• The Journal of the Acoustical Society of Korea
• /
• v.23 no.1
• /
• pp.61-74
• /
• 2004

In this paper, a contort- and speaker-dependent cepstrum extraction method and a channel normalization method for minimizing the loss of speaker characteristics in the cepstrum were proposed for a robust speaker recognition system over the channel. The proposed extraction method creates a cepstrum based on the pitch synchronous analysis using the inherent pitch of the speaker. Therefore, the cepstrum called the 〃pitch synchronous cepstrum〃 (PSC) represents the impulse response of the vocal tract more accurately in voiced speech. And the PSC can compensate for channel distortion because the pitch is more robust in a channel environment than the spectrum of speech. And the proposed channel normalization method, the 〃formant-broadened pitch synchronous CMS〃 (FBPSCMS), applies the Formant-Broadened CMS to the PSC and improves the accuracy of the intraframe processing. We compared the text-independent closed-set speaker identification on 56 females and 112 males using TIMIT and NTIMIT database, respectively. The results show that pitch synchronous km improves the error reduction rate by up to 7.7% in comparison with conventional short-time cepstrum and the error rates of the FBPSCMS are more stable and lower than those of pole-filtered CMS.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.2 no.4
• /
• pp.531-538
• /
• 1998

In this paper the system performance degradation resulting from nonlinear transmitter power amplifier which is essential to increase the efficiency is analysed in a CDMA system. The power amplifier is modeled by its AM-AM, AM-PM characteristics. The effects of power amplifier's nonlinearity such as intersymbol interference, phase distonion on the RF system performance were visualized by examining the distorted time domain waveforms, signal vector constellation. And through the investigation of the power spectrum density of the transmitted signal, spectral regrowth or sideband regrowth which is result from amplitude distortion can be seen. All these characteristics result in BER performance degradation due to other user interferences and intersymbol interference. The analysis technique described here applies not only to power amplifier but also to any other nonlinear components such as mixers and switches. Also the effects of adjacent channel interference and supurious emission can be analysed between different systems.

• The Journal of the Acoustical Society of Korea
• /
• v.19 no.8
• /
• pp.68-77
• /
• 2000

Line special frequency (LSF) parameters have been widely used in low bit-rate speech coding due to their efficiency for representing the short-time speech spectrum. In this paper, a new distance measure based on the masking properties of human ear is proposed for quantizing LSF parameters whereas most conventional quantization methods are based on the weighted Euclidean distance measure. The proposed method derives the perceptual distance measure from the definition of noise-to-mask ratio (NMR) which has high correspondence with the actual distortion received in the human ear and uses it for quantizing LSF parameters. In addition, we propose an adaptive bit allocation scheme, which allocates minimal bits to LSF parameters maintaining the perceptual transparency of given speech frame for reducing the average bit-rates. For the performance evaluation, we has shown the ratio of perceptually transparent frames and the corresponding average bit-rates for the conventional and proposed methods. By jointly combining the proposed distance measure and adaptive bit allocation scheme, the proposed system requires only 770 bps for obtaining 95.5% perceptually transparent frames, while the conventional systems produce 89.9% at even 1800 bps.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.4
• /
• pp.1-9
• /
• 2007

Linearity is the one of the most important features for analog-optic transmission system. In our research, the available bandwidth for the feed-forward compensation circuit is enhanced by using a 180 hybrid coupler in the circuit. The bandwidth having the decreased 3rd-order intermodulation distortion(IMD3) over 10 dB is extended over 200 MHz with the center frequency of 1.6 GHz. We performed an efficient bandwith measurement for the feed-forward compensation system, which uses the network analyzer instead of the traditional measuring system that uses two RF signal generators and the spectrum analyzer. We identify the usefulness of this method from experimental results. In this study, we used cheap digital-purpose laser diodes for economical aspect, which proves the efficiency of the proposed analog system. The spurious-free dynamic range is improved about 6 dB/Hz.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.16 no.9
• /
• pp.1788-1795
• /
• 1992

Numerical simulations have been performed to investigate various spectral estimators used in LDV signal processing. In order to simulate a particle arrival time statistics known as the doubly stochastic poisson process, an autoregressive vector model was adopted to construct a primary velocity field. The conditional Poisson process with a random rate parameter was generated through the rescaling time process using the mean value function. The direct transform based on random sampling sequences and the standard periodogram using periodically resampled data by the sample and hold interpolation were applied to obtain power spectral density functions. For low turbulent intensity flows, the direct transform with a constant Poisson intensity is in good agreement with the theoretical spectrum. The periodogram using the sample and hold sequences is better than the direct transform in the view of the stability and the weighting of the velocity bias for high data density flows. The high Reynolds stress and high fluctuation of the transverse velocity component affects the velocity bias which increases the distortion of spectral components in the direct transform.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.15 no.4
• /
• pp.43-50
• /
• 2001

In this paper, the discharge phenomena and electromagnetic waves caused by discharge with insertion of a solid insulator and flame between sphere-sphere electrodes in air ware investigated. The surface discharge light and patterns of flame generated on a solid insulator surface were observed by using a CCD(Charged Coupled Device) camera. Also, the radiated electromagnetic waves were measured by using a biconical antenna and a spectrum analyzer. The surface discharge light generated on the solid insulator surface was larger and the size of flame was smaller by increasing allied voltages. Also, voltage distortion by voltage drop was strongly revealed when a insulator surface was polluted. When a solid insulator surface was not polluted, the electric field stength of electromagnetic waves was 10∼17[dBuV/m] higher than a polluted solide insulator, and 5∼9[dBuV/m] higher than a polluted solide insulator and flame.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.7 no.5
• /
• pp.907-912
• /
• 2006

Pre-emphasizing the speech compensates for falloff at high frequencies. The most common form of pre-emphasis is y(n)=s(n)-A${\cdot}$s(n-1), where A typically lies between 0.9 and 1.0 in voiced signal. And, this value reflects the degree of pre-emphasis and equals R(1)/R(0) in conventional method. This paper proposes a new flattening method to compensate the weaked high frequency components that occur by vocal cord characteristic. We used QMF(Quardrature Mirror Filter) to minimize the output signal distortion. After using the QMF to compensate high frequency components, flattening process is followed by R(1)/R(0) at each frame. Experimental results show that the proposed method flattened the weaked high frequency components effectively than auto correlation method. Therefore, the flattening algorithm will apply in speech signal processing like speech recognition, speech analysis and synthesis.

• Journal of KIISE:Software and Applications
• /
• v.30 no.11
• /
• pp.1037-1043
• /
• 2003

This paper describes a speech synthesis technique using a diphone as an unit phoneme. Speech synthesis is basically accomplished by concatenating unit phonemes, and it's major problem is discontinuity at the connection part between unit phonemes. To solve this problem, this paper proposes a new spectral smoothing technique which reflects not only formant trajectories but also distribution characteristics of spectrum and human's acoustic characteristics. That is, the proposed technique decides the quantity and extent of smoothing by considering human's acoustic characteristics at the connection part of unit phonemes, and then performs spectral smoothing using weights calculated along a time axis at the border of two diphones. The proposed technique reduces the discontinuity and minimizes the distortion which is caused by spectral smoothing. For the purpose of performance evaluation, we tested on five hundred diphones which are extracted from twenty sentences using ETRI Voice DB samples and individually self-recorded samples.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.3
• /
• pp.562-569
• /
• 2019

Raman spectroscopy has been receiving increased attention as a standoff explosive detection technique. In addition, there is a growing need for a fast search method that can identify raman spectrum for measured chemical substances compared to known raman spectra in large database. By far the most simple and widely used method is to calculate and compare the Euclidean distance between the given spectrum and the spectra in a database. But it is non-trivial problem because of the inherent high dimensionality of the data. One of the most serious problems is the high computational complexity of searching for the closet spectra. To overcome this problem, we presented the MPS Sort with Sorted Variance+PDS method for the fast algorithm to search for the closet spectra in the last paper. the proposed algorithm uses two significant features of a vector, mean values and variance, to reject many unlikely spectra and save a great deal of computation time. In this paper, we present two new methods for the fast algorithm to search for the closet spectra. the PCA+PDS algorithm reduces the amount of computation by reducing the dimension of the data through PCA transformation with the same result as the distance calculation using the whole data. the Hierarchical Cluster Tree algorithm makes a binary hierarchical tree using PCA transformed spectra data. then it start searching from the clusters closest to the input spectrum and do not calculate many spectra that can not be candidates, which save a great deal of computation time. As the Experiment results, PCA+PDS shows about 60.06% performance improvement for the MPS Sort with Sorted Variance+PDS. also, Hierarchical Tree shows about 17.74% performance improvement for the PCA+PDS. The results obtained confirm the effectiveness of the proposed algorithm.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.27 no.2
• /
• pp.75-79
• /
• 2017

Honeycomb-shaped Ag-grid transparent conductive electrodes (TCEs) were fabricated using two different processes, high density plasma etching and lift-off, and the optical and electrical properties were compared according to the fabrication method. For the fabrication of the Ag-grid TCEs by plasma etching, etch characteristics of the Ag thin film in $10CF_4/5Ar$ inductively coupled plasma (ICP) discharges were studied. The Ag etch rate increased as the power increased at relatively low ICP source power or rf chuck power conditions, and then decreased at higher powers due to either decrease in $Ar^+$ ion energy or $Ar^+$ ion-assisted removal of the reactive F radicals. The Ag-grid TCEs fabricated by the $10CF_4/5Ar$ ICP etching process showed better grid pattern transfer efficiency without any distortion or breakage in the grid pattern and higher optical transmittance values of average 83.3 % (pixel size $30{\mu}m/line$ width $5{\mu}m$) and 71 % (pixel size $26{\mu}m/line$ width $8{\mu}m$) in the visible range of spectrum, respectively. On the other hand, the Ag-grid TCEs fabricated by the lift-off process showed lower sheet resistance values of $2.163{\Omega}/{\square}$ (pixel size $26{\mu}m/line$ width $18{\mu}m$) and $4.932{\Omega}/{\square}$ (pixel size $30{\mu}m/line$ width $5{\mu}m$), respectively.