• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.55 no.6
• /
• pp.236-241
• /
• 2006

This paper presents a transfer capability enhancement process using VSC HVDC system which can control active power as well as reactive power. The transfer capability is constrained by stability like voltage stability as well as thermal rating of power system components. Transfer capability of the power system limited by these constraints may be enhanced by reactive power control ability and active power flow control ability of the VSC HVDC system. To enhance the transfer capability of the system using VSC HVDC, selection of the HVDC installation site is performed. In this work, power zones which consist of major power plants and their sinks are identified using power tracing and distribution factor. Alternative route of major AC transmission line in the power zone is identified as VSC HVDC system.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.26 no.7
• /
• pp.814-819
• /
• 2016

The Stockbridge damper is used to control the aeolian vibration of a overhead transmission line due to the natural wind under a low velocity, between 1 m/s to 7 m/s. The damper model can be simply derived with several design parameters and the location of eigenvalues of design parameters are important to determine the efficiency of energy dissipation by excitation itself with two counterweights. First, the importance of resonance frequencies of Stockbridge damper was reviewed through the analysis of frequency response function of damper system. Then, the best selection of design parameters was investigated with the introduction of objected function that minimize the distance between the calculated eigenvalues and target frequency points. The best choice of design parameters was reviewed using the simulated results from the objective function and the effectiveness of selected design case was discussed at the point view of practical implementation.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.3
• /
• pp.1377-1382
• /
• 2015

Power system restoration following a massive blackout starts with re-energizing Primary Restorative Transmission (PRT) systems at first. As power systems have been gradually enlarged and become more complex, periodical evaluation and reassignment of PRTs are needed. So far it has been decided by try and error approach by corresponding human experts to analyze and evaluate them. This paper presents an intelligent system that finds optimal primary restoration paths using analytic and heuristic knowledge from PSS/E data, and suggests an optimal PRTs depending on the condition of Ferranti effect or a reactive power capability margin of black-start generator. This system was tested in Korea Electric Power system, and showed a promising result.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.367-368
• /
• 2015

최근에 인도와 유럽을 중심으로 기존의 AC 송전계통 중 일부를 DC 송전계통으로 대체하는 하이브리드형 송전방식에 대한 연구가 진행중이다. 따라서 본 연구는 기존에 연구되고 있는 하이브리드형 가공송전계통을 기반으로 지중송전계통을 포함한 하이브리드형 혼합송전계통이 향후 머지않아 국내에서 계획 및 건설될 것을 대비한 초기 연구로서 진행하였다. 본 논문의 관점은 하이브리드 혼합송전계통 중 지중송전계통구간에서 DC 선로가 AC선로로부터 얼마나 고조파 전압 및 전류 측면에서 영향을 받는가를 평가하고, 이를 근거로 DC 케이블의 배열을 선정하고자 한다. 또한 DC 케이블 배열 선정을 위해 가능성이 있는 여러 개의 CASE별로 구분하고, 가장 타당한다고 평가되는 배열을 제안하고자한다. 본 연구에서 계통 모델링 및 해석은 EMTP를 이용하였다.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.416-417
• /
• 2015

In this study, the parameters of the lightning flashover rate calculation algorithm in South Korea, USA, Japan are investigated for the suitable algorithm for South Korea. Each parameters used in each calculation algorithms have a obvious difference by the environment of the area and transmission lines, because they have different environmental parameters respectively. In this paper, the environmental parameters are weighted according to the change of outputs by different inputs, environmental parameters. In addition, the methods of the selection CRIEPI algorithm and the application EPRI, CRIEPI parameters for improvement the KEPRI algorithm are proposed.

• Proceedings of the KIEE Conference
• /
• 2002.11b
• /
• pp.355-357
• /
• 2002

Distribution lines are spanned on a much large area as compared to transmission lines, and therefore, are more often susceptible to lightning strokes. The selection of the proper value of basic insulation level(BIL), for particular insolation components of distribution structures in specific, is very important. Lightning strikes has current risetimes ranging from 0.1 to several $\mu s$ and can produce transient overvoltages substantially greater than the BIL of many distribution systems in spite of lightning arresters. This paper describes lightning overvoltage of a 22.9kV distribution system due to lightning strike. This study will provide the information on insulation coordination studies to adopt BIL.

• Journal of Sensor Science and Technology
• /
• v.9 no.6
• /
• pp.448-454
• /
• 2000

This paper describes the implementation of a multi-subject, multi-channel optical telemetry system for the short range measurement of electrocardiograms (EKGs) a system which receives command signals and transmits physiological signals to the external system using LED (Light Emitting Diode) and PD (Photodiode). This system decreases the dependency of power supply voltage to the CMOS IC chips and a new enforced synchronization technique using infrared bi-directional communication has also been proposed. The telemetry IC with the size of $5.1{\times}5.1mm^2$ has the following functions: receiving of command signal, initialization of internal state of all functional blocks, decoding of subject selection signal, time division multiplexing of 4-channel modulated physiological signals, transmission of modulated signals to external system, and auto power down control.

• Proceedings of the Korea Institute of Convergence Signal Processing
• /
• 2001.06a
• /
• pp.57-60
• /
• 2001

Most power retailers adopt systematic, integral supply chain system to minimize the logistics cost. However, small and medium sized retail shops that don't have a distribution channel, unavoidably spend a big amount of distribution cost. This study is to propose an efficient system to manage the information of trucks by using the portable GPS. This system includes the real-time mapping of truck location, the transmission of delivery information from the truck, and the algorithm concerning the selection of the most cost efficient truck.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.5
• /
• pp.2379-2397
• /
• 2017

Content distribution technology, which routes content to the cache servers, is considered as an effective method to reduce the response time of the user requests. However, due to the exponential increases of content traffic, traditional content routing methods suffer from high delay and consequent inefficient delivery. In this paper, a content selection policy is proposed, which combines the histories of cache hit and cache hit rate to collaboratively determine the content popularity. Specifically, the CGM policy promotes the probability of possible superior paths considering the storage cost and transmission cost of content network. Then, the content routing table is updated with the proportion of the distribution on the paths. Extensive simulation results show that our proposed scheme improves the content routing and outperforms existing routing schemes in terms of Internet traffic and access latency.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.4
• /
• pp.1051-1058
• /
• 1998

We propose a bandpass filter using wavelength selectivity as variation of writing beam incident angle in photorefractive crystal. From TWM(Two-Wave Mixing) experiment, optimal diffraction properties are induced, and bandpass filter for selection wavelength transmission bandwidth are taken by change of writing beam incident angle.