• Journal of Nutrition and Health
• /
• v.8 no.2
• /
• pp.7-13
• /
• 1975

In the classic point of view, it has well known that the tangle is the mineral source, especially iodide. However, there are few reports that the tangle can be used the high-protein source. With the consideration whether the tangle can be used as a protein source as well as one of the foodstuff or not, this studies is done by animal experiment. The Albino rats to be examined were fed on the basal diet (Table 1) and the others including the polished tangle by weight 2%, 3%, 4% and 5%, as experimental diets, for 4 weeks, respectively. The weight gain(Fig. 1), total amount of diet intake (Fig. 2), total water intake(Fig. 3), feed efficiency ratio (Fig. 4) and protein efficiency ratio (Fig. 5) was measured by each week, respectively. In addition, organ weight (Fig. 6) and blood study (Fig. 7, Fig. 8) was also analyzed at the end of the experiment. As the results of this study, growth rate, that is, weight gain, feed efficiency ratio and protein efficiency ratio in all experimental groups increased more than those of the control group. Moreover, it was also found that weight gain, feed efficiency ratio, protein efficiency ratio by feeding on the 2 percent tangle group was higher than the corresponding values of all experimental groups. However, feed intake and total water gain were the most by feeding on the 5% tangle group. This result may be interpreted to show that the total content of sodium includes more than enough in the feed intakes. To obtain further information concerning the effect of the tangle-dietary conditions on the growth rate of Albino rats, it was measured the organ weight. In the adrenal and spleen, the total weight by feeding on the all experimental groups were decreased more than that in the case of the control group. In the other hand, in the liver the weight by feeding on the high concentration groups (4%, 5% tangle diets) were not higher than the control group, while in the case of the low concentration groups (2%, 3% tangle diets) were higher than that of the control group. When it was observed the blood components, total protein, hemoglobin, sodium, potassium, white blood cell and red blood cell of rats, the content of white blood cell by feeding on all experimental groups were lower than that by feeding on the control group, but it was also clear that in the other components except white blood cell in blood the contents by feeding on all experimental groups were similar to that in the case of the control groups. However, in the 5% tangle group, the content of sodium was the lowest of all experimental groups, where as the content of potassium was the highest of all experimental groups.

• Journal of the Korean Solar Energy Society
• /
• v.32 no.2
• /
• pp.1-10
• /
• 2012

A photovoltaic/thermal (PVT)solar system is the solar technology that allows for simultaneous conversion of solar energy into both electricity and heat. This paper compared the performance of PVT system with a conventional PV module and solar collector and analyzed electrical and thermal efficiency of PVT system in terms of solar irradiance and inlet temperature of the working fluid. Based on the experimental data, thermal and electrical efficiencies of he glazed PVT system were57.9% and14.27% under zero reduced temperature condition which were lower by 13.6% than the solar thermal absorber plate and by 0.08% than the PV module respectively. For the unglazed PVT system it had lower thermal efficiency than the solar thermal absorber plate but higher electrical performance than the PV module due to the cooling effect by the working fluid. However, total efficiency of the glazed PVT system was72.2% which was higher than combined efficiencies of the solar collector and PV module. Besides, total efficiency of the PVT system would be much higher if calculated based on unit area.

• Journal of Korean Society on Water Environment
• /
• v.23 no.6
• /
• pp.881-888
• /
• 2007

In order to investigate the characteristics of the non-biodegradable material, the $BOD_5/COD_{Cr}$ ratio was used. The average ratio of industrial complex's influent wastewater was 2.29~2.96, the effluent ratio was 4.29~19.0. The removal efficiency of $UV_{254}$ by physicochemical treatment was 22.8~94.7% and 5.3~77.2% by biological treatment, respectively. Of the wastewater removal efficiency for each of the items, the $BOD_5$ treatment efficiency was the greatest at 97.3% and the color & TN treatment efficiency was 40~70%. The study of the economical assessment showed that the complex as well as the individual companies spent 722~1,298 won for each ton of treated wastewater. All of the wastewater treatment facilities spent the most money on chemicals needed to treat the wastewater. The total cost for Nylon manufacturing wastewater treatment plant was the greatest while the total cost for cotton manufacturing wastewater treatment plant turned out to the lowest. As respects of removal efficiency and economocal assessment, Polyester A and Cotton manufacturing wastewater treatment plants were better effective than a dyeing industrial complex wastewater treatment plant.

• 한국태양에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.60-67
• /
• 2011

A photovoltaic/thermal(PVT)solar system is the solar technology that allows for simultaneous conversion of solar energy into both electricity and heat. This paper compared the performance of PVT system with a conventional PV module and solar collector and analyzed electrical and thermal efficiency of PVT system in terms of solar irradiance and inlet temperature of the working fluid. Based on the experimental data, thermal and electrical efficiencies of the glazed PVT system were 57.9% and 14.27% under zero reduced temperature condition which were lower by 13.6% than the solar thermal absorber plate and by 0.08% than the PV module respectively. For the unglazed PVT system, it had lower thermal efficiency than the solar thermal absorber plate but higher electrical performance than the PV module due to the cooling effect by the working fluid. However, total efficiency of the glazed PVT system was 72.2% which was higher than combined efficiencies of the solar collector and PV module. Besides, total efficiency of the PVT system would be much higher if calculated based on unit area.

• International Journal of Fluid Machinery and Systems
• /
• v.3 no.4
• /
• pp.379-385
• /
• 2010

We developed a high-efficiency, wide-operating-range centrifugal blower stage to meet the demand for reduced total energy-consumption in sewage treatment plants. We improved the efficiency of the two-dimensional impeller using a shape optimization tool and one-dimensional performance prediction tool. A limit of the throat deceleration ratio was set to maintain the stall-margin of the impeller. The low solidity vaned diffuser and return channel were designed using a sensitivity analysis with orthogonal arrays and three-dimensional steady flow simulations. The low solidity diffuser was designed in order to improve the performance in the low-flow-rate region. The return channel was designed so that the total pressure loss in the return channel was minimized. Model tests of both the conventional and optimized blower stages were carried out, and the efficiency and operating range of both stages were compared. The optimized blower stage improved in stage efficiency by 3% and in operating range by 5% compared with the conventional blower stage.

• Journal of Korean Society on Water Environment
• /
• v.23 no.2
• /
• pp.244-250
• /
• 2007

This study was carried out to obtain the optimum design factors for an eletrolytric flotation reactor. When the effluent of the leachate treatment facility was treated under the condition of 10 volts, 30 minutes, at the Al-Al electrode system; COD removal efficiency was 45%, and total phosphorus removal efficiency was 98%. The high removal efficiency was caused by the fact that phosphate was removed by leaching $Al^{3+}$ from two electrodes. The leachate containing high ammonium nitrogen concentration was treated by a batch test under the condition of 60 minutes reaction time and added chloride ion; ammonium nitrogen removal efficiency was 89%. This high efficiency was affected by added chloride ion to wastewater. To find the optimum current density and voltage of the leachate containing chloride ion (ratio of $Cl^-/NH_4-N$ is 11) a electrochemical polarization curve was used. These values were found to be $4.5mA/cm^2$ and about 2.1 V, respectively. When C-Al electrode system was used at a batch test, the total nitrogen removal efficiency was increased by 1.8 to 3.3 times, compared to Al-Al electrode system due to high $Cl_2$ gas production.

• The Journal of Asian Finance, Economics and Business
• /
• v.9 no.7
• /
• pp.261-271
• /
• 2022

Over the last 20 years, the insurance industry in Vietnam has been rapidly growing with an average annual growth rate of 21%, one of the most active markets in Southeast Asia, raising the question of efficiency to managers, investors, and regulators. This article is one of the first research works using Data Envelopment Analysis combined with the Malmquist index over the period from 2016 to 2020 for 37 insurance firms in Vietnam to investigate the efficiency of this sector. The value-added approach is employed with total equity and operating expenses as inputs, finance income, and gross written premium as outputs. The findings reveal that most of Vietnam's insurance companies are operating quite effectively, and the non-life sector is more efficient than the life sector. There is also a regression in efficiency change, while there is a progression in technological change and total factor productivity change during the period examined. The goal of this research is to give a fundamental understanding of the overall efficiency of insurance firms in Vietnam, and help managers, investors, policyholders, and government agencies make better decisions regarding self-assessment, M&A activities, deregulation... Consequently, the insurance sector could improve in terms of efficiency and develop sustainably over time.

• International journal of advanced smart convergence
• /
• v.11 no.1
• /
• pp.101-110
• /
• 2022

The purpose of this study is to evaluate the efficiency of financial support for rural industry revitalization in eastern China. Comparative analysis of the efficiency of provincial financial support for rural industrial revitalization in eastern China can provide reference for various provinces to formulate financial policies for rural revitalization. In the research process, 5 evaluation indicators were selected using the panel data of the 2016-2021 "China Financial Statistical Yearbook" and "China Statistical Yearbook", and the DEA and Malmquist index methods were used for calculation. The results show that the average efficiency of financial support for rural revitalization in the 10 eastern provinces from 2015 to 2020 was generally higher, with the efficiency values all higher than 0.8, and reached 0.908 in 2017. The comprehensive efficiency of financial support for rural industry revitalization in Tianjin, Shanghai and Hainan has reached the best. From 2015 to 2020, the total factor productivity of financial support for rural industry revitalization in the eastern region has a "V"-shaped fluctuation. Total factor productivity has the fastest growth. The provinces are Beijing, Hebei and Shandong showing negative growth. It is recommended that relevant provinces improve their strategies for financial support for the revitalization of rural industries. The scope of future research should be expanded to most areas of China and the evaluation indicators should be optimized.

• Korean Journal of Social Welfare
• /
• v.52
• /
• pp.117-141
• /
• 2003

This study is to identify the efficiency in Busan social welfare agencies between input factors and output factors. For this purpose, gathered are the 2001 services reports of those study agencies. This study used 4 difference model, model 1; comparing input factor(social worker number & labor cost) about output factor(the total number of program used person), model 2; comparing input factor(the total number of social welfare agencies staff & the total working expenses) about output factor(the total number of program used person), model 3; comparing input factor(the total number of volunteer, social welfare agencies staff & a period of operation) about output factor(the total number of program used person), model 4; comparing input factor(the total number of volunteer, social welfare agencies staff, a period of operation & the total working expenses) about output factor(the total number of program used person). Charnes's study(1978) provided an analytical tool for efficiency services output of non-profit organizations, and DEA(Data Envelopment Analysis) was a analytical framework for evaluating the impact of social service outcome. the finding are as follows : (1) In the results of comparing 4 models as same standard, we can find 35-55%(16-25) efficiency agencies among the 45 social welfare agencies. (2) For all DMU becoming the efficiency 1 to standard of output factor, model 1; 33 agencies are increasing the social worker number($\Delta$0.8 number), 10 agencies are raising the labor cost of social worker($\Delta$1,189,000 Won), model 2; 30 agencies are increasing the total number of social welfare agencies staff($\Delta$1.25 number), 14 agencies are raising the total working expenses($\Delta$1,447,000 Won), model 3; 8 agencies are increasing the total number of social welfare agencies staff($\Delta$2.26 number), 14 agencies are increasing the total number of volunteer($\Delta$52 number), and 10 agencies are increasing a period of operation($\Delta$13 month), model 4; 24 agencies are increasing the total number of social welfare agencies staff($\Delta$1.8 number), 12 agencies are raising the total working expenses($\Delta$5,017,000 Won), 12 agencies are increasing the total number of volunteer($\Delta$43.2 number), and 23 agencies are increasing a period of operation($\Delta$16 month).

• The Journal of the Korea Contents Association
• /
• v.20 no.4
• /
• pp.159-168
• /
• 2020

This study aims to utilize DEA, analyze the efficiency of Korean coffee franchises, look into the factors that affect efficiency, and improve the efficiency of Korean coffee franchises. The main results of this study are as follows. First, according to CCR model standards, there are a total of 9 efficient coffee franchises and according to BCC model standards, there are a total of 12 efficient coffee franchises. A total of three of the inefficient DMUs were found to have a value of 1 for BCC, while the other 25 were found to be inefficient for both technology and scale. Second, of 28 franchises, 11 were analyzed to be decreasing return to scale and through future increased investments of optimum levels, business performance can be improved and efficiency can be enhanced. Analysis showed that 9 franchises appeared as CRS and it is most ideal to maintain the yield of future output elements at current levels and the work efficiency of 8 franchises in increasing returns to scale states expands as production scales increase according to specialization and role division and yield can relatively improve a lot. Third, the analysis of factors affecting the efficiency of franchises through the Tobit regression analysis showed that the number of franchises and operating periods had a positive (+) effect on efficiency. Based on this study, the efficiency of coffee franchises should be analyzed to establish strategies to maximize efficiency. Based on this study, the efficiency of coffee franchises should be analyzed to establish strategies to maximize efficiency.