• Proceedings of the Korean Magnestics Society Conference
• /
• 2002.12a
• /
• pp.200-201
• /
• 2002

Recently, a countermeasure for the electromagnetic noise emission on RF integrated transmission line using the loss generation of ferromagnetic thin films is briefly suggested$\^$1,2/. Without the magnetic film, the noise harmonics of the signal pass through the transmission line with only a little attenuation. The ideal role of magnetic film is not to raise insertion losses in the pass-band and to give as large attenuation as possible to eliminate the noise harmonics at the stop-band, the frequency range higher than the meaningful signal as shown in Fig. 1. and Fig. 2. (omitted)

• Proceedings of the KIPE Conference
• /
• 2015.07a
• /
• pp.245-246
• /
• 2015

본 논문에서는 삼중 델타 전원과 새로운 커먼-모드 필터 결선을 통해 스위칭에 의한 고조파를 저감하는 방법을 제안한다. PWM에 의해 생성되는 측대파 고조파(Sideband harmonics) 위상을 분석함으로써, 인터리빙 운전 시 삼중 델타 전원 연결과 제안된 커먼모드 필터가 측대파 고조파 전류를 크게 저감할 수 있음을 보인다. 3개의 고정자 권선을 가지는 영구자석 전동기를 이용하여 제안된 필터의 유효성을 검증하였다.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.145-149
• /
• 2003

The parallel feedback dielectric resonator oscillator (DRO) which is applicable to satellite communications and broadcasting has been investigated. In the design of oscillator, the phase noise is important parameter. In this paper, The proposed oscillator has good phase noise level because it suppressed harmonics. Measurement show the fabricated oscillator is output power of about 9 dBm at fundamental frequency of 12.0 GHz and fundamental frequency suppression of -47.5 dBc. The phase noise level is about -110 dBc/Hz at 100 KHz offset frequency.

• Journal of electromagnetic engineering and science
• /
• v.7 no.4
• /
• pp.175-182
• /
• 2007

In this paper, a study on the reflector type frequency doubler, to suppress the undesired harmonics, is presented. A 12 to 24 GHz reflective frequency doubler is simulated and experimented. Design procedure of the frequency doubler with reflector is provided and the frequency doubler with good spectral purity is fabricated successfully. It has harmonic suppression of the $40{\sim}50\;dBc$ in the $1^{st}$ harmonic and the $50{\sim}60\;dB$ in the $3^{rd}$ harmonic with no additional filter. And, it has conversion gain with the input power of 0 dBm over bandwidth of 500 MHz. A NEC's ne71300(N) GaAs FET is used and the nonlinear model(EEFET3) using IC-CAP program is extracted for harmonic load pull simulation. Good agreement between simulated and measured results has been achieved.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.9 s.100
• /
• pp.909-916
• /
• 2005

This paper describes that the Q factor of a conventional $\lambda$/4-microstrip resonator with short load can be improved and also the problem that the serial-resonant frequency(2$f_o$) should be deviated from can be settled by the proposed $\lambda$/4-microstrip resonator, which is used to suppress the harmonics of a nonlinear circuit.

• ETRI Journal
• /
• v.29 no.4
• /
• pp.533-535
• /
• 2007

For the purpose of decreasing intermodulation distortion, a new multi-harmonic suppression band-pass filter based on a microstrip radial stub is studied. Compared with traditional resonator filters, the new filter can suppress the second, third, and even fourth harmonics directly. The dimension of the filter is about $0.3\;{\lambda}_{g^0}{\times}0.13\;{\lambda}_{g^0}$ (${\lambda}_{g^0}$ is the guiding wavelength at the resonant frequency). Only one gap was introduced, so lower insertion loss can be obtained. Basic agreement between the measured and simulated results has been achieved.

• 한국정보통신설비학회:학술대회논문집
• /
• 2006.08a
• /
• pp.197-201
• /
• 2006

Folded lines are applied to design a compact microstrip ring hybrid. Using the proposed structure we achieve both significant size reduction and good harmonic suppression with the same results of conventional ring hybrid at 2.41GHz. Including the third harmonic frequency, up to 11GHz band harmonics are suppressed to -20dB. The size of the proposed ring-hybrid is reduced to one forth of the conventional ring hybrid. The measured frequency responses agree well with simulated ones.

• Journal of electromagnetic engineering and science
• /
• v.16 no.3
• /
• pp.191-193
• /
• 2016

This paper proposes a voltage-controlled oscillator (VCO) that has broadband turning and low-level of phase noise characteristics. Due to the micro-strip line resonant circuit with a low Q value, which is applied to the broadband tuning range, the depreciated phase noise performance is compensated by restraining the harmonics of the oscillating frequency. The VCO was designed according to the proposed structure as well as the conventional structure, and the superiority of the proposed structure was verified through its simulation, fabrication, and measurement.

• Journal of Power Electronics
• /
• v.18 no.6
• /
• pp.1659-1669
• /
• 2018

An improved circulating current suppression control method is proposed in this paper. In the proposed controller, an outer loop of the average capacitor voltage control model is used to balance the sub-module capacitor voltage. Meanwhile, an individual voltage balance controller and an arm voltage balance controller are also used. The DC and harmonic components of the circulating current are separated using a low pass filter. Therefore, a multiple quasi-proportional-resonant (multi-quasi-PR) controller is introduced in the inner loop to eliminate the circulating harmonic current, which mainly contains second-order harmonic but also contains other high-order harmonics. In addition, the parameters of the multi-quasi-PR controller are designed in the discrete domain and an analysis of the stability characteristic is given in this paper. In addition, a simulation model of a three-phase MMC system is built in order to confirm the correctness and superiority of the proposed controller. Finally, experiment results are presented and compared. These results illustrate that the improved control method has good performance in suppressing circulating harmonic current and in balancing the capacitor voltage.

• Journal of Power Electronics
• /
• v.17 no.3
• /
• pp.798-810
• /
• 2017

This paper presents a combined system of a small-capacity inverter and multigroup delta-connected thyristor switched capacitors (TSCs). The system is referred to as a hybrid static compensator (HSC) and has the functions of dynamic reactive power compensation and harmonic suppression. In the proposed topology, the load reactive power is mainly compensated by the TSCs. Meanwhile the inverter is meant to cooperate with TSCs to achieve continuous reactive power compensation, and to filter the harmonics generated by nonlinear loads and the TSCs. First, the structure and mathematical model of the HSC are discussed Then the control method of the HSC is presented. An improved reduced order generalized integrator (ROGI)-based selective current control method is adopted in the inverter to achieve high-performance reactive and harmonic current compensation. Meanwhile, a switch control strategy is proposed to implement precise and fast switching of the TSCs and to avoid changing the time delay needed by the conventional switch strategy. Experiments are implemented on a 20 KVA HSC prototype and the obtained results verify the validity of the proposed HSC system.