• 한국표면공학회지
• /
• 제43권1호
• /
• pp.7-11
• /
• 2010

Solid phase crystallization (SPC) is a simple method in producing a polycrystalline phase by annealing amorphous silicon (a-Si) in a furnace environment. Main motivation of the crystallization technique is to fabricate low temperature polycrystalline silicon thin film transistors (LTPS-TFTs) on a thermally susceptible glass substrate. Studies on SPC have been naturally focused to the low temperature regime. Recently, fabrication of polycrystalline silicon (poly-Si) TFT circuits from a high temperature polycrystalline silicon process on steel foil substrates was reported. Solid phase crystallization of a-Si films proceeds by nucleation and growth. After nucleation polycrystalline phase is propagated via twin mediated growth mechanism. Elliptically shaped grains, therefore, contain intra-granular defects such as micro-twins. Both the intra-granular and the inter-granular defects reflect the crystallinity of SPC poly-Si. Crystallinity and SPC kinetics of high temperatures were compared to those of low temperatures using Raman analysis newly proposed in this study.

• Bulletin of the Korean Chemical Society
• /
• 제27권10호
• /
• pp.1557-1561
• /
• 2006

The use of chemically modified silica-salen$(NEt_2)_2$ was studied for the separation and concentration of the metal ions from an aqueous solution by a solid phase extraction. After the salen(NEt2)2 was synthesized, it was chemically bonded to silica gel by a diazonium coupling reaction. The adsorption capacities and binding constants were obtained with respect to Cu(II), Mn(II), Pb(II) and Zn(II) by a graphical method. Some experimental conditions were optimized for the determination of the trace elements. After the silica-salen(NEt2)2 was pulverized in a sample solution of which the pH was adjusted, the solution was stirred to pre-concentrate the metal ions. The metal ions adsorbed were desorbed with nitric acid solution. And the concentrated analytes were determined by a flame AAS. The method proposed here was so rarely influenced by a sample matrix that the procedure was applied to 3 types of water samples. The reproducible results of less than 10% RSD were obtained at the concentration level of ca. 100 ng/mL and the recoveries of 95-109% were obtained in the spiked samples in which given amounts of analytes were added.

• 한국연초학회지
• /
• 제28권2호
• /
• pp.152-157
• /
• 2006

A new procedure has been developed for the quantitation of aromatic amines in mainstream cigarette smoke. Two solid-phase extraction (SPE) clean up steps, using a different retention mechanisms, are required to process the samples. The first step used a cation-exchange cartridge, followed by a second step that used a cartridge with a hydrophobic retention character. The aromatic amines eluted from the second SPE cartridge are derivatized with pentafluoropropionic anhydride. This new method have advantages over other reported techniques, being sensitive, robust, and easily automated. The detection limits were ranged from 0.12 ng/mL for 1-aminonaphthalene to 0.16 ng/mL for 3-aminobiphenyl and the recoveries were from 97 to 106%. Compared with other reports for analysis of 2R4F reference cigarette, this method shows a close analytical data and good repeatability.

• Journal of Mechanical Science and Technology
• /
• 제18권10호
• /
• pp.1712-1721
• /
• 2004

A method of measuring the thermal diffusivity of semi-infinite solid material at room temperature using photothermal displacement is proposed. In previous works, within the constant thickness of material, the thermal diffusivity was determined by the magnitude and phase of deformation gradient as the relative position between the pump and probe beams. In this study, however, a complete theoretical treatment of the photothermal displacement technique has been performed for thermal diffusivity measurement in semi-infinite solid materials. The influence of parameters, such as, radius and modulation frequency of the pump beam and the thermal diffusivity, was studied. We propose a simple analysis method based on the zero -crossing position of real part of deformation gradient and the minimum position of phase as the relative position between two beams. It is independent of parameters such as power of pump beam, absorption coefficient, reflectivity, Poisson's ratio, and thermal expansion coefficient.

• Bulletin of the Korean Chemical Society
• /
• 제30권6호
• /
• pp.1325-1330
• /
• 2009

A general method has been developed for the solid phase synthesis of drug-like 7-aryl-benzo[b][1,4]oxazin-3(4H)- one derivatives 6. The method relies on a novel, microwave irradiation promoted cyclization reaction of the BOMBA resin bound, N-substituted-$\alpha$-(2-chloro-4-bromophenoxy)acetamide 3 that takes place via a Smiles rearrangement. The 7-bromobenzo[1,4]oxazine 4, produced in this process is converted to 7-aryloxazin analogs 5 by utilizing Suzuki coupling with various substituted arylboronic acids. Finally, the target 7-aryl-benzo[b][1,4]oxazin-3(4H)-ones 6 are liberated from the resin by treatment with 5% TFA. The progress of the reactions involved in this preparative route can be monitored by using ATR-FTIR spectroscopy on a single bead. The target compounds, obtained by using this five-step sequence, are produced in high yields and purities.

• Bulletin of the Korean Chemical Society
• /
• 제30권11호
• /
• pp.2675-2679
• /
• 2009

This paper reports the example of headspace mulberry paper bag micro solid phase extraction (HS-MPB-$\mu$-SPE) as a new sampling method for the determination of volatile flavor composition of coriander seeds. Adsorption efficiencies between two configurations of mulberry paper bag were compared, and several parameters affecting the HS-MPB-$\mu$-SPE were investigated and optimized. The optimized technique uses an adsorbent (Tenax TA, 0.1 mg) contained in a mulberry paper bag of front configuration where fine surface was outside, and minimal amount of organic solvent (0.6 mL). Linalool and $\gamma$-terpinene were found as abundant flavor compounds from coriander seeds. The limit of detection (LOD) and the limit of quantitation (LOQ) for linalool of major flavor in coriander seeds were 10.3 ng/mL and 34.4 ng/mL, respectively. The proposed method showed good reproducibility and good recovery. The HS-MPB-$\mu$-SPE is very simple to use, inexpensive, requires small sample amounts and solvent consumption. Because the solvent for extraction is reduced to only a very small volume, there is minimal waste or exposure to toxic organic solvent and no further concentration step.

• 식품보건융합연구
• /
• 제10권3호
• /
• pp.19-22
• /
• 2024

The field of synthetic biology has emerged in response to the ongoing progress in the life sciences. Advances have been made in medicine, farming, eating, making materials, and more. Synthetic biology is the exploration of using living organisms to create new organisms. By manipulating specific genes to express targeted proteins, proteins can be created that are both productive and cost-effective. Solid-phase extraction (SPE) and liquid-liquid extraction (LLE) are employed for protein separation during the production process involving microorganisms. This study centers on Scanning Probe Microscopy (SPM) to showcase its utility in the food industry and food management. SPE is predominantly utilized as a pretreatment method to eliminate impurities from samples. In comparison to LLE, this method presents benefits such as decreased time and labor requirements, streamlined solvent extraction, automation capabilities, and compatibility with various other analytical instruments. Anion exchange chromatography (AEC) utilizes a similar methodology. Pharmaceutical companies utilize these technologies to improve the purity of biopharmaceuticals, thereby guaranteeing their quality. Used in the food and beverage industry to test chemical properties of raw materials and finished products. This exemplifies the potential of these technologies to enhance industrial development and broaden the scope of applications in synthetic biology.

• 대한화장품학회지
• /
• 제30권3호
• /
• pp.399-404
• /
• 2004

새로운 Gly-His-Lys (약자로 GHK)가 결합된 키토산을 $N^{\alpha}-Fmoc$ 아미노산과 BOP 커플링 시약을 사용한 고상법에 의해 제조하였다. 이를 위해 키토산 마이크로 비드를 W/O 에멀젼 상분리법으로 평균 입자크기 70 마이크로미터로 얻었다. GHK 펩타이드는 순차적으로 고상법에 의해 키토산 마이크로비드 위에 커플링 하였다. 아미노산 분석을 실시한 결과 Gly, His, kys의 비율이 1.02:1.13:0.96의 비율로 나타나 이론치와 거의 일치함을 확인할 수 있었다. GHK 펩타이드가 결합된 마이크로비드의 세포증식 효과는 MTT 분석으로 측정하였다. 측정결과 GHK 펩타이드가 결합된 키토산 마이크로비드는 대조군인 펩타이드가 결합되지 않은 키토산 마이크로비드 자체에 비해 높은 세포증식 효과를 보였다.

• 상하수도학회지
• /
• 제32권6호
• /
• pp.559-572
• /
• 2018

The aim of this study was to evaluate pretreatment methods for 27 pharmaceuticals and personal care products (PPCPs) in various sewage samples using a modified quick, easy, cheap, effective, rugged, and safe (QuEChERS) and online solid-phase extraction with LC-MS/MS. Extraction efficiencies of PPCPs in the solid phase under different experimental conditions were evaluated, showing that the highest recoveries were obtained with the addition of sodium sulfate and ethylenediaminetetraacetic acid disodium salt dehydrate in acidified conditions. The recoveries of target compounds ranged from 91 to 117.2% for liquid samples and from 61.3 to 137.2% for solid samples, with a good precision. The methods under development were applied to sewage samples collected in two sewage treatment plants (STPs) to determine PPCPs in liquid and solid phases. Out of 27 PPCPs, more than 19 compounds were detected in liquid samples (i.e., influent and effluent) of two STPs, with concentration ranges of LOQ-33,152 ng/L in influents and LOQ-4,523 ng/L in effluents, respectively. In addition, some PPCPs such as acetylsalicylic acid, ibuprofen, and ofloxacin were detected at high concentrations in activated sludge as well as in excess sludge. This methodology was successfully applied to sewage samples for the determination of the target compounds in STPs.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2008년도 12th Asian Congress of Fluid Mechanics
• /
• pp.33.3-33.3
• /
• 2008