• Proceedings of the KSME Conference
• /
• 2004.11a
• /
• pp.1640-1645
• /
• 2004

The pumping characteristics of a single-stage disk-type drag pump ( DTDP ) are calculated,for the variation of the vertical clearance between a rotor and stator and of the radial clearance between a rotor and casing wall, by the three-dimensional direct simulation Monte Carlo (DSMC)method. The gas flow mainly belongs to the molecular transition flow region. Spiral channels of a DTDP are cut on the both the upper and lower sides of a rotating disk, but the stationary disks are planar. As a consequence of results, the vertical and radial clearances have a significant effect on the pumping performance. Experiments are performed under the outlet pressure range of 0.4 $^{\sim}$ 533 Pa. When the numerical results are compared to the experimental data, the numerical results agree well qualitatively.

• Journal of the Korean Society for Library and Information Science
• /
• v.9
• /
• pp.99-118
• /
• 1982

This paper first reviews various techniques proposed for automatic indexing with special emphasis placed on statistical techniques. Frequency-based statistical techniques are categorized into the following three approaches for further investigation on the basis of index term selection criteria: term frequency approach, document frequency approach, and probabilistic approach. In the experimental part of this study, Pao's technique based on the Goffman's transition region formula and Harter's 2-Poisson distribution model with a measure of the potential effectiveness of index term were tested. Experimental document collection consists of 30 agriculture-related documents written in Korean. Pao's technique did not yield good result presumably due to the difference in word usage between Korean and English. However, Harter's model holds some promise for Korean document indexing because the evaluation result from this experiment was similar to that of the Harter's.

• Journal of Photoscience
• /
• v.12 no.2
• /
• pp.57-61
• /
• 2005

The ground and excited state dipole moments of Coumarin 450 (C 450) laser dye were measured at room temperature in several solvents of varying dipole moments. The ground state dipole moment (${\mu}_g$) is estimated by using the modified Onsagar model and the excited state dipole moments (${\mu}_e$) were estimated by the method of solvatochromism as well as by utilizing the microscopic solvent polarity parameter ($E^N_T$). Further, the deviation of some of the points from the linearity of the $E^N_T$ versus Stokes shift indicates the existence of specific type of solute-solvent interaction. The excited state dipole moment of C 450 were found to be higher than those of the ground state and is interpreted in terms of the resonance structure of the molecule. A reasonable agreement has been observed between the values obtained by the method of solvatochromism and modified Onsagar model. It is observed that, corresponding to cyclohexane solution, the fluorescence maxima shift towards the red region with increasing the polarity of the solvents, hence the transition involved are of ${\pi}-{\pi}^*$ type.

• Journal of the Mineralogical Society of Korea
• /
• v.12 no.1
• /
• pp.1-10
• /
• 1999

Talc (Mg3Si4O10(OH)2), one of the sheet silicate minerals, which is the hydrothermal alteration product of serpentinite at Cheongarm mine was prepared for the high pressure compressibility studies. Energy dispersive X-ray diffraction experiment was carried out using the Synchrotron Radiation with the Mao-Bell type diamond anvil cell at room temperature. Polycrystalline talc was mixed with MgO powder for pressure sensor as well as pressure medium in the sample chamber. High pressure runs were performed at pressures up to 35.2 GPa. Talc shows no phase transition within the present high pressure region. Bulk modulus of this talc was determined by the Birch-Murnaghan equation of state to be 78 GPa assuming its first pressure derivative Ko' of 4.

• Textile Coloration and Finishing
• /
• v.15 no.4
• /
• pp.8-16
• /
• 2003

Poly(trimethylene terephthalate)(PTT) fiber was pretreated with organic solvent/water solution of various compositions. The organic solvents used in this experiment were benzyl alcohol, n-buthanol, and N,N-dimethylformamide(DMF). Density of the fibers were investigated as a measure of crystallite region. The dye uptake increased in the order of pretreatment with hot water < untreated < 5% benzyl alcohol < 100% benzyl alcohol < 90% benzyl alcohol; hot water < untreated $\risingdotseq$ 5% butanol < 100% beutanol < 90% butanol; hot water $\risingdotseq$ 5% DMF < untreated < 90% DMF < 100% DMF. The dye uptake increases with increase of crystallinity. It seems likely that the recrystallization process during the pretreatment with organic solvent/water solutions leads to an increase in the microvoid and then a large increase in the dye uptake. Also the dyeing rate increased and the dyeing transition temperature decreased with the pretreatments. The results obtained are corresponds with the plasticization of the fiber structure formed during the pretreatrnent.

• 한국가시화정보학회:학술대회논문집
• /
• 2005.12a
• /
• pp.50-53
• /
• 2005

The turbulent flow around a sphere was investigated in a streamwise meridian plane using two experimental techniques: smoke-wire flow visualization in wind tunnel at Re=5,300 and PIV measurements in a circulating water channel at Re=7,400. The smoke-wire visualization shows flow separation points near an azimuthal angle of $90^{\circ}$, recirculating flow, transition from laminar to turbulent shear layer, evolving vortex roll-up and fully turbulent eddies in the sphere wake. In addition, the mean flow pattern extracted by particle tracing method in water tunnel at Re= 14,500 reveals two distinct comparable toroidal(not closed) vortices in the recirculation region. The mean velocity field measured using a PIV technique demonstrates the detailed wake configuration of close symmetric recirculation and near-wake configuration with two toroidal vortices, reversed velocity zone and vorticity contours.

• The Korean Journal of Ceramics
• /
• v.4 no.2
• /
• pp.68-71
• /
• 1998

The effect of Mn and Nb additions on the electrical properties of BaTiO$_3$ has been studied by means of equilibrium electrical conductivity as a function of temperature, oxygen partial pressure(Po$_2$) and composition. If the manganese ion is added to the normal Ti site, i.e. BaTi$_{1-x}Mn_xO_{\delta-6}$, the equilibrium conductivity shows strong evidence of acceptor-doped behavior. The conductivity minimum, corresponding to the transition from oxygen excess, p-type behavior to oxygen deficient, n-type behavior with decreasing Po$_2$, is displaced to lower Po$_2$ and is broadened and flattened. The partial replacement of Mn ion with Nb decreases the acceptor-doped effect and the total replacement exhibits a typical donor-doped behavior. It was confirmed that unlike undoped or other acceptor-doped behavior. It was confirmed that unlike undoped or other acceptor-doped samples, for the p-type region, the electrical conductivity follows the 1/6th power dependence of oxygen partial pressure.

• Journal of the Korean Society of Safety
• /
• v.14 no.4
• /
• pp.3-12
• /
• 1999

This research concentrates on the influence of non-linearities associated with impact for the nonlinear rocking behavior of rigid block subjected to one dimensional sinusoidal excitation of horizontal direction. The transition of two governing rocking equations, the abrupt reduction in the kinetic energy associated with impact, and sliding motion of block. In this study, two type of rocking vibration system are considered. One is the undamped rocking vibration system, disregarding energy dissipation at impact and the other is the damped rocking system, including energy dissipation and sliding motion. The response analysis using non-dimensional rocking equation is carried out for the change of excitation parameters and friction coefficient. The chaos responses were discovered in the wide response region, particularly, for the case of high excitation amplitude and their chaos characteristics were examined by the time history, Poincare map, power spectra and Lyapunov Exponent of rocking responses. The complex behavior of chaos response, in the phase space, were illustrated by Poincare map. The bifurcation diagram and Poincare map were shown to be effective in order to understand chaos of rocking system.

• Journal of Power System Engineering
• /
• v.4 no.3
• /
• pp.40-47
• /
• 2000

The turbulent flow with wake, reattachment and recirculation flow is very important from the viewpoint of engineering. But that is still difficult because of especially the unsteady problems which are related with the vehicle dynamics and the aerodynamics noise. This paper evaluate LES that can analyze about all fluid flow region including the laminar, transition and turbulent. So we compare the results of LES with those of PIV measurement and Reynolds averaging models. In conclusion, LES predicts flow behavior better than Reynolds averaging models.

• 한국전산유체공학회:학술대회논문집
• /
• 2001.05a
• /
• pp.78-84
• /
• 2001

A dual-time stepping algorithm combined with a parallelized multigrid DADI method is presented to predict the dynamic damping coefficients. The Basic Finner model is chosen to validate the prediction capability of the present unsteady Euler method. The linearity of the pitch- and roll-damping coefficients is shown in the low angular rates and the interesting large drop and stiff increment in transonic region for roll-damping coefficients are explained in detail. Through the analysis for the pressure distributions at Mach number 1.0 to 1.2, the sudden drop results from the normal shock and the stiff increment of roll-damping reflects the transition of the normal shock to the oblique shock. The results also show that the Euler equations can give the damping coefficients with a comparable accuracy.