• Journal of the Korean Society of Safety
• /
• v.35 no.3
• /
• pp.96-104
• /
• 2020

The numerical simulations were conducted to investigate the thermal-fluid phenomena occurred inside the experimental apparatus during a PCCS, used to remove heat released in accidents from a containment of light water nuclear power plant, operation. Numerical simulations of the flow and heat transfer caused by wall condensation inside the containment simulation vessel (CSV), which equipped with 18 vertical heat exchanger tubes, were conducted using the commercial computational fluid dynamics (CFD) software ANSYS-CFX. Shear stress transport (SST) and the wall condensation model were used for turbulence closure and wall condensation, respectively. The simulation using the actual size of the apparatus. However, rather than simulating the whole experimental apparatus in consideration of the experimental cases, calculation resources, and calculation time, the simulation model was prepared only in CSV. Selective simulation was conducted to verify the effects of non-condensable gas(NC gas) concentration, CSV internal pressure, and wall sub-cooling conditions. First, as a result of the internal flow of CSV, it was observed that downward flow due to condensation occurred surface of the vertical tube and upward flow occurred in the distant place. Natural convection occurred actively around the heat exchanger tube. Due to this rising and falling internal flow, natural circulation occurred actively around the heat exchanger tubes. Next, in order to check the performance of built-in condensation model using according to the non-condensable gas concentration, CSV internal flow and wall sub-cooling, the heat flux values were compared with the experimental results. On average, the results were underestimated with and error of about 25%. In addition, the influence of CSV internal pressure and wall sub-cooling was small, but when the condensate was highly generated due to the low non-condensable gas concentration, the error was large compared to the experimental values. This is considered to be due to the nature of the condensation model of the CFX code. However, in spite of the limitations of CFD, it is valid to use the built-in condensation model of CFD for PCCS performance prediction from a conservative perspective.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.8
• /
• pp.9-15
• /
• 2010

This paper presents an analysis of asynchronous multicarrier-code division multiple access (MC-CDMA) uplink systems over frequency-selective multipath fading channels when the frequency offsets (FOs) of all users are random variables and the frequency offset for the desired user is compensated. The effect of a residual frequency offset(RFO) on the average bit error rate (BER) is evaluated by the semi-analytical method, then the approximated BER performance is obtained as a closed-form expression. Moreover, the signal to noise ratio (SNR) loss caused by RFO is evaluated. Derived results show that the performance degradation due to RFO is negligible if the estimation error of RFO for the desired user is less than the normalized value of 0.1.

• The Plant Pathology Journal
• /
• v.24 no.2
• /
• pp.101-111
• /
• 2008

The fungal genus Alternaria is comprised of many saprophytic and endophytic species, but is most well known as containing many notoriously destructive plant pathogens. There are over 4,000 Alternaria/host associations recorded in the USDA Fungal Host Index ranking the genus 10th among nearly 2,000 fungal genera based on the total number of host records. While few Alternaria species appear to have a sexual stage to their life cycles, the majority lack sexuality altogether. Many pathogenic species of Alternaria are prolific toxin producers, which facilitates their necrotrophic lifestyle. Necrotrophs must kill host cells prior to colonization, and thus these toxins are secreted to facilitate host cell death often by triggering genetically programmed apoptotic pathways or by directly causing cell damage resulting in necrosis. While many species of Alternaria produce toxins with rather broad host ranges, a closely-related group of agronomically important Alternaria species produce selective toxins with a very narrow range often to the cultivar level. Genes that code for and direct the biosynthesis of these host-specific toxins for the Alternaria alternata sensu lato lineages are often contained on small, mostly conditionally dispensable, chromosomes. Besides the role of toxins in Alternaria pathogenesis, relatively few genes and/or gene products have been identified that contribute to or are required for pathogenicity. Recently, the completion of the A. brassicicola genome sequencing project has facilitated the examination of a substantial subset of genes for their role in pathogenicity. In this review, we will highlight the role of toxins in Alternaria pathogenesis and the use of A. brassicicola as a model representative for basic virulence studies for the genus as a whole. The current status of these research efforts will be discussed.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.11 no.3
• /
• pp.253-258
• /
• 2018

The multiband communication technique is effective in terms of performance and throughput efficiency because it can overcome selective frequency fading by allocating the same data to different frequency bands in the environment of rapidly changing channel transfer characteristic. In addition, the transmission distance can be further extended while overcoming various underwater channel environments. In this paper, we analyzed the performance of multiband transmission technique in underwater communication by increasing number of band using Turbo pi code with a coding rate of 1/3. Simulation results shows that the performance is improved when the number of bands is increased based on the received SNR.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.6A
• /
• pp.623-630
• /
• 2004

The adaptive modulation along with SFBC transmit diversity is a very effective method to increase the capacity of an OFDM system. However, severe performance degradation is resulted when inter-symbol interference is applied due to frequency-selective fading in mobile communications. In this paper, we have proposed and analyzed an OFDM system with SFBC transmit diversity and adaptive modulation scheme based on pre-equalization methods, in order to increase the data transmission rate in the downlink without much increase in system complexity. By introducing subchannel grouping and the pre-equalization method among adjacent subchannels, we could enhance the efficiency of the adaptive modulation a lot. By computer simulation, it has been proven that the proposed schemes show a better BER and throughput performance than the conventional schemes under severely time-varying multipath fading channel.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.10a
• /
• pp.369-372
• /
• 2003

This paper describes a design of OFDM (Orthogoanl Frequency Division Multiplexing) based wireless LAN system receiver, defined in IEEE 802.11a standards. Because OFDM system uses several orthogonal sequence sets, it ran avoid selective fading of fast data transfer problem when it is used with error correction code. But if the receiver is not synchronized, the orthogonal of between sub-ralliers will be destroyed and the data interruption will be generated. So it makes error property get worse very murk. For improving the noise error, we use the relationship of phasor between sub-carriers and make system synchronization using one tab equalizer. The designed OFDM block is described by Verilog HDL for the efficient and small size hardware. And we preform the functional verification and evaluation using the vector of standards.

• The KIPS Transactions:PartC
• /
• v.13C no.3 s.106
• /
• pp.369-374
• /
• 2006

This paper related with the performance improvement of adaptive equalizer that is a based on the tricepstrum eqalization algorithm by using the received signal. Adaptive equalizer used for the improvement of communication performance, like as high speed, maintain of synchronization, BER, at the receive side in the environment of communication channel of the presence of the aditive noise, phase distortion and frequency selective fading, mainly. It's characteristics are nearly same as the inverse characterstics of the communication channel. In this paper, the TEA algorithm using the HOS and the 16-QAM which is 2-dimensional signaling method for being considered signal was used. For the precoding of 16-QAM singnal in the assignment of the signal costellation, Gray code was used, and the improvement of performance was gained by computer simulation in the residual intersymbol interence and mean squared error which is representive measurement of adaptive equalizer.

• Structural Engineering and Mechanics
• /
• v.39 no.2
• /
• pp.241-266
• /
• 2011

The Self Compacting Concrete, SCC is the new generation type of concrete which is not needed to be compacted by vibrator and it will be compacted by its own weight. Since SCC is a new innovation and also the high strength self compacting concrete, HSSCC behavior is like a brittle material, therefore, understanding the strength effect on the serviceability performance of reinforced self compacting concretes is critical. For this aim, first the normal and high strength self compacting concrete, NSSCC and HSSCC was designed. Then, the serviceability performance of reinforced connections consisting of NSSCC and HSSCC were investigated. Twelve reinforced concrete connections (L = 3 m, b = 0.15 m, h = 0.3 m) were simulated, by this concretes, the maximum and minimum reinforcement ratios ${\rho}$ and ${\rho}^{\prime}$ (percentage of tensile and compressive steel reinforcement) are in accordance with the provision of the ACI-05 for conventional RC structures. This study was limited to the case of bending without axial load, utilizing simple connections loaded at mid span through a stub (b = 0.15 m, h = 0.3 m, L = 0.3 m) to simulate a beam-column connection. During the test, concrete and steel strains, deflections and crack widths were measured at different locations along each member. Based on the experimental readings and observations, the cracked moment of inertia ($I_{cr}$) of members was determined and the results were compared with some selective theoretical methods. Also, the flexural crack widths of the members were measured and the applicability for conventional vibrated concrete, as for ACI, BS and CSA code, was verified for SCCs members tested. A comparison between two Codes (ACI and CSA) for the theoretical values cracking moment is indicate that, irrespective of the concrete strength, for the specimens reported, the prediction values of two codes are almost equale. The experimental cracked moment of inertia $(I_{cr})_{\exp}$ is lower than its theoretical $(I_{cr})_{th}$ values, and therefore theoretically it is overestimated. Also, a general conclusion is that, by increasing the percentage of ${\rho}$, the value of $I_{cr}$ is increased.

• Journal of IKEEE
• /
• v.16 no.2
• /
• pp.138-144
• /
• 2012

In this paper, a semi-analytical approach is proposed for DSF(Decode and Selective Forward)-Relay MC-CDMA(MultiCarrier-Code Division Multiple Access) systems over multipath Rayleigh fading channels. Considering BER(bit error rate) performance and complexity, the MMSE-C(Minimum Mean squared Error-per subCarrier) is used as the combining method for MC-CDMA systems. At first, the analytical method based on error-events at relay nodes for DSF-Relay schemes is utilized in order to derive the averaged BER. Then, the averaged BER is expressed as the form considering possible all error-events. Also, proposed semi-analytical expressions have been verified by comparing with simulation results. Finally, it is verified that the derived analytical expressions can be a frame work to cover different multipath Rayleigh fading channel conditions and to measure the upper performance for DSF-Relay MC-CDMA systems.

• Journal of Advanced Navigation Technology
• /
• v.8 no.2
• /
• pp.144-154
• /
• 2004

In this paper we apply the space-time block codes (STBCs), the key technologies for the 4th generation mobile communication systems, to the OFDM system and analyze their performances. First, we derive the signal models for representative STBC schemes and demodulation procedures for each scheme. We also select the parameters for OFDM system considering mobile cellular environments and assign adequate modulation schemes to STBC-OFDM schemes according to the transmission rate from 2bps/Hz to 4bps/Hz. We finally compare and analyze the performances of STBC-OFDM schemes for the selected transmission rates through computer simulations, together with performance comparison when the same modulation scheme being adopted.