• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.6 no.2
• /
• pp.119-128
• /
• 2008

Thermal assessment of a new CANDU spent fuel disposal system, which improves the retrievability of the spent fuel and enhances the densification factor compared with the Korean Reference disposal System, is carried out in this study. The canisters for CANDU spent fuels are stored for long term and cooled by natural convection in the proposed disposal system for the retrievability. The steady state thermal analyses for proposed CANDU disposal system are carried out with the ANSYS 10.0 CFX code. The thermal analyses are performed through two steps. At the first step, the sensitivity of the disposal tunnel spacing is analysed. The differences of maximum temperatures by several tunnel spacings are calculated at three points in the disposal tunnel. The result shows that the differences of the temperature at the three points are almost negligible because 99% of the decay heat is removed by natural convection. At the second procedure, 60m tunnel spacing with a ventilation system instead of natural convection is considered. The result is applied to the calculation of the canister surface temperature in disposal tunnel as boundary conditions. Consequently, the average and the maximum surface temperature of disposal canisters are $79.9^{\circ}C$ and $119^{\circ}C$, respectively. The inner maximum temperature of a basket in the disposal canister is calculated as $140.9^{\circ}C$. The maximum temperature of the basket meets the thermal requirement for the CANDU spent fuel cladding.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.3 no.1
• /
• pp.30-36
• /
• 2001

Schisandra nigra Max. has been cultivated far a medical use as well as food. It is an endemic species which has a unique habitat at the altitude of 600-1,400 m in Cheju island. In this study, three natural populations of S. nigra were investigated by using of starch-gel electrophoresis to determine the extent and distribution of genetic diversity. Except 2 monomorphic locus (Mdh-2 and Pgi-1), 4 of the 6 isozyme locus (Idh, Mdh-2, Mnr, and Pgi-2), verified from 4 isozymes, revealed polymorphism in the three populations of S. nigra. The mean number of allele per locus was 1.7 and the percentages of polymorphism loci were 38.9% at 95% level and 50% at 99% level respectively. The observed and estimated heterozygosities were 0.141 and 0.147 respectively. Although plants which were in the face of crisis and distributed in the restricted area, have been known to the very low degree of genetic variation, S. nigra showed higher genetic variation than others. Genetic variation was mostly allocated within population and individuals than that among populations. The result of Wright's F analysis estimates of $F_{IT}$ and $F_{IT}$ showed that S. nigra population revealed Hardy-Weinberg steady state.

• Journal of Korea Soil Environment Society
• /
• v.3 no.1
• /
• pp.83-92
• /
• 1998

This study presents a relationship between gas quantity and measurement resistance using the bubble meter, the water head indicator and the rotor meter from the gas vent sanitary landfill. From the one-dimensional analyses and experiments, the below results have been obtained. The gas volume sourcing from the gas vent depends on the permeability of final cover soil, its cover depth and distance between the gas vents. The total gas volume producing in the interested domain may be accurately measured by the bubble meter, the water head indicator and the rotor meter if the clay is used for the final cover soil. The required times approaching to the steady-state are different with respect to the flow meters, one day is for the bubble meter and the water head indicator and one hour for the rotor meter.

• Journal of Distribution Science
• /
• v.9 no.3
• /
• pp.47-54
• /
• 2011

This paper presents exploratory research on consumer awareness and attitudesabout organic food, for which consumer demand continues to increase the paper also assesses consumers' organic food distribution channel preferences. By conducting a literature review, a case study has been carried out in order to glean customer behavior, market condition and typesof distribution channels, and development of specialty stores for organic foods. The early research indicates that consumer awareness and customer attitudes toward organic food are mostly positive however, organic food's high price, as well as a lack of organic food stores, cause a negative effect on consumers' purchase intention. Secondly, the U.S. organic food retail channel consists of such mainstream supermarket/grocery stores and leading natural and organic food supermarket chains as Whole Foods, Trader Joe's, and Sunflower Farmers Market. For the current retail distribution of organic food in Korea, off-line stores are composed of direct management stores and franchise chains. Most of the organic food retail distribution operates through the Internet shopping mall, and are commonly located at retail distribution centers as multi-channel, shop-in-shop stores. Moreover, unlike in the U.S., association and consumers' cooperatives (Co-Ops), and such other member-direct retail stores as Hansallim, iCOOP, Nature Dream,and online shopping malls, are all active in Korea. Thirdly, as a result of an analysis of the present state of the organic food retail channel, as well as building a case for organic food specialty stores, the distinctive featuresand rapid growth of such unique organic food stores as Whole Foods Market, or Trader Joe's successful downsizing strategies, as well as Sunflower Farmers Market low-price approach, show steady industry growth. Moreover, as a result of a case studyof such domestic representative organic food specialty stores as "Olga" and "Chorokmaeul," a similar management style to the United States' "Whole Foods Market" and "Trader Joe's," respectively, can be seen. Similar to the U.S. market, Korean organic food markets should also implement active retail distribution opportunities, allowing consumers to select from various diverse and differentiated choices. In order to accomplish this goal, it is necessary to prepare such measures as sustaining reasonable prices, securing various suppliers for unique products,and improving consumer trust through advertisement strategies that are suitable for each company's branding processes.

• Environmental and Resource Economics Review
• /
• v.28 no.2
• /
• pp.277-306
• /
• 2019

Mackerel is one of the most widely consumed aquatic products in Korea. Concerns about the depletion of stocks have also arisen as the catch has decreased. The primary purpose of this study is to estimate the mackerel stock and derive the optimal level of catch in Korea. We apply a generalized maximum entropy econometric method to estimate the mackerel growth function, which does not require the steady state assumption. We incorporate a bootstrapping approach to derive the significance levels of parameter estimates. We found that the average ratio of catch to the estimated total stock was less than 30% before the 1990s but exceeded 40% in the 1990s. After 2000, it dropped back to about 36%. This finding indicates that mackerel may have been over-fished in the 1990s, but the government regulations introduced in the 2000s alleviated over-fishing problems. Nevertheless, our dynamic optimization analysis suggests that the total allowable catch may need to be carefully controlled to achieve socially optimal management of resources.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.2
• /
• pp.644-648
• /
• 2019

This study examined effects of the wall thermal conductivity coefficients on the thermal fluid phenomenon of a compartment fire. The reduced scale compartment was 0.4 m in width, 0.6 m in length and 0.6 m in height with a fire-board, which has a thermal conductivity coefficient of $0.18W/m{\cdot}K$. The local temperature at a 0.37 m height and the overall heat release rate were measured under the following experiment conditions: a $0.12m^2$ opening area and $0.01m^2$ pool size of a gasoline fire. The numerical results obtained by the Fire Dynamic Simulation were compared with the experimentally measured temperature. The deviations were within 10 % in the period of the steady state for maximum heat release rate (4.8 kW). The numerical results show that the average temperature of the compartment wall decreases by approximately 71 % with increasing thermal conductivity coefficient from $0.1W/m{\cdot}K$ to $100.0W/m{\cdot}K$ on the fixed heat release rate.

• Clean Technology
• /
• v.25 no.1
• /
• pp.1-6
• /
• 2019

Effects of the Cu and K addition and the reduction condition of Fe-based catalysts for Fischer-Tropsch reaction are studied in a continuous flow reactor in this research. The catalysts for the reaction were prepared by homogeneous precipitation followed by incipient wetness impregnation. Physicochemical properties of the $Al_2O_3$ supported Fe-based catalysts are characterized by various methods including X-ray diffraction (XRD), temperature programmed reduction (TPR), and scanning electron microscopy (SEM). Catalytic activities and stabilities of the Fe/Cu/K catalyst are investigated in time-on-stream for an extended reaction time over 216 h. It is found that a reduction of the catalysts using a mixture of CO and $H_2$ can promote their catalytic activities, attributed to the iron carbides formed on the catalysts surface by X-ray diffraction analysis. The addition of Cu induces a fast stabilization of the reaction reducing the time to reach at the steady state by enhancement of catalytic reduction. The addition of K to the catalysts increases the CO conversion, while the physical stability of catalyst decreases with potassium loading up to 5%. The Fe/Cu (5%)/K (1%) catalyst shows an enhanced long term stability for the Fischer-Tropsch reaction under the practical reaction condition, displaying about 15% decrease in the CO conversion after 120 h of the operation.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.5D
• /
• pp.831-838
• /
• 2006

An experimental/analytic study has been conducted to understand the adverse effects of low vehicle speed, high axle load and high tire pressure on the performance of asphalt pavements. Of 33 asphalt sections at KHC test road, two sections having different base layer thickness (180 mm versus 280 mm) are adopted for rollover tests. During the test, a standard three-axle dump truck maintains a steady state condition as moving along the wheel path of a passing lane, and lateral offsets and real travel speed are measured with a laser-based wandering system. Test results suggest that vehicle speed affects both longitudinal and transverse strains at the bottom of asphalt layer (290 mm and 390 mm below the surface), and even slightly influences the measured vertical stresses at the top of subbase and subgrade due to the dynamic effect of rolling vehicle. Since the anisotropic nature of asphalt-aggregate mixtures, the difference between longitudinal and transverse strains appears prominent throughout the measurements. As the thickness of asphalt pavement increases, the measured lateral strains become larger than its corresponding longitudinal strains. Over the limited testing conditions, it is concluded that higher axle weight and higher tire pressures induce more strains and vertical stresses, leading to a premature deterioration of pavements. Finally, a layered elastic analysis overestimates the maximum strains measured under the 1st axle load, while underestimating the maximum vertical stress in both pavement sections.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.4A
• /
• pp.373-384
• /
• 2009

For the first step on the quantitative evaluation of shrinkage reduction and differential shrinkage analysis of lightweight aggregate concrete, this study sets the moisture transport model of concrete by pre-absorbed water of porous lightweight aggregates and measured effective moisture diffusion coefficient, moisture capacity, degree of humidity supply and degree of humidity consumption by water binder ratio and aggregate type. The effective moisture diffusion coefficient in steady state caused by humidity difference between inside and outside of concrete had low value as low water-binder ratio. And in case of same water-binder ratio, effective moisture diffusion of mixtures used normal aggregates were lower than those used lightweight aggregates. To determine moisture store capability of concrete - moisture capacity, moisture contents were measured in 9 humidity conditions. As a result moisture contents of mixtures used lightweight aggregates was higher than mixtures used normal aggregates in all humidity conditions. This study measured lightweight aggregates' degree of humidity supply that applicable to normal atmospheric environment (above RH 50%) and made it quantitatively. Also amount of moisture release was set as a exponential function that represents a clear trend proportion to time and inverse proportion to humidity of the surroundings. As the result of measurement about degree of moisture consumption inside concrete following the internal consumption caused by cement hydration self-drying, it was showed that rapid decrease of humidity, around 10%, at early ages (7~10 days) when water-binder ratio is 0.3 and slow decrease around 5% and 1% when water-binder ratio is 0.4 and 0.5.

• Journal of Radiation Protection and Research
• /
• v.10 no.1
• /
• pp.50-63
• /
• 1985

A derivation of new release limit, named Derived Release Limit(DRL), into the atomsphere from a reference nuclear power plant has been performed on the basis of the new system of dose limitation recommended by the ICRP, instead of the (MPC)a limit which has been currently used until now as a general standard for radioactive effluents in Korea. In DRL Calculation, a Concentration Factor Method was applied, in which the concentrations of long-term routinely released radionuclides were in equilibrium with dose in environment under the steady state condition. The analytical model used in the exposure pathway analysis was the one which has been suggested by the USNRC and the exposure limits applied in this analysis were those recommended by the USEPA lately. In the exposure pathway analysis, all of the pathways are not considered and some may be excluded either because they are not applicable or their contribution to the exposure is insignificant compared with other pathways. In case, the environmental model developed in this study was applied to the Kori nuclear power plant as the reference power plant, the highest DRL value was calculated to be as $9.10{\times}10^6Ci/yr$ for Kr-85 in external whole body exposure from the semi-infinite radioactive cloud, while the lowest DRL value was observed 3.64Ci/yr for Co-60 in external whole body exposure from the contaminated ground, by the radioactive particulates. The most critical exposure pathway to an individual in the unrestricted area of interest (Kilchun-Ri, 1.3 km to the north of the release point) seems to be the exposure pathway from the contaminated ground and the most critical radionuclide in all pathways appears to be Co-60 in the same pathway. When comparing the actual release rate from KNU-l in 1982 with the DRL's obtained here the release of radionuclides from KNU-1 were much lower than the DRL's and it could be conclued that the exposure to an individual had been kept below the exposure limits recommended by the USEPA.