• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.25 no.4
• /
• pp.207-218
• /
• 2013

This study is based on a series of numerical modeling experiments to understand the circulation and its change in the Chunsu Bay (CSB), Yellow Sea of Korea. A skill analysis was performed for the tidal height and tidal current of the observation data using the amplitude and phase of the 4 major tidal constituents respectively for verification of modeling experimental results. As a result, most of the skill score was seen to be over 90%, so numerical model experiment results can be said to be in good agreement with the observed tidal height and tidal current. Tidal wave proceeded from the entrance of the CSB towards inside, and the tidal range gradually increased to the north. It took about 10 to 30 minutes for the tidal wave to reach to northern end. The tidal wave showed a characteristic to rotate counter-clockwise in the southern part. The tidal current flowed to the north-south direction along the bottom topography; the angle of the major axis appeared alongside the isobath. It showed the characteristics of reversing tidal current with the minor axis less than 10% of the major axis. The strength of the tidal residual current that is influenced by geographical factors including bathymetry and coastline showed the range of 1~30 cm/sec, greater in the south channel and smaller in northern Bay. Two pairs of cyclonic/anti-cyclonic eddies around Jukdo and 3~4 pairs of strong eddies at the southern part of CSB in hundreds of m to a few km size by relative vorticity derived from the tidal residual current.

• Journal of Ocean Engineering and Technology
• /
• v.23 no.1
• /
• pp.109-113
• /
• 2009

Several tidal current power plants are being planned and constructed in Korea utilizing the strong tidal currents along the west and south coasts. A tidal current reaches 9.7 m on the west coast; there are few potential regions for tidal current power generation. The construction of a dam to store water can prevent the circulation of water, causing a great environmental impact on the coast and estuary. The tidal barrage could produce a large amount of power, but it should be carefully considered. The purpose of developing renewable energies is to minimize the environmental impact and to maximize the utilization of clean energy. To produce a great quantity of power, tidal current farms require the placement of numerous units in the ocean. The power generation is very dependent on the size of the rotor and the incoming flow velocity. Also, the interactions between devices contribute greatly to the production of power. The efficiency of a power farm is estimated to determine the production rate. This paper introduces 3 D interaction problems between rotating rotors, considering the axial, transverse, and diagonal distances between horizontal axis tidal current devices.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.517-520
• /
• 2006

The Korean peninsula has a number of coastal sites where the rhythmic rising and lowering of water surface due to tides results in strong tidal current. The kinetic energy of these currents can be efficiently exploited by use of tidal current turbines. The pilot tidal current power plant is to be constructed at the Uldolmok narrow channel between J info and Haenam, Our ins next Year, and extensive coastal engineer ing research works have been carried out. This paper describes and analyzes some observation results of field test about the efficiency of Helical turbine for tidal current power plant. The efficiency of turbine, which is diameter 2.2m and height 2.5m, is evaluated meximum RPM, torque, and current velocity. The tested turbines had the maximum efficiencies of the bounds of 25 to 35% in the current velocity range between 1.4 and 2.6 m/s. This result shows that the pilot tidal current power plant needs three helical turbines with diameter 3.0m and height 3.6m to produce electric power 500kW.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.11a
• /
• pp.610-613
• /
• 2009

Uldolmok tidal current power plant was constructed on May 2009 at Jindo Gun in Korea. However it had much trouble in installing structure due to the extremely fast tidal current velocity(max. 5.5m/sec) and the jacket type plant structure. Therefore in this paper, The characteristics of tidal current and sea bed topography at Uldolmok tidal current plant site are investigated, and the detailed foundation work process of the plant is described.

• Journal of the Korean Society for Precision Engineering
• /
• v.31 no.8
• /
• pp.665-670
• /
• 2014

In this paper, characteristics of a tidal current power generation system are analysis using power hardware-in-the-loop simulation (PHILS). A 10 kW motor generator set is connected to the real grid through a fabricated 10 kW back to back converter. A power control scheme is applied to the back to back converter. A 2 MW class tidal current turbine is modeled in real time digital simulator (RTDS). Generating voltage and current from the 10 kW PMSG is applied to a 2 MW class tidal current turbine in the RTDS using PHILS. The PHILS results depict the rotation speed, power coefficient, pitch angle, tip-speed ratio, and output power of tidal current turbine. The PHILS results in this paper can contribute to the increasing reliability and stability of the tidal current turbines connected to the grid using PHILS.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.11a
• /
• pp.169.1-169.1
• /
• 2010

Due to global warming, the need to secure an alternative resource has become the international issue. Not like other renewable energy sources, TCP is the high reliable and predictable and continuous energy source as the current pattern and speed can be predicted throughout the year. Having very strong tidal current speeds, there are many suitable site for the application of TCP (Tidal Current Power) on the west and south coastal region in Korea. The maximum current speed in the south is recorded up to 6.5m/s. Due to the high tidal current speed on the west coast of Korea, numerous tidal current projects are being planned. To extract a significant quantity of power, a tidal current farm with number of devices is required in the ocean. However, it is important to estimate the potential quantity of energy in the area. Also the realistic quantity that can be extracted is to be investigated. Based on the estimated energy production considering the number of devices and the interactional effects, system type, the water depth and etc., the cost of the development and the benefit from SMP can be estimated. The feasibility study for the 200MW tidal in Incheon, Korea has been performed recently. Based on the actual feasibility study, the procedure and the key points for the application of tidal current power farm are introduced in the paper.

• Journal of Korean Port Research
• /
• v.12 no.1
• /
• pp.95-104
• /
• 1998

Water pollution in a semi-enclosed sea area such as a bay due to stagnancy of water has been a serious water environmental problem. Recently, some kinds of new methods to activate the tidal exchange between an inner bay and an outer sea area by control of a tidal residual current have been proposed. However, these methods have several problems, that is, I). deterioration in a natural view due to building of huge structures, II). increase of risk of navigation in case of a submerged structure, III). limition of sea area where a tidal current can be controlled and IV). difficulty in removing those structures in case of occurrence of an unexpected impact on water environment. In this paper, a new method is proposed, which can solve all the above problems, to purify water quality in a semi-enclosed bay by creation and control of a pattern of a tidal residual current. The tidal residual current is controlled by unsymmetric structures, which change the properties of resistance according to the direction of flow, arranged on the sea bottom. In this study, several numerical and hydraulic experiments of tidal current and particle-tracking for various arrangements of bottom roughness in a semi-enclosed model bay were carried out. As a result of experiments, it becomes clear that it is possible to generate a new tidal residual current and to activate a tidal exchange by only operation of bottom roughness arrangement.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.58 no.2
• /
• pp.159-174
• /
• 2022

Flow prediction was carried out through observational survey and three dimensional multi-layered numerical diagnostic model experiment to clarify the time and spatial structure of tidal current and residual flow dominant in the sea exchange and material circulation of the waters around Geumo Islands in the southern waters of Korea. The horizontal variation of tidal current is so large that it causes asymmetric tidal mixing due to horizontal eddies and the topographical effect creating convergence and dispersion of flow direction and velocity. Due to strong tidal currents flowing northwest-southeast, counterclockwise and clockwise eddies are formed on the left and right sides of the south of Sori Island. These topographical eddies are created by horizontal turbulence and bottom friction causing nonlinear effects. Baroclinic density flows are less than 5 cm/s at coastal area in summer and the entire sea area in winter. The wind driven currents assuming summer and winter seasonal winds are also less than 5 cm/s and the current flow rate is high in winter. Density current in summer and wind driven current in winter have a relatively greater effect on the net residual flows (tidal residual current + density current + density driven current) around Geumo Islands Sea area.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.15 no.3
• /
• pp.110-114
• /
• 2010

A data set of current, wind and wave height measured at the monitoring buoy and sea level at Busan harbor were analyzed to explain the physical conditions during the strong rip current events at Haeundae Beach of Suyeong Bay during 13~15 August 2009. Tidal current, with spring-neap variations, has similar average speed to the short-term non-tidal currents. The common features at the time of rip currents are the strong northeasterly wind and superposition of tidal and non-tidal currents both flowing toward the coast. However on 14 August when the rip current did not occur, tide and wave height were similar to the rip-current cases but the tidal and non-tidal current were to nearly opposite directions. While strong winds produce large waves thus the basic condition for rip current but its influence on the local circulation in the bay is relatively small. Of the three adjacent beaches, only at Haeundae the rip currents are reported. This difference may be due to the unique bottom topography featured by underwater hill in the central region off Haeundae which can decay the incoming waves, tides and currents to intensify the rip current.

• Journal of the Korean Solar Energy Society
• /
• v.36 no.1
• /
• pp.75-81
• /
• 2016

The west and south coastal regions of Korea are known to be of strong tidal current speed. With the increasing demand for renewable energies, the resource assessment has been a crucial issue which should be conducted before any detail planning and development of the potential sites for tidal current farm. Although there are several results of resource assessment of tidal current energy in Korea, the resource assessment method is not officially announced. This undefined methodology makes the results unreliable and useless. Recently new renewable energy potential definition has been announced by KIER (Korea Institute of Energy Research). This categorizes energy potential as four steps; theoretical, geographical, technical and market potentials. This paper describes the resource assessment of tidal current power in Korea based on API (Averaged Power Intercepted). The results show that the Incheon-Gyeonggi and Jeollanam-do are very promising areas for tidal current power in Korea.