• Journal of the Korean GEO-environmental Society
• /
• v.13 no.8
• /
• pp.45-55
• /
• 2012

This study is about the application of waste stone sludge as fill material. Waste stone sludge, weathered granite soil, and the mixture of the former and the latter strengthened with staple fiber are experimentally analyzed for measuring strength property. When staple fiber was mixed with waste stone sludge, weathered granite soil, and the mixture, there was a nearly linear relationship between the amount of the staple fiber and the increasing ratio of unconfined compressive strength. The increasing ratio of unconfined compressive strength was the largest in weathered granite soil. The increasing ratio of unconfined compressive strength of the mixture was similar to that of waste stone sludge. In the case of the mixture of weathered granite soil and waste stone sludge, an internal friction angle tended to increases rely on increasement of staple fiber content, whereas the change of cohesion was small. An internal friction angle was increased by 21 percent when staple fiber content is 0.75 percent. Comparing with weathered granite soil or waste stone sludge, strength parameters of the mixture were increased relatively. Thus strengthening effect of staple fiber in the mixture is expected.

• Journal of the Korean GEO-environmental Society
• /
• v.16 no.6
• /
• pp.31-38
• /
• 2015

Recently, the participation on the development of the natural gas pipeline in Russia as well as the recent construction of the second Korean Antarctic research station, the Jangbogo station provide the research interests on the behavior of the permafrost ground. To investigate the effect of fines on the mechanical responses of frozen sands, unconfined compression tests were performed on the frozen sands with 0, 5, 10 and 15% of fine contents at -5, -10 and $-15^{\circ}C$. The poorly graded (SP) Joomunjin sand and kaolinite, silt with low plasticity (ML) were used for the preparation of the frozen soil specimens. The mechanical responses of the tested soils were investigated via unconfined compression tests in the temperature controlled laboratory and analyzed in terms of peak unconfined compressive strength and secant modulus at 50% of the peak strength. As the fine contents increase, the unfrozen water contents increase and thus the strength and stiffness of frozen soils decrease. The increment of the stiffness and strength due to the temperature decrease vary with the fine contents.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.10
• /
• pp.5-12
• /
• 2011

Recently, NDS(Natural and Durable Stabilizer)method and other similar methods are composed of inorganic accelerating agent and the ultra-super fine cement have been studied as the ground improvement material in Korea. However, in the existing research, the chemical changing process of NDS in the strength development mechanism with the elapsed curing time and the principles of strength development did not give an explanation. For the popularization of the inorganic grout material, it determined that the mechanism verifying of the curing process had to be clearly preceded. Therefore, unconfined compression test, SEM and XRD analysis were performed by the elapsed curing time and were analyzed. In addition, the same trial for SGR method, that is the representative example of the water glass grout material, was selected as comparative target in order to distinguish properties of NDS more clearly. The result of experiment, the strength development mechanism of NDS could be investigated through the close correlation of the unconfined compression strength - SEM - XRD analysis, and excellence of a performance was confirmed.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.1
• /
• pp.101-110
• /
• 2008

This paper investigates the mechanical characteristics of monofilament-reinforced bottom ash mixtures for recycling dredged soil. Reinforced bottom ash mixture is a lightweight soil added with monofilament in order to increase its shear strength. Test specimens were fabricated by various mixing conditions including monofilament content, its length and its diameter. Then several series of unconfined compression tests and direct shear tests were performed to investigate mechanical characteristics of reinforced lightweight soil. The experimental results indicated that stress-strain behaviors of reinforced lightweight soil were strongly influenced by mixing conditions of monofilament content, its length and diameter. The compressive strength of reinforced lightweight soil generally increased by adding monofilament. In this test, the maximum increase in compressive strength was obtained at 0.5% content and 4cm length of monofilament. These results were similar to those of direct shear tests. The unconfined compressive strength of reinforced lightweight soil with monofilament of 0.25mm in diameter was greater than that of reinforced lightweight soil with monofilament of 0.5mm in diameter.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.10
• /
• pp.33-45
• /
• 2006

C.S.G is a material made by adding cement and water to rock-like material such as riverbed gravel or excavation muck that can be obtained easily near dam si. Recently, the use of C.S.G is gradually increasing as the construction material for dam, road, revement and so on. Commonly, the strength characteristics of C.S.G is affected by various influence factors such as grade, unit cement, age and water contents. In this study, a series of compaction test and unconfined compressive strength test were performed to investigate the relationship between a strength and influence factors such as three kinds of gradation, age, unit cement and water contents with riverbed gravel in Hwa Buk dam. The results show that strength Properties of C.S.G is variously affected by these influence factors. Especially, gradation and water contents are found to be very important factors fur determining the strength of C.S.G material. And, from the results of experimental study, the correlation equations between uncompressive strength and these factors are proposed.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.2C
• /
• pp.95-107
• /
• 2010

To calculate the end bearing capacity of a drilled Shaft socketed into the rockmass, the unconfined compression strength could be used. But it is difficult to find the unconfined compression strength because it is impossible to get undisturbed samples in weathered soils and rocks. So, to calculate the end bearing capacity, the existing bearing formula could not be used. In this study, for five zones (near pile tip, tip~lower 1D, tip~lower 2D, upper 1D~lower 1D, upper 1D~lower 2D), the relationships between the characteristic values of in-situ tests(SPT, DCPT PMT, BST) and the end bearing capacity of drilled shafts were analysed. As a result, DCPT results were represented the best credibility. Also, a design chart of end bearing capacity using DCPT was suggested.

• Journal of Korea Water Resources Association
• /
• v.56 no.10
• /
• pp.691-695
• /
• 2023

In this study, two sections with different topographic gradients were in the Hyogyo-ri area, the hydraulic gradients were calculated for each section, and the hydraulic gradient fluctuations according to the topographic gradient and rainfall were analyzed. The variations of the hydraulic gradient within the research site was large in the section with steep topographic gradient and small in the section with gradual topographic gradient. The influence of the variation in hydraulic gradient due to rainfall was high in the section with steep topographic gradient, and low in the section with gradual topographic gradient. Through this study, it was found that the hydraulic gradient fluctuations in unconfined aquifer showed as a complex effect of topographic gradient and rainfall.

• Nuclear Engineering and Technology
• /
• v.56 no.5
• /
• pp.1854-1862
• /
• 2024

This study aims to investigate the strain-dependent-deformation property of Gyeongju bentonite buffer material. A series of unconfined compressive tests were performed with cylindrical specimens prepared at varying dry densities (𝜌_d = 1.58 g/cm³ to 1.74 g/cm³) using cold isostatic pressing technique. It is found that as 𝜌_d increase, the unconfined compressive strength (q_u), failure strain, and elastic modulus (E) of Gyeongju compacted bentonite (GCB) increases. Normalized elastic modulus (E_sec/E_max) degradation curves of GCB specimens are fitted using Ramberg-Osgood model and the elastic threshold strain (𝜀_e,th) is determined through the fitted curves. The strain-dependency of E and Poisson's ratio (v) of GCB were observed. E and v were measured constant below 𝜀_e,th of 0.14 %. Then, E decreases while v increases after exceeding the strain threshold. The E_sec/E_max degradation curves of GCB in this study suggests wider linear range and higher linearity than those of sedimentary clay in previous study. On top of that, the influence of 𝜌_d is observed on E_sec/E_max degradation curves of GCB, showing a slight increase in 𝜀_e,th with increase in 𝜌_d. Furthermore, an empirical model of q_u with 𝜌_d and a correlation model between q_u and E are proposed for Gyeongju bentonite buffer materials.

• Journal of the Korean Geotechnical Society
• /
• v.40 no.5
• /
• pp.51-58
• /
• 2024

Chemical ground reinforcement involves enhancing the mechanical properties of soil through chemical reactions. Existing ground reinforcement materials pose challenges, including environmental pollution during production and use, pH fluctuations caused by leaching into groundwater, and ecological disturbances. This study investigates the engineering performance of soils treated with casein polymer, a milk-derived, eco-friendly reinforcement material. The performance assessment was carried out by measuring unconfined compressive strength and hydraulic conductivity across different soil types, including Jumunjin sand, granite weathered soil, and soft soils. The analysis examined the relationship between unconfined compressive strength, hydraulic conductivity, and soil type. The findings indicate significant correlations based on the concentration of casein polymer and soil type. The outcomes of this study provide foundational data for the application of casein polymer in soil reinforcement efforts.

• Journal of the Korean GEO-environmental Society
• /
• v.16 no.2
• /
• pp.15-25
• /
• 2015

As the physical and mechanical properties of lightweight air-mixed soil change in the procedure of transportation of mix truck, it is necessary to assure whether the properties during construction satisfy those in design. In this study, variations of properties of mixed soil after transportation by mix truck are proved by field test. Lightweight air-mixed soil used field test the unit weight of $9.0{\pm}1.0kN/m^3$, the flow value of $190{\pm}20mm$ was produced. To analyze variations of properties of mixed soil the unit weight and flow value of the sample before and after transport was measured unconfined compressive strength tests were performed. Mixing time was 19~175 minutes diversified. As the test results, it is known that the density, the flow value and the unconfined compressive strength of lightweight air-mixed soil change by transportation, but these values satisfy the specifications of material of air-mixed soil. After transportation the average value of the unit weight and flow value change in the flow of the $(+)0.10kN/m^3$, 4.8 mm respectively, the average change in the unit weight and the flow value due to the mixing time was constant. And unconfined compressive strength of 28-day specimen increases from 20 to $150kN/m^2$. But, these values do not have some clear relationship with the transportation time within 175 minutes which is longest test time. Consequently, Within 175 minutes the changes of properties by transportation are too small to show some problems in the construction field.