• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2003.11a
• /
• pp.130-134
• /
• 2003

The quantity of solid waste produced during HANARO operation for the years from 1996 to 2002 has been investigated and the interrelation with the reactor power output has been analysed. The waste amount produced during this period was $69, 598{\ell}$ and the processing expense was 1, 878, 000 won. The waste amount and processing expense per reactor power output are $3.01{\ell}/MWD$ and 811 won/MWD, respectively. A dry equipment for the spent resin was developed and the spent resin volume has been reduced by about 40% by using it.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.5 no.2
• /
• pp.116-123
• /
• 2010

The current enforcement regulation of "The Act on the Promotion of Construction Waste Recycling" defines disposal method of combustible construction waste without obvious recyclging method of those. This leads most combustible construction waste to incinerate or landfill as mixed construction waste. Therefore, it needs regulations to decrease incineration or landfill and to increase recyling of combustible construction waste. This study analyzed the problems of disposal and management of domestic combustible construction waste. As well as considerated regulations relative to utilization of waste solid fuel. From these results, it suggested utilization plans of combustible construction waste as fuel.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.80-83
• /
• 2001

According to the EPA in Taiwan report, 9.05 million metric tons of solid wastes were generated in 1999, and the waste glass was accounted of 4.95 percent. However, with the increasing tonnage of disposal cost and existing disposal sites are reaching full capacity, recycling is currently accepted as a sustainable approach to waste management. Therefore, it's essential and urgent that the government in Taiwan establish the recycling and recovery framework for the minimization of the solid waste, reduction of materials and energy consumption, and the encouragement for the reuse, recycle and recovery development. To achieve this Boal, Taiwan has been strived for a long period of time in waste glass recovery and recycle. Waste glass, unlike other kinds of resource waste, is 100% recyclable. The EPA in Taiwan now center on a lot of different kinds of waste glass, such as glass container, flat glass, CRT glass, windshields glass, fluorescent lamps, and waste pesticide glass container. This article will focus on the framework of the recycling market access, and also try to provide some strategies to improve waste glass recycling efficiently.

• Environmental Engineering Research
• /
• v.11 no.1
• /
• pp.14-27
• /
• 2006

The proper management of discarded electronic devices (often called electronic-waste) is an emerging issue for solid waste professionals throughout the world because of the large growth of the waste stream, and the content of toxic metals in them, most notably heavy metals such as lead. Notebook computers are becoming one of the major components of discarded computer devices and will continue to increase in the waste stream in the future. While the computers hold great promise for recycling, a substantial amount of this waste is often disposed in municipal solid waste (MSW) landfills. The toxicity characteristic leaching procedure (TCLP) is commonly used to simulate worse case leaching conditions where a potentially hazardous waste is assumed to be disposed along with municipal solid waste in a landfill with actively decomposing materials overlying an aquifer. The objective of this study was to examine leaching potential of lead from discarded notebook computers using the scale-up TCLP, other standard leaching tests such as California waste extraction test (Cal WET), and the synthetic precipitation leaching procedure (SPLP) and actual landfill leachates as leaching solution. The scale-up TCLP is a modified TCLP (where the device was disassembled and leached in or near entirety) to meet the intent of the TCLP. The results showed that the scale-up TCLP resulted in relatively high lead found in the leachate with an average of 23.3 mg/L. The average level was less than those by the standard TCLP and WET (37.0 mg/L and 86.0 mg/L, respectively), but much greater than those by the SPLP and the extractions with the landfill leachates (0.55 mg/L and 1.47 mg/L, respectively). The pH of the leaching solution and the ability of the organic acids in the TCLP and WET to complex with the lead were identified as major factors that controlled the amount of lead leached from notebook computers. Based on the results obtained by a number of leaching tests in this study, notebook computers may present a potential leaching risk to the environment and human health upon land disposal. However, further investigation is still needed to assess the true risk posed by the land disposal of discarded notebook computers.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.6 no.2
• /
• pp.69-79
• /
• 1998

The purpose of this study is to suggest the design parameters, which are applied to the solid waste treatment and management systems in rural area. In order to drive out the parameters, the solid waste production and management systems in rural and urban areas had been surveyed and analyzed, respectively. The comparisons of the analyzed results are also introduced in the paper. The rural areas referred to the survey are grouped in accordance with the industrial activities in those areas. The conclusions of the study are as follows: 1) The solid waste volumes produced per day per capita in rural area are less than those of urban area. For example, the average volume produced in rural area in 1995 is 0.85kg, which is two thirds of those in Seoul area. 2) for the treatment, the country has depended mainly on landfill. On the other hand, the incineration treatment ratio has been in creasing in rural area. 3) The physical and chemical properties of the rural solid waste, according to the analysis, are similar to those of the urban areas, which means the living pattern in those two areas have a little difference.

• Journal of the Korea Institute of Building Construction
• /
• v.16 no.1
• /
• pp.53-58
• /
• 2016

In order to investigate the feasibility of municipal solid waste incineration ash melted slag powder as admixture, an experimental study was performed on cement mortar with municipal solid waste incineration ash melted slag powder. Fresh mortar properties and strength properties with various municipal solid waste incineration ash melted slag powder replacement ratios were estimated. There replacement ratio adopted in this study was 0, 10, 20, 30, 40, 50%. After then flow properties was considered as properties of fresh mortar. And compressive strength was determined 3, 7, 14, 28, 56 days for the hardened mortar specimens. According to the test results, the flow of mortar was increased with in replacement amount of municipal solid waste incineration ash melted slag powder. Furthermore, compressive strength at early age was decreased, whereas the compressive strength at the age of 28, 56day was increased.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2018.11a
• /
• pp.349-350
• /
• 2018

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.20 no.9
• /
• pp.2924-2932
• /
• 1996

As the environmental pollution can be greatly reduced and the waste heat can be also recovered through a combustion of municipal solid waste, the incineration begins to be highlighted recently in our country. But it is very difficult to be operated with constant combustion conditions for a long time as the domestic waste is composed of various components, contains a large percentage of water, and has a low heating value. Therefore, the cold flow test and partial hot flow test were conducted in the incinerator by use of injection angles of a secondary air affecting fluid flow as the first action to maintain the optimum combustion conditions. A model to a scale of 1:10 was designed and manufactured through the similarity of model and prototype flows. Velocities and temperatures were measured through the experiment. From the results, fluid flows of secondary air obtained from partial hot flow test correspond almost well with those of main flow obtained from cold flow test. Consequently, injection angles of secondary air are proved to affect main flow decisively.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.675-679
• /
• 2001

The research is to discuss the current resource recycling and recovery policy, which was enacted by Environmental Protection Administrative (EPA) in Taiwan. For the past few years, the solid waste generated in Taiwan has greatly increased about 5 % per year. In addition to the construction of landfill sites and incineration plants, 4 R techniques (Reduction, Reuse, Recycle and Recovery) were also publicized among the citizens and then promulgated to furthermore manage these increased solid waste. Although the regulations have been carried out to a great success, they still need to be revised and updated since solid waste contains varieties of different materials. Therefore, this research discusses the current regulation and makes suggestion for future regulation revision. From the results of this study, energy recovery was suggested to be emphasized in the regulation. Energy could be recovered from materials such as waste tires, and all kinds of plastic containers. Waste tires and most of the plastic containers made of hydrocarbon species, which contains great heating values, should be considered as one of the alternatives for the resource recycling.

• Mass Spectrometry Letters
• /
• v.2 no.1
• /
• pp.12-15
• /
• 2011

The Korean government has regulated emission of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in waste water of manufacturing facilities producing chlorinated compounds since 2009. As this regulation is expected to be reinforced in 2013 to 50 pg I-TEQ/L, a large sample volume is required for the analysis of trace amounts of PCDD/Fs in waste water. Liquid-liquid extraction (LLE) is used to extract PCDD/Fs from aqueous samples; however, its low efficiency makes it inadequate for analyzing large sample volumes. Herein, we present a disk-type solid-phase extraction (SPE) method for the analysis of dioxin at a part per quadrillion level in waste water. This SPE system contains airtight glass covers with a decompression pump, which enables continuous semi-automated extraction. Small (0.5 L) and large (7 L) samples were extracted using LLE and SPE methods, respectively. The method detection limits (MDLs) were 0.001.0.25 and 0.015.4.1 pg I-TEQ/L for the SPE and LLE methods, respectively. The concentrations of detected congeners with both methods were similar. However, the concentrations of several congeners that were not detected with the LLE method were quantified using the SPE method.