• The KSFM Journal of Fluid Machinery
• /
• v.16 no.3
• /
• pp.18-25
• /
• 2013

Recently the requirement of long-term mobile energy source for mobile robot or small-sized unmanned vehicle is highly increased, and the micro turbine generator(MTG) which is known to have high energy and power density is under development. MTG is designed to have air foil bearing and high speed rotor of which operating speed is 400,000rpm. In the development stage of high speed rotor and bearing, stability analysis for the full operational speed range is essential and the dynamic coefficients such as stiffness and damping coefficients of bearing depending on the rotational speed are required for that. Although perturbation method is usually used to identify the dynamic coefficients, it's not easy to give the perturbation to the high speed rotating rotor. In this study, we present the dynamic coefficients measurement system for air foil bearing which consists of electromagnets, gap sensors, high speed motor and controller. This measurement system can exert the sine sweep force to the rotor-bearing, measure the displacement of rotor and get FRF(Frequency response function) of rotor-bearing. The least square estimation method is applied to identify the dynamic coefficients of bearing from the measured frequency response at the different rpm and the identified dynamic coefficients for the wide rotational speed range are presented.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.15 no.5
• /
• pp.519-525
• /
• 2015

Positive bias stress-induced instability in amorphous indium-gallium-zinc-oxide (a-IGZO) bottom-gate thin-film transistors (TFTs) was investigated under high $V_{GS}$/low $V_{DS}$ and low $V_{GS}$/high $V_{DS}$ stress conditions through incorporating a forward/reverse $V_{GS}$ sweep and a low/high $V_{DS}$ read-out conditions. Our results showed that the electron trapping into the gate insulator dominantly occurs when high $V_{GS}$/low $V_{DS}$ stress is applied. On the other hand, when low $V_{GS}$/high $V_{DS}$ stress is applied, it was found that holes are uniformly trapped into the etch stopper and electrons are locally trapped into the gate insulator simultaneously. During a recovery after the high $V_{GS}$/low $V_{DS}$ stress, the trapped electrons were detrapped from the gate insulator. In the case of recovery after the low $V_{GS}$/high $V_{DS}$ stress, it was observed that the electrons in the gate insulator diffuse to a direction toward the source electrode and the holes were detrapped to out of the etch stopper. Also, we found that the potential profile in the a-IGZO bottom-gate TFT becomes complicatedly modulated during the positive $V_{GS}/V_{DS}$ stress and the recovery causing various threshold voltages and subthreshold swings under various read-out conditions, and this modulation needs to be fully considered in the design of oxide TFT-based active matrix organic light emitting diode display backplane.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.7
• /
• pp.692-698
• /
• 2003

This paper presents IM model which is produced in 3 port RF passive component. We calculated forward and reflect PIM of 3 port component by using the model. And they are reasonable agreement with measurement result like below. In the case of forward IM, calculated result is -122 dBc(at 43 dBm), which differ 2.5 dB with measurement result. And reflected IM, the average calculated result is -130 dBc(at 43 dBm), which differ 3 dB with measurement result. The results which are calculated and measured under various condition(IM source level, frequency sweep, contour length, etc.) show that forward method gets more fixed result than that of reflect. Consequently, PIM of 3 port component is predicted and analyzed for desensitizing by the proposed model.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.4
• /
• pp.377-387
• /
• 2016

Design of X-band frequency FMCW based imaging radar with multi-resolutions and performances of the self-manufactured radar system are presented in this study. In order to implement the multi-bandwidths, a ramp sequence of the FMCW signal is consisting of two kinds of 'saw-tooth' waveform with different bandwidth, and a receiver circuit consisting of L-band source and frequency converter circuit is used to effectively extract spectra of beat-frequency from the received signal of X-band frequency. The system setups for performance measurement of self-manufactured radar system are maximum output power of 35 dBm, sampling frequency of 1.2 MHz and sweep time of 1 ms. Then, the measured resolutions of the modulated signal having bandwidth of 500 MHz and 300 MHz in range & azimuth-direction are (0.28 m, 0.26 m) and (0.44 m, 0.27 m), respectively.

• Advances in aircraft and spacecraft science
• /
• v.5 no.2
• /
• pp.225-237
• /
• 2018

The difficulties of satellite vibration testing are due to the commonly expressed qualification requirements being incompatible with the limited performance of the entire controlled system (satellite + interface + shaker + controller). Two features cause the problem: firstly, the main satellite modes (i.e., the first structural mode and the high and low tank modes) are very weakly damped; secondly, the controller is just too basic to achieve the expected performance in such cases. The combination of these two issues results in oscillations around the notching levels and high amplitude beating immediately after the mode. The beating overshoots are a major risk source because they can result in the test being aborted if the qualification upper limit is exceeded. Although the abort is, in itself, a safety measure protecting the tested satellite, it increases the risk of structural fatigue, firstly because the abort threshold has been already reached, and secondly, because the test must restart at the same close-resonance frequency and remain there until the qualification level is reached and the sweep frequency can continue. The beat minimum relates only to small successive frequency ranges in which the qualification level is not reached. Although they are less problematic because they do not cause an inadvertent test shutdown, such situations inevitably result in waiver requests from the client. A controlled-system analysis indicates an operating principle that cannot provide sufficient stability: the drive calculation (which controls the process) simply multiplies the frequency reference (usually called cola) and a function of the following setpoint, the ratio between the amplitude already reached and the previous setpoint, and the compression factor. This function value changes at each cola interval, but it never takes into account the sensor signal phase. Because of these limitations, we firstly examined whether it was possible to empirically determine, using a series of tests with a very simple dummy, a controller setting process that significantly improves the results. As the attempt failed, we have performed simulations seeking an optimum adjustment by finding the Least Mean Square of the difference between the reference and response signal. The simulations showed a significant improvement during the notch beat and a small reduction in the beat amplitude. However, the small improvement in this process was not useful because it highlighted the need to change the reference at each cola interval, sometimes with instructions almost twice the qualification level. Another uncertainty regarding the consequences of such an approach involves the impact of differences between the estimated model (used in the simulation) and the actual system. As limitations in the current controller were identified in different approaches, we considered the feasibility of a new controller that takes into account an estimated single-input multi-output (SIMO) model. Its parameters were estimated from a very low-level throughput. Against this backdrop, we analyzed the feasibility of an LQG control in cancelling beating, and this article highlights the relevance of such an approach.

• Journal of the Korean Vacuum Society
• /
• v.22 no.3
• /
• pp.131-137
• /
• 2013

The thin insulator films for organic memory device were made by the plasma polymerization method using the styrene monomer which was not the wet process but the dry process. For the formation of stable plasma, we make an effort for controlling the monomer with bubbler and circulator system. The thickness of plasma polymerized styrene insulator layer was 430 nm, the thickness of the Au memory layer was 7 nm thickness of plasma polymerized styrene tunneling layer was 30, 60 nm, the thickness of pentacene active layer was 40 nm, the thickness of source and drain electrodes were 50 nm. The I-V characteristics of fabricated memory device got the hysteresis voltage of 45 V at 40/-40 V double sweep measuring conditions. If it compared with the results of previous paper which was the organic memory with the plasma polymerized MMA insulation thin film, this result was greater than 18 V, the improving ratio is 60%. From the paper, styrene indicated a good charge trapping characteristics better than MMA. In the future, we expect to make the organic memory device with plasma polymerized styrene as the memory thin film.

• Korean Chemical Engineering Research
• /
• v.54 no.6
• /
• pp.854-862
• /
• 2016

As the demand for a clean energy to replace fossil fuel being depleted increases, hydrogen energy is considered as a promising candidate for future energy source. Water electrolysis which produces hydrogen has high energy efficiency and stability but still has a large overpotential for oxygen evolution reaction (OER). In this study, $Co_3O_4$ catalysts with different morphology were prepared by spray pyrolysis from solutions which contain Co precursor and various organic additives (urea, sucrose, and citric acid), followed by post heat treatment. For the catalysts synthesized, X-ray diffraction (XRD) measurements were performed to identify their crystal structure. Morphology and surface shape of the catalysts were observed by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). Surface area and pore volume were examined by nitrogen adsortpion & desorption tests and X-ray photoelectron spectroscopy (XPS) was conducted to confirm nitrogen doping. Linear sweep voltammetry (LSV) was carried out to investigate OER activity of $Co_3O_4$ catalysts. As a result, bare-$Co_3O_4$ which has high surface area and small particle size determined by spray pyrolysis showed high activity toward OER.

• Journal of Science of Art and Design
• /
• v.3
• /
• pp.145-177
• /
• 2001

The artist's interest has been captivated by ecological phenomena in Nature. Her keen captivation has then been focused into plastic art depicting the image of primitive life. The wide sweep of her work encompasses the totality of nature which consists of the human's subconscious power and imagination which she then portrays by organic images. These organic images are in contrast to scientific, mathematical and logical inference and consciousness. This research examines the character of the organic images in modern art by her analysis of some representative works by others. The image is an essential concept in the art which appeared in very different ways and in different perspectives. The image in the artwork appears to be the realistic expression until the early part of the 20th Century. Well into the 20th Century, it began being expressed in various ways such as combined images by imagination which is combined or rejected in the story of artwork. It also began being expressed by transferred images by changed original conditions. It is the main purpose of this research is to study of various expressions of organic images in the artwork of the Post-Modernism era. The character and meaning of organic image painting helps people to approach the human instinct more easily to find out the natural essence. It is also an objective of the organic image to tenderise our human sensibilities, thus helping us to regain vitality and recover our poor humanity in the barren wilderness of modern society. 'Life communion with nature' is a meeting point and common ground for Oriental Philosophy and organic image painting. Through this research, organic image painting is characterised in the four following ways : 1st) Organic image painting seeks regularity and perfection of outer shapes, in contrast to disordered and deformed nature, resulting in organic and biotic formalistic mode of plastic art. 2nd) Organic image painting seeks the formative. 3rd) Organic image painting pursues the priceless dignity of life by researching the formatted arrangement and figure, which contains primitive power of life. 4th) Organic image painting makes crystal clear the power of human and nature, which is a historic and biological phenomenon. This, in turn, exposes the humanistic view of the world from modern society best characterised in lost self-understanding, isolation and materialism. The representative organic image painting artists are Elizabeth Murray, Kusama Yayoi, and Niki do Saint Phalle. Elizabeth Murray used shaped canvas and a round construction of relief works. Kusama Yayoi used Automatistic expressionism originating from the realms of unconsciousness and which is represented by the mass and shape of a water drop. Niki do Saint Phalle shows the transcendence of universal life and anti-life to respect the dignity of life and the eco-friendliness relationship of human and nature in the post-modernism in art history. This is accomplished by surrealistic, symbolic, fantastic and humoristic expression. These three artists' works express the spirit of the organic image in contemporary art. It contains the stream of nature and life to seek not only the state of materialism in the reality, but also the harmonized world of nature and human which has almost lost the important meaning in modern times. Finally, this organic image is the plastic language of the majestic life. It is the romantic idea that the intimacy of nature and the universe and Surrealism, which emphasizes the unconsciousness , is the source of truth and spirit. Also it is influenced by primitive art and abstract art. According to this research, the subject 'Research About Organic Images' is not only an important element in the plastic arts from primitive society to the present, but is also fundamental to an true understanding of Post-Modernism.