• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5B
• /
• pp.573-581
• /
• 2011

The underwater channel is known to offer poor communications channel. The channel medium is highly absorptive and the transmission bandwidth is limited. In addition, the channel is highly frequency selective; the degree of selectiveness depends on a detailed geometry of the channel. Furthermore, the response changes over time as the channel conditions affecting the response such as water temperature, sea surface wind and salinity are time-varying. The transceiver design to deal with the frequency and time selective channel, therefore, becomes very challenging. It has been known that deep fading at certain specific sub-carriers are detrimental to OFDM systems. To mitigate this negative effect, the proposed coded OFDM system employs an LDPC code based modulation. In this paper, we aim 1) to provide a detailed underwater channel model; 2) to design a robust LDPC coded OFDM system; 3) to test the proposed system under a variety of channel conditions enabled by the channel model.

• Journal of the Korea Society of Computer and Information
• /
• v.17 no.7
• /
• pp.77-86
• /
• 2012

Using OFDM(Orthogonal Frequency Division Multiplexing) provides the same diversity order as MRRC(Maximal Ratio Receiver Combining). It is assumed that fading channel is constant across two consecutive symbols. Unfortunately, when the channel condition is changed for the two consecutive symbols, the OFDM using STBC(Space Time Block Code) does not offer good performance due to the large doppler shift. In this paper, we have proposed a performance enhancement scheme for OFDM using STBC over time-selective fading channel. Simulation results for various doppler shift rates are presented to robust system performance of OFDM due to using our proposed scheme over time-selective fading channel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.1C
• /
• pp.102-109
• /
• 2008

The higher data rate of mobile communications has been required for various multimedia services. In DS-CDMA system, one of the solutions to increase the throughput is to use multicode. However, multipath channel destorys the orthogonality of spreading codes, which causes the intercede interference(ICI). ICI gives severe effect on multicode DS-CDMA for BER performance. Conventionally, multicode DS-CDMA system uses the Rake receiver with turbo code, which cannot overcome error floor caused by ICI. In this paper, we propose frequency domain turbo equalization based on minimum mean squared error(FDTE-MMSE) for multicode DS-CDMA in frequency selective channel and evaluate its BER performance by computer simulation. The simulation results show that FDTE-MMSE gives much better performance in high Eb/N0 than the Rake receiver with turbo code in multipath length L>1.

• Proceedings of the KSR Conference
• /
• 2011.10a
• /
• pp.2493-2502
• /
• 2011

For Static analysis of software code, an experienced tester prefer detecting defects with using selective static technique. Many cases of static method have been reported such as coding rules, software metrics, defect data, etc. However, many of analysis case only present effectiveness of static analysis, not enough description for how the tester judged to classify code defects used in code analysis and removed them properly for ensure high quality. Occasionally, there are materials to show the effect of through some examples through some examples. But difficult to gain trust, because of not enough detail for application process. In this paper, introduced the static technique commonly used in railway and applied to the real development challenges. And the each of results were compared and analyzed. It is hard to generalize the results of this parer. But can be used and referenced as a case of study.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.2
• /
• pp.199-208
• /
• 2014

Code division multiple access (CDMA) is one of the promising medium access control (MAC) schemes for underwater acoustic sensor networks because of its robustness against frequency-selective fading and high frequency-reuse efficiency. As a way of performance evaluation, sea or lake experiment has been employed along with computer simulation.. In this study, we design the underwater CDMA forward-link transceiver and evaluate the feasibility aginst harsh underwater acoustic channel in water-tank first. Then, based on the water-tank experiment results, we improved the transceiver and showed the improvements in a lake experiment. A pseudo random noise code acquisition process is added for phase error correction before decoding the user data by means of a Walsh code in the receiver. Interleaving and convolutional channel coding scheme are also used for performance improvement. Experimental results show that the multiplexed data is recovered by means of demultiplexing at receivers with error-free in case of two users while with less than 15% bit error rate in case of three and four users.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.9 no.6
• /
• pp.428-434
• /
• 2004

Coarse clumping of solid materials within diseased biological cells can have a marked influence on the light scattering pattern. Perturbations in refractive index lead to distinct varia­tions in the cytometric signature, especially apparent over wide scattering angles. The large dynamic range of scattering intensities restricts collection of data to narrow angular intervals be­lieved to have the highest potential for medical diagnosis. We propose the use of an interfer­ence filter to reduce the dynamic range. Selective attenuation of scattering intensity levels is expected to allow simultaneous data collection over a wide angular interval. The calculated angu­lar transmittance of a commercial shortwave-pass filter of cut-off wavelength 580 nm indicates significant attenuation of scattering peaks below ${\~}\;10^{circ}$, and reasonable peak equalization at higher angles. For the three-dimensional calculation of laser light scattered by cells we use a spectral method code that models cells as spatially varying dielectrics, stationary in time. How­ever, we perform preliminary experimental testing with the interference filter on polystyrene microspheres instead of biological cells. A microfluidic toolkit is used for the manipulation of the microspheres. The paper intends to illustrate the principle of a light scattering detection system incorporating an interference filter for selective attenuation of scattering peaks.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.5 no.3 s.11
• /
• pp.29-39
• /
• 2006

In this paper, we propose an efficient method to detect the signal and evaluate performance of the system in frequency selective fading channel. We combine proposed system with OFDM (Orthogonal Frequency Division Multiplexing) to improve performance of the system. First, we study the SOSTTC-OFDM system using two transmit antenna and one receive antenna, and compare performance of the proposed space-time coded OFDM with that of previous system. We expand this system to the system using four transmit antennas with the proposed decoding method. Simulation results show that the proposed decoding method can detect the signal efficiently, and we identify that the performance of the proposed system is shown with varying doppler frequency in frequency selective fading channel.

• Journal of Advanced Marine Engineering and Technology
• /
• v.28 no.5
• /
• pp.818-826
• /
• 2004

The spray-induced mixing characteristics and thermal decomposition of aqueous urea solution into ammonia have been studied to design optimum sizes and geometries of the mixing chamber in SCR(Selective Catalytic Reduction) system. The cold flow tests about the urea-injection nozzle were performed to clarify the parameters of spray mixing characteristics such as mean diameter and velocity of drops and spray width determined from the interactions between incoming air and injected drops. Discrete particle model in Fluent code was adopted to simulate spray-induced mixing process and the experimental results on the spray characteristics were used as input data of numerical calculations. The simulation results on the spray-induced mixing were verified by comparing the spray width extracted from the digital images with the simulated Particle tracks of injected drops. The single kinetic model was adopted to predict thermal decomposition of urea solution into ammonia and solved simultaneously along with the verified spray model. The hot air generator was designed to match the flow rate and temperature of the exhaust gas of the real engines The measured ammonia productions in the hot air generator were compared with the numerical predictions and the comparison results showed good agreements. Finally, we concluded that the design capabilities for sizing optimum mixing chamber were established.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.13 no.6
• /
• pp.535-544
• /
• 1988

In this paper, the hybrid ARQ scheme, which is incorporated the selective-repeat ARQ system with the finite receiver buffer and the single-error-correcting and double-error-detecting(63.56) cyclic Hamming code system, has been investigated. As a result of simulation, the proposed hybrid ARQ scheme shows that that throughput efficiencies are improved by one error correction, and that the reversed codewords due to retransmission are delivered to the user in order by means of detecting two errors. The hybrid ARQ scheme significantly outperforms the FEC or the ideal selective-repeat ARQ system in the respect of throughput and reliability, especially when the channel error rate is approximately in the range from $10^{-2}$~$10^{-3}$.

• Journal of Korean Society for Geospatial Information Science
• /
• v.4 no.2 s.8
• /
• pp.79-90
• /
• 1996

It is well known that point positioning using a C/A-code receiver is severely biased by errors in pseudorange. This paper shows the procedures of quantitive analysis for several error elements and that some methods to monitor SA(selective availability) of witch process is not opened are proposed. It is possible to verify the effects of SA in the Doppler shift and receiver clock drift variation. Easy methods to reduce SA effects are to fit second order polynomials for the one and a linear function for the other. With periodic autocorrelation functions. SA effects are analyzed and first order Gauss-Markov process parameters are decided.