• KEPCO Journal on Electric Power and Energy
• /
• v.5 no.4
• /
• pp.337-341
• /
• 2019

In this study, the effects of two materials, active alumina and CaO based inorganic binder, which cause the side reaction on the K₂CO₃-based solid CO₂ sorbents was investigated. K₂CO₃-based solid sorbents called KAM series was prepared by spray drying method and then measured its physical properties and CO₂ sorption capacity. Among the KAM series sorbents, KAM(0.5) maintained high CO₂ sorption capacity of 7.6 wt% after 3 cycle of sorption/regeneration reaction and showed very low attrition loss as low as 3.1 % which was measured by ASTM D5757-95.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2000.11a
• /
• pp.793-797
• /
• 2000

The environmental problems by using coolant demanded the new cooling methods. As one of them the studies on the dry grinding with compressed cold air have been done. The cooling method using compressed cold air was effdve thmugh going down the temperature of compressed air supplied below $-25^{\circ}C$ and inneasing the amount of mmpresd cold air, but had not enough cooling effect due to the low performance of lubrication. Therefore, the cooling methods using MQL(Minimum Quantity Lubrication) or mist newly were suggested. These two methods can satisfy both cooling effect and lubrication with only small amount of coolant, also has the benefit in the point of decreasing the envimnmental pollution. This paper focused on analyzing the grindmg characteristics of the cooling method using mid. The generated heat and grinding force of the cooling method using mist were compared with them of coolant and compressed cold air. And them grinding test according to the temperature of compressed cold air, mist spray amount and mist supply direction were done.

• Journal of Microbiology and Biotechnology
• /
• v.12 no.5
• /
• pp.740-745
• /
• 2002

The current study was conducted to identify the differences in the rheological properties of Chlorella sp. powder cultured in a fermentor and in a pond-like environment. Cells. cultured in the same media were harvested and spray dried. The biomass yield from the fermentor culture was 4.7% (dry basis), while that from the pond was 4.3% (dry basis). Measurements of the loose bulk density, tapping test, Hausner's ratio, and compressibility test all revealed differences between the rheological properties of the Chlorella sp. from the two cultivation systems. Although both the fermentor and pond cultured Chlorella sp. showed the same angle of repose, the mean size of the cells was 2.26 $\mu\textrm{m}$ and 2.89 $\mu\textrm{m}$, respectively. The weight of the Chlorella sp. tablets cultured in the fermentor and pond was 0.663 g/tablet and 0.593 g/tablet, respectively, while the friability of the tablets was 21% and 41%, respectively. Observation by Transmission Electron Microscope (TEM) showed that the cell wall of the Chlorella sp. cultured in the fermentor was thinner and more spherical than that cultured in the pond, thereby providing the main characteristic rheological properties of the powder.

• Journal of Welding and Joining
• /
• v.14 no.3
• /
• pp.66-74
• /
• 1996

In this study, friction and wear properties of flame sprayed specimens and hard Cr plating specimens were tested, and their properties were compared each other in dry and lubrication condition. Ni-Cr powder and steel powder were used as the spray powder and sprayed on the steel(S45C) substrate by flame sprayed method. Each wear surface was observed with SEM after friction and wear test. The friction coefficient of the as-forged steel specimens was the highest among surface treatment specimens, and the other specimens appeared in order as follows ; hard Cr-plating specimens, Ni-Cr powder sprayed specimens, steel powder sprayed specimens. Comparing the wear volumes in dry condition, as forged steel specimens appeared the greatest wear volume, and the other specimens appeared wear volume in order as follows ; Ni-Cr powder sprayed specimens, steel powder sprayed specimens, hard Cr plating specimens. In friction and wear test, the hard Cr plating specimens were worn by the abrasive phenomenon, involving the cracks. The wear volume of steel powder sprayed specimens was lower than that of Ni-Cr powder sprayed specimens. Comparing the tensile strength of both sprayed coating layers, the steel powder sprayed coating layer was better than Ni-Cr powder sprayed coating layer.

• Journal of Power System Engineering
• /
• v.11 no.1
• /
• pp.121-126
• /
• 2007

This study aims at investigating the effect of heat treatment conditions on the dry sliding wear behavior of thermally sprayed Ni-based self-flux alloy coatings. Ni-based self-flux alloy powders were sprayed onto a carbon steel substrate and then heat-treated at 700, 800, 900 and $1000^{\circ}C$ for 30 minutes in a vacuum furnace. Dry sliding wear tests were performed using sliding speed of 0.4 m/s and applied load of 6 N. AISI 52100 ball(diameter 8 mm) was used as counterparts. Microstructure and wear behavior of both as-sprayed and heat-treated Ni-based self-flux alloy coatings were studied using a scanning electron microscope(SEM), energy dispersive X-ray spectroscopy(EDX), electron probe micro-analysis(EPMA) and X-ray diffraction(XRD). It was revealed that microstructure and wear behavior of thermally sprayed Ni-based self-flux alloy coatings were much influenced by heat treatment conditions.

• Journal of Bio-Environment Control
• /
• v.29 no.1
• /
• pp.80-88
• /
• 2020

This study was conducted to examine the effect by application method and concentration of the indole-3-butyric acid (IBA), which is auxin-based plant growth regulator, on the growth and runner plants production of strawberry in the greenhouse. The seedlings of strawberry were transplanted in the pot (150 ×135 × 90 mm) filled with coir medium on April 12, 2019. The IBA was applied with a foliar spray or drench as 50, 100, 150, and 200 mg·L^-1 (50 mL per plant), respectively. The treatment was started on April 29, 2019. The foliar spray and drench treatment of IBA were repeated at 2-week intervals for 9 weeks from the start date of treatment. At 9 weeks after treatment, the petiole length of mother plants was the shortest in the control. The number of runner plants showed a tendency to decreased in the foliar spray. The number of lateral buds showed a tendency to decreased in the IBA treatment, and the least in the foliar with 100 mg·L^-1. There was not significantly difference in the fresh and dry weights of the first and second runner plants. However, in the third runner plants, the fresh and dry weights were the greatest in the drench with 100 mg·L^-1. Therefore, when considering the growth of third runner plants and lateral bud suppression, the drench with the 100 mg·L^-1 could be better application method and concentration of IBA treatment for growth of the third runner plants and runner plants production of strawberry, and the results can be used as a basic research of plant growth regulator application to save the labor force and enhance the seedling quality in strawberry seedling stage.

• Journal of Environmental Science International
• /
• v.24 no.6
• /
• pp.755-762
• /
• 2015

The present study was conducted to develop seed treatment for the production of healthy and clean peanut sprout. Dry heat treatment of peanut seeds reduced the incidence of the rot. The seed treatment condition at $52^{\circ}C$ for 10 h. was the most efficient without inhibiting seed viability significantly. Seeds were dark cultured at $27^{\circ}C$ for up to 9 days. The treatment of Indole-B and gibberellic acid influenced germination, T50, fresh, dry weight, hypocotyl length, hypocotyl length diameter, root length, number of lateral root and epicotyl of peanut sprout. There were no differences in the germinability of peanut seeds between gibberellic acid treatment methods but higher fresh weight was observed in the GA3 solution spray after 2 hour water soaking. The general growth and lateral root development of peanut sprouts were suppressed by Indole-B which is used for inhibiting root formation and promoting hypocotyls. The treatment of gibberellic acid promoted hypocotyl elongation, but it did not influence on the growth of hypocotyls and root system.

• Asian-Australasian Journal of Animal Sciences
• /
• v.17 no.8
• /
• pp.1139-1144
• /
• 2004

In Exp. 1, a total of 36 pigs (6.55$\pm$0.10 kg average initial body weight and 21 d average age) were used in a 14 d growth study to determine the effects of replacing spray-dried plasma protein (SDPP) with spray-dried egg protein containing specific egg yolk antibody (SDEP) on growth performance and nutrient digestibility in weaned pigs. The pigs were blocked by weight and assigned to treatments based on sex. There were three pigs per pen and four pens per treatment. Dietary treatments were 0, 3, or 6% SDEP and contained 6, 3, or 0% SDPP, respectively. Through the entire experimental period, average daily gain (ADG), average daily feed intake (ADFI), and gain/feed tended to decrease as the concentration of SDEP increased in the diets. However, there were no significant differences among the treatments (p>0.05). As the addition of SDEP in the diets increased, apparent digestibilities of dry matter (DM) and nitrogen (N) were decreased without significant (p>0.05). For Exp. 2, 36 pigs (2.63$\pm$0.04 kg average initial body weight and 10 d average age) were used in a 14 d growth study to determine the effects of antibiotic replacement with SDEP on growth performance and nutrient digestibility in early-weaned pigs. The pigs were blocked by weight and assigned to treatments based on sex. There were three pigs per pen and four pens per treatment. Dietary treatments included 1) ANTIBIOTIC (corn-dried whey-soybean meal based diet+0.08% antibiotics, 4 mg of tiamuline hydrogen fumarate; 10 mg of sulfadimidine per kg of complete diet), 2) SDEP0.1 (corndried whey-SBM based diet+0.1% SDEP), and 3) SDEP0.2 (corn-dried whey-SBM based diet+0.2% SDEP). ADG and gain/feed of pigs fed the SDEP0.2 diet were higher than for pigs fed the ANTIBIOTIC diet without significant (p>0.05). Pigs fed the diet with SDEP0.2 tended to have increased apparent digestibilities of DM and N compared to pigs fed the ANTIBIOTIC diet without significant (p>0.05). In conclusion, the dietary SDEP seemed to be partial replacing the SDPP portion of high nutrient dense diet for weaned pigs. Also, dietary SDEP seemed to be approximately 0.2% or more when the pigs fed the antibiotic-free diet for early-weaned pigs.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.31 no.4
• /
• pp.389-394
• /
• 2011

This experiment was carried out to find effective weed control method of henbit deadnettle ($Lamium$ $amplexicaule$ L.) on cultivating field of Italian ryegrass ($Lolium$ $multiflorum$ Lam) using herbicide in Grassland and Forages Division, National Institute of Animal Science, RDA, Cheonan from 2008 to 2009. When Onehof was treated two times of spray, weed control ratio was most high as 90%, but this method can not be used because of much damage to Italian ryegrass. When MCPP was treated two times of spray, weed control ratio was high as 82%, and damage to Italian ryegrass was very insignificant. Especially, when the spray of MCPP was treated two times, dry matter yield of Italian ryegrass was 11,427 kg/ha, but that of non treatment was 1,658 kg/ha. That is to say, forage harvest was impossible in non treatment field. According to these results, to control henbit deadnettle on cultivating field of Italian ryegrass using herbicide, you need to treat with two times of spray of MCPP in mid-March. If you do, you can get regular harvest as much as 11,427 kg/ha.

• Economic and Environmental Geology
• /
• v.52 no.2
• /
• pp.119-128
• /
• 2019

About 300,000 tones of oyster shell are annually produced in Korea and, thus, a massive recycling plan is required. Many desulfurizing studies using oyster shells with chemical composition of $CaCO_3$ have been performed so far; however, most of them have focused on dry desulfurization. This study investigates the possibility of using oyster shells for wet desulfurization after calcination. For this, a simulated wet desulfurization facility of spray type was devised and compared the SOx-stripping characteristics of calcined oyster shell with those of limestone. The calcined oyster shell slurry indicate a better desulfurizability than the slurries of raw shell or limestone because the oyster shell transformed to a more reactive phase ($Ca(OH)_2$) by the calcination and hydration. Because of this reason, when the calcined oyster shell slurries were used, the reaction residue showed the higher gypsum ($CaSO_4{\cdot}2H_2O$) contents than any other cases. In the continuous desulfurization experiments, calcined oyster shell slurry showed a wider pH variation than limestone or raw oyster shell slurries, another clear indication of high reactivity of calcined oyster shells for $SO_2$ absorption. Our study also shows that the efficiency of wet desulfurization can be improved by the use of calcined oyster shells.