• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제49권10호
• /
• pp.553-558
• /
• 2000

This paper deals with change of contact angle, surface potential decay, surface resistivity and XPS of water-treated epoxy insulator. From the experimental results on the contact angle was reduced from $74^{\circ}$to $24^{\circ}$ due to the formation of polar hydroxyl groups on surface which was associated with intermolecular reaction between epoxy chains of three-dimensional network structure and water molecules. From the experimental results in the surface potential decay of water treated-samples, it was found that the accumulation of charge is decreased and the surface potential decay time is shortened by the interaction of polar hydroxyl groups induced on the treated surface as the increment of treatment time. The positive charging on the treated surface compared with negative charging is relatively lowered by the induction of polar hydroxyl groups. The surface resistivity was changed from $10^{15}[{\Omega}/cm^2$] to $10^{12}[{\Omega}/cm^2$] caused by water treatment. From XPS, it was found that the changes affected by the surface degradation of epoxy were caused by the generation of carboxyl groups through the chain decomposition and recombination with oxygen molecules in the air.

• 한국습지학회지
• /
• 제7권2호
• /
• pp.53-67
• /
• 2005

천수만은 전형적인 반 폐쇄형만으로 수로, 사퇴, 작은 섬 그리고 갯벌 등 다양한 환경들이 있다. 1983년에서 1985년 사이에 건설된 서산 A와 B 방조제는 천수만 북부의 퇴적환경을 지속적으로 변화시켰을 것으로 보인다. 황도 갯벌과 주변 해역의 퇴적환경을 파악하기 위하여 2003년 6월과 10월에 표층과 주상 퇴적물을 채취하였다. 표층 퇴적물은 5개의 퇴적상으로 구성되어 있었다. 일반적으로 10월의 표층퇴적물은 6월과 비교하여 갯벌은 조립해 졌으나 주변 해역은 거의 변화가 없었다. 3개의 주상퇴적물의 퇴적상은 황도 주변 갯벌은 파랑과 조류 에너지가 상대적으로 높고, 조수로 근처의 갯벌은 에너지가 상대적으로 낮은 것으로 나타났다. 황도 갯벌의 11개월 동안 단기 퇴적률은 중앙지역은 퇴적 되었으나, 갯벌의 동쪽 측면과 서쪽 측면은 침식된 것으로 나타났다. 이는 방조제에 의하여 조류 형태와 퇴적물 순환이 변화되었기 때문으로 보인다.

• 한국지하수토양환경학회지:지하수토양환경
• /
• 제27권5호
• /
• pp.1-9
• /
• 2022

A correlation analysis was performed to investigate differences in the response of surface water and groundwater to drought using the Standardized Precipitation Index (SPI). Water level data of 20 agricultural reservoirs, 4 dams, 2 rivers, and 8 groundwater observation wells were used for the analysis. SPI was calculated using precipitation data measured at a nearby meteorological station. The water storage of reservoirs and dams decreased significantly as they responded sensitively to the drought from 2014 to 2016, showing high correlation with SPI of the relatively long accumulation period (AP). The responses of rivers varied greatly depending on the presence of an upstream dam. The water level in rivers connected to an upstream dam was predominantly influenced by the dam discharge, resulting in very weak correlation with SPI. On the contrary, the rivers without dam exhibited a sharp water level rise in response to precipitation, showing higher correlation with SPI of a short-term AP. Unlike dams and reservoirs, the responses of groundwater levels to precipitation were very short-lived, and they did not show high correlation with SPI during the long-term drought. In drought years, the rise of groundwater level in the rainy season was small, and the lowered water level in the dry season did not proceed any further and was maintained at almost the same as that of other normal years. Conclusively, it is confirmed that groundwater is likely to persist longer than surface water even in the long-term drought years.

• Membrane and Water Treatment
• /
• 제11권3호
• /
• pp.231-235
• /
• 2020

Industrialization and modern developments have led to an influx of toxic heavy metals into the aquatic environment, and the accumulation of heavy metals has serious adverse effects on humans. Among the various heavy metal treatment methods, adsorption is very useful and frequently used. Plastic materials, such as polypropylene and polyethylene, have been widely used as filter media due to their mechanical and chemical stability. However, the surface of plastic material is inert and therefore the adsorption capability of heavy metals is very limited. In this study, granular media and fiber media composed of polypropylene and polyethylene are used, and the surface modification was conducted in order to increase adsorption capability toward heavy metals. Oxygen plasma generated hydroxyl groups on the surface of the media to activate the surface, and then acrylic acid was synthesized on the surface. The grafted carboxyl group was confirmed by FT-IR and SEM. Heavy metal adsorption capability of pristine and surface modified adsorbents was also evaluated. Overall, heavy metal adsorption capability was increased by surface modification due to electrostatic interaction between the carboxyl groups and heavy metal ions. Fibrous PP/PE showed lower improvement compared to granular PP media because pore blockage occurred by the surface modification step, thereby inhibiting mass transfer.

• 한국토양비료학회지
• /
• 제48권2호
• /
• pp.105-118
• /
• 2015

This study was carried out to investigate the effects of profile disturbance with different artificial accumulation history on physico-chemical properties of soil under plastic film house. The investigations included soil profile description using soil column cylinder auger F10cm x h110cm, in situ and laboratory measurements of soil properties at five sites each at the cucumber (Site Ic ~ Vc) and grape (Site Ig ~ Vg) plastic film houses with artificial soil accumulation. The sites except sites Ic, IVc, IVg and Vg, belong to ex-paddy area. The types of accumulates around root zone included sandy loam soil for 3 sites, loam soil for 1 site, saprolite for 2 sites, and multi-layer with different accumulates for 3 sites. Especially, Site IIg has mixed plow zone (Ap horizon) with original soil and saprolite, whereas disturbed soil layers of the other sites are composed of only external accumulates. The soil depth disturbed by artificial accumulation ranged from 20 cm, for Site IIg, to whole measured depth of 110 cm, for Site IVc, Vc, and Site IVg. Elapsed time from artificially accumulation to investigation time ranged from 3 months, Site IIc, to more than 20 years, Site Vg, paddy-soil covering over well-drained upland soil during land leveling in 1980s. Disturbed top layer in all sites except Site Vg had no structure, indicating low structural stability. In situ infiltration rate had no correlation with texture or organic matter content, but highest value with highest variability in Site IIIc, the shortest elapsed time since sandy loam soil accumulation. Relatively low infiltration rate was observed in sites accumulated by saprolite with coarse texture, presumably because its low structural stability in the way of weathering process could result in relatively high compaction in agro-machine work or irrigation. In all cucumber sites, there were water-transport limited zone with very low permeable or impermeability within 50 cm under soil surface, but Site IIg, IIIg, and Vg, with relatively weak disturbance or structured soil, were the reverse. We observed the big change in texture and re-increase of organic matter content, available phosphate, and exchangeable cations between disturbed layer and original soil layer. This study, therefore, suggest that the accumulation of coarse material such as saprolite for cultivating cash crop under plastic film house might not improve soil drainage and structural stability, inversely showing weaker disturbance of original soil profile with higher drainage.

• 대한기계학회논문집A
• /
• 제24권2호
• /
• pp.448-454
• /
• 2000

This study was undertaken to investigate tribological characteristics with atmospheric pressure for three alumina ceramics of different purity, such as, 85 %, 95 % and 99.7 %. The wear test was carried out using the wear test device which was designed for this study in air, $10^-2$ Torr and $10^-4$ Torr. The friction coefficient depends entirely on atmospheric pressure and alumina with lower purity than higher purity has been much affected by heat accumulation. The friction surface of ceramics have been protected in the air by the influence of the oxides transferred from STB2. However, the protective layer can not be formed due to the decrease of oxygen in vacuum.

• 한국정밀공학회지
• /
• 제17권3호
• /
• pp.174-183
• /
• 2000

Non-Parallelism the axial direction occurs during grinding process of long slender shafts. The reason for the axial error is due to elastic deformation of the components, accumulation phenomenon of the grinding and wheel wear during the grinding process. The accumulation phenomenon, the size generation mechanism and the wheel wear process during traverse grinding result in complicated process at each step on the wheel surface. The grinding system stiffness obtained from the stiffness of the center on the tailstock and the workpiece varing according to the relative position of the wheel and the workpiece. Further more, the value of wheel wear increases as the grinding process advances. The above mentioned issues make the shape generation process during traverse grinding quite complicated. This research analyzes the shape generation process in the direction of the work spindle. First, the formulation of the grinding system stiffness was conducted and the simulation analysis method of the traverse grinding was established. Also, a measuring system for assessing the dimensinal accuracy of the workpiece has been developed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 하계학술대회 논문집
• /
• pp.764-767
• /
• 2001

Because using LB method, result that produce Arachidic acid and Stearic acid LB film and measure the accumulation characteristic and electrical characteristic is as following. Organic monolayers of surface of the water compression each 9 layer's LB film to slide glass and manufactured MIM device compressing molecular film only. Could confirm that accumulation was good seeing as absorption coefficient and SEM picture, AFM picture that prevent manufactured LB films. Formation of domain of coexistence form that prevent LB film is indefinite and distinction of border side was not clear, and could know that roughness appears greatly. Obtained current by applied voltage could know that is proportional almost, though Arachidic acid appeared as bulk of current that happen in equaler certification voltage than Stearic acid is less, this alkyl chain longer Arachidic acid that serving relations special quality is superior know can .

• KIEE International Transactions on Electrophysics and Applications
• /
• 제5C권2호
• /
• pp.49-53
• /
• 2005

The current drive in a MOSFET is limited by the intrinsic channel resistance. All other parasitic elements in a device structure perform significant functions leading to degradation in the device performance. These other resistances must be less than 10$\%$-20$\%$ of the channel resistance. To meet the necessary requirements, the methodology of separation and quantification of those resistances should be investigated. In this paper, we developed an extraction method for the resistances using calibrated TCAD simulation. The resistance of the extension region is also partially determined by the formation of a surface accumulation region that gathers below the gate in the tail region of the extension profile. This resistance is strongly affected by the abruptness of the extension profile because the steeper the profile is, the shorter this accumulation region will be.

• 생약학회지
• /
• 제9권4호
• /
• pp.157-167
• /
• 1978

Atherosclerosis is associated with the presence of extracellular lipid droplets and large fatty deposits, both of which are to be covered at the surface mainly by zwitterionic phospholipids. The development of atherosclerosis is often associated with the accumulation of calcium. Furthermore, the presence of glycosaminoglycans directly underlying fatty deposits in human aorta has been demonstrated. Also, the possible involvement of the interaction between sulfated polysaccharide and lipoprotein in the development of atherosclerosis has been suggested in view of the presence of both low density lipoproteins and glycosaminoglycans, as well as their complexes, in atherosclerotic aortas. Therefore interactions of sulfated polysaccharides with low density lipoproteins which serve as a vehicle for cholesterol and cholesterol ester and with zwitterionic phospholipids have been studied extensively by a number of workers to provide mechanisms. In this paper, the mechanism of the interaction of sulfated polysaccharides with low density lipoproteins and the mechanism of the interaction between sulfated polysaccharides and zwitterionic phospholipids are reviewed. The possibility of the occurence of these interactions in the body are also considered.