• 한국응용과학기술학회지
• /
• 제23권1호
• /
• pp.37-44
• /
• 2006

Solvent-free low foaming scouring agents (LFSC) were prepared by blending of 2-ethylhexylaminoethyl sulfate (2-EHAS), POE(10) octadecylbenzyl- ammonium chloride (POBAC) and Sedlan FF-200 (FF-200). As the results of several tests, 2-EHAS/POBAC/FF-200/water (8g/12g/20g/60g) mixture (LFSC-5) showed good cleaning power, penetrating ability and stability to alkali, and gave less problem in water pollution. The foaming power of LFSC-5 measured by Ross and Miles method was 8mm foam height immediately after foaming, and that measured by Ross and Clark method was less than 300mm foam height at $30^{\circ}C$, and 18mm at $80^{\circ}C$. As a result, LFSC-5 proved a good low foaming scouring agent for fiber.

• 한국응용과학기술학회지
• /
• 제21권2호
• /
• pp.156-163
• /
• 2004

Low foaming scouring agents (LSSA) were prepared by blending of amine salt of dodecylbenzene sulfone, poly (PO-b-EO) glycol, Newpol PP-2000, MJU-100, ethylene glycol and organic solvent. As the results of several tests, LSSA-2 showed good scouring effect, penetrating ability and emulsifiability, and showed not much water pollution. The foaming power of LSSA-2 measured by Ross & Miles method was 11mm foam height immediately after foaming. And the foaming power of LSSA-2 measured by Ross & Clark method were less than 310mm foam height at $30^{\circ}C$, 17mm at $80^{\circ}C$. As a result, LSSA-2 was proved as a good foaming scouring agent.

• Elastomers and Composites
• /
• 제51권2호
• /
• pp.93-98
• /
• 2016

The composites of EVA/EPDM including aluminum trioxide (ATH) as a fire retardant were manufactured for the purpose of improving low temperature property and flame resistance in the rubbery materials. The ratio of EVA to EPDM didn't affect the flame resistance of the rubber composites. The addition of ATH resulted in increase of the flame resistance. In the evaluation of the cold resistance, the increasing EPDM content showed enhancement of cold resistance in the composites due to increasing low Tg EPDM. It was found out that tensile strengths of the composites showed a maximum value at 100 phr of ATH by reinforcing effect, but a minimum value at 200 phr of ATH owing to slippage between the flame retardant by the external stress. In the measurement of solvent resistance in tetrahydrofuran, the increasing ATH content yielded enhancement of solvent resistance by reducing swelling of the composite, and increasing EPDM content also resulted from increase of the solvent resistance by reduction of polarizability as well as increase of crosslink in the composites.

• Bulletin of the Korean Chemical Society
• /
• 제35권9호
• /
• pp.2711-2716
• /
• 2014

The high content of potassium in molasses limits its usage as a raw material for stock feed. Moreover, its high viscosity makes it difficult to develop an efficient removal process. In this study, ion exchange and solvent extraction experiments have been performed to investigate the removal of potassium from a mixture of molasses with water. Cationic exchange resins (AG50W-X8 and Diphonix) showed a high loading percentage of potassium but the occurrence of breakthrough in few bed volumes was a drawback to the industrial application. Among the cationic extractants (D2EHPA, PC 88A, Cyanex 272) tested in this study, saponified PC 88A was found to be the best extractant for the removal of potassium. Batch simulation studies on a three stage counter current extraction confirmed that 85% of potassium was removed from 50 wt % molasses solution in water by using saponifed PC 88A.

• 자원리싸이클링
• /
• 제22권1호
• /
• pp.11-19
• /
• 2013

코발트와 니켈에 대한 수요가 증가함에 따라 다양한 자원으로부터 순도가 높은 상태로 이 금속들을 회수하는 것은 중요하다. 고순도 코발트와 니켈을 얻기 위해서는 다른 금속이온과의 분리가 필요하다. 본 총설에서는 순수한 코발트와 니켈용액을 얻을 수 있는 용매추출, 이온교환 및 침전법을 소개하고 비교하였다. 특히 용매추출에 대해서는 기존 공정의 장단점과 함께 공정조건을 조사하였다.

• Macromolecular Research
• /
• 제13권2호
• /
• pp.152-155
• /
• 2005

A dynamic density functional theory is presented for the observation of the phase revolutions of a solution-casting film of di- and tri-block copolymers under solvent evaporation conditions. With the evaporation of the solvent, the inverted phases, the minor part of the component becomes the continuous phase at the higher solvent evaporation rate, as observed in this experiment. Further simulation revealed that these inverted phases are converted into the normal phase and the major part of the component becomes the continuous phase, implying that the inverted phases observed in this experiment are unstable.

• 한국고분자학회:학술대회논문집
• /
• 한국고분자학회 2006년도 IUPAC International Symposium on Advanced Polymers for Emerging Technologies
• /
• pp.344-344
• /
• 2006

Poly(n-hexyl-(S)-3-methylpentylsilane) aggregates confined in microcapsules to keep the aggregation number and ranging in average polymer mass in a microcapsule from $2{\Box}10^{-16}\;to\;2{\Box}10^{-14}g$. were studied by circular dichroism measurements in ethanol (a non solvent) and tetrahydrofuran (an associative solvent at low temperature) at varioustemperatures. The size of each aggregate did not affect the optical activity because the circular dichroism was proportional to the aggregation number at the same condition. Moreover, the circular dichroism appreciably reflected the prepared method, i.e. temperature and solvent.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2006년도 6th International Meeting on Information Display
• /
• pp.1150-1153
• /
• 2006

In this paper, we investigated the effect of solvent on electrical properties of triisopropylsilyl (TIPS) pentacene organic thin-film transistors (OTFTs). The TIPS pentacene was spin coated by using chlorobenzene, p-xylene, chloroform and toluene as solvent. Fabricated OTFT with chlorobenzene showed field-effect mobility of $0.01\;cm^2/V{\cdot}s$, on/off ratio $4.3{\times}10^3$ and threshold voltage of 5.5 V. In contrast, with chloroform the mobility was $5.8{\times}10^{-7}\;cm^2/Vs$, on/off ratio $1.1{\times}10^2$ and threshold voltage of 1.7 V.

• 공업화학
• /
• 제7권1호
• /
• pp.1-8
• /
• 1996

자동차 엔진용 thermostat에서 냉각수 온도제어를 위해 사용되는 wax의 제조 및 성분 분석을 실시하였다. 제조된 시료에 대해 lift 실험을 실시해 본 결과, 용제 추출법에 의해 제조된 시료가 자동차 엔진용 thermostat으로 사용 가능한 범위내에 있게 됨을 볼 수 있었다. 또한, 원유의 pitch를 용제 추출한 후 감압 증류 및 산처리를 하면 보다 정밀한 wax를 제조 할 수 있음을 알 수 있었다.

• Korea-Australia Rheology Journal
• /
• 제14권2호
• /
• pp.71-76
• /
• 2002

Metal thin films, which are indispensable constituents of ULSI (Ultra Large Scale Integration) circuits, have been fabricated by physical or chemical methods. However, these methods have a drawback of using expensive high vacuum instruments. In this work, the fabrication of tungsten metal film by spin coating was investigated. First of all, inorganic peroxopolytungstic acid (W-IPA) powder, which is soluble in water, was prepared by dissolving metal tungsten in hydrogen peroxide and by evaporating residual solvent. Then, the solution of W-IPA was mixed with organic solvent, which was spin-coated on wafers. And then, tungsten metal films, were obtained after reduction procedure. By selecting an appropriate organic solvent and irradiating UV, the sheet resistance of the tungsten metal film could be remarkably reduced.