• Analytical Science and Technology
• /
• v.12 no.4
• /
• pp.290-298
• /
• 1999

A study on the application of impedance phase angle for redox titration, acid-base titration, chelate titration and precipitation titration has been carried out. A constant alternating current was passed between two platinum electrodes. One of them was a polarizable micro-electrode of $0.1cm^2$ or $0.026cm^2$ surface area and the other a non-polarizable large electrode of $1cm^2$ surface area dipped in the solution to be titrated. The impedance and the phase angle of the titration cell were measured with lock-in amplifier to obtain well behaved titration curve respectively. In titration of oxalic acid vs. potassium permanganate, the end-point was obtained successfully from the phase angle titration curve. In this experiment, the concentration of 0.0005 M to 0.05 M, the current of $50{\mu}A$ and the frequency of near 50 Hz were used. In titration of phosphoric acid vs. sodium hydroxide, the first end-point was obtained successfully on the optimum experimental condition of 0.001 M concentration, $50{\mu}A$ current and 25~97 Hz frequency. However, the end-point in titration of cupric sulfate vs. disodium-EDTA couldn't be obtained clearly. The end-point was obtained with the out-of-phase impedance curve on the experimental condition of 0.01 M concentration, $100{\mu}A$ current, 5~35 Hz frequency range. In titration of sodium chloride vs. silver nitrate, the end-point was obtained successfully on the experimental condition of 0.1 M concentration, $100{\mu}A$ current and 5~47 Hz frequency range. This study showed that the impedance phase angle was applicable for the detection of the end-points in redox titration curve, acid-base titration curve, chelate titration curve and precipitation titration curve.

• Journal of the Korean Chemical Society
• /
• v.11 no.4
• /
• pp.159-164
• /
• 1967

An exact expression of the titration fraction as a function of the potential is derived for the cases where the coefficients of the both half reactions involved in the titration are homogeneous. It shows that the potential is independent of the concentration of the reagents not only at the equivalence point but also at all titration fractions. The sharpness of the end point detection by potentiometric method is shown to depend not only on the difference of the normal potentials involved but also strongly on the number of electrons transferred in each half reaction. The inflexion point of the potentiometric titration curve is shown to be slightly off from the equivalence point, including the cases where the number of electrons involved are equal. Completeness of the reaction in the course of titration is analyzed, too, mostly in terms of equilibrium constant, thus most of the results are applicable to any type of equilibrium in a single phase with particular relationship of coefficients of chemical equation.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.124.1-124
• /
• 2001

Control of pH neutralization process plays a very important role in some chemical process. Because of their high nonlinearity, frequent disturbance, and time-varying characteristics, it is difficult to control and estimate pH processes. For the adaptive control of pH processes, a lot of researchers have made an efforts in the modeling and control of pH processes. It is very difficult to obtain information of influent stream such as concentrations and dissociation constants and the titration curve equation is very complex. Therefore, several simple models, which hate small number of unknown parameters and estimate the titration curve, have been available, These models were considered here and were transformed into forms that can applied the linear least square method.

• Macromolecular Research
• /
• v.15 no.6
• /
• pp.587-594
• /
• 2007

Well defined amphiphilic diblock copolymers of poly(styrene-b-vinylbenzylphosphonic acid) (PS-b-PVBPA) were prepared by controlled radical polymerization technique, two-step hydrolysis reactions using trime-thylsilyl bromide from the corresponding phosphonic ethyl ester. By indirect, backward pH titration of the block copolymer, a good titration curve of a dibasic acid was observed. The IEC values obtained from both backward pH titration and volumetric back titration were almost identical. Thermal gravimetric analysis (TGA) of the phosphonic acid containing block copolymer showed a high thermal stability up to $400^{\circ}C$.

• Bulletin of the Korean Chemical Society
• /
• v.22 no.6
• /
• pp.559-564
• /
• 2001

A method for calculating the main characteristics of a potentiometric titration curve in a carboxylic ion exchanger has been investigated. The potentiometric titration curves of simple electrolyte and ion exchangers (polyelectrolytes) showed a great difference between them. The acidity parameters of the ion exchangers, the thermodynamic constant (pK0), apparent equilibrium constant (K), and correction for the apparent equilibrium constant (b), were introduced and used to express the characteristics of the carboxylic ion exchanger. A characteristic equation related to the acidity parameters of the ion exchangers systems was derived. A fibrous carboxylic cation exchanger was used and potentiometric titration curves at different concentrations of the supporting electrolyte were obtained . To prove the validity of the characteristic equation, the concentration of the supporting electroyte was varied. In the present study, good agreement between the data points and the fitted curves was found in all the cases. The g (number of moles of alkali to 1 g of ion exchanger) of carboxylic ion exchanger was calculated from the concentration of supporting electrolyte (C), pH of the solution, and degree of neutralization of ion exchanger (x).

• Economic and Environmental Geology
• /
• v.51 no.6
• /
• pp.509-520
• /
• 2018

Alkalinity is one of the basic variables, which determine geochemical characteristics of natural waters and participate in processes changing concentrations of various contaminants either directly or indirectly. However, not a few laboratories and researchers of Korea still use alkalinity-measurement methods not appropriate for groundwaters, and which becomes one of the major reasons for the poor ion balance errors of the geochemical analysis. This study was performed to review alkalinity-measurement methods, to discuss their advantages and disadvantages, and, thus, to help researchers and analytical specialists in analyzing alkalinity of groundwaters. The pH-titration-curve-inflection-point (PTC-IP) methods, which finds the alkalinity end point from the inflection point of the pH titration curve are revealed to be most accurate. Gran titration technique among them are likely to be most appropriate for accurate estimation of titrant volume to the end point. In contrast, other titration methods such as pH indicator method and pre-selected pH method, which are still commonly being used, are likely to cause erroneous results especially for groundwaters of low ionic strength and alkalinity.

• Journal of the Korean Chemical Society
• /
• v.14 no.4
• /
• pp.341-345
• /
• 1970

An improved derivative thermometric titration apparatus designed around operational amplifiers is described which is capable of monitoring the small temperature change and of computing the derivatives for accentuation of the titration end point that is difficult to locate by extrapolation methods. The instrument is constructed of four commercial operational amplifiers. A use of dummy cell provides the subtraction means for compensation of the initial temperature and random temperature fluctuations with a resultant gain in signal-to-noise ratio. The successive differentiation action of the computer has been nearly "perfect," so that the two breaks (blank or starting and end point of the titration curve can be located with the precision of 0.2% by observing two peak points on the second derivative curve. Arrangements useful in obtaining such a good derivative response that is exactly proportional to the input signal are discussed. Plots of the enthalphogram and its derivatives are presented, with the results of several titrations used to evaluate the performance of the apparatus.

• Applied Chemistry for Engineering
• /
• v.10 no.6
• /
• pp.871-875
• /
• 1999

We calculated the characteristics of a phosphoric cation exchanger and studied on an accurately computable method to determine the ion exchange capacity for type of potentiometric titration curve. The ion exchanger was prepared by phosphorylation of a styrene-divinylbenzene copolymer with 4% crosslinking. The ion exchange capacity is 5.7 meq/g. The experimental pK values versus ${\mathit{x}}$ in phosphoric cation exchanger can be expressed as a linear equation. The ${\Delta}pK$ values were obtained from the slope of linear equation. The ${\Delta}pK$ values are the differences of antilogarithms(pK) values of the apparent equilibrium constant at complete and zeroth neutralization of the ion exchanger. Also the experimental pK values at ${\mathit{x}}=0.5$ were accorded well with theoretical data. And when it is titrated with NaOH and $Ba(OH)_2$ solutions, a good agreement between experimental and theoretical pK values for various ${\mathit{x}}$ was seen in all the potentiometric titration curves. We knew that the inflection point of potentiometric titration curve in the case of divalent ions are changed much large than that for monovalent ions. If the relation between g values and ${\partial}pH/{\partial}g$ was plotted to the Lorentz distribution curve, ion exchange capacity can be accurately evaluated.

• Journal of the Korean Chemical Society
• /
• v.14 no.4
• /
• pp.287-296
• /
• 1970

The varation of potential and completeness of reaction in an oxidation-reduction titration of Red$_1$ ($a\;Ox_1+N_1e{\leftrightarrow}b\;Red_1)\;by\;Ox_2\;(C\;Ox_2+n_2e{\leftrightarrow}d\;Red_2)$ is analyzed on the basis of general expressions. It is shown that the reaction deficiency as well as the rate of variation of the potential with titration fraction change in proportion to the $[n_2(a-b)-n_1(c-d)]$ th power of the concentration of the reagents. In particular, at the equivalence point, the expression of the potential contains a concentration dependent term that is proportional to ac-bd. Thus, the equivalence-point potential varies with the concentration of the reagents unless ac=bd is satisfied. It is also shown that the sharpness of the potentiometric titration curve is shown to occur either prior to or after the equivalence point depending upon whether $n_1cn_2b$, the deviation being the same order of magnitude as the relative deficiency at the equivalence point.

• Analytical Science and Technology
• /
• v.34 no.3
• /
• pp.128-133
• /
• 2021

During titration, several chemical reactions result in changes not only in the potential of chemicals, but also in the colors of the indicator. In a potentiometric titration, a titration curve is obtained by measuring the abrupt change in the potential at the endpoint. Generally, acid-base titration is performed by observing the color change caused by an indicator to determine the endpoint. The method of determining the endpoint by measuring the potential difference has been well established and commercialized; however, the devices that can obtain the endpoint by observing the color change are limited. Consequently, in this study, a simple and precise spectral endpoint detector was manufactured using a drop-counter comprising an infrared emitter and a phototransistor, a white light LED as the light source and photodetector, and an analog-to-digital converter (Arduino). Spectrator, a new named, showed excellent results in terms of the reproducibility of acid-base titration using thymol blue as an indicator. Herein, we present the results of the Spectrator-manufacturing process as well as the experimental results.