing the partition. length, The exchange flow rate increases with increasing the separated flow zone. It is found that a maximum exchange flow rate exists at $H_p/H_1$ of 1. As a result fo comparison of the exchange flow rates by changing the partition ration the fluids interaction in the unseparated zone is found to be an important factor on the helium-air exchange flow rate.