• Journal of Korean Society for Atmospheric Environment
• /
• v.33 no.3
• /
• pp.265-276
• /
• 2017

The $PM_{2.5}$ samples were obtained from coal combustion with the four different combustion temperatures (550, 700, 900 and $1100^{\circ}C$) to understand chemical composition in carbonaceous aerosol. OC concentration was the highest when the combustion temperature was $550^{\circ}C$, while, the highest concentration for EC was shown at $700^{\circ}C$ of the coal combustion temperature. However, OC concentrations were very low and EC was not detected when the temperature was over $900^{\circ}C$. It indicates complete combustion was achieved when the combustion temperature was over $900^{\circ}C$. For six groups of organic compounds, n-alkanes and n-alkanoic acids were predominant at all of the combustion temperature in smoke of coal combustion, while, PAHs was only detected at $550^{\circ}C$. The diagnostic ratios of PAHs calculated in this study were 0.59 for Fluoranthene/(Fluoranthene+Pyrene), reflecting the characteristics of coal combustion. The Carbon number Preference Index (CPI) values of n-alkanes which ranged from 0.9 to 1.3 also showed the characteristics of coal combustion.

• Applied Chemistry for Engineering
• /
• v.9 no.7
• /
• pp.1085-1089
• /
• 1998

The well-established nitric acid-sulfuric acid mixed acid process for the nitration of aromatic compounds has serious problems due to the large amount of waste acids and severe reaction conditions. Nitration of toluene can be conducted using nitrogen dioxide and ozone instead of mixed acid. We found that conc. nitric acid increased the reactivity as catalyst and the amount of nitrogen dioxide controlled the extent of nitration. Dinitration proceeded to more than 92 mole % conversion within 2 hr at $0^{\circ}C$ with 6 eq. of nitrogen dioxide and 2 eq./hr of ozone flow. Toluene completed mononitration within 30 min using 3 eq. of nitrogen dioxide, 3 eq. of nitric acid, and 1.5 eq./hr of ozone flow. As a clean process of aromatic nitration, this method is expected to replace the present process which causes the environmental problems.

• Journal of Korean Society for Atmospheric Environment
• /
• v.29 no.6
• /
• pp.701-712
• /
• 2013

The purpose of this study is to determine concentrations and compositions of $PM_{2.5}$ and their characteristic variations at Ieodo Ocean Research Station in the East China Sea and to examine the influence of air pollutants transported from Asia continents. $O_3$ and meteorological parameters were measured since June 2003 and $PM_{2.5}$ filter samples were collected from June 2004 to June 2008. In total, 244 samples were analyzed for water soluble ions and carbonaceous compounds. The mean mass concentration of $PM_{2.5}$ and $O_3$ were $21.8{\pm}14.9{\mu}g/m^3$ and $51.6{\pm}16.1$ ppb, respectively. The average concentrations (mass fractions) of sulfate and ammonium were $6.26{\mu}g/m^3$ (28.74%) and $1.59{\mu}g/m^3$ (7.31%), respectively. Nitrate was considered to be lost through evaporation due to long stay at the station. The mean concentrations of EC and OC were $1.01{\mu}g/m^3$ and $2.34{\mu}g/m^3$, respectively, from June 2006 to June 2008. The average OC/EC ratio was 2.31. The organic matter converted from OC by multiplying 2.1 and elemental carbon constituted 22.60% and 4.66% of $PM_{2.5}$ mass, respectively.

• Advances in Energy Research
• /
• v.4 no.2
• /
• pp.177-187
• /
• 2016

Ammonia borane $NH_3BH_3$ solubilized in organic solvent is a potential liquid-state chemical hydrogen storage material. In this study, metal acetylacetonates like $Fe(O_2C_5H_7)_3$, $Co(O_2C_5H_7)_2$, $Ni(O_2C_5H_7)_2$, $Pd(O_2C_5H_7)_2$, $Pt(O_2C_5H_7)_2$ and $Ru(O_2C_5H_7)_3$ are considered for assisting dehydrocoupling of ammonia borane in diglyme (0.135 M) at $50^{\circ}C$. The molar ratio between ammonia borane and metal acetylacetonate is fixed at 100. A protocol for the separation of the soluble and insoluble fractions present in the slurry is proposed; it consists in using acetonitrile to make the precipitation of metal-based compounds easier and to solubilize boron-based intermediates/products. The nature of the metal does not affect the dehydrocoupling mechanisms, the $^{11}B\{^1H\}$ NMR spectra showing the formation of the same reaction intermediates. The aforementioned metal acetylacetonates do mainly have effect on the kinetics of dehydrocoupling. Dehydrocoupling takes place heterogeneously and dehydrogenation of ammonia borane in these conditions leads to the formation of polyborazylene via intermediates like e.g., B-(cyclodiborazanyl) amine-borane and borazine. Our main results are reported and discussed herein.

• Korean Journal of Materials Research
• /
• v.15 no.2
• /
• pp.93-96
• /
• 2005

The arc melting was employed to prepare undoped $CoSb_3$ compounds and their thermoelectric properties were investigated. Specimen annealed at $400^{\circ}C$ for 24 hrs showed sound microstructure. However, considerable voids and cracks were found after annealing at above $500^{\circ}C$. It seems to be attributed to the phase dissociation and thermal expansion due to phase transitions during annealing and cooling. Single phase $\delta-CoSb_3$ was successfully obtained by annealing at $400^{\circ}C$ for 24 hrs. In the case of increasing annealing temperature, phase decompositions occurred. Undoped $CoSb_3$ showed p-type conduction and intrinsic semiconducting behavior at all temperatures examined. Thermoelectric properties were remarkably improved by annealing and they were closely related to phase transitions.

• Journal of Magnetics
• /
• v.13 no.1
• /
• pp.23-29
• /
• 2008

The magnetic and other physical characteristics of $Mn_xSi_{1-x}Te$ have been investigated by electron magnetic resonance (EMR), X-ray diffraction (XRD) and other experiments. $Mn_xSi_{1-x}Te$ is found to have corundum structure for manganese contents up to 10% and also to be ferromagnetic for temperatures below 80 K. While ferromagnetic resonance signal coexists with the usual paramagnetic resonance signal, invariance of the g-factor inferred from the electron paramagnetic resonance signals throughout all temperature ranges clearly confirms that the manganese ions are in the electronic 3d5 state. The temperature dependence of EMR line-width is the same as other diluted magnetic semiconductors. From the EMR signals relaxation times $T_2$ and $T_1$ of $Mn_xSi_{1-x}Te$ compounds are estimated to be about $4.4{\times}10^{-10}s$ and $9.3{\times}10^{-8}s$ respectively and are found to vary slightly with temperature or composition change. Exchange narrowing of the EMR line-width becomes dominant for the sample in which the substitution ratio, x = 30%. For one sample, in which x = 0.5%, spin glass-like behavior is indicated by EMR signals for temperatures lower than 60 K. This behavior may authentic for samples within a certain range of x.

• Journal of the Korean Ceramic Society
• /
• v.51 no.1
• /
• pp.43-50
• /
• 2014

We fabricated undoped and Sb-doped $SnO_2$ thin films on glass substrates by a pulsed laser deposition (PLD) process. Undoped and 2 - 8 wt% $Sb_2O_3$-doped $SnO_2$ targets with a high density level of ~90% were prepared by the spark plasma sintering (SPS) process. Initially, the effects of the deposition temperature on undoped $SnO_2$ thin films were investigated in the region of $100-600^{\circ}C$. While the undoped $SnO_2$ film exhibited the lowest resistivity of $1.20{\times}10^{-2}{\Omega}{\cdot}cm$ at $200^{\circ}C$ due to the highest carrier concentration generated by the oxygen vacancies, 2 wt% Sb-doped $SnO_2$ film exhibited the lowest resistivity value of $5.43{\times}10^{-3}{\Omega}{\cdot}cm$, the highest average transmittance of 85.8%, and the highest figure of merit of 1202 ${\Omega}^{-1}{\cdot}cm^{-1}$ at $400^{\circ}C$ among all of the doped films. These results imply that 2 wt% $Sb_2O_3$ is an optimum doping content close to the solubility limit of $Sb^{5+}$ substitution for the $Sb^{4+}$ sites of $SnO_2$.

• Journal of the Korean Ceramic Society
• /
• v.47 no.6
• /
• pp.590-597
• /
• 2010

HTGR using a TRISO coated particles as nuclear raw fuel material can be used to produce clean hydrogen gas and process heat for a next-generation energy source. For these purposes, a TRISO coated particle was prepared with 3 pyro-carbon (buffer, IPyC, and OPyC) layers and 1 silicone carbide (SiC) layer using a CVD technique on a spherical $UO_2$ kernel surface as a fissile material. In this study, a spherical $UO_2$ particle was prepared using a modified sol-gel method with a vibrating nozzle system, and TRISO coating fabrication was carried out using a fluidized bed reactor with coating gases, such as acetylene, propylene, and methyltrichlorosilane (MTS). As the results of this study, a spherical $UO_2$ kernel with a sphericity of 1+0.06 was obtained, and the main process parameters in the $UO_2$ kernel preparation were the well-formed nature of the spherical ADU liquid droplets and the suitable temperature control in the thermal treatment of intermediate compounds in the ADU, $UO_3$, and $UO_2$ conversions. Also, the important parameters for the TRISO coating procedure were the coating temperature and feed rate of the feeding gas in the PyC layer coating, the coating temperature, and the volume fraction of the reactant and inert gases in the SiC deposition.

• Biomedical Science Letters
• /
• v.24 no.1
• /
• pp.30-34
• /
• 2018

Silver (Ag) has been widely used in commercial products and medical fields since ancient times because of its antibacterial effect. It is harmless and non-toxic to the human body. For this reason, recent research has actively evaluated antimicrobial activity using silver (Ag). In this study, we investigated the inhibitory effect of a silver-based compound, silver phosphate ($Ag_3PO_4$) on the growth of Staphylococcus aureus and the activation of human immunity. First, the inhibitory effect of $Ag_3PO_4$ on the growth of Staphylococcus aureus was confirmed by a growth curve and a colonyounting method. As a result, the growth inhibitory effect increased as the concentration of $Ag_3PO_4$ increased. Specifically, treatment with $5{\mu}g/mL$ of $Ag_3PO_4$ resulted in no bacteria growth, and the colony-counting method showed a remarkable inhibition. In addition, the expression of cytokine IL-8 by $Ag_3PO_4$ was examined to investigate the cellular immune system activation by $Ag_3PO_4$. After pretreatment of Staphylococcus aureus for 1 hour with $50{\mu}g/mL$ $Ag_3PO_4$, an increased IL-8 mRNA expression resulted. In cells treated with $Ag_3PO_4$, we found that the expression of IL-8 was enhanced in a time-dependent fashion compared to non-treated cells. These results indicate that $Ag_3PO_4$ induces antimicrobial activity against Staphylococcus aureus and activates human immunity. These results are expected to contribute to the future study of the mechanism of silver (Ag) and silver-based compounds in relation to antibacterial activity.

• Journal of Ginseng Research
• /
• v.35 no.4
• /
• pp.487-496
• /
• 2011

Good manufacturing practice (GMP)-based quality control is an integral component of the common technical document, a formal documentation process for applying a marketing authorization holder to those countries where ginseng is classified as a medicine. In addition, authentication of the physico-chemical properties of ginsenoside reference materials, and qualitative and quantitative batch analytical data based on validated analytical procedures are prerequisites for certifying GMP. Therefore, the aim of this study was to propose an authentication process for isolated ginsenosides $Rb_1$ and $Rg_1$ as reference materials (RM) and for these compounds to be designated as RMs for ginseng preparations throughout the world. Ginsenoside $Rb_1$ and $Rg_1$ were isolated by Diaion HP-20 adsorption chromatography, silica gel flash chromatography, recrystallization, and preparative HPLC. HPLC fractions corresponding to those two ginsenosides were recrystallized in appropriate solvents for the analysis of physico-chemical properties. Documentation of the isolated ginsenosides was made according to the method proposed by Gaedcke and Steinhoff. The ginsenosides were subjected to analyses of their general characteristics, identification, purity, content quantitation, and mass balance tests. The isolated ginsenosides were proven to be a single compound when analyzed by three different HPLC systems. Also, the water content was found to be 0.940% for $Rb_1$ and 0.485% for $Rg_1$, meaning that the net mass balance for ginsenoside $Rb_1$ and $Rg_1$ were 99.060% and 99.515%, respectively. From these results, we could assess and propose a full spectrum of physicochemical properties for the ginsenosides $Rb_1$ and $Rg_1$ as standard reference materials for GMP-based quality control.