• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.1
• /
• pp.120-125
• /
• 1986

Data analysis methods in lock-in amplifier based DLTS systems were discussed with regards to the signal-to-noise ratio and improvement of resolution of DLTS spectrum. The DLTS system based on wideband two-phase lock-in amplifier is shown to be the most preferabe for the studies in deep levels of low concentration. A single-temperature scanning DLTS methods in lock-in amplifier based system with the improved sensitivity is proposed. The method is tested on the characterization of deep levels in n-GaAs.

• Journal of The Korean Astronomical Society
• /
• v.27 no.1
• /
• pp.1-11
• /
• 1994

We have observed the emission of $HC_3N$ J=4-3, 5-4,10-9 and 12-11 transitions toward the Sgr B2 central region in an area of $150'\times150'$ with resolutions of 16'-48'. The intensities and central velocities of line profiles show significant variations with positions. In contrast to the intensities of the low J-level transitions which gradually increase from the central source toward the outside region, the $HC_3N$ emission of the high J-level transition become stronger toward 'the central radio continuum source MD5. Systematic change in the radial velocity of each line profile occurs along north-south direction. There are a few peaks in most line profiles, and these indicate that there are multiple velocity components along the line of sight. Distributions of excitation temperature and column density which were estimated from the excitation calculations show the existence of a small $(1\times2pc),\;hot\;(T_{ex}>50K)$ core which contains two temperature peaks at-15' east and north of MD5. The column density of $HC_3N\;is\;(1-3)\times10^{14}cm^{-2}$ Column density at distant position from MD5 is larger than that in the central region. We have deduced that this 'hot-core' has a mass of 105M 0, which is about an order of magnitude larger than those obtained by previous studies.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.5
• /
• pp.1068-1072
• /
• 2011

Hydrogen Fuel Cell Vehicle(HFCV) is system that uses electrical energy of fuel cell stack to main power source, which is different system with other vehicles that use high-voltage, large-current. Isolation performance of this system which is connected with electrical fire and electrical shock is important point. Isolation resistance of electric installation is divided according to working voltage, it follows criterion more than $100{\Omega}$/VDC (or $500{\Omega}$/VAC) about system operation voltage in a hydrogen fuel cell vehicle. Although measurement of isolation resistance in a hydrogen fuel cell vehicle is two methods, it uses mainly measurement by megger. However, the present isolation resistance measurement system that is optimized to use in electrical facilities is unsuitable for isolation performance estimation of a hydrogen fuel cell vehicle because of limit of maximum short current and difference of measurement resolution. Therefore, this research developed the isolation resistance measurement system so that may be suitable in isolation performance estimation of a hydrogen fuel cell vehicle, verified isolation performance about known resistance by performance verification of laboratory level about developed system, and executed performance verification through comparing results of developed system by performance verification of vehicle level with ones of existing megger. Developed system is judged to aid estimation and upgrade of isolation performance in a hydrogen fuel cell vehicle hereafter.

• Progress in Superconductivity
• /
• v.1 no.1
• /
• pp.20-25
• /
• 1999

We constructed a high-$T_c$ scanning SQUID microscope (SSM) operating in the liquid nitrogen. We used a washer-type YBCO SQUID with inner and outer dimensions of $12{\mu}m$ and $36{\mu}m$, respectively, which was grown on the $SrTiO^3$ bicrystal substrate. The sample, rather than SQUID, was scanned using two stepping motors. We also developed readout electronics, stepping motor controller, and the software for system control and data display. We took images of various samples using our SSM and found that the spatial resolution is about $40{\mu}m$ and noise level is lower than $10^{-7}T/{\surd}Hz$ at 100 Hz and higher at lower frequencies. The noise level was much higher than that of a typical SQUID due to the other coupling from the electric parts. We present a simple argument on the inductive coupling between the sample and the SQUID which should be under-stood for the proper interpretation of the obtained images. By comparing the measured data with the simulation results the gap between the SQUID and the sample is estimated to be $40{\mu}m$.

• Proceedings of the KSRS Conference
• /
• 1998.09a
• /
• pp.252-256
• /
• 1998

Accurate mapping of satellite images is one of the most important Parts in many remote sensing applications. Since the position and the attitude of a satellite during image acquisition cannot be determined accurately enough, it is normal to have several hundred meters' ground-mapping errors in the systematically corrected images. The users which require a pixel-level or a sub-pixel level mapping accuracy for high-resolution satellite images must use a number of Ground Control Points (GCPs). In this paper, the performance of two geometric correction algorithms is tested and compared. One is the polynomial warping algorithm which is simple and popular enough to be implemented in most of the commercial satellite image processing software. The other is full camera modelling algorithm using Physical orbit-sensor-Earth geometry which is used in satellite image data receiving, pre-processing and distribution stations. Several criteria were considered for the performance analysis : ultimate correction accuracy, GCP representatibility, number of GCPs required, convergence speed, sensitiveness to inaccurate GCPs, usefulness of the correction results. This paper focuses on the usefulness of the precision correction algorithm for regular image pre-processing operations. This means that not only final correction accuracy but also the number of GCPs and their spatial distribution required for an image correction are important factors. Both correction algorithms were implemented and will be used for the precision correction of KITSAT-3 images.

• Korean Journal of Remote Sensing
• /
• v.35 no.1
• /
• pp.137-149
• /
• 2019

Traffic emissions are the main cause of environmental pollution in cities and respiratory problems amongst people. This study developed a model based on an integration of support vector regression (SVR) algorithm and geographic information system (GIS) to map traffic carbon monoxide (CO) concentrations and produce prediction maps from micro level to macro level at a particular time gap in a day in a very densely populated area (Utara-Selatan Expressway-NKVE, Kuala Lumpur, Malaysia). The proposed model comprised two models: the first model was implemented to estimate traffic CO concentrations using the SVR model, and the second model was applied to create prediction maps at different times a day using the GIS approach. The parameters for analysis were collected from field survey and remote sensing data sources such as very-high-resolution aerial photos and light detection and ranging point clouds. The correlation coefficient was 0.97, the mean absolute error was 1.401 ppm and the root mean square error was 2.45 ppm. The proposed models can be effectively implemented as decision-making tools to find a suitable solution for mitigating traffic jams near tollgates, highways and road networks.

• Korean Journal of Radiology
• /
• v.1 no.2
• /
• pp.84-90
• /
• 2000

Objective: To determine the effects of respiration on the size of lung cysts by comparing inspiratory and expiratory high-resolution CT (HRCT) scans. Materials and Methods: The authors evaluated the size of cystic lesions, as seen on paired inspiratory and expiratory HRCT scans, in 54 patients with Langerhans cell histiocytosis (n = 3), pulmonary lymphangiomyomatosis (n = 4), confluent centrilobular emphysema (n = 9), paraseptal emphysema and bullae (n = 16), cystic bronchiectasis (n = 13), and honeycombing (n = 9). Using paired inspiratory and expiratory HRCT scans obtained at the corresponding anatomic level, a total of 270 cystic lesions were selected simultaneously on the basis of five lesions per lung disease. Changes in lung cyst size observed during respiration were assessed by two radiologists. In a limited number of cases (n = 11), pathologic specimens were obtained by open lung biopsy or lobectomy. Results: All cystic lesions in patients with Langerhans cell histiocytosis, lymphangiomyomatosis, cystic bronchiectasis, honeycombing, and confluent centrilobular emphysema became smaller on expiration, but in two cases of paraseptal emphysema and bullae there was no change. Conclusion: In cases in which expiratory CT scans indicate that cysts have become smaller, cystic lesions may communicate with the airways. To determine whether, for cysts and cystic lesions, this connection does in fact exist, paired inspiratory and expiratory HRCT scans are necessary.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.26 no.6
• /
• pp.493-497
• /
• 2016

Infrared (IR) imaging is capable of detecting targets that are not visible at night, thus it has been widely used for the security and defense system. However, the quality of the IR image is often degraded by low resolution and noise corruption. This paper addresses target segmentation with the IR image. Multiple regions of interest (ROI) are extracted by the multi-level segmentation and targets are segmented from the individual ROI. Each level of the multi-level segmentation is composed of a k-means clustering algorithm an expectation-maximization (EM) algorithm, and a decision process. The k-means clustering algorithm initializes the parameters of the Gaussian mixture model (GMM) and the EM algorithm iteratively estimates those parameters. Each pixel is assigned to one of clusters during the decision. This paper proposes the selection and the merging of the extracted ROIs. ROI regions are selectively merged in order to include the overlapped ROI windows. In the experiments, the proposed method is tested on an IR image capturing two pedestrians at night. The performance is compared with conventional methods showing that the proposed method outperforms others.

• Journal of Microbiology and Biotechnology
• /
• v.17 no.1
• /
• pp.89-95
• /
• 2007

Improvements in the dissolution of proteins in two-dimensional gel electrophoresis have greatly advanced the ability to analyze the proteomes of microorganisms under a wide variety of physiological conditions. This study examined the effect of various combinations of chaotropic agents, a reducing agent, and a detergent on the dissolution of the Streptomyces peucetius cytosolic proteins. The use of urea alone in a rehydration buffer as a chaotropic agent gave the proteome a higher solubility than any of the urea and thiourea combinations, and produced the highest resolution and clearest background in two-dimensional gel electrophoresis. Two % CHAPS, as a detergent in a rehydration buffer, improved the protein solubility. After examining the effect of several concentrations of reducing agent, 50 mM DTT in a rehydration buffer was found to be an optimal condition for the proteome analysis of Streptomyces. Using this optimized buffer condition, more than 2,000 distinct and differentially expressed soluble proteins could be resolved using two-dimensional gel electrophoresis with a pI ranging from 4-7. Under this optimized condition, 15 novel small proteins with low-level expression, which could not be analyzed under the non-optimized conditions, were identified. Overall, the optimized condition helped produce a better reference gel for Streptomyces peucetius.

• Journal of the Daesoon Academy of Sciences
• /
• v.38
• /
• pp.115-151
• /
• 2021

According to Lee Young-geum, the ideas of grievance resolution and mutual beneficence were already present in shamanism. She also insists that Jeungsan merely theorized upon these ideas by inheriting them and his religious activities must be identified from within a shamanistic worldview. Contrary to Lee's claim, Cha Seon-keun argues that the grievance resolution of Jeungsan is far beyond the contents and level of development found in shamanism. He also insists that Jeungsan's religious activities must be identified as having a certain orderly uniqueness distinct from shamanism. The argument between these two different perspectives has not attracted other researchers besides those who are directly involved. However, this debate deserves attention with regard to the problem of how one approaches a given religion and which academic perspective should be applied. Based on the perspective of the Daesoon Jinrihoe, this study examines their debate by considering four issues. Firstly, whether Jeungsan inherited or expanded upon the subject of grievance resolution and its range remains undetermined. Secondly, the ethics of mutual beneficence and grateful reciprocation in Jeungsan's concept of grievance resolution should be analyzed as to whether that idea reasserts the ethics of shamanism. Thirdly, it is necessary to study whether his method of grievance resolution fully embraced the methods of grievance resolution that exist in shamanism. Lastly, it should be determined whether or not Jeungsan's religious activities and system of thought should be identified within a shamanistic worldview. Through this review, Lee and Cha can be shown to have different opinions on the academic approach to research on religion. Accordingly, this study concludes that Lee's method of only interpreting Jeungsan's religious thought via a shamanic worldview is incompatible with academic methodology. A scholar of religious studies should discuss Jeungsan on his own merits rather than just imply that Jeungsan thoroughly reflects the worldview of shamanism, doctrinal studies of Buddhism, and Daoist thought as well as other theologies. In other words, if certain tangible and intangible elements found in shamanism, Buddhism, Confucianism, Daoism, and Christianity are also observed in Jeungsan's religious thought, it is necessary to comprehend how different or similar those elements are or whether they are re-interpreted in any manner. In the case of Lee, her method of overemphasizing similarities is now criticized as outdated. Nowadays, it is necessary to demonstrate awareness of modern religious studies tendency to pay equal attention to similarities and differences.