• Journal of Environmental Science International
• /
• v.11 no.12
• /
• pp.1217-1226
• /
• 2002

This study aims at the effective estimation of water supply capacity of small scale reservoir and the proposal of the data which is necessary to establish the water resources management plan of down stream area of the reservoir in the future by comparison and examination about reservoir operation technique for the security of agricultural water in small scale reservoir. The result of flow calculation by Tank model is used for the input data as the inflow data which is needed for the analysis of water supply capacity. Stochastic method, simulation method, and optimization method are used to examine the water supply capacity, and water security amount is compared with each method. From the analyses of water supply capacities by each method, slightly different results are shown in spite of the effort to compare them equally using input data such as inflow data under equal conditions, and the comparison of water supply capacities by each method are as follows; linear planning method, simulation method, and transition probability matrix method in the order of amount from the largest. It is thought that the simulation method in which comparatively reasonable application of the inflow data is possible and is simulated in successive time series dam operation of the three methods used in this study thus, simulation model is proper to estimate the water supply capacity of agricultural small scale reservoir. And it is judged that the heightening of efficiency of water resources utilization according to the development of downstream area of dam may be possible using the upward readjusted water supply amount of $55.18{\tiems}10^6ton$ and $63.7{\times}10^6ton$ at 95% and 90% supply reliability respectively which are above the planning water supply amount of $50.0{\times}10^6$ton when the simulation method is introduced as the standard.

• Solar Energy
• /
• v.16 no.2
• /
• pp.113-122
• /
• 1996

This study presents experimental results of heat transfer characteristics of P.C.M. during outward melting process in a vertical cylinder. The experiment was carried out in six conditions, i. e., three different inlet temperature($7^{\circ}C,\;4^{\circ}C\;and\;1^{\circ}C$) and two directions of working fluid(upward and downward). Melting P.C.M. produced a bell-shaped phase change interface. When the inlet temperature was $7^{\circ}C$, the lower region remained at $4^{\circ}C$ until the temperature of upper region reached $4^{\circ}C$. This was due to the state of maximum density of the lower region. When the direction of the working fluid in the case of $7^{\circ}C$, inlet temperature, was upward, the rate of melting and the total melting energy were higher than when it's direction was downward. But the rate of melting and the total melting energy appeared higher value as it's direction was downward when the inlet temperature is $4^{\circ}C$ and $1^{\circ}C$.

• Korean Journal of Applied Biomechanics
• /
• v.19 no.2
• /
• pp.337-345
• /
• 2009

The purpose of this study were to find out the differences in kinematic variables of racket movement by performing the tennis serve. Three top male tennis players participated in this study. Three synchronized high-speed cameras were used to record the service action of top players for Three dimensional video analysis. The results of this study showed that (1) the velocity of the tennis racket at impact is important to the generation of racket velocity to Y-axis. This result indicates that forward motion and upward movement of the racket; (2) with respect to racket angular velocity at impact, the fast angular momentum of X-axis is important to generate the velocity of the tennis ball. This result indicate upward movement of the racket with a strong flexor of wrist joint; (3) the velocity of the tennis ball was influenced by the change of angular linking the Z-axis to -X-axis. This result indicates that the high velocity of the tennis ball is obtained from having the racket unitedly moving to the direction of the bill's flight at the acceleration interval and acquiring the distance of acceleration with the racket head vertically to the ground at the back scratching.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.19 no.1
• /
• pp.39-49
• /
• 2017

The present study conducted a comparison on tree growth and productivity of high-density apple orchards by several orchard management systems: making scaffolds by heading-back and thinning out pruning (T-1), maintaining scaffolds upward and bearing shoots downward (T-2), managing branches slightly upward without heading-back (T-3), keeping leaders downward and shoots pending (T-4), maintaining leaders high and branches horizontal with severe pinching (T-5), making leaders with lower branches vigorous and upper shoots pending (T-6), and controlling very high planting density with bending branches (T-7). In conclusion, the orchards of (T-5) and (T-6) management systems showed a superior performance in controlling tree growth, productivity, and quality of fruits. Also, superior management efficiency was obtained in the orchards of (T-5) and (T-6).

• The Journal of the Korea Contents Association
• /
• v.20 no.7
• /
• pp.629-635
• /
• 2020

Using a sample of two-hundred thirty-eight employees in the service industry, this study examined the relationships between perceived similarity, leader-member exchange (LMX), envy, and deviant workplace behavior (DWB) drawing on social comparison theory. Specifically, the current study predicts that an individual who perceives similarity to co-workers whose LMX is higher is more likely to report lower levels of LMX by focusing on upward social comparison. In addition, the study examines the moderating effect of envy in the relationship between perceived similarity and LMX. The results of the study supported the hypotheses, implying that, first, envious feelings coming from lower levels of LMX positively predict DWB. Second, employee envy moderated the relationship between perceived similarity and LMX such that envious people who report being similar to their colleagues also report lower levels of LMX with their supervisors. This means that employees who reported lower levels of LMX with their supervisors, reported committing more DWB than their counterparts. Finally, LMX mediates the relationship between perceived similarity and DWB, indicating that individuals who view themselves similarly to their colleagues report lower levels of LMX with their supervisors and in turn commit more DWB. We believe that it highlights the need for employees to feel special in order to have unique attention by, and relationships with their supervisors. These results have implications and suggest the need for the further study of employee's negative emotions, LMX theory, and DWB.

• Journal of the Korean earth science society
• /
• v.29 no.2
• /
• pp.128-139
• /
• 2008

Intercomparison among the three radiative transfer models (RTMs) which have been used in the studies for COMS, was carried out on the condition of aerosol-laden atmospheres. Also the role of aerosols in the atmospheric radiation budget was analyzed. The results (hereafter referred to as H15) from Halthore et al.'s study (2005) were used as a benchmark to examine the models. Aerosol Radiative Forcing (ARF) values from the three RTMs, calculated under two conditions of Aerosol Optical Thickness (AOT=0.08, 0.24), were systematically underestimated in comparison to H15 in the following shortwave components; 1) direct and diffuse irradiance at the surface, 2) diffuse upward fluxes at the surface and the top of the atmosphere, and 3) atmospheric absorbance. The ARF values for the direct and diffuse fluxes at the surface was $-10{\sim}-40Wm^{-2}$. The diffuse upward values became larger with increasing both AOT and Solar Zenith Angle (SZA). Diffuse upward/downward fluxes at the surface were more sensitive to the SZA than to the atmospheric type. The diffuse downward values increased with increasing AOT and decreasing SZA. The larger AOT led to surface cooling by exceeding the reduction of direct irradiance over the enhancement of diffuse one at the surface. The extinction of direct solar irradiance was due mainly to water vapor in tropical atmospheres, and to both ozone and water vapor in subarctic atmospheres. The effect of water vapor in the tropics was $3{\sim}4$ times larger than that of the ozone. The absorbance values from the three RTMs agree with those from H15 within ${\pm}10%$.

• Journal of the Korean Society of Physical Medicine
• /
• v.8 no.3
• /
• pp.369-378
• /
• 2013

PURPOSE: The purpose of present study was to ascertain how the activity of the serratus anterior muscle, the upper trapezius muscle and the pectoral major muscle was affected while the upper arm was being flexed at 70, 90 and 110 degrees respectively in a closed kinetic chain exercise (wall push up plus) and an open kinetic chain exercise (static hug). METHODS: Sixteen healthy young men subjects participated in the study. Surface electromyography (EMG) data were collected from the dominant-side muscles during a closed kinetic chain exercise and an open kinetic chain exercise. The activity of each muscle was measured quantitatively, and by the use of the two-way repeated ANOVA, the data were compared with each other according to exercises and shoulder flexion angles. RESULTS: Results indicated that the closed kinetic chain exercise did not interact with the open kinetic chain exercise (p>.05). In both the closed kinetic chain exercise and the open kinetic chain exercise, the activity of the serratus anterior muscle became different significantly according to angles (p<.05). Its activity increased in order of 70, 90 and 110 degrees (p<.05). In both exercises and all angles, muscle activity was significantly higher in the serratus anterior muscle than in the upper trapezius muscle and the pectoral major muscle (p<.05). CONCLUSION: The above results show that there is a need to selectively control the exercise stress of the serratus anterior muscle in the case of the patients with the shoulder impingement syndrome characterized by the winged scapula, insufficient scapular protraction and upward rotation.

• Journal of Preventive Medicine and Public Health
• /
• v.53 no.1
• /
• pp.45-55
• /
• 2020

Objectives: This study was conducted to explore recent trends in the prevalence of pediatric elevated blood pressure and hypertension (HTN) in Korea and the United States, applying the new HTN reference values for adolescents. Methods: This study analyzed 17 339 (8755 Korean and 8584 American) adolescents aged 10 to 17 who participated in the Korea National Health and Nutrition Examination Survey and the National Health and Nutrition Examination Survey, respectively, between 2005 and 2016. HTN was defined using percentile-based reference values for non-overweight adolescents from 7 nations, and obesity was defined by body mass index (BMI) based on country-specific growth charts. All analyses were stratified by sex and year-over-year changes were evaluated by calculating the p for trend. Results: Systolic blood pressure showed a statistically meaningful upward trend in Korean boys and girls, while diastolic blood pressure did not show any significant changes. Both systolic and diastolic blood pressure levels declined among United States boys and girls. The prevalence of elevated blood pressure and HTN remained similar in Korean adolescents, but declined in both sexes among United States adolescents. BMI increased in both sexes among Korean adolescents, although the overweight and obesity rates stayed the same. No significant trends were found in any obesity indices among United States adolescents. The prevalence of elevated blood pressure and HTN by obesity level was higher among Korean adolescents than among their United States peers in both sexes, and the gap became higher at more severe levels of obesity. Conclusions: Despite the strong correlation between obesity and HTN, recent trends in the prevalence of HTN and obesity among Korean and United States adolescents were strikingly different. Follow-up studies are necessary to determine why the prevalence of HTN was more than twice as high among Korean adolescents than among their United States counterparts.

• Journal of the Korea Concrete Institute
• /
• v.15 no.1
• /
• pp.11-16
• /
• 2003

The objective of this study is to clarify the seismic capacity and the characteristics in the hysteretic behavior of RC structures with non-seismic detailing. To do this, an exterior beam-column subassemblage was selected from a ten story RC building and six 1/3-scale specimens were manufactured with three variables; (1) with and without slab, (2) upward and downward direction of anchorage for the bottom bar in beams, and (3) with and without hoop bars in the joint region. The test results have shown that (1) the existence of slab increased the strength in positive and negative moment, 25% and 52%, respectively; (2) the Korean practice of anchorage (downward and 25 $d_{b}$ anchorage length) caused the 8% reduction of strength and the early strength degradation in comparison with the case of seismic details; and (3) the existence of hoop bars in the joint region shows significant role in preventing the pull-out.t.

• The Journal of Engineering Geology
• /
• v.2 no.2
• /
• pp.155-165
• /
• 1992

The purpose of this study is to evaluate compatability of seismic source characteristics of the Kern County earthquake to those of Korean Peninsula seismotectonics. The compatability could be used to make Korean type response spectrum from the strong ground motions observed from the assingned earthquake. The July 21, 1952, Kern County, California, earthquake is the largest earthquake to occur in the western U.S. since 1906, and the repeat of this event poses a significant seismic hazard. The Kern County event was a complex thrusting event, with a surface rupture pattern that varied from pure leftlateral strike-slip to pure dip-slip. A time dependent moment tensor inversion was applied to ten observed teleseismic long-period body waves to investigate the source complexity. Since a conventional moment tensor inversion(constant geometry through time) returns a non-double-couple source when the seismic source changes(fault orientation and direction of slip) with time, we are required to use the time dependent moment tensor which allows a first-order mapping of the geometric and temporal complexity. From the moment tensor inversion, a two-point seismic source model with significant overlap for the White Wolf fault, which propagates upward(20 km to 5 km) from SW to NE, fits most of the observed seismic waveforms in the least squares sense. Comparison of P, T and B axes of focal mechanisms and focal depths suggests that seismic source characteristics of the Kern County earthquake is consistant with those of Korean Peninsula Seismotectonics.