• 대한방사선기술학회지:방사선기술과학
• /
• 제9권1호
• /
• pp.73-81
• /
• 1986

This paper carried out an experiment on the characteristics of time, temperature, electric field and the dependense of electrode materials and gap length by the conduction current of the insulating oil used for x-ray tube housing. The obtained results can be summarized as following: 1. In the x-ray tube housing insulating oil with vacuum condition, conduction current is declined more than the x-ray tube housing insultaing oil with the air, and is held stable states. 2. At the low electric field the higher temperature of the x-ray tube housing insulating oil is increased, the more conduction current. 3. The dependence of electrode material is appeared at the low electric field and the short gap length than the high and the long with Fe> Cu >Al. 4. At the I-E characteristics, the low electric field than 1000 [V/cm] is appeared Ohm's law region, and the high become saturation region. 5. At the same electric field, the longer gap length become, the more conduction current is increased, and the same applied voltage, the longer, the less conduction current is decreased, the less low than high temperature x-ray tube housing insulating oil.

• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 1996년도 제23회 춘계학술대회
• /
• pp.99-107
• /
• 1996

Examined in this paper is the effect of B$_{4}$C addition on the frictional characteristics of Cu-Sn based sintered friction material. For the specimens 1%, 2% and 4% of B$_{4}$C were added into the reference material. A pin-on-disk type friction tester was used to measure the friction and wear with respect to the surface temperature and sliding distance. Wear mechanism of each specimen is analyzed in the view point of the oxide film formation. The specimen containing 4% of B$_{4}$C showed stable friction and low wear since the oxide film was sustained up to higher surface temperature ranges.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2010년도 추계학술대회 초록집
• /
• pp.198.2-198.2
• /
• 2010

Three dimensional numerical analysis of the oxygen and air were performed to investigate the combustion characteristics in a Corner-type pulverized coal boiler. With the actual operation data of the power plant, the distribution of velocity, gas temperature, $O^2$, $CO_2$, $H_2O$, $N_2$ as well as the particle tracking in the boiler were investigated. The predicted values at the outlet of furnace for the gas temperature and major species concentrations gave a good agreement with the designed values. The present analysis on combustion characteristics in a boiler would provide the useful information for the stable boiler operation and in trouble shooting boiler problem.

• 전기학회논문지
• /
• 제59권6호
• /
• pp.1083-1086
• /
• 2010

The $Sr_{0.7}Bi_{2.3}Nb_2O_9$ thin films were deposited on Si substrate using RF magnetron sputtering method. And the SBN thin films were annealed at 650~800$[^{\circ}C$]. The surface rougness showed about 0.42[nm] in annealed thin film at $650[^{\circ}C$]. The dielectric constant(150) of SBN thin film was obtained by annealing temperature above $700[^{\circ}C$]. The voltage dependence of dielectric loss showed a value within 0.02 in voltage ranges of -10~＋10[V]. The dielectric constant characteristics showed a stable value with the increase of frequency. Also, the SBN thin films annealed at $750[^{\circ}C$] showed a fatigue-free characteristics up to $1.0\times10^8$ cycles.

• 한국미생물·생명공학회지
• /
• 제27권6호
• /
• pp.466-470
• /
• 1999

Protease production and its characteristics were investigated with Mucor racemosus f. racemosus PDA 103 which was isolated from Korean traditional meju. Optimum culture conditions of the strain for the production of the protease in basic medium[bean(Baektae):H2O=1:1(w/v)] were as follows: pH 6, 3$0^{\circ}C$ and 72hrs. Optimum pH and temperature for the enzyme activity of the protease produced by Mucor racemosus f. racemosus were pH 5 and 5$0^{\circ}C$, respectively. The enzyme was relatively stable a pH2.0~5.0 and at temperature below 4$0^{\circ}C$. Phenylmethane-sulfonyl fluoride and Ag+ inhibited the enzyme activity. This indicates that the enzyme is serine protease. Km value was 0.9$\times$10-4M and Vmax value was 5.93$\mu\textrm{g}$/min. This enzyme hydrolyzed casein more rapidly than bovine albumin.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2001년도 제23회 KOSCO SYMPOSIUM 논문집
• /
• pp.73-82
• /
• 2001

The characteristics of the catalytically supported thermal combustion with Pd-based catalyst using the bench scale high pressure combustor has been investigated up to 7 atm. The emission of $NO_{\chi}$ depends on the preheating temperature and the excess air ratio. Most $NO_{\chi}$ emission seems to come from the pre-burner for the preheating of the inlet gas. Decreasing excess air ratio in the inlet gas below 1.5 results in the stable catalytically supported thermal combustion in the post combustion region while the $NO_{\chi}$ emission increased up to 15 ppm. Further, the increase of the pressure shows the dramatic increase of the emission CO and THC. However, the $NO_{\chi}$ emission decreased slightly due to the lower combustion temperature at the high pressure.

• 한국연소학회지
• /
• 제13권3호
• /
• pp.24-32
• /
• 2008

Steady Laminar Flamelet Model (SLFM) calculation is performed to compare the turbulent combustion characteristics of air combustion and oxy-combustion with $CO_2$ recirculation. Radiative heat loss is considered by the optically thin limit assumption. For more realistic simulation the first-order conditional moment closure(CMC) model is applied to SANDIA PILOTED FLAME D again for the oxidants of air and mixture of $O_2$ and $CO_2$. The chemical kinetic machanism for methane is GRI Mech 3.0. Results show that oxy flames are much more stable than air flames, while comparable stability is maintained with 65% $CO_2$ recirculation. The comparable peak temperature is maintained with 80% $CO_2$ recirculation. Higher the temperature, higher the fractions of intermediate species, CO and OH, due to dissociation.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집
• /
• pp.185-189
• /
• 2002

Flexible displays such as plastic based LCDs and organic light-emitting diodes for mobile communication devices have been researched and developed at KETI in KOREA since 1997. The Plastic film substrate has so poor thermal tolerance and non-rigidness that the fabrication of active devices and panel assembly have to perform at low temperature and pressure. In addition, high thermal expansion of the substrate is also a serious problem for reliable metallic film deposition. In this paper, we investigated particularly on the fundamental characteristics of various plastic substrates and then, suggested novel methods that improve the fabrication processes of plastic LCD panel. In order to maintain stable substrate surface and uniform cell gap during panel assembly, we utilized newly-invented iii and vacuum chuck. Electro-optical characteristics of fabricated plastic LCD are better than or equivalent to those of typical glass based LCDs though it is thinner, lighter-weight and more robust.

• 한국태양에너지학회 논문집
• /
• 제34권6호
• /
• pp.85-92
• /
• 2014

This study carried out experimental on the cooling characteristics of clathrate compound including TMA(Tri-Methyl-Amine ; $(CH_3)_3N$) as a low temperature latent heat storage material. And additive was used for subcooling improvement of TMA-water clathrate compound. The conclusion of above study is as following ; TMA 25wt%-water clathrate compound is shown stable phase change and low subcooling degree. The subcooling was improved in the case ethanol($CH_3CH_2OH$) 0.5wt% is added to TMA 25wt%-water clathrate compound.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2011년도 제40회 동계학술대회 초록집
• /
• pp.252-253
• /
• 2011

ZnO-based thin film transistors (TFTs) are of great interest for application in next generation flat panel displays. Most research has been based on amorphous indium-gallium-zinc-oxide (IGZO) TFTs, rather than single binary oxides, such as ZnO, due to the reproducibility, uniformity, and surface smoothness of the IGZO active channel layer. However, recently, intrinsic ZnO-TFTs have been investigated, and TFT- arrayss have been demonstrated as prototypes of flat-panel displays and electronic circuits. However, ZnO thin films have some significant problems for application as an active channel layer of TFTs; it was easy to change the electrical properties of the i-ZnO thin films under external conditions. The variable electrical properties lead to unstable TFTs device characteristics under bias stress and/or temperature. In order to obtain higher performance and more stable ZnO-based TFTs, HZO thin film was used as an active channel layer. It was expected that HZO-TFTs would have more stable electrical characteristics under gate bias stress conditions because the binding energy of Hf-O is greater than that of Zn-O. For deposition of HZO thin films, Hf would be substituted with Zn, and then Hf could be suppressed to generate oxygen vacancies. In this study, the fabrication of the oxide-based TFTs with HZO active channel layer was reported with excellent stability. Application of HZO thin films as an active channel layer improved the TFT device performance and bias stability, as compared to i-ZnO TFTs. The excellent negative bias temperature stress (NBTS) stability of the device was analyzed using the HZO and i-ZnO TFTs transfer curves acquired at a high temperature (473 K).