• Wind and Structures
• /
• v.29 no.5
• /
• pp.299-312
• /
• 2019

Due to the rugged terrain, metro lines in mountain city across numerous wide rivers and deep valleys, resulting in instability of high-pier bridge and insecurity of metro train under crosswind. Compared with the conditions of no-wind, crosswind triggers severer vibration of the dynamic system; compared with the short-pier viaduct, the high-pier viaduct has worse stability under crosswind. For these reasons, the running safety of the metro vehicle traveling on a high-pier viaduct under crosswind is analyzed to ensure the safe operation in metro lines in mountain cities. In this paper, a dynamic model of the metro vehicle-track-bridge system under crosswind is established, in which crosswind loads model considering the condition of wind zone are built. After that, the evaluation indices and the calculation parameters have been selected, moreover, the basic characteristics of the dynamic system with high-pier under crosswind are analyzed. On this basis, the response varies with vehicle speed and wind speed are calculated, then the corresponding safety zone is determined. The results indicate that, crosswind triggers drastic vibration to the metro vehicle and high-pier viaduct, which in turn causes running instability of the vehicle. The corresponding safety zone for metro vehicle traveling on the high-pier is proposed, and the metro traffic on the high-pier bridge under crosswind should not exceed the corresponding limited vehicle speed to ensure the running safety.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.27 no.6
• /
• pp.293-301
• /
• 2023

Existing reinforced concrete buildings with seismically deficient details have premature failure under earthquake loads. The fiber-reinforced polymer column jacket enhances the lateral resisting capacities with additional confining pressures. This paper aims to quantify the retrofit effect varying the confinement and stiffness-related parameters under three earthquake scenarios and establish the retrofit strategy. The retrofit effects were estimated by comparing energy demands between non-retrofitted and retrofitted conditions. The retrofit design parameters are determined considering seismic hazard levels to maximize the retrofit effects. The critical parameters of the retrofit system were determined by the confinement-related parameters at moderate and high seismic levels and the stiffness-related parameters at low seismic levels.

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.14 no.1
• /
• pp.1-11
• /
• 1985

Solar/absorption cooling system was analyzed and its operating condition was examined. For the system, the optimum size of absorption refrigerator and collector area should be determined. As the temperature of water supplied to the generator increases, the collector efficiency decreases whereas the coefficient of performance of absorption refrigerator increases up to a certain point, and vice versa for decreasing of the temperature of water supplied to the generator . Thus if the reeling load is given, the appropriate operating condition can be determined between the two opposing trends by simulation program. As an example of the simulation, the case of Jejudo province was studied. Under the conditions (such as weather data and prices of components, etc.) given en the sample calculation, the result shows that the optimum temperature of water supplied to the generator turned out to be $80.3^{\circ}C$, and still shows a large economical disadvantage in present stage compared to the case of conventional vapor compression cooling/heating combined heat pump system.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.37 no.1
• /
• pp.96-103
• /
• 2014

A steady-state controllable M/G/1 queueing model operating under the (TN) policy is considered where the (TN) policy is defined as the next busy period will be initiated either after T time units elapsed from the end of the previous busy period if at least one customer arrives at the system during that time period, or the time instant when Nth customer arrives at the system after T time units elapsed without customers' arrivals during that time period. After deriving the necessary system characteristics such as the expected number of customers in the system, the expected length of busy period and so on, the total expected cost function per unit time in the system operation is constructed to determine the optimal operating policy. To do so, the cost elements associated with such system characteristics including the customers' waiting cost in the system and the server's removal and activating cost are defined. Then, the optimal values of the decision variables included in the operating policies are determined by minimizing the total expected cost function per unit time to operate the system under consideration.

• Journal of Arbitration Studies
• /
• v.13 no.1
• /
• pp.169-205
• /
• 2003

Arbitration means the procedure that a party inquires a third party arbitrator for a resolution on the dispute on certain matters of interest to follow through with the commitment of the arbitration, and a series of procedures performed by the arbitrator of the Korean Commercial Arbitration Board. Arbitration is implemented in accordance with the procedure determined by the Arbitration Act and Arbitration Regulations. In the event the parties reach to the reconciliation during the process of arbitration, the reconciliation is recorded in the form of arbitration award(decision), and in the event a reconciliation is not made, the arbitrator shall make the decision on the particular case. The arbitration award(decision) for reconciliation during the arbitration procedure (Article 31 of Arbitration Act, hereinafter referred to as the 'Act') or the mediation under the Arbitration Regulation of the Korean Commercial Arbitration Board (Article 18 of the Arbitration Regulations) shall have the same effectiveness with the decision rendered by a court that, in the event a party does not perform the obligation, the enforcement document is rendered under the Rules on Enforcement Document on Mediation Statement of various dispute resolution committees of the Supreme Court to carry out the compulsory enforcement. However, in the event that the party to take on the obligation to perform under the arbitration award (decision) rendered by the arbitrator (Article 32 of the Act) does not perform without due cause, a separate enforcement decision in accordance with the procedure determined under the Civil Enforcement Act shall be obtained since the arbitration award(decision) cannot be the basis of enforcement under the Civil Enforcement Act. And, in order to enforce the judgment compulsorily in accordance with the regulations under the Civil Enforcement Act under the foreign arbitration judgment (Article 39 of the A.1), it shall fulfill the requirement determined under the Civil Litigation Act (article 217 of Civil Litigation Act) and shall obtain a separate enforcement decision in accordance with the procedure determined under the Civil Enforcement Act (Article 26 and Article 27 of Civil Enforcement Act) since the arbitration judgment of foreign country shall not be based on enforcement under the Civil Enforcement Act. It may be the issue of legislation not to recognize the arbitration award(decision) as a source of enforcement right, and provide the compulsive enforcement by recognizing it for enforcement right after obtaining the enforcement document with the decision of a court, however, not recognizing the arbitration award(decision) as the source of enforcement right is against Clause 3 of Article 31 of the Act, provisions of Article 35, Article 38 and Article 39 that recognized the validity of arbitration as equal to the final judgment of a court, and the definition that the enforcement decision of a court shall require the in compulsory enforcement under Clause 1 of Article 37 of the Act which clearly is a conflict of principle as well. Anyhow, in order to enforce the arbitration award(decision) mandatorily, the party shall bring the litigation of enforcement decision claim to the court, and the court shall deliberate with the same procedure with general civil cases under the Civil Litigation Act. During the deliberation, the party obligated under the arbitration award(decision) intended to not to undertake the obligation and delay it raises the claim and suspend the enforcement of cancelling the arbitration award(decision) on the applicable arbitration decision within 3 months from the date of receiving the authentic copy of the arbitration award(decision) or the date of receiving the authentic copy of correction, interpretation or additional decision under the Regulation of Article 34 of the Act (Clause 3 of Article 36 of the Act). This legislation to delay the sentencing of the enforcement and then to sentence the enforcement decision brings the difficulties to a party to litigation costs and time for compulsory enforcement where there is a requirement of an urgency. With the most of cases for arbitration being the special field to make the decision only with the specialized knowledge that the arbitrator shall be the specialists who have appropriate knowledge of the system and render the most reasonable and fair decision for the arbitration. However, going through the second review by a court would be most important, irreparable and serious factor to interfere with the activation of the arbitration system. The only way to activate the arbitration system that failed to secure the practicality due to such a factor, is to revise the Arbitration Act and Arbitration Regulations so that the arbitration decision shall have the right to enforce under the Rules on Enforcement Document on Mediation Statement of various dispute resolution committees of the Supreme Court.

• Proceedings of the KIEE Conference
• /
• 2003.11a
• /
• pp.67-70
• /
• 2003

In recent, the importance and necessity of some studies on reliability evaluation of grid come from the recent black-out accidents occurred in the world. The quantity evaluation of transmission system reliability is very important under competitive electricity environment. The reason is that the successful operation of electric power under the deregulated electricity market depends on transmission system reliability management. The various results of many case studies for the IEEE 25buses system using the Transmission Reliability Evaluation for Large-Scale Systems(TRELSS) Version 5_1, a program made in EPRI are introduced in this paper. Some sensitivity analysis has been included. This paper suggests that the some important input parameters of the TRELSS can be determined optimally from this sensitivity analysis for high reliability level operation of a system.

• Proceedings of the Korean Operations and Management Science Society Conference
• /
• 1998.10a
• /
• pp.137-140
• /
• 1998

In this study, we have developed algorithms to find more effective solutions for compensatory decision-making problems in the case of the decision maker with fuzziness which can occur in a real world fuzzy environment. We have applied the algorithm to the problems related to the structural reform of the capital and the number of workers in the local industry. We have selected Taegu city for this study. In this study, we have determined the capital and the number of workers, satisfying maximum productivity and minimum air and water pollution under the constraints such as capital-labor ratio, the demand for land and water and the fluctuation of the capital and the number of workers. The determined capital and the number of workers could improve the competitive advantage of Taegu city and could be utilized as criteria for the compilation of the budget, determination of policy for supporting plan of companies, the forecast of number of workers and the training plan of workers.

• Journal of the Ergonomics Society of Korea
• /
• v.15 no.2
• /
• pp.1-13
• /
• 1996

The purpose of this study is to suggest a brassiere sizing chart for elderly women. 2 control dimensions(under bust girth and cup size) were chosen as 2 axes of brassiere size chart. A loss function was used to determined intervals of under bust girth and cup size of size chart, because the loss function introduces the concept of frequency to size chart for better customer's satisfaction. From the dual distribution table whose intervals had been determined by a loss function. The 15 sizs, which had more than 2% of appearance were suggested for brassiere size chart. The suggested brassiere sizes covered 87.6% of all subjects. Considering that KS brassiere size chart consisting of 32 sizes covers 88.5%, the suggested brassiere size chart would be considered quite feasible. Also it is suggested supply reference measurement chart relevant to brassiere manufacturing for 10 most frequent sizes.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2001.05a
• /
• pp.1150-1155
• /
• 2001

The updating of the FE model to match it with the experimental results needs the modal information. There are two causes where this methodology is ill-equip to deal with; under-determined and ill-conditioning problem. In this research, the feedback exciter which uses the summation of the white noise and the signals from the measurement sensors multiplied with feedback gains is proposed. The new energy path generated by the feedback exciter changes the modal characteristics of the system and this additional modal information can solve the under-determined problem in the model updating. Through the proper selection of the exciter and sensor locations and the feedback gain, the eigenvalue sensitivity of the updating parameters which cause the ill-conditioning of the sensitivity matrix can be modified. This methodology does not require any additional equipments, makes the acquirement of the additional modal information easy and is robust to the measurement noise.

• Nonlinear Functional Analysis and Applications
• /
• v.29 no.2
• /
• pp.597-620
• /
• 2024

In this study, the conformable fractional derivative(CFD) of order 𝝔 in conjunction with the LC operator of orderρ is used to develop the model of the transmission of the A(H1N1) influenza infection. A brand-new A(H1N1) influenza infection model is presented, with a population split into four different compartments. Fixed point theorems were used to prove the existence of the solutions and uniqueness of this model. The basic reproduction number R₀ was determined. The least and most sensitive variables that could alter R₀ were then determined using normalized forward sensitivity indices. Through numerical simulations carried out with the aid of the Adams-Moulton approach, the study also investigated the effects of numerous biological characteristics on the system. The findings demonstrated that if 𝝔 < 1 and ρ < 1 under the CFD, also the findings demonstrated that if 𝝔 = 1 and ρ = 1 under the CFD, the A(H1N1) influenza infection will not vanish.