• Journal of radiological science and technology
• /
• v.38 no.4
• /
• pp.451-461
• /
• 2015

In megavoltage (MV) radiotherapy, delivering the dose to the target volume is important while protecting the surrounding normal tissue. The purpose of this study was to evaluate the modulation transfer function (MTF), the noise power spectrum (NPS), and the detective quantum efficiency (DQE) using an edge block in megavoltage X-ray imaging (MVI). We used an edge block, which consists of tungsten with dimensions of 19 (thickness) ${\times}$ 10 (length) ${\times}$ 1 (width) $cm^3$ and measured the pre-sampling MTF at 6 MV energy. Various radiation therapy (RT) devices such as TrueBeam$^{TM}$ (Varian), BEAMVIEW$^{PLUS}$ (Siemens), iViewGT (Elekta) and Clinac$^{(R)}$iX (Varian) were used. As for MTF results, TrueBeam$^{TM}$(Varian) flattening filter free(FFF) showed the highest values of $0.46mm^{-1}$ and $1.40mm^{-1}$ for MTF 0.5 and 0.1. In NPS, iViewGT (Elekta) showed the lowest noise distribution. In DQE, iViewGT (Elekta) showed the best efficiency at a peak DQE and $1mm^{-1}DQE$ of 0.0026 and 0.00014, respectively. This study could be used not only for traditional QA imaging but also for quantitative MTF, NPS, and DQE measurement for development of an electronic portal imaging device (EPID).

• Journal of IKEEE
• /
• v.28 no.3
• /
• pp.382-389
• /
• 2024

In this paper, a design of dynamic braking resistor for stationary mode of azimuth driving equipment (ADE) for multi-function radar (MFR) is presented. The ADE carries out missions which is the rotation mode for all directions and the stationary mode for tracing a subject with standstill. The ADE has to transfer the operation mode in demand time from rotation mode to stationary mode for precise target tracing. During the transition with deceleration, it may cause the fault of input power device due to back-electromotive force (back-EMF) of PMSM with generator mode. To protect the power device, a design of dynamic braking resistor is essential for consuming back-EMF. This paper presents the development of dynamic braking resistor for consuming back-EMF of ADE with deceleration mode. The validity and effect of the design is verified using simulation results.

• International Journal of Highway Engineering
• /
• v.18 no.2
• /
• pp.73-82
• /
• 2016

PURPOSES: The national highways and expressways in Korea constitute a total length of 17,951 km. Of this total length of pavement, the asphalt pavement has significantly deteriorated, having been in service for over 10 years. Currently, hot in-place recycling (HIR) is used as the rehabilitation method for the distressed asphalt pavement. The deteriorated pavement becomes over-heated, however, owing to uncontrolled heating capacity during the pre-heating process of HIR in the field. METHODS: In order to determine the appropriate heating method and capacity of the pre-heater at the HIR process, the heating temperature of asphalt pavement is numerically simulated with the finite element software ABAQUS. Furthermore, the heating transfer effects are simulated in order to determine the inner temperature as a function of the heating system (IR and wire). This temperature is ascertained at $300^{\circ}C$, $400^{\circ}C$, $500^{\circ}C$, $600^{\circ}C$, $700^{\circ}C$, and $800^{\circ}C$ from a slab asphalt specimen prepared in the laboratory. The inner temperature of this specimen is measured at the surface and five different depths (1 cm, 2 cm, 3 cm, 4 cm, and 5 cm) by using a data logger. RESULTS: The numerical simulation results of the asphalt pavement heating temperature indicate that this temperature is extremely sensitive to increases in the heating temperature. Moreover, after 10 min of heating, the pavement temperature is 36%~38% and 8%~10% of the target temperature at depths of 25 mm and 50 mm, respectively, from the surface. Therefore, in order to achieve the target temperature at a depth of 50 mm in the slab asphalt specimen, greater heating is required of the IR system compared to that of the gas. CONCLUSIONS : Numerical simulation, via the finite element method, can be readily used to analyze the appropriate heating method and theoretical basis of the HIR method. The IR system would provide the best heating method and capacity of HIR heating processes in the field.

• Journal of Plant Biotechnology
• /
• v.46 no.3
• /
• pp.205-216
• /
• 2019

Since the RNA interference (RNAi) had been discovered in many organisms, small non-coding RNA-mediated gene silencing technology, including RNAi have been widely applied to analysis of gene function, as well as crop improvement. Despite the usefulness of RNAi technology, RNAi transgenic crops have various potential environmental risks, including off-target and non-target effects. In this study, we developed methods that can be effectively applied to environmental risk assessment of RNAi transgenic crops and verified these methods in 35S::dsRNAi_eGFP rice transgenic plant we generated. Off-target genes, which can be non-specifically suppressed by the expression of dsRNAi_eGFP, were predicted by using the published web tool, pssRNAit, and verified by comparing their expressions between wild-type (WT) and 35S::dsRNAi_eGFP transgenic rice. Also, we verified the non-target effects of the 35S:: dsRNAi_eGFP plant by evaluating horizontal and vertical transfer of small interfering RNAs (siRNAs) produced in the 35S::dsRNAi_eGFP plant into neighboring WT rice and rhizosphere microorganisms, respectively. Our results suggested that the methods we developed, could be widely applied to various RNAi transgenic crops for their environmental risk assessment.

• International Journal of Oral Biology
• /
• v.45 no.3
• /
• pp.134-142
• /
• 2020

Colon cancer is one of the most common malignant tumors, but there are still a few validated biomarkers of colon cancer. Exosome-mediated microRNAs (miRNAs) have been recognized as potential biomarkers in cancers, and miRNAs can regulate a variety of genes. Recently, Fusobacterium nucleatum was discovered in the tissues of human colon cancer patients. Its role in colon cancer was highlighted. F. nucleatum may contribute to the progression of colon cancer through the mechanism of exosome-mediated miRNAs transfer. However, the exosomal miRNAs regulation mechanism by F. nucleatum in colon cancer is not well known. Thus, we performed next-generation sequencing to investigate the overall pattern of exosomal miRNAs expression in the colon cancer cell culture supernatant. We have confirmed the alterations of various exosomal miRNAs. In addition, to investigate the function of exosomal miRNAs, a Kyoto Encyclopedia of Genes and Genomes analysis was performed on the target genes of changed miRNAs. Potential target genes were associated with a variety of signaling pathways, and one of these pathways was related to colorectal cancer. These findings suggested that F. nucleatum can alter exosomal miRNAs released from colorectal cancer cells. Furthermore, exosomal miRNAs altered by F. nucleatum could be potential biomarkers for the diagnosis and therapy of colon cancer.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.20 no.6
• /
• pp.769-778
• /
• 2007

In this paper, excitation systems using linear mass shaker (LMS) and active tuned mass damper (ATMD) are presented in order to simulate the wind induced responses of a building structure. The actuator force for the excitation systems is calculated by using the inverse transfer function of a target structural response to the actuator. Filter and envelop function are used such that the error between the wind and actuator induced responses is minimized by preventing the actuator from exciting unexpected modal response and initial transient response. The analyses results from a 76-story benchmark building problem in which wind load obtained by wind tunnel test is given, indicate that the excitation system installed at a specific floor can approximately embody the structural responses induced by the wind load applied to each floor of the structure. The excitation system designed by the proposed method can be effectively used for evaluating the wind response characteristics of a practical building structure and for obtaining an accurate analytical model of the building under wind load.

• Journal of Embryo Transfer
• /
• v.13 no.2
• /
• pp.159-172
• /
• 1998

사람 성장호르몬 수용체(hGHR) cDNA는 PCR방법에 의하여 fagment로서 보고되어진 바 있으나, liver cDNA로 부터 전장을 cloning한 보고는 없는 실정으로 본 연구에서는 기능을 가진 약 4.6kbp의 cDNA hGHR을 cloning 하는데 성공하였다. 먼저 cloning하기 위하여 human liver mRNA와 human breast cancer tissue로부터 회수한 mRNA를 RT-PCR방법에 의하여 human cDNA library와 cloning에 필요한 probe를 제작하였다. human library mRNA는 GT-PCR방법에 의하여 증폭하여 증폭되어진 산물은 λZAP Vector를 이용하여 cDNA library를 구축하였고,screeing을 위하여 임 보고 되어진 hGHR fragment native sequence를 기초로 N-terminal부분의 primer를 설계하여 950bp의 probe를 얻는데 성공하였다. 이 probe를 이용하여 준비된 human liver cDNA library로부터 2.5$\times$10 6개의 plaque로부터 6개의 positive clone을 획득하였고, 이들중 poly Asignal인 "AATAAA"를 포함하고 있는 가장 긴 약 3.8kbp의 clone을 sequencing한 결과 open reading frame을 포함하고 있었으나, 5'부분의 결손되어 있었다. 그리하여 이 부분은 human breast cancer tissue로 부터 회수한 mRNA를 RT-PCR에 의하여 증폭하였고, sequencing결과 이미 보고되어진 native hGHR와 비교한 결과 하나의 nucleotide가 silent mutation으로 판명되었다.한편 human liver cDNA library로부터 cloning한 3.8cp의 positive clone의 5'end의 결손된 부분에 silent mutation된 PCR 산물을 연결함으로써 native hGHR와 유사한 cDNA hGHR subcloning에 성공하였다. 이러한 cDNA hGHR의 clone이 function을 가지고 있는지를 검토하기 위하여 eukaryotic 발현 vector인 pCXN2에 의거 ligation한 후 chinese hamster ovary cell[CHO-KI]에 transfect를 실시하였다. Dexamethasone은 첨가하지 않고 hGH만의 존재하에서 이들 cell을 배양시키고 cell menbrane에서 발현 여부를 판정키 위하여 hGHR monocloual antibody를 사용하여 flow cytometery해석을 실시하는 한편 125I-hGH binding assay에 의하여 hGH binding activity를 측정하였다. 최종적으로 GH signal transduction의 target genedf으로 알려져 있는 serine protease inhibitor 2.1(Spi 2.1) gene의 promotor activity를 검토한 결과 hGHR을 transfect한 CHO Cell에 있어서 hGH의 농도에 의존적으로 증가되었다. 따라서 본 실험에서 cloning한 cDNA hGHR는 native hGHR와 같은 기능을 가지는 것으로 판명되었다.것으로 판명되었다.

• The Journal of the Acoustical Society of Korea
• /
• v.23 no.5
• /
• pp.400-409
• /
• 2004

In this paper. a voice personality transformation method is proposed. which makes one person's voice sound like another person's voice. To transform the voice personality. vocal tract transfer function is used as a transformation parameter. Comparing with previous methods. the proposed method makes transformed speech closer to target speaker's voice in both subjective and objective points of view. Conversion between vocal tract transfer functions is implemented by classification of entire vector space followed by linear transformation for each cluster. LPC cepstrum is used as a feature parameter. A joint classification and transformation method is proposed, where optimum clusters and transformation matrices are simultaneously estimated in the sense of a minimum mean square error criterion. To evaluate the performance of the proposed method. transformation rules are generated from 150 sentences uttered by three male and on female speakers. These rules are then applied to another 150 sentences uttered by the same speakers. and objective evaluation and subjective listening tests are performed.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.1101-1104
• /
• 2005

As intelligence of robot is developed, consumer of robot changes by ordinary people. Intelligent service robot is produced to a target of ordinary people. It is risen that need the most service robot business. Among the control mobile robot because using network by real time. Do to appear on mobile phone LCD screen being transmitted image from device that acquire transmit of mobile phone user interface development and real time mobile robot in this study. Use the BREW that is Qualcomm's Mobile platform for mobile phone user interface development. Mobile phone JPEG compression function chooses excellent camera phone and display transmit image which send connection setting screen and mobile robot on LCD screen by real time. At the same time, materialize to make screen that can process button input that can control transfer of robot. Also, Relay Server used to help processing of protocol to control direction of mobile robot.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.20 no.1
• /
• pp.22-28
• /
• 2010

Approximate analysis for a building installed with a friction damper is performed to get insight of its dynamic behavior. Energy balance equation is used to have a closed analytical form solution of dynamic magnification factor(DMF). It is found out that DMF is dependent on friction force ratio and resonance frequency. Approximation of DMF and equivalent damping ratio of a friction damper is proposed with such assumption that the building with a friction damper shows harmonic steady-state response and narrow banded response behavior near resonance frequency. Linear transfer function from input external force to output building displacement is suggested from the simplified DMF equation. Root mean square of a building displacement is derived under earthquake-like random excitation. Finally, design procedure of a friction damper is proposed by finding friction force corresponding to target control ratio. Numerical analysis is carried out to verify the proposed design procedure.