• Journal of Environmental Science International
• /
• v.8 no.2
• /
• pp.227-231
• /
• 1999

This study was conducted to investigate the removal characteristics of $PO_4^{3-}-P$ contained in livestock wastewater using waste concrete. With small particle size, increased dosage and temperature of water, $PO_4^{3-}-P$ was well removed by waste concrete.$PO_4^{3-}-P$ was removed by adsorption reaction in low pH of the primary phase, but the crystallization reaction predominated for increasing pH with passed time. As a result of adapting the adsorption isotherm equation, $PO_4^{3-}-P$ removal was more affected by the crystallization reaction than the adsorption reaction. In the SEM micrograph, there was no evident change on the waste concreter surface. Particle size was plate-phase before reaction but appeared a dense form to progress in the crystallization reaction.

• Journal of environmental and Sanitary engineering
• /
• v.14 no.4
• /
• pp.172-179
• /
• 1999

In this research, biological treatability test was conduced using seawater flocculated tannery wastewater by fixed biofilm reactor. During one cycle, the removal efficiency of organic corbon obtained with fixed biofilm process for treating tannery wastewater was considerably greater than that with activated sludge process. As the hydraulic retention time increased form 0.5day to 4day, removal efficiency of organic carbon was increased from 72% to 87.3%. Attached biomass in media increased with influent organic loading up to 29g MLSS/L, that could reduce the specific organic loading rate. The continual measurement of attached biomass was possible for the operation of the biofilm reactor. Equal and low nitrication rates were observed in both suspended growth activated sludge process and fixed biofilm process, despite commercial nitrifier was seeded. Through the process of treating the tannery wastewater, EC50 values which is measured by the use of Ceriopdaphnia dubia, were decreased to the extent of 50% after treatment of seawater flocculation and of 83% after biological treatment, respectively, compared to those of the untreated wastewater.

• Journal of environmental and Sanitary engineering
• /
• v.20 no.2 s.56
• /
• pp.47-55
• /
• 2005

The World Health Organization(WHO, 1998) and the United States Environmental Protection Agency (USEPA, 1992) recommended $2{\mu}\;guranium/{\ell}$ in drinking water as a guideline. The Korea Institute for Environmental Research recently reported that the radioactive pollution in ground water was almost negligible In Korea$(1999\~2002)$. Cs were cast into beads(2mm in wet form) and treated with hexamethylene diisocyanate for stability in acidic aqueous solution through cross-linking of the beads surfaces. The removal study was carried out in a static batch system and a flow system. In the static system, a certain amount of sample water was confined in a vessel and beads(dry weight 0.5g) were packed into it in order to adsorb uranium for a certain period of time. Afterwards the remaining uranium in water vessel was determined by inductively coupled plasma mass spectrometry. The effective pH range was 4 to 8. The smaller the size of beads, the better the removal efficiency. Furthemore, the lower the flow rates, the higher the removal efficiency. The results showed that chitosan beads can be effectively used for the removal of uranium contained in water.

• The Journal of Advanced Prosthodontics
• /
• v.3 no.2
• /
• pp.106-109
• /
• 2011

Oral cancer treatment involves the surgical removal of all or part of the maxilla, leaving the patient with a defect that compromises the integrity and function of the oral cavity. The postoperative restoration of esthetics, deglutition, and speech shortens recovery time in the hospital and expedites the patient's return to the community as a functioning member. The surgical obturator is the proven treatment option in such situations. This article describes a simple technique to fabricate a surgical obturator that restores patient's original dentition and facial and palatal tissue form. The obturator fabricated with this technique utilizes the vacuum formed index of patient's original tissue form and duplicated partly in heat and partly in auto polymerizing acrylic resin. Duplication of the original tissue form helps patient to minimize the immense physiological trauma immediately after the surgical resection. The obturator fabricated with this technique supports soft tissues after surgery and minimizes scar contracture and disfigurement, and thus may have a positive effect on the patients' psychology.

• Journal of Environmental Health Sciences
• /
• v.27 no.3
• /
• pp.43-48
• /
• 2001

Terephthalic acid and ethylene glycol resulting form the weight-reduction process of polyester make trouble in the operation of activated sludge process. Also, polyester weight loss wastewater shows high pH, high organic strength and wide variation of organic loading. Therefore, this study was conducted in order to improve treatment efficiency by activated sludge process with Pseudomonas sp degrading components of polyester weight loss wastewater. The CO $D_{Mn}$ and BO $S_{5}$ of the waste wastewater were 560~3,000 mg/$\ell$ and 8000~3,000 mg/$\ell$, respectively. pH was 11.8~12.3. COD removal efficiency by activated sludge-coagulation process with Pseudomonas sp was 94.1~95.8% for 35 hr of hydraulic retention time. Total organic carbon removal efficiency was 97.1%. Ethylene glycol and terephthalic acid in the wastewater were completely degraded during 32 hr of hydraulic retention time.e.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1998.04a
• /
• pp.249-254
• /
• 1998

Recently, high quality architectural concrete, i.e., appearance of natural stone and a marbling effect, is needed, to achieve high quality glassy reflective surface for outer wall of the building. In this study to achieve above characteristics of the "glossing exposure concrete" we developed a form practice and the best mix proportion and derived the optimistic removal time of form to bring out the durable glassy reflective surface and durable concrete. Hereby with the "glossing exposure concrete" obtained we applicate for first time, to Electronics and Telecommunications Research Institute situated on Taedok Science Town and it will be the beginning of the construction of "glossing exposure concrete" in this country.oncrete" in this country.ntry.

• Journal of the Korea Concrete Institute
• /
• v.13 no.6
• /
• pp.629-636
• /
• 2001

To apply the research results to the design and the construction of the high rise buildings, long-term behavior of reinforced concrete structure have been widely studied. However, shoring and reshoring at early ages have not been considered in the most of studies. The removal of forms and shores has been dealt with one construction sequence. i.e. the deformation occurred at the early age before the removal of shore has been neglected. In this paper, two-dimensional frame analysis program for long-term behavior of reinforced concrete was developed. In the developed program, construction sequence including the settlement and the removal of shores is considered to predict axial force variation due to forms ,shores, and time-dependent concrete stiffness. Analysis results show that the time-dependent axial force of shores is reduced, and the redistributed axial force of the interior column is greater than the value by elastic analysis and that of the exterior column is smaller. In order to demonstrate the validity of this program, the test frame was constructed in sequence of the placement of concrete, form removal, reshoring, shore removal, and the application of additional load. The proposed program predicts experimental results well.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1993.06a
• /
• pp.121-124
• /
• 1993

This paper is a study on the word recognition using neural network. A limited vocabulary, speaker independent, isolated word recognition system has been built. This system recognizes isolated word without performing segmentation, phoneme identification, or dynamic time wrapping. It needs a static pattern approach to recognize a spatio-temporal pattern. The preprocessing only includes preceding and tailing silence removal, and word length determination. A LPC analysis is performed on each of 24 equally spaced frames. The PARCOR coefficients plus 3 other features from each frame is extracted. In order to simplify a structure of neural network, we composed binary code form to decrease output nodes.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.12
• /
• pp.1310-1315
• /
• 2006

This study examines algae removal and reduction using ultrasonic. Experiments were carried out on frequency: 28 kHz single-wave, 40 kHz multi-wave; intensity: 10, 15, 20, 25, 30 W/L; algae concentration: 500, 1000, 1700/ml; exposure time: 1, 3, 5, 7, 10, 15, 20 min. Also, We investigated algae removal and reduction in single cistern where raw water including algae was directly exposed to ultrasonic and in the double cisterns located in 4 cm from ultrasonic vibrator. The algae type used in this study was Melosira genus of Bacillariophceae. The Bacillariophceae is the representative algae which causes blockage of filter basin. Because of its resistance against oxidizers, it flows into the filter basin after sterilization. As a result of this study, the form of Bacillariophceae was completely destroyed and dissolved after the application of ultrasonic waves unlike the sterilization using oxidizers. Removal efficiency of algae using ultrasonic waves increased in proportion to intensity and exposure time of ultrasonic waves, and in double cisterns is better than single cistern.

• Membrane and Water Treatment
• /
• v.1 no.4
• /
• pp.283-296
• /
• 2010

During the disinfection of potable water, humic substances present in the solution react with chlorine to form potential carcinogenic compounds. This study evaluates the feasibility of using a submerged membrane photocatalysis reactor (SMPR) process for treatment of humic substances through the characterization of both organic removal efficiency and membrane hydraulic performance. A simple SMPR was operated and led to the removal of up to 83% of the polluting humic matters. Temporal rates of organic removal and membrane fouling were found to decrease with filtration time. Using tighter membrane in the hybrid process resulted in not only higher organic removal, but also more significant membrane fouling. Under the experimental conditions tested, optimum $TiO_2$ concentration for humic removal was found to be 0.6 g/L, and increasing initial pollutant concentration expectedly resulted in a more substantial membrane fouling. The importance of the influent nature and pollutant characteristics in this type of treatment was also assessed as various water sources were tested (model humic acid solution vs. local water containing natural organic matters). Results from this study revealed the promising nature of the SMPR process as an alternative technique for organic removal in the existing water treatment system.