• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.1132-1134
• /
• 2006

In this research, we examined the correlation between the polymer wall boundary condition and the dynamic/ memory behavior of the ferroelectric liquid crystal (FLC) molecules. It was shown that the polymer wall perpendicular to the rubbing direction induces asymmetric switching to the rubbing direction and induce smaller cone angle angle of LC. On the contrary, in the cell with polymer wall parallel to the rubbing direction, the FLC molecules are oriented in the rubbing direction and shows symmetric switching and has larger cone angle. Memory behavior of each cell has strong correlation with the dynamic state of the FLC molecules. Response time of each cell was also examined.

• Proceedings of the KIEE Conference
• /
• 1989.07a
• /
• pp.515-517
• /
• 1989

This PWM inverter are used bridge circuit of two pair complementary transistor at each phase. The operation signals are 3 level PWM wave of W type and M type modulation, Which were obtained from switching time data by switching position calculation of triangular and sine wave. The output voltage waveforms of this inverter have the 5 level phase voltage and the 9 level line voltage of PWM.

• Proceedings of the KIEE Conference
• /
• 1989.07a
• /
• pp.544-547
• /
• 1989

The introduction of resonant link inverters has allowed the use of much higher switching frequencies in induction motor current regulators. The resonant link inverter,however, requries the use of discrete time switching strategies. This type of controller,while giving the best possible performance, is difficult to implement, since motor parameters must be calculated or measured. The delta modulated current regurator (DMCR) has been introduced as a controller without additional state feedback. A discrete pulse modulated current regulator which controls load current is introduced in the paper.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.53 no.12
• /
• pp.751-758
• /
• 2004

This paper presents a new method to compensate the non-linearity for matrix converter drives using PQR instantaneous Power theory. The non-linearity of matrix converter drives such as commutation delay, turn-on and turn-off time of switching device, and on-state switching device voltage drop is modelled by PQR power theory and compensated using a reference current control scheme. The proposed method does not need any additional hardware and off-line experimental measurements. The proposed compensation method is applied for high performance induction motor drives using a 3 kW matrix converter system without a speed sensor. Simulation and experimental results show the proposed method using PQR power theory Provides good compensating characteristic.

• Proceedings of the KIEE Conference
• /
• 2001.11c
• /
• pp.338-340
• /
• 2001

Power factor improved for single-phase buck-converter is studied in the paper. To sinusoidal waveform the input current with a near-unity power factor over a wide variety of operating conditions, the output capacitor is operated with voltage reversibility for the supply by arranging the auxiliary diode and power switching device. Then the output voltage is superposed on the input voltage during on time duration of power switching devices in order to minimize the input current distortion caused by the small input voltage when changing the polarity. The tested setup, using two insulated gate bipolar transistors(IGBT) and a microcomputer, is implemented and IGBT are switched with 20[kHz], which is out of the audible band. Moreover, a rigorous state-space analysis is introduced to predict the operation of the rectifier. The simulated results confirm that the input current can be sinusoidal waveform with a near-unity power factor and a satisfactory output voltage regulation can be achieved.

• Proceedings of the KIEE Conference
• /
• 1999.07f
• /
• pp.2662-2664
• /
• 1999

To improve the current waveform of diode rectifiers, we propose a new operating principle for the voltage diode rectifiers. In the conventional voltage rectifier circuit, relatively large capacitors are used to boost the output voltage, while the proposed circuit uses smaller ones and a small reactor not to boost the output voltage but improve the input current waveform. A circuit design method is shown and confirmed simulation. It explained that compared conventional SPWM inverter with HPWM(Half Pulse-width modulated)Inverter. Proposed HPWM inverter eliminated dead-time by lowering switching loss and holding over-shooting. Output voltage and current of this paper were applied for real air-conditioner.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.1
• /
• pp.66-71
• /
• 2008

In this paper, an antenna-switching scheme using negative acknowledgement for hybrid automatic repeat request (H-ARQ) is proposed and analyzed in the Vertical Bell Labs Layered Space-Time(V-BLAST) system, in which the transmit antenna is alternatively switched under retransmission. By analytically evaluating the channel capacity of the proposed scheme over correlated fading channels, it is shown that the adverse effect of the channel correlation is alleviated by the antenna switching scheme. Simulation results demonstrate that the average throughput may be improved in a correlated fading channel without adding much complexity to the process.

• Journal of IKEEE
• /
• v.23 no.4
• /
• pp.1182-1186
• /
• 2019

This paper discussed the research results on the development and output characteristics of single-phase direct drive 20W BLDC motor with ADC converter. It is designed to drive the rotor through PWM inverter switching and position the back electromotive force of the motor electrically 30° ahead of the hall sensor phase angle signal to ensure optimum switching time. As a major result of the characteristics evaluation, the maximum inverter efficiency was 92[%], the system efficiency was 53.34[%,] and the motor efficiency was 57.85[%].

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.162.1-162
• /
• 2001

In this paper, the adaptive fuzzy system is used as an adaptive approximator for robot nonlinear dynamic. A theoretical justification for the adaptive approximator is proving that if the representive point(RP or switching function) and its derivative in sliding mode control are used as the inputs of the adaptive fuzzy system, the adaptive fuzzy system can approximate robot nonlinear dynamics in the neighborhood of the switching surface. Thus the fuzzy controller design is greatly simplified and at the same time, the fuzzy control rule can be obtained easily by the reaching condition. Based on this, a new method for designing an adaptive fuzzy control system based on sliding mode is proposed for the trajectory tracking control of a robot with unknown nonlinear dynamics.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.5
• /
• pp.55-64
• /
• 1996

This paper presents performance evaluation of a new high speed inter-processor communication(HIPC) network for large capacity and high performance digitral switching system. The HIPC structure implements the fast reservation and concurrent arbitration technique (modified round-robin arbitration). The performance evaluation of HIPC was performed by not only computer simulation but also numerical approximation method which was derived for a single server multi-queue system with nonexhaustive cyclic service. The approximation results are almost same with that of computer simulation. The TDX-10 basic callscenario was applied to the HIPC netowrk and analyzed. these results were compared with TDX-10 IPC and shows that the difference of th emean waiting time in the TX buffer of NTP node increases sharply according to the increase of the message arrival rate.