• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.16 no.6
• /
• pp.406-412
• /
• 2023

In this paper, we studied the effect of noise caused by ambient light on a reflective PPG measurement device using infrared light. Noise caused by ambient light was examined by dividing it into general situations and special situations. In the general situation, noise due to changes in time and ambient light sources was randomly observed, and in the special situation, a halogen lamp was used to observe the effect of noise variations. In the experiment, PPG signals were measured and data acquired in real-time depending on each situation, and the measured data was analyzed in the time domain and frequency domain. First, through a general situation experiments, it was visually observed that noise increases with the brightness of ambient light, and through frequency analysis, it was observed that the noise sources were white noise, power line noise, and internal noise of the circuit. Futhermore, using a halogen lamp, we experimented with the change in noise depending on the change in distance from the ambient light and calculated the SNR. As a result of the experiment, an SNR of 3.2 dB was shown at a distance of 50 cm with an irradiance of 278.3 W/m². It was observed that normal measurement was difficult at SNRs below that, and an irradiance of 27.7 W/m² was obtained. It showed a value of 18.2 dB at a distance of 2 m, and it was observed that normal PPG measurement was possible through a filter at values above that.

• The KIPS Transactions:PartB
• /
• v.9B no.6
• /
• pp.745-752
• /
• 2002

The purpose of the paper is to enable a format transcoding between a heterogeneous compression format in a real time, and to enhance the compression ratio using characteristics of the compressed frame. In this paper, for the heterogeneous format transcoding, we tried to transcode from MPEG2 having a lower compression ratio to H.263 having a higher compression ratio. After analyzing MPEG 2 bit stream and H.263 bit stream of the same original video, we found that the number of intra coded macro blocks in MPEG 2 data is much higher than the number of the intra coded macro blocks in H.263 data. In the process of P frame generation, a intra coded macro block is generated when a motion estimation value representing the similarity between the previous frame and current frame does not meet a threshold. Especially the intra coded macro block has a great impact on the compression ratio. Hence the paper, we tried to minimize the number of intra coded macro blocks in H.263 data stream which is transcoded from MPEG 2 in a compressed domain. For the purpose, we propose a guided search method for transcoding the INTRA coded block into INTER coded block using the information about motion vectors surrounding the intra macro block in order to minimize the complexity of the motion estimation process. The experimental results show that the transcoding of MPEG 2 into H.263 can be done in a real time successfully.

• Journal of Korea Water Resources Association
• /
• v.39 no.7 s.168
• /
• pp.605-615
• /
• 2006

In order to analyze movement of soil moisture, Time Domain Reflectometry(TDR) with multiplex system has been installed at the Bumreunsa hillslope of Sulmachun Watershed to configure spatial-temporal variation pattern considering seasonal characteristic. An intensive surveying was performed to build a refined digital elevation model(DEM) and flow determination algorithms with inverse surveying have been applied to establish an efficient soil moisture monitoring system. Soil moisture data were collected through an intensive and long term monitoring 380 hrs in November of 2003 and 1037 hrs in May and June of 2004. Soil moisture data shows corresponding variation characteristics of soil moisture on the up slope, buffer, main channel zones of the hillslope which were classified from terrain analysis. Measured soil moisture data were discussed in conjunction with flow characteristic through terrain analysis. Regardless season, immediate responses of soil moisture about rainfall looks similar but recession and recharge are primary characteristics of intermediate soil moisture variation for spring to summer and fall to winter season, respectively.

• Journal of the Korean Home Economics Association
• /
• v.39 no.6
• /
• pp.25-40
• /
• 2001

The purpose of this study was to find out the amount of the household work time related to food and examine the factors affecting the time accomplished by married female home-based workers and on-site workers. The data were collected from 165 married female home-based workers, and 292 married female on-site workers in Pusan and Kyungnam province, by the self-administered questionnaire. frequency distributions, Cronbach's alpha, t-tests, Pearson's correlations, and multiple regression analyses were conducted by SPSS/PC+. The major findings of this study were as follows: (1) both married female home-based and on-site workers spent more time on household work related to food in a weekend than in a weekday, (2) in a weekday, occupation was significantly related to the amount of time that married female home-based workers spent on food household work, whereas age and occupation were significant for married female on-site workers, (3) on Saturday, the significant factors of the time spent on food household work were the number of family and occupation for married female home-based workers, and educational level, occupation, sex role attitude, existence of children of 6 years or under, and existence of elders/disability within the family for married female on-site workers, and (4) on Sunday, for married female home-based workers, the number of family, occupation, and the level of market good substitution had significant effects on the amount of time spent on food household work, and for married female on-site workers, age, the number of family, occupation, sex role attitude, work hours on Sunday, and the level of market good substitution were significant.

• Journal of Korea Water Resources Association
• /
• v.47 no.7
• /
• pp.599-614
• /
• 2014

In this study, two dimensional finite volume model was parallelized to improve computing time, which has been developed to be able to apply for the mixed meshes of triangle and quadrilateral. MPI scheme which is free from limitation of the number of cores was applied, and non-blocking point-to-point communication was used for fluxes and time steps calculation domain. The developed model is applied to analyze dam break in a L-shaped experimental channel with $90^{\circ}$ bend and Malpasset dam breach event to calibrate the consistency between parallelized model and existing model and examine the speed-up and efficiency of computing time. Computational speed-up about the size of the input data was considered by simulating 4 cases classified by the number of meshes, Consequently, the simulation results reached a satisfactory accuracy compared to measured data and the results from existing model, and achieved more than 3 times benefit of computational speed-up against computing time of existing model. Simulation results of 3 cases classified by the size of input data lead us to the conclusion that it is important to use proper size of input data and the number of process in order to minimize the communication overhead.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.6
• /
• pp.135-140
• /
• 2015

The Cyber-Physical Systems (CPS) complexly perform modeling and simulation (M&S) for the various embedded systems. In this case, due to use diverse formatted models, we suggest to apply with the SEDRIS to systematically manage the different formatted data on M&S. The SEDRIS can reduce time and cost with reusing and interoperating environment data developed in the specific domain. To do this, we should input the data transformed the height map for terrain representation in a simulator into raster data of SEDRIS for which interoperate between the existed simulator and the SEDRIS. To solve the problem, we propose the transformation method to transfer the polygon data from RAW file used in terrain representation. With the proposed method, we can provide two advantages. First, it can possibly express the environment data into SEDRIS. Second, we can see the terrain like an image file through a viewer. Therefore, even non-expert easily constructs the terrain environment data.

• Journal of Internet Computing and Services
• /
• v.24 no.5
• /
• pp.17-27
• /
• 2023

Today, as AI (Artificial Intelligence) technology develops and its practicality increases, it is widely used in various application fields in real life. At this time, the AI model is basically learned based on various statistical properties of the learning data and then distributed to the system, but unexpected changes in the data in a rapidly changing data situation cause a decrease in the model's performance. In particular, as it becomes important to find drift signals of deployed models in order to respond to new and unknown attacks that are constantly created in the security field, the need for lifecycle management of the entire model is gradually emerging. In general, it can be detected through performance changes in the model's accuracy and error rate (loss), but there are limitations in the usage environment in that an actual label for the model prediction result is required, and the detection of the point where the actual drift occurs is uncertain. there is. This is because the model's error rate is greatly influenced by various external environmental factors, model selection and parameter settings, and new input data, so it is necessary to precisely determine when actual drift in the data occurs based only on the corresponding value. There are limits to this. Therefore, this paper proposes a method to detect when actual drift occurs through an Anomaly analysis technique based on XAI (eXplainable Artificial Intelligence). As a result of testing a classification model that detects DGA (Domain Generation Algorithm), anomaly scores were extracted through the SHAP(Shapley Additive exPlanations) Value of the data after distribution, and as a result, it was confirmed that efficient drift point detection was possible.

• Journal of Information Processing Systems
• /
• v.2 no.1
• /
• pp.13-17
• /
• 2006

In this paper, we propose an audio extraction method to decrease the influence of the original signal by modifying the watermarking detection system proposed by P. Bassia et al. In the extraction of the watermark, we employ a simple mean filter to remove the influence of the original signal as a preprocessing of extraction and the repetitive insertion of the watermark. As the result of the experiment, for which we used about 20 kinds of actual audio data, we obtain a watermark detection rate of about 95% and a good performance even after the various signal processing attacks.

• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 2000.10a
• /
• pp.41-48
• /
• 2000

We have installed the borehole seismic recording system at Hyodongri in eastern part of Kyungsan Basin, which has the advantages of reduction in noise by human activities and distorting effects of near-surface rocks. Here we describe briefly the borehole seismic station and recording system. And we analyse the characteistics of back ground the station obtained from borehole sensors. The back ground noise level in time domain is about 50~100$\mu$cm/sec. The average curve of noise spectrum is lower than NHNM(New High Noise Model)of GSN(Global Seismic Network)operated by USGS. The results could be useful prior information for study on earthquake records observed at Hydongri station.

• Journal of computational fluids engineering
• /
• v.15 no.2
• /
• pp.35-40
• /
• 2010

In the present work, LES with new variational multiscale method is conducted on the fully developed channel flow with Reynolds number, 180 based on the friction velocity and the channel half width. Incompressible Navier-Stokes equations are integrated using finite element method with the basis function of NURBS. To solve space-time equations, Newton's method with two stage predictor multicorrector algorithm is employed. The code is parallelized using MPI. The computational domain is a rectangular box of size $2{\pi}{\times}2{\times}4/3{\pi}$ in the streamwise, wall normal and spanwise direction. Mean velocity profiles and velocity fluctuations are compared with the data of DNS. The results agree well with those of DNS and other traditional LES.