• Journal of Korean Society for Atmospheric Environment
• /
• v.19 no.1
• /
• pp.45-56
• /
• 2003

In this study the distribution patterns of the metallic components were analyzed both before and after the Asian Dust (AD) events at 2001 by comparing the chemical composition of metallic components in terms of various statistical methods. According to the AD/NAD concentration ratio of metallic components, the main components of crustal soils were exhibiting the values above 1.0; but opposite results were seen dominantly for hazardous metallic components. Examination of fine-to-coarse (F/C) ratios of metallic components showed higher values for major anthropogenic components including Pb (5.83). Ni (2.61), etc. Comparison of our measurement data with those obtained within and across the Korean peninsula indicated that the metallic distribution patterns of the study area can be distinguished from previous studies. The results of our analysis, when investigated in relation with air mass movement patterns. indicated evidence of the direct influence of AD events and anthropogenic processes.

• Journal of Korean Society for Atmospheric Environment
• /
• v.17 no.4
• /
• pp.299-312
• /
• 2001

The analysis of vent -emitted Hg concentrations and relevant environmental parameters was made from the inlet of 42 ventpipes in Nan-Ji-Do area of Seoul during September/october of 2000. Using these data, the fluxes of Hg from the ventpipes were also derived. The mean concentration of Hg, computed using the data sets collected from 42 ventpipes, was 420$\pm$619ng m$^{-3}$ with the range of 3.45~2,952ng m$^{-3}$ . Because of large differences in concentration levels between two sectors 1 and 2 and between plain and slope areas. evaluation of the data was made by dividing them into four different categories such as plain areas of sectors 1 and 2 (and/or slope areas of sectors 1 and 2). When this classification was applied, the computed fluxes were highly different among each group with the generally enhanced fluxes in plain area relative to slope area. The computed fluxes were then used to make comparative analysis of different source processes in the study area.

• Journal of Electrical Engineering and Technology
• /
• v.3 no.1
• /
• pp.121-124
• /
• 2008

This paper presents the fabrication and field emission of carbon nanotube field emitters for a micro mass spectrometer. The carbon nanotube is an adequate material as a field emitter since it has good characteristics. We have successfully fabricated a diode field emitter and a triode field emitter. Each field emitter has been constructed using several micromachining processes and a thermal CVD process. In the case of the diode field emitter, to increase the electric field, the carbon nanotubes are selectively grown on the patterned nickel catalyst layer. The electron current of the diode field emitter is 73.2 ${\mu}A$ when the anode voltage is 1100V. That of the triode field emitter is 3.4 pA when the anode voltage is 1000V.

• Journal of the Korean Society of Combustion
• /
• v.4 no.2
• /
• pp.1-10
• /
• 1999

Pulverized coal is widely used as the source of electrical power generation and industrial processes. Numerical analysis on the transient ignition process of the cloud of pulverized coal particles in various cases is carried out. Particle radius, initial particle temperature, number density are chosen as major parameters that influence the characteristics of ignition and combustion. The result can be summarized as follow. The ignition occurs at the position that is closed to the surface of the cloud. Maximum temperature and velocity appear at ignition point, and the concentrations of gaseous fuel and oxidizer decrease rapidly near the ignition point. The chemical reaction takes place in wider zone as number density and particle radius decrease. The ignition delay is shortest when particle radius is about $50\;{\mu}m$, and tends to be shorter as number density and initial ambient temperature increase.

• Journal of Microbiology and Biotechnology
• /
• v.25 no.11
• /
• pp.1773-1781
• /
• 2015

Environmental security is one of the major concerns for the safety of living organisms from a number of harmful pollutants in the atmosphere. Different initiatives, legislative actions, as well as scientific and social concerns have been discussed and adopted to control and regulate the threats of environmental pollution, but it still remains a worldwide challenge. Therefore, there is a need for developing certain sensitive, rapid, and selective techniques that can detect and screen the pollutants for effective bioremediation processes. In this perspective, isolated enzymes or biological systems producing enzymes, as whole cells or in immobilized state, can be used as a source for detection, quantification, and degradation or transformation of pollutants to non-polluting compounds to restore the ecological balance. Biosensors are ideal for the detection and measurement of environmental pollution in a reliable, specific, and sensitive way. In this review, the current status of different types of microbial biosensors and mechanisms of detection of various environmental toxicants are discussed.

• International Journal of Automotive Technology
• /
• v.5 no.3
• /
• pp.195-200
• /
• 2004

This paper is concerned with the Homogeneous Charge Compression Ignition (HCCI) engine as a new concept in engines and a power source for future automotive applications. Essentially a combination of spark ignition and compression ignition engines, the HCCI engine exhibits low NOx and Particulate Matter (PM) emissions as well as high efficiency under part load. The objective of this research is to determine the effects of Exhaust Gas Recirculation (EGR) rate on the combustion processes of HCCI. For this purpose, a 4-cylinder, compression ignition engine was converted into a HCCI engine, and a heating device was installed to raise the temperature of the intake air and also to make it more consistent. In addition, a pressure sensor was inserted into each of the cylinders to investigate the differences in characteristics among the cylinders.

• Bulletin of the Korean Space Science Society
• /
• 2003.10a
• /
• pp.27-27
• /
• 2003

The Automated Quantitative Knife-Edge Test (AQuaKET) method was developed for testing the surface profiles of large optics with high accuracy. Testing with the required accuracy of very large telescope is not an easy job to achieve, as it is a nano-technology. There are lots of possible error sources which can occur during the measurements and in the data processing of the AQuaKET. The error sources can be categorized into 5 areas: optics, mechanics, electronics, numerical processes, and system. In this paper, possible error sources in Optics are discussed, which are intensity variation of the light source, diffraction effects, and parallax effect. In this talk, those possible error sources in optics are presented and discussed.

• Journal of Korean Neurosurgical Society
• /
• v.42 no.6
• /
• pp.470-474
• /
• 2007

Objective : The brain is dependent on glucose as an energy source. Intricate homeostatic mechanisms have been implicated in maintaining the blood glucose concentration in the brain. The aim of this study is to find the way to identify the metabolic proteins regulating the glucose in rat hypothalamus. Methods : In this study, we analysed the secretome from rat hypothalamus in vivo. We introduced 500 nM of insulin into the rat hypothalamus. The chromatographic patterns of the secretome were identified, after which Mass Spectrometry-Mass Spectrometry (MS-MS) analysis was performed. Results : In Liquid Chromatography-Mass Spectrometry (LC-MS) analysis, 60 proteins were identified in the secretome. Among them, 8 novel proteins were unveiled and were associated with the energy metabolism of insulin signaling in mitochondria of rat hypothalamic neuron. Nineteen other proteins have unknown functions. These ligands were confirmed to be secreting from the rat hypothalmus on insulin signaling by western blotting. Conclusion : The hypothalamus is the master endocrine gland responsible for the regulation of various physiological and metabolic processes. Proteomics using LC-MS analysis offer a efficient means for generating a comprehensive analysis of hypothalamic protein expression by insulin signaling.

• The Korean Journal of Malacology
• /
• v.32 no.1
• /
• pp.63-65
• /
• 2016

Carbonic anhydrase (CA), which is involved in shell formation processes in bivalves, is one of the major biocatalysts for carbon capture and storage. In this study we investigated CA activity in the total hemocytic proteins of five bivalves. The highest CA activity was observed in Scapharca broughtonii, which had more than twice the activity found in Crassostrea gigas. No CA activity was observed among the total hemocytic proteins of Pinctada fucata and Saxidomus purpuratus. The results suggest that marine invertebrates may provide a better source of CA, as an alternative to mammalian sources.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.35 no.3
• /
• pp.74-80
• /
• 1993

Runoff simulation tests to investigate the flow mechanics of nonsuomerged overland flow in a natural grass intervening land system were condueted and a modified kinematic wave overland runoff model developed by Choi et al. (1993) was verified. Nonhomogeneity and heterogeneity of the soil, slope, local topography, infiltration, grass density, and the density and activity of the soil microhes and wild animals were the major factors affecting the flow. Streamlines were disturbed by grass stems and small concentrated flows due to the disturbed streamlines and local topography were observed a lot. Relatively larger concentrated flows were observed where bundles of grass were dominant than where individual grasses were growing. Predicted hydrographs were agreed verv well with measured hydrographs. Since the modified model considers grass density in computing flow depth and hydraulic radius, it can be better than existing kinematic wave model if it were used to route nonpoint source pollutant attenuation processes in many grass intervening land systems.