• ETRI Journal
• /
• v.23 no.1
• /
• pp.1-8
• /
• 2001

The performance of a long wavelength-band erbium-doped fiber amplifier (L-band EDFA) using 1530nm-band pumping has been studied. A 1530nm-band pump source is built using a tunable light source and two C-band EDFAs in cascaded configuration, which is able to deliver a maximum output power of 23dBm. Gain coefficient and noise figure (NF) of the L-band EDFA are measured for pump wavelengths between 1530nm and 1560nm. The gain coefficient with a 1545nm pump is more than twice as large as with a 1480nm pump. It indicates that the L-band EDFA consumes low power. The noise figure of 1530nm pump is 6.36dB at worst, which is 0.75dB higher than that of 1480nm pumped EDFA. The optimum pump wavelength range to obtain high gain and low NF in the 1530nm band appears to be between 1530nm and 1540nm. Gain spectra as a function of a pump wavelength have bandwidth of more than 10nm so that a broadband pump source can be used as 1530nm-band pump. The L-band EDFA is also tested for WDM signals. Flat Gain bandwidth is 32nm from 1571.5 to 1603.5nm within 1dB excursion at input signal of -10dBm/ch. These results demonstrate that 1530nm-band pump can be used as a new efficient pump source for L-band EDFAs.

• Proceedings of the IEEK Conference
• /
• 2001.06b
• /
• pp.289-292
• /
• 2001

A Novel fully-differential bipolar current-controlled current amplifier(CCCA) for electrically tunable circuit design at current-mode signal processing were designed. The CCCA was consisted of fully-differential subtracter and fully-differential current gain amplifier. The simulation result shows that the CCCA has current input impedance of 0.5 Ω and a good linearity. The CCCA has 3-dB cutoff frequency of 20 MHz for the range over bias current 100$mutextrm{A}$ to 20 ㎃. The power dissipation is 3 mW.

• Journal of Korea Society of Industrial Information Systems
• /
• v.18 no.5
• /
• pp.1-8
• /
• 2013

This paper presents a variable gain amplifier(VGA) without passive devices. This VGA employes the architecture of current feedback amplifier and variable gain can be achieved by using the GM ratios of two trans-conductance(gm) circuits. To obtain linearity and high gain, it uses current division technique and source degeneration in feedback GM circuits. Input trans-conductance(GM) circuit was biased by using a tunable voltage controller to obtain variable gain. The prototype of the VGA is designed in $0.35{\mu}m$ CMOS technology and it is operating in sub-threshold region for low power consumption. The the gain of proposed VGA is varied from 23dB to 43dB, and current consumption is $2.82{\mu}A{\sim}3{\mu}A$ at 3.3V. The area of VGA is 1$120{\mu}m{\times}100{\mu}m$.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.12 no.4
• /
• pp.405-410
• /
• 2012

This paper presents an inductorless 8-Gb/s adaptive passive equalizer with low-power consumption and small chip area. The equalizer has a tunable RC filter which provides high-frequency gain boosting and a limiting amplifier that restores the signal level from the filter output. It also includes a feedback loop which automatically adjusts the filter gain for the optimal frequency response. The equalizer fabricated in $0.18-{\mu}m$ CMOS technology can successfully equalize 8-Gb/s data transmitted through up to 50-cm FR4 PCB channels. It consumes 6.75 mW from 1.8-V supply voltage and occupies $0.021mm^2$ of chip area.

• Korean Journal of Optics and Photonics
• /
• v.16 no.4
• /
• pp.392-396
• /
• 2005

A new structure of tunable wavelength converter based on XCM in SOA was tried and analyzed. This converter used single SOA and had very simple structure. In this paper, results were experimentally obtained and demonstrated. Pump signal was generated with NRZ $(PRBS\;2^{31}-1)$ and data rate 2.5 Gbps. WDM multi conveted signals showed more than 8.3 dB extinction ratio. For BER performance, all these converted signals had within 5.0 dB power penalty compared with the pump signal. With these results, we showed that this converter was suitable for 2.5 Gbps WDM multi-channel wavelength converting.

• Korean Journal of Optics and Photonics
• /
• v.1 no.2
• /
• pp.155-161
• /
• 1990

A Continous wave tunable $CO_2$ laser which is the slow axial flow type was construccted for the optical pumping of methyl alcohol ($CH_3OH$) laser. The reflective grating of 100 grooveslmm and 10.6$\mu\textrm{m}$ blaze wavelength was used to select wavelength. We have investigated continous outpu: power characteristics, and then have compared tuned output power profile with the gain curve of $CO_2$ laser. The optimum condition for maxium power was found at the gas mixing ratio 1 : 3 : 10 for $CO_2: N_2$ and He. under this condition the flow rate, pressure of lasing gas and discharge current are 9.5 llmin. 14 torr, and 55 mA respectively. The maxium output power was 55 Wlm. Output power of single wavelength operation was measured on 60 individual rotation vibration transitions in the P and K branches of the 9.5$\mu\textrm{m}$ band and 10.4$\mu\textrm{m}$ band in $CO_2$. The output power profile obtained from each band is well consistent with the gain curve of $CO_2$ laser and maxium tuned output power was 20 watt.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.7
• /
• pp.3425-3430
• /
• 2013

The fast-growing market in wireless communications has led to the development of multi-standard mobile terminals. In this paper, a frequency-tunable active RC bandpass filter for multi-standards wireless communication system is designed using an active inductor. The conventional bandpass filter design methods employ the high order filter or high quality factor Q to improve the stopband attenuation characteristics and frequency selectivity of the passband. The proposed bandpass filter based on the high Q active inductor has an improved frequency characteristics. The center frequency and gain of the designed bandpass filter is tuned by employing the tuning circuit. We have performed the simulation using TSMC $0.18{\mu}m$ process parameter to analyze the characteristics of the designed active RC bandpass filter. The bandpass filter with Q=20.5 has 90MHz half power bandwidth at the center frequency of 1.86GHz. Moreover, the center frequency of the proposed bandpass filter can be tuned between 1.86~2.38GHz for the multi-standards wireless communication system using the capacitor of the tuning circuit.

• Korean Journal of Optics and Photonics
• /
• v.21 no.5
• /
• pp.181-184
• /
• 2010

A simple technique for a flexibly tunable and switchable dual wavelength-switchable erbium-doped fiber (EDF) laser using fiber Bragg gratings is proposed and demonstrated by using both linear cavity loss controlling and homogeneous gain broadening of the EDF. The oscillating wavelength switching is successfully realized by using the modulation of the acousto-optic modulator driven by the RF signal. The wavelength spacing and lasing wavelength of the proposed wavelength-switchable laser can also be controlled by using the bending-induced tension or compression strain. The proposed tunable dual wavelength-switchable fiber laser has a lot of advantages, such as a high extinction ratio larger than 40dB and a high tunability of ~7.2 nm/$m^{-1}$.

• Korean Journal of Optics and Photonics
• /
• v.10 no.5
• /
• pp.430-438
• /
• 1999

We have utilized soft-aperturing by gain media to develop a high-power tunable Ti:Sapphire laser with sub-40-fs and broad tuning range. The tunable spectral range was only limited by the bandwidth of mirrors. We made use of knife-edge slits near an intra-cavity prism controlled by micro-stepping-motors to tune the center wavelength continuously. The tunability of the center wavelength was ranged from 770 nm to 870 nm, and the measured pulsewidth was sub-40 fs throughout the above spectral range. The shortest pulsewidth was about 17 fs at the center wavelength of 820 nm and the spectral bandwidth was 72 nm. At 5 W pumping power of the Ar-ion laser we obtained average output power of 440 mW~580 mW. For the cw and Kerr-lens mode-lodking conditions, we have evaluated the value of an amplitude modulation to be ${\gamma}=2.5{\times}10^{-8}/W$ from the calculated waists of a Gaussian beam on the Ti:sapphire crystal surface. Using this result we demonstrate that the generation of sub-40-fs Kerr-lens mode-locked pulse can be described by the Ginzberg-Landau model which is a weak pulse shaping model.

• Korean Journal of Optics and Photonics
• /
• v.14 no.3
• /
• pp.321-326
• /
• 2003

We constructed grating- tuned external cavity semiconductor lasers using Littman and Littrow configuration, for which the wavelengths are tuned by rotation of the grating. This wavelength tunable semiconductor laser is one of the main devices of WDM optical communication. In Littman configuration, the wavelength range of about 60 nm (The C- and L-band range of 1,530~1,590 nm) was obtained by changing the incidence angle of the grating about $\pm$1$^{\circ}$ from the incidence angle of 70$^{\circ}$. In the 40 nm tuning range, the output power variation was less than 1.25 ㏈ and the side mode suppression ratio(SMSR) was 32 ㏈. In Littrow configuration (The incidence angle and the first order diffraction angle is the same, i.e. $\alpha$=$\delta$), the wavelength tuning range was about 80 nm for the same conditions used in Littman configuration except the incidence angle ($\alpha$=49$^{\circ}$). In 60 nm tuning range, the output power variation was less than 1.5 ㏈ and SMSR was 35 ㏈.