• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.9
• /
• pp.1840-1846
• /
• 2011

It is necessary to estimate the Doppler spectrum for each range cell for the extraction of useful information from the return echoes in radar systems used for the remote sensing purpose such as detection of moving targets and weather surveillance. The signal amplitude in the beat frequency band is the important parameter in the detection and tracking of targets. However, strong clutter echoes do exist in most radar operation environments and the system phase noise spreads both the clutter and signal echoes of the target. In this paper, the effects of this system phase noise are analyzed concerning the clutter and the signal beat spectrum. It is shown that the separation capability of adjacent beat signal depends on the degree of spread in the clutter and beat signal caused by the radar system phase noise

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.7
• /
• pp.989-998
• /
• 1993

In a bursty user traffic mode, ALOHA random multiple access protocol achieves higher performance than any conventional fixed assignment technique. One of central problems in slotted ALOHA is synchronization. Because of the long propagation delay in satellite mobile communication, packet may be spilt over into adjacent slots and thus guard time may be included between packet intervals. In conventional ALOHA channels, simultaneous transmission by two or more users results in a collision : the unsuccessful packets have to be retransmitted according to some retransmission algorithm. However, in a radio environment, users are often at different distances from the receiver : therefore, their received signals have substantially different power levels. The packet arriving with the highest energy now has a good chance of being detected accurately. Similarly, in some spread-spectrum random access systems, the earliest arriving packet dominates later arriving packets and thus captures the channel. In this paper slotted ALOHA channel with non zero guard time and capture probability is studied. Using the Markovian model, the performance of slotted ALOHA with guard time and capture effects is derived and compared with that of the conventional ALOHA via numerical analysis.

• Journal of the Institute of Convergence Signal Processing
• /
• v.2 no.3
• /
• pp.39-44
• /
• 2001

In frequency hopping spread spectrum(FHSS) communication systems, exact frequency synchronization is required due to the random hopping of carrier frequencies between transmitter and receiver even under harsh channel conditions. For synchronization of FHSS communications, multi-frequency hopping synchronization(MFHS) method has been used in which a small set of frequencies are repeatedly sent several times for long duration. But this long duration resulted in being easily detected by the unauthorized users as well as long duration of acquisition time. In this paper, motivated by these problems, an adaptive synchronization method(ASM) is proposed. ASM is technics to reduce the synchronization time where the number of synchronization frequencies and repetition numbers is adaptively changed (increased or decreased) according to the channel conditions. The performance analysis showed that the time duration of synchronization was reduced to 0.2sec, and the influence of jamming or interference was decreased to 46% in ASM.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.10A
• /
• pp.922-929
• /
• 2005

This paper proposes an adaptive pilot beacon equipment for mobile communication systems based on direct spread spectrum technology which generates the pilot channel for handoff between base stations by using the information acquired from the downstream wireless signal regarding the overhead channel information. Such an adaptive pilot beacon equipment will enable low power operation since among the wireless signals, only the pilot channel will be generated and transmitted. The pilot channel in the downstream link of the CDMA receiver is used to acquire time and frequency synchronization and this is used to calibrate the offset for the beacon, which implies that time synchronization using GPS is not required and any location where forward receive signal can be received can be used as the installation site. The downstream link pilot signal searching within the CDMA receiver is performed by FPGA and DSP. The FPGA is used to perform the initial synchronization for the pilot searcher and DSP is used to perform the offset correction between beacon clock and base station clock. The CDMA transmitter the adaptive pilot beacon equipment will use the timing offset information in the pilot channel acquired from the CDMA receiver and generate the downstream link pilot signal synchronized to the base station. The intermediate frequency signal is passed through the FIR filter and subsequently upconverted and amplified before being radiated through the antenna.