• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.42 no.8 s.338
• /
• pp.35-42
• /
• 2005

This paper describes novel flip-flops with improved robustness and reduced power consumption. Variable sampling window flip-flop (VSWFF) adjusts the width of the sampling window according to input data, providing robust data latching as well as shorter hold time. The flip-flop also reduces power consumption for higher input switching activities as compared to the conventional low-power flip-flop. Clock swing-reduced variable sampling window flip-flop (CSR-VSWFF) reduces clock power consumption by allowing the use of a small swing clock. Unlike conventional reduced clock swing flip-flops, it requires no additional voltage higher than the supply voltage, eliminating design overhead related to the generation and distribution of this voltage. Simulation results indicate that the proposed flip-flops provide uniform latency for narrower sampling window and improved power-delay product as compared to conventional flip-flops. To evaluate the performance of the proposed flip-flops, test structures were designed and implemented in a $0.3\mu m$ CMOS process technology. Experimental result indicates that VSWFF yields power reduction for the maximum input switching activity, and a synchronous counter designed with CSR-VSWFF improves performance in terms of power consumption with no use of extra voltage higher than the supply voltage.

• Journal of Bio-Environment Control
• /
• v.18 no.3
• /
• pp.215-224
• /
• 2009

A survey on the actual state of heating, cooling, ventilation, and air-flow and experimental measurement of temperature and humidity distribution in tomato greenhouse were performed to provide fundamental data required in the development of air-flow control technology. In single-span plastic houses, which account for most of 136 tomato greenhouses surveyed, roof windows, ventilation and air-flow fans were installed in a low rate, and installation specs of those facilities showed a very large deviation. There were no farms installed greenhouse cooling facilities. In the hot air heating system, which account for most of heating type, installation specs of hot air duct showed also a large deviation. The exhaust air temperature and wind speed in hot air duct also were measured to have a big difference depending on the distance from the heater. We are using the maximum difference as indicator to determine whether temperature distribution is uniform. However if the temperature slope is not identical in greenhouse, it can't represent the uniformity. We analyzed relation between the maximum difference and the uniformity of temperature and humidity distribution. The uniformity was calculated using the mean and standard deviation of data from 12 measuring points. They showed high correlation but were represented differently by linear in the daytime and quadratic in the nighttime. It could see that the uniformity of temperature and humidity distribution was much different according to greenhouse type and heating method. The installation guidelines for ventilation and air-flow fan, the spread of greenhouse cooling technology for year-round stable production, and improvement of air duct and heating system, etc. are needed.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.39 no.10
• /
• pp.1029-1037
• /
• 2015

Recently, the importance of rotordynamic stability has been increased because of the tendency to employ ultra-high speeds in rotating machinery. In particular, the dynamic characteristics of gas bearings for high-speed rotating machinery need to be identified at various excitation frequencies to predict the rotor's behavior. In this study, we perform dynamic loading tests for gas-foil bearings (GFBs) to determine the bump foil structure and an air-film combined bump-foil structure for varying excitation frequencies. We calculate the dynamic characteristics from the measured force and displacement data. The air film is generated by a pressurized air supply. Based on the results, the stiffness coefficients of the bump structure and the air-film combined bump structure increased, while the damping coefficients decreased at increasing excitation frequencies. Further, the stiffness and damping coefficients of the air-film combined structure show lower values than those of the bump structure. Consequently, we identify the frequency-dependent dynamic characteristics of the bump structure and the effect of gas film on the dynamic characteristics of GFBs. Furthermore, to reveal the effectiveness of the proposed method, we perform experiments and discuss two methods of extracting the dynamic characteristics from the measured data.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.4
• /
• pp.41-49
• /
• 2010

This paper proposes a new high speed SHA-1 architecture using multiple unfolding and pre-computation techniques. We unfolds iterative hash operations to 2 continuos hash stage and reschedules computation timing. Then, the part of critical path is computed at the previous hash operation round and the rest is performed in the present round. These techniques reduce 3 additions to 2 additions on the critical path. It makes the maximum clock frequency of 118 MHz which provides throughput rate of 5.9 Gbps. The proposed architecture shows 26% higher throughput with a 32% smaller hardware size compared to other counterparts. This paper also introduces a analytical model of multiple SHA-1 architecture at the system level that maps a large input data on SHA-1 block in parallel. The model gives us the required number of SHA-1 blocks for a large multimedia data processing that it helps to make decision hardware configuration. The hs fospeed SHA-1 is useful to generate a condensed message and may strengthen the security of mobile communication and internet service.

• Journal of Digital Convergence
• /
• v.15 no.8
• /
• pp.333-340
• /
• 2017

Timelapse is an imaging technique that captures motion at regular intervals and then projects it at normal speed. We looked at Timelapse advertising images of global brands and presented a model for analyzing components and expression methods of Timelapse, a new image technique. In previous research, literature research, Internet data survey, and YouTube data were investigated. Continuous photography has been developed as an imaging technique, and we have examined the current production status applied to domestic and foreign documentary, domestic and foreign drama, film, and advertisement. In 2015-2016, I will analyze the techniques of iPhones (2016), Ralph Lauren Polo Ads (2015), and Canon EOS (2013) videos that use Timelapse techniques in their recent advertisements. The results show that the Timelapse component is a static element, the static motif is mainly an artificial structure, the place is outdoor, the color is taken at a time showing the characteristics of the place, and the layout is all centered. The dynamic motif is a moving object. The dynamic line consists of a story based on the object. The time is about 11-15 seconds, the longest is about 1 minute and 30 seconds, and the editing is mainly focused on the product with the brand logo emphasized. In conclusion, it is the role of the image to pay attention to the advertisement and catch the eye. In order to motivate the buyer's mind, it is necessary to direct and edit such as Timelapse, which stimulates the emotions inherent in the mind and stimulates the non-verbal symbols. Future research is likely to reveal various attempts at temporal editing of images.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.316-316
• /
• 2017

The objective of this study is to estimate quantitatively soil salinity and soil loss at upland soils in agriculture land region in Saemangeum reclaimed land on the south Korea coasts. Soil loss and soil salinity are the most critical problem at reclaimed tidal saline soil in Korea. The several thematic maps of research area such as land cover map, topographic and soil maps, together with tabular precipitation data used for soil erosion and soil salinity calculation. Meteorological data were measured directly as air temperature, wind speed, solar radiation, and precipitation. The experiment was conducted 2% sloped lysimeter ($5.0m{\times}20.0m$) with 14 treatments and it were separated by low salinity division (LSD) and high salinity division (HSD) install. The cation content in ground water increased during time course, but in the case of land surface water the content was variable, and $K^+$ was lower than that of $Na^+$ and $Mg^{2+}$. At the LSD under rainproof condition, the salinity was directly proportional to soil water content, but at the HSD the tendency was no reversed. In condition of rainproof, the amount of soil salinity was higher at the HSD than at the LSD. Positive correlation was obtained between the soil water content and available phosphorous content at the rainfall division, but there was no significance at the surface soil of the rainproof division. Sodium adsorption ratio and anion contents in soil were repressed in the order of vinyl-mulching > non-mulching > bare field. According to the result of analyzing soil loss, soil loss occurred in a vinyl-mulching, a non-mulching and a bare field in size order, and also approximately 11.2 ton/ha soil loss happened on the reclaimed land area. The average soil loss amount by the unit area takes place in a non-mulching and bare field a lot. Our results indicate that soluble salt control and soil erosion are critical at reclaimed tidal saline soil and the results can provide some useful information for deciding management plans to reduce soil loss and salt damage for stable crop production and diverse utilization or cultivation could be one of the management options to alleviate salt damage at reclaimed tidal saline soil in Korea.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.28 no.4
• /
• pp.337-346
• /
• 1992

Hydroacoustic surveys were conducted in the East China Sea, in the summers of 1990-1991 to investigate the distribution and migration behavior of fish, such as the diel changes in the distributions of fish, the thermoselection behavior of fish, and the fish reactions to a surveying vessel. The hydroacoustic observations were taken with a scientific echo sounder operating at 50kHz and a microcomputer-based echo processor. Fish samples were collected by bottom trawling and temperature was measured with a DBT system. The patterns of fish distributions were compared with the vertical profiles of water temperature. The results obtained can be summarized as follows: 1. The time series of hydroacoustic observations on the downward migration at dawn in the central region of East China Sea showed that the migration rate was 0.24 m/min. In this region, most of the fish collected by bottom trawling during the surveys were squid (Photologio edulis f. budo) and horse mackeral (Trachurus japonicus). 2. The hydroacoustic observations, which together associated with temperature data, indicated that squid and horse mackeral concentrated nocturally in a narrow vertical band of thermocline, particularly in summer when the survey region was strongly stratified. This result suggest that the nocturnal vertical distribution of these species evidently is controlled by temperature. 3. When the survey vessel, that is running at a speed of 11 knots, has suddenly stopped, the fish which concentrated beneath the transducer showed a strong avoidance reaction in the form of rapid downward migration. After a few minutes, the descending reaction disappeared and the fish slowly began the upward migration toward their original swimming positions. Trawl data suggest that the fish, which showed the avoidance reaction, was Liparis tessellatus.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.7
• /
• pp.29-38
• /
• 2009

In this paper, a high performance pipelined computing design of parallel multiplier-temporal buffer-parallel accumulator is present for the convolution-based non-cascaded architecture aiming at the real time Discrete Wavelet Transform(DWT) processing. The convolved multiplication of DWT would be reduced upto 1/4 by utilizing the filter coefficients symmetry and the up/down sampling; and it could be dealt with 3-5 times faster computation by LUT-based DA multiplication of multiple filter coefficients parallelized for product terms with an image data. Further, the reutilization of computed product terms could be achieved by storing in the temporal buffer, which yields the saving of computation as well as dynamic power by 50%. The convolved product terms of image data and filter coefficients are realigned and stored in the temporal buffer for the accumulated addition. Then, the buffer management of parallel aligned storage is carried out for the high speed sequential retrieval of parallel accumulations. The convolved computation is pipelined with parallel multiplier-temporal buffer-parallel accumulation in which the parallelization of temporal buffer and accumulator is optimize, with respect to the performance of parallel DA multiplier, to improve the pipelining performance. The proposed architecture is back-end designed with 0.18um library, which verifies the 30fps throughput of SVGA(800$\times$600) images at 90MHz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.48 no.4
• /
• pp.84-91
• /
• 2011

Recently, WBAN(Wireless Body Area Network) which has progressed standardization based on IEEE 802.15.6 standardization is a network for the purpose of the short-range wireless communications within around 3 meters from the inner or outer human body. Effective QoS control technique and data efficient management in limited bandwidth such as audio and video are important elements in terms of users and loads in short-range wireless networks. In this paper, for high-speed WBAN IEEE 802.15.6 standard, the dynamic allocation to give an efficient bandwidth management and weighted fair queueing algorithm have been proposed through the adjustment of the super-frame about limited data and Quality of Service (QoS) based on the queuing algorithm. Weighted Fair Queueing(WFQ) Algorithm represents the robust performance about elements to qualitative aspects as well as maintaining fairness and maximization of system performance. The performance results show that the dynamic allocation expanded transmission bandwidth five times and the weighted fair queueing increased maximum 24.3 % throughput and also resolved delay bound problem.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.4
• /
• pp.63-72
• /
• 2007

In this paper, we propose a novel reconfigurable coprocessor for multimedia mobile terminals. Because most of multimedia operations require fast operations of large amount of data in the limited clock frequency, it is necessary to enhance the performance of the embedded processor that is widely used in current multimedia mobile terminals. Therefore, we proposed and have designed the coprocessor which had the ability of fast operations of multimedia data. The proposed coprocessor was not only reconfigurable, but also flexible and expandable. The proposed coprocessor has been designed by using VHDL and compared with previous reconfigurable coprocessors and a commercial embedded processor in architecture and speed. As a result of the architectural comparison, the proposed coprocessor had better structure in terms of hardware size and flexibility. Also, the simulation results of DCT application showed that the proposed coprocessor was 26 times faster than a commercial ARM processor and 11 times faster than the ARM processor with fast DCT core.