• Journal of Aerospace System Engineering
• /
• v.18 no.1
• /
• pp.37-45
• /
• 2024

This paper presents a design approach for passive vibration control to reduce vertical vibrations transmitted to the control unit during hovering flight of a quadrotor drone. Ground vibration test simulation based on finite element model was performed for forced vibration analysis of the quadrotor drone. First, modal analysis was performed to evaluate dynamic characteristics. Forced vibration response analysis was then performed to obtain the steady-state response within the operating frequency range under the hovering flight condition. Furthermore, to obtain the vibration reduction effect, a viscous damping tape was applied at positions that could induce vibrations transmitted to the control unit under the same conditions. Such a passive vibration control approach was investigated. Relevant vibration reduction effect was assessed with respect to the application of damping materials and the attachment position.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.5
• /
• pp.473-480
• /
• 2011

The proton exchange membrane (PEM) fuel cell system is critically dependent on the humidity, which should be properly maintained over the entire operating range. A membrane humidifier is used for the water management in the PEMFC because of the membrane humidifier's reliable performance and zero parasitic power loss. In the PEMFC system, the membrane humidifier is required to provide appropriate humidity for the design point of the fuel cell. Although the performance of the fuel cell depends on the performance of the humidifier, few studies have provided a systematic analysis of the humidifier. We carry out an experimental analysis of the membrane humidifier using a vapor condensation bottle. The dry air pressure, water flow temperature, and air flow rate were chosen as the operating parameters. The results show that the time constant for the dynamic response of the membrane humidifier is relatively short, but additional analysis should be carried out.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.11
• /
• pp.73-82
• /
• 2017

Recently, offshore bucket cut-off walls were developed to solve several problems in conventional offshore cut-off walls. In this study, a numerical analysis was carried out to investigate the seepage stability of offshore bucket cut-off walls. The ground was assumed as uniform homogeneous sand and steady state flow conditions were applied. The flow condition was compared among 2-dimensional flow (2-D), 2-dimensional concentrated flow (2-DC), and axisymmetric flow. The analysis results showed that the seepage velocities in axisymmetric flow were about 1.5 and 2 times larger than those of 2-DC and 2-D flow conditions, respectively. Thereafter, the axisymmetric flow condition was applied because the seepage flow was concentrated toward the center of the circular-shaped wall. A parametric study was performed varying bucket radius, penetration depth, total head difference between in and outside of the wall. The exit gradient, which used for the calculation of piping stability, decreased with increase of the penetration depth and bucket radius. Design charts were proposed to estimate the factor of safety and the exit gradient at various analysis conditions. Finally, the design equation was proposed to calculate the exit gradient for the preliminary design of the bucket cut-off wall.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.26 no.2
• /
• pp.12-19
• /
• 2022

Propellant grains with embedded metal wires have been used for enhancement of burning rate while maintaining high loading density. For the performance design of a solid rocket motor using propellant grain with embedded metal wires, burn-back analysis is required according to number, location, arrangement angle of metal wires, and augmentation ratio of the propellant burning rate near a wire region. In this study, a numerical method to quickly calculate a burning surface area was developed in response to the design change of the propellant grain with embedded metal wires. The burning surface area derived from the developed method was compared with the results of a CAD program. Error rate decreased as the radial size of the grid decreased. Analysis for characteristics of burning surface area was performed according to the number and location of metal wires, the initial and final phases were shortened and the steady-state phase was increased when the number of metal wires increased. When arranging the metal wires at different radii, the burning surface area rapidly increased in the initial phase and sharply decreased in the final phase compared to the case where the metal wires were disposed in the same radius.

• International Area Studies Review
• /
• v.15 no.1
• /
• pp.341-365
• /
• 2011

This study used a non-parametric linear program, Data Envelopment Analysis to compare the efficiency of South Korean and Chinese banks from 2000 to 2008, which is said to be the reformation period of their financial structure. The sample banks were 10 commercial banks and 6 regional banks in Korea, and 4 state-owned commercial banks and 11 stock commercial banks in China. The main objective of our research is to compare their efficiency, as well as the changes in efficiency periodically according to the types of the banks. According to the periodical analysis, both of the countries showed steady increase in efficiency. This shows that finance restructure and merging were positive factors for bank's efficiency during the revolution of finance structure. The study showed that between Korea and China, the bank of Korea has higher efficiency than that of China. Although the reconstruction period happened around the same time, due to the earlier acceleration period to opening Korea's financial market, made the difference in efficiency.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.406-406
• /
• 2016

To get high efficiency n-type crystalline silicon solar cells, passivation is one of the key factor. Tunnel oxide (SiO2) reduce surface recombination as a passivation layer and it does not constrict the majority carrier flow. In this work, the passivation quality enhanced by different chemical solution such as HNO3, H2SO4:H2O2 and DI-water to make thin tunnel oxide layer on n-type crystalline silicon wafer and changes of characteristics by subsequent annealing process and firing process after phosphorus doped amorphous silicon (a-Si:H) deposition. The tunneling of carrier through oxide layer is checked through I-V measurement when the voltage is from -1 V to 1 V and interface state density also be calculated about $1{\times}1012cm-2eV-1$ using MIS (Metal-Insulator-Semiconductor) structure . Tunnel oxide produced by 68 wt% HNO3 for 5 min on $100^{\circ}C$, H2SO4:H2O2 for 5 min on $100^{\circ}C$ and DI-water for 60 min on $95^{\circ}C$. The oxide layer is measured thickness about 1.4~2.2 nm by spectral ellipsometry (SE) and properties as passivation layer by QSSPC (Quasi-Steady-state Photo Conductance). Tunnel oxide layer is capped with phosphorus doped amorphous silicon on both sides and additional annealing process improve lifetime from $3.25{\mu}s$ to $397{\mu}s$ and implied Voc from 544 mV to 690 mV after P-doped a-Si deposition, respectively. It will be expected that amorphous silicon is changed to poly silicon phase. Furthermore, lifetime and implied Voc were recovered by forming gas annealing (FGA) after firing process from $192{\mu}s$ to $786{\mu}s$. It is shown that the tunnel oxide layer is thermally stable.

• Nuclear Engineering and Technology
• /
• v.19 no.1
• /
• pp.22-33
• /
• 1987

The confirmed integrity of nuclear fuel cladding materials is an important object during steady state and transient operations at nuclear power plant. In this context, the clad material yielding behavior is especially important because of pellet-clad gap expansion. During the steep power excursion, the in-pile irradiation behavior differences between uranium-dioxide fuel pellet and zircaloy clad induce the contact pressure between them. If this pressure reaches the zircaloy clad yield pressure, the zircaloy clad will be plastically deformed. After the reactor power resumed to normal state, this plastic permanent expansion of clad tube give rise to the pellet-clad gap expansion. In this paper, the simple mandrel expansion test method which utilizes thermal expansion difference between copper mandrel and zircaloy tube was adopted to simulate this phenomenon. That is, copper mandrel which has approximately three times of thermal expansion coefficient of zircaloy-4 (PWR fuel cladding material) were used in this experiment at the temperature range from 400C to 700C. The measured plastic expansion of zircaloy outer radius and derived mathematical relations give the yield pressure, yield stress of zircaloy-4 clad at the various clad wall temperatures, the activation energy of zircaloy tube yielding, and pellet-clad gap expansion. The obtained results are in good agreement with previous experimental results. The mathematical analysis and simple test method prove to be a reliable and simple technique to assess the yielding behavior and gap expansion measurement between zircaloy-4 tube and uranium-dioxide fuel pellet under biaxial stress conditions.

• Korean journal of food and cookery science
• /
• v.21 no.4 s.88
• /
• pp.440-446
• /
• 2005

To determine the shelf-life of low salted Myungran-jeot (low salted and fermented Alaska pollack roe), various chemical, microbiological and sensory analyses were carried out with Myungran-jeot stored at 10 days. The lactic acid content was slowly increased in the early stage of storage but then was rapidly increased with lengthening storage period, while pH was decreased during storage. The $NH_2-N$ content was steady at 10 days and peaked at 17 days. The production of VBN was increased to over $30mg\%$ at 19 days. In microbiological tests, the viable cell count and halotolerant bacteria were $1.5\times10^3\;and\;5.5\times10^3CFU/g$, respectively, at the initial state, but they slowly increased to $10^7 CFU/g$ at 17 days. Yeast or fungi did not appear on the surface of Myungran-jeot. Sensory evaluation showed that the original torture of Myungran-jeot in the mouth was a very important indicator for acceptability. Sensory characters and acceptability of Myungran-jeot at 17 days were not significantly different from those of the initial state. From these results, the estimated shelf-life of Myungran-jeot whom sealed with aluminum coated paper, was about 18 days in this study.

• Journal of Korean Society of Transportation
• /
• v.23 no.1
• /
• pp.67-80
• /
• 2005

In this paper, the primary objective of the research are to review the methods currently avaliable for estimating the delay incurred by vehicles at signalized intersections. The paper compares the delay estimates from a deterministic queueing model, a model based on shock wave theory , the steady-state Webster model, the queue-based models defined in the 1994 and 2001 version of the High way Capacity Manual, in addition to the delays estimated from the TRANSYT-7F macroscopic simulation and NETSIM microscopic simulation. More especially, this paper is to compare the delay estimates obtained using macroscopic and microscopic simulation tools against state-of-the practice analytical models that are derived from deterministic queueing and shock wave analysis theory. The results of the comparisons indicate that all delay models produce relatively similar results for signalized intersections with low traffic demand, but that increasing differences occur as the traffic demand approaches saturation. In particular, when the TRANSYT-7F and NETSIM are compared, it is highly differences as approach for traffic condition to over-saturation. Also, the NETSIM microscopic simulation is the lowest estimates among the various models.

• Korean Journal of Veterinary Research
• /
• v.32 no.2
• /
• pp.157-164
• /
• 1992

Changes in the both inward current and conductance of membrane by the fertilization were observed using the one microelectrode voltage clamp(or switch clamp) technique. Unfertilized eggs and both 1- and 2-cell stage eggs after fertilization were donated from the superovulated mouse (ICR, more than 6 weeks old) treated with PMSG(pregnant mare serum gonadotropin, Sigma) and HCG(human chorionic gonadotropin, Sigma) and naturally mated ones, respectively in this experiment. Membrane potential was held at -90mV and the voltage step was applied from -80mV to 50mV with interval of 10mV or 20mV for 300ms. since both of amplitudes and time courses in the membrane currents were various according to the states of cells and clamping condition, results were presented by their $averages{\pm}SEM$(standard mean error)and ratios or percentages. Inward currents began to appear in response to the step depolarization from -60mV and reached its maximum at -50mV. However, since the potential was not clamped evenly during the voltage step, current-voltage(I-V) relationship might be positively shifted 10 or 20mV. From the steady-state currents plotted in the I-V curve, outward rectification was markedly observed. Peak inward currents$(i_{in})$ at -50mV were $-0.62{\pm}0.23nA$(n=4),$-0.52{\pm}0.25nA$(n=5) and $-0.37{\pm}0.25nA$(n=6), in the 1-cell stage, 2-cell stage fertilized eggs and in the unfertilized eggs, respectively. Pure inward current (difference between steady-state and peak, $i_{in. pure}$) were $-1.01{\pm}0.23nA$, $-0.69{\pm}0.43nA$ and $-0.68{\pm}0.29nA$, respectively in the 1-cell stage fertilized eggs, unfertilized eggs and 2-cell stage fertilized eggs. These results suggested that the outward current in fertilized eggs of 2-cell stage was more increased than those in the unfertilized eggs. Pure inward currents in the all stages of eggs showed a similar fashion in the I-V relationship from -50mV to 50mV and reversal potential at 50mV. Time constant of inactivation$({\tau})$ in the inward current was decreased as the membrane potential was depolarized in the unfertilized and 2-cell stage eggs but in the 1-cell stage eggs t was not likely to be affected significantly. Slope conductances were 14.2nS, 8.9n5 and 7.7nS in the 1-cell, 2-cell stage fertilized eggs and the unfertilized eggs, respectively. Membranes between two cells within a zona pellucida seem to be electrical-connected in the 2-cell stage eggs from the observation made in the analysis for the electronic spread and decay to the current stimuli. Both of inward current and membrane conductance were increased after fertilization in the mouse eggs. Inward current seems to be carried by the same ion or through the same channels up to the 2-cell stage and ion that carried inward current was thought to play important function after fertilization in the mouse eggs.