• Journal of the Korea Concrete Institute
• /
• v.17 no.2 s.86
• /
• pp.293-302
• /
• 2005

This study describes data from determination of the optimum mix proportion and site application of the mass concrete placed in bottom slab and side wall having a large depth and section as main structures of LNG in-ground tank. This concrete requires low heat hydration, excellent balance between workability and consistency because concreting work of LNG in-ground tank is usually classified by under-pumping, adaptation of longer vertical and horizontal pumping line than ordinary pumping condition. For this purpose, low heat Portland cement and lime stone powder as cementitious materials are selected and design factors including unit cement and water content, water-binder ratio, fine aggregate ratio and adiabatic temperature rising are tested in the laboratory and batch plant. As experimental results, the optimum unit cement and water content are selected under $270kg/m^3$ and $l55{\~}l60 kg/m^3$ separately to control adiabatic temperature rising below $30^{\circ}C$ and to improve properties of the fresh and hardened concrete. Also, considering test results of the confined water ratio($\beta$p) and deformable coefficient(Ep), $30\%$ of lime stone powder by cement weight is selected as the optimum replacement ratio. After mix proportions of 5cases are tested and compared the adiabatic temperature rising($Q^{\infty}$, r), tensile and compressive strength, modulus of elasticity, teases satisfied with the required performances are chosen as the optimum mix design proportions of the side wall and bottom slab concrete. $Q^{\infty}$ and r are proved smaller than those of another project. Before application in the site, properties of the fresh concrete and actual mixing time by its ampere load are checked in the batch plant. Based on the results of this study, the optimum mix proportions of the massive concrete are applied successfully to the bottom slab and side wall in LNG in-ground tank.

• Journal of Fashion Business
• /
• v.24 no.1
• /
• pp.1-14
• /
• 2020

Based on the trend of pluralization and globalization the collapse of national borders now is a manifestation of mixed and compromised cultures and societies. It is also emerging as a hybrid fashion in fashion. Hybrid fashion means creating a new image by mixing various cultures beyond the time and space. This study aims to analyze the current state of Chinese fashion design and present its direction by grasping the characteristics of hybrids in the works of rising Chinese fashion designers in the era of pluralization. The research method was literature review and empirical research. According to the selection criteria of new fashion designers, 6 new fashion designers of 5 fashion brands were selected and their total 458 points works were analyzed. The analysis results are as follows. First, most of the time trade-offs were 'past and present' trade-offs that express Chinese traditional culture and the image of the past with modern design. The trade-offs between 'present and future' is expressed by mixing print patterns, colors and light with fractal art. Second, spatial trade-offs was expressed in the way of expressing Chinese themes in the composition of western clothing, expressing the Western themes in oriental colors, and inspired by Japanese culture expressed by deconstructionism, Third, the gender mix mainly used dark embroidery on women's clothing, while the men's wear showed a delicate feminine charm with a surreal pattern on thin and transparent gauze fabric.

• Resources Recycling
• /
• v.17 no.3
• /
• pp.35-41
• /
• 2008

The study of coking technology to upgrade oil sand bitumen which is considered as alternative fuel was performed by using thermogravity analyzer and delayed coking reactor(600ml). To analyzed and compared coking characteristics of oil sand bitumen, the reactivities of oil sand bitumen were measured in the TGA. At the temperature conditions of $400{\sim}550^{\circ}C$ and the temperature rising velocity of $50^{\circ}C/min$. the termination time of coking reaction and conversion efficiencies increased with an increase of bed temperature. However the increase rate decreased over $450^{\circ}C$. So the coking reaction with oil sand bitumen might be over $450^{\circ}C$. Also the termination time decreased with increasing the temperature rising velocity. But the content of coke increased with increasing temperature rising velocity. At the experiments in the delayed coker, the temperature condition at maximum oil yield was $475^{\circ}C$ and the fuel properties of oil from coking reaction was almost equal with conventional diesel. It was verified that the coking process might be useful process to upgrade the oil sand bitumem by using API and SIMDAS.

• Journal of the Korean Geotechnical Society
• /
• v.16 no.1
• /
• pp.167-178
• /
• 2000

An experimental study on step up filling method is carried out to reinforce the Yano method which is widely used to estimate volume ratio and self-weight consolidation settlement in reclamation area. This method considers actual reclamation construction in which dredged clay is continuously filled and rising of deposit height is presented as a result of volume decrease by height rising and self-weight consolidation. It measured the relationship between filling velocity and deposit rising velocity; calculated the total filling height which is needed to achieve the planned final deposit height, and its solid height and the time which is taken to finish the planned final deposit height; and on the basis of these calculated parameters, predicted the self-weight consolidation and volume change ratio in reclamation construction. Yano method is also used to predict the same conditions. 29.8% in self-weight consolidation, 31.1% in volume ratio, 40% in void ratio and water content is underestimated in Yano method compared to step up filling method.

• Journal of Advanced Navigation Technology
• /
• v.18 no.3
• /
• pp.254-260
• /
• 2014

We studied water level rising of drum versus time in the small hydraulic vertical water turbine system in this paper. The water level rises continuously up to a certain point with the passage of time if the constant incoming water is supplied, while it stops rising and maintains equilibrium state without any more rising because it increases position energy and evatually makes outgoing velocity and outgoing water quantities of runner area. The water level of drum is determined independent of size, height, width, figure of drum or runner configuration. It comes out that the water level is dependent only on the incoming and outgoing water quantities, and the output power has similar behavior. Therefore, desirable water level and output power are not available unless incoming water quantities is abundant. We validate this phenomina through applyng our methodolgies to the real small hydraulic vertical water turbine system under constructing and testing in industrial facilities in Korea.

• Journal of Korea Water Resources Association
• /
• v.52 no.6
• /
• pp.397-409
• /
• 2019

Gate operation of hydraulic structures is important for proper management in rivers. In this study, the characteristics of flood time were analyzed and predicted using the HEC-RAS model, which is capable of one-dimensional and two-dimensional connectivity analysis of the main points downstream of the Geum river. As a result, flood travel time was decreased once discharge increase and downstream water level rising. However, When the floodplain was overflowed, the arrival time increased due to the rapid increase of the river width. Also, the same condition, flood wave travel time at the major point was approximately twice as fast as water level rising travel time, indicating that waves progressed faster than actually water. Using the results of this study, it will be helpful in the river.

• Journal of the Korea Concrete Institute
• /
• v.20 no.6
• /
• pp.797-807
• /
• 2008

For this study, the semi-adiabatic temperature rising test is accomplished by using ternary system cement (OPC, BFS, FA) reducing temperature crack. Two tests are conducted; one is for the paste test, and the other is for the concrete test. As the results of paste tests, using fly ash is better to reduce hydration temperature than doing blast furnace slag. In the case of the paste mixed ternary system cement, the more fly ash is mixed and the less blast furnace slag is used, the lower the temperature is. The less the mixture ratio of blast furnace slag is and the more the mixture ratio of fly ash is, the later the temperature rising velocity and descending velocity are. Besides, the temperature is lower if water/binder ratio is high. The use of ternary system cement has the retardation effect of temperature rising because the time to reach the maximum temperature is in the order of OPC100, binary system cement, and ternary system cement. From the test, the maximum temperature of concrete used ternary system cement is $8{\sim}11^{\circ}C$ lower than that of concrete used OPC100. Moreover, temperatures rising velocity and descending velocity of ternary system cement range $47{\sim}51%$ and $37{\sim}42%$ compared with OPC100. The specimen of concrete shows remarkable low internal temperature and slow temperature rising velocity and descending velocity compared with the specimen of paste because it is that temperature loss of concrete is much more than paste specimen according to aggregates.

• Journal of the Ergonomics Society of Korea
• /
• v.29 no.6
• /
• pp.869-874
• /
• 2010

The purpose of this study was to analyze the skin conductance level (SCL) induced by unexpected situation which reflected the emotional and cognitional responses during driving. The participants included 57 college graduates; 28 males aged $24.5{\pm}1.3$ with $2.3{\pm}1.5$ years of driving experiences and 29 females aged $23.6{\pm}2.6$ with $2.2{\pm}1.7$ years of driving experience. Reaction time of brake, averaged SCL, maximum SCL, and rising time to maximum amplitude were measured. They were analysed according to condition (crash, non-crash) and gender (male, female). The reaction time of brake was more faster and averaged SCL was greater during non-crash condition than during crash condition. There were no significant differences between male and female drivers in the reaction time of brake and averaged SCL whether or not it crash. There were no significant differences between crash and non-crash conditions in the maximum SCL and rising time to maximum amplitude, but there were significant differences between male and female in them. These results support the hypothesis that averaged SCL is more related to cognitional response and maximum SCL and rising time to maximum amplitude are more related to emotional responses.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2007.11a
• /
• pp.23-24
• /
• 2007

• Korean Journal of Community Nutrition
• /
• v.11 no.1
• /
• pp.25-38
• /
• 2006

This study was carried out to identify factors related to breakfasts in elementary, middle and high school students. This study was surveyed by questionnaires and data was analyzed by SPSS program. Exploratory analysis was conducted according to three school student groups (elementary children, middle school students, and high school students). The subjects were 1,886 school students (female 893, male 959) of 51 schools in the nationwide region. The distribution of subjects was elementary school children 544, middle school students 661 and high school students 681. The results are summarized as follows. Only sixty percent of the subjects had breakfast regularly. About one fourth of the subjects had the habit of skipping breakfast or eating it 2$\sim$3 times per week. Frequency of having breakfast and reasions of skipping breakfast were significantly different according to school student groups (p < 0.001 respectively). The rate of skipping breakfast was $14.4\%$ in elementary school, $16.1\%$ in middle school, and $25.0\%$ in high school. The main reason for skipping breakfast was 'not delicious or poor appetite' in elementary school ($42.5\%$), but 'busy' in middle ($50.2\%$) and high school ($61.1\%$). There was no significant difference in frequency of having breakfast according to living areas (rural and urban). There were not significant differences between frequency of having breakfast and BMI and degree of satisfaction on body weight. But there were significant difference in frequency of having breakfast according to economical status (p < 0.05). There were significant differences in degree of school performance according to frequency of having breakfast (p < 0.001) There was significant relationship between the time of attending school and the frequency of having breakfast. But there were significant relationships between frequency of having breakfast and time of rising. These findings suggested that the time of rising was controlled by having enough time that students eat breakfast. And mother (or person who prepares meals) must have more concerns about preparing breakfast for children and students.