• Journal of Communications and Networks
• /
• v.12 no.6
• /
• pp.616-623
• /
• 2010

In this paper, exact closed-form expressions for outage probability and bit error probability (BEP) are presented for multi-hop decode-and-forward (DF) relaying schemes in conjunction with cooperative diversity, in which selection combining technique is employed at each node. We have shown that the proposed protocol offers remarkable diversity advantage over direct transmission as well as the conventional DF relaying schemes with the same combining technique. We then investigate the system performance when different diversity schemes are employed. It has been observed that the system performance loss due to selection combining relative to maximal ratio combining is not significant. Simulations are performed to confirm our theoretical analysis.

• ETRI Journal
• /
• v.28 no.1
• /
• pp.77-83
• /
• 2006

In order to improve the accuracy of cell selection in heterogeneous cellular systems, this paper proposes a fuzzy multiple-objective decision-based cell selection (FMDCS) strategy. Since heterogeneous cellular systems have different access technologies and multiple traffic classes, the strategy adopts cell type, data rate, coverage, transmission delay, and call arrival rate as evaluation indices, and uses different weight vectors according to the traffic classes of the mobile host. Then, a fuzzy multiple-objective decision algorithm is applied to select the optimal cell from all candidates. This paper also gives an instance analysis and simulation. The instance analysis shows FMDCS makes different selections for different traffic classes. Simulation results of the after-handoff quality-of-service (QoS) show the selected cell can provide MH optimal service.

• Proceedings of the Korean Information Science Society Conference
• /
• 2004.10c
• /
• pp.142-144
• /
• 2004

To provide more qualified data service on the HFC(Hybrid-Fiber Coaxial) access network, the channel characteristics of upstream transmission band should be carefully investigated and analysed. It will be easier to do network management if the monitoring system for noise measurement in the network is available, In this paper, noise analysis method and the frequency selection method in the upstream band for duplex transmission are suggested. And, Data aquisition device for the signal measurement Is implemented. With this network monitoring system, field test and the result from the collected data are described.

• Proceedings of the KIEE Conference
• /
• 2006.11a
• /
• pp.129-131
• /
• 2006

KEPCO constructed the first 765kV 2 circuit transmission line in the world with its home grown technologies. Through this 765kV transmission system project, KEPCO accumulated experience and technologies related to the 765 kV power system. Based on the successful completion of the 765kV transmission project, KEPCO is conducting overseas business by using its abundant experience and know-how. In particular, KEPCO developed the training course for power system, called the ATT (Advanced Transmission Technology) training courses for overseas business, especially for developing countries. Therefore, KEPCO developed the "Transmission line design system for overseas projects". This system supports the calculation of wind pressure load, tower design, wire selection, insulation design, etc. by applying the meteorological data of foreign countries and design standards. And this system is applied to the training program so that the trainees can design the optimal transmission line for their own countries.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.7
• /
• pp.2365-2382
• /
• 2014

While single-user spatial multiplexing multiple-input multiple-output (SU-MIMO) allows spatially multiplexed data streams to be transmitted to one node at a time, multi-user spatial multiplexing MIMO (MU-MIMO) enables the simultaneous transmission to multiple nodes. However, if the transmission time required to send packets to each node varies considerably, MU-MIMO may fail to utilize the available MIMO capacity to its full potential. The transmission time typically depends upon two factors: the link quality of the selected channel and the data length (packet size). To utilize the cumulative capacity of multiple channels in MIMO applications, the assignment of channels to each node should be controlled according to the measured channel quality or the transmission queue status of the node.A MAC protocol design that can switch between MU-MIMO and multiple SU-MIMO transmissions by considering the channel quality and queue status information prior to the actual data transmission (i.e., by exchanging control packets between transmitter and receiver pairs) could address such issues in a simple but in attractive way. In this study, we propose a new MAC protocol that is capable of performing such switching and thereby improve the system performance of very high throughput WLANs. The detailed performance analysis demonstrates that greater benefits can be obtained using the proposed scheme, as compared to conventional MU-MIMO transmission schemes.

• Journal of Biosystems Engineering
• /
• v.18 no.4
• /
• pp.305-316
• /
• 1993

Fuel efficiency in tractor operations dep6nds on the selection of transmission gears and upon the engine being operated at or near maximum torque much of time. The objective of this study was to develop automatic control systems for tractor transmission ratio and governor setting so that the engine is operated at or near maximum torque as much of time as possible. An indoor test unit, which can be used to simulate tractor operation, was built in order to investigate the system design parameters and test the performance of the control system designed. The test-unit consists of engine, gear-type transmission, dynamometer, and control systems for transmission ratio and engine speed. Governor setting lever was controlled by a step motor, and the clutch and transmission levers were controlled by hydraulic cylinders and solenoid valves. The control systems showed good time responses which are assumed to be suitable for optimal tractor operation. The time required for shifting gears from clutch disengagement to engagement was about 1 second, which is almost the same as that for manual shift. And the settling time for engine speed control system was about 5 to 6 seconds.

• Journal of Families and Better Life
• /
• v.15 no.1
• /
• pp.191-200
• /
• 1997

The purpose of this research was to test a model of intergenerational transmission of marital instability. An important aspect of the present study was to test the direct and indiect intergenerational transmission processes of marital instability. This study revealed four very important findings. First the effects of parental divorce on children's marital instability were both direct and indirect through mate selection risk factors marital quality and marital commitment. Second premarital backgrounds such as socioeconomic status of parents and relative heterogeneity between spouse before marriage were important to explain one's marital relationship. Third the higher the barriers the higher the marital commitment. Fourth marital quality and marital commitment were important predictors of marital instability. Taken together this study supports the intergenerational transmission perspective that exposure to conflict marriage in one's own childhood would forecast lower marital sat sfaction higher conflict and higher marital instability in the marital relationship. The findings from this study also underline the importance of predisposing marital characteristics such as parental socioeconomic status and relative heterogeneity in explaining marital relationship.

• Journal of Electrical Engineering and Technology
• /
• v.6 no.6
• /
• pp.760-768
• /
• 2011

The performance of transmission lines and its shielding design during a lightning phenomenon are quite essential in the maintenance of a reliable power supply to consumers. The leader progression model, as an advanced approach, has been recently developed to calculate the shielding failure rate (SFR) of transmission lines using geometrical data and physical behavior of upward and downward lightning leaders. However, such method is quite time consuming. In the present paper, an effective method that utilizes artificial neural networks (ANNs) to create a metamodel for calculating the SFR of a transmission line based on shielding angle and height is introduced. The results of investigations on a real case study reveal that, through proper selection of an ANN structure and good training, the ANN prediction is very close to the result of the detailed simulation, whereas the Processing time is by far lower than that of the detailed model.

• Asian-Australasian Journal of Animal Sciences
• /
• v.8 no.2
• /
• pp.171-174
• /
• 1995

Heteromorphisms of chromosome banding patterns can be useful markers for gene mapping and other kinds of genetic studies. In Japanese quail, the centromere region of chromosome No. 4 is the site of a heteromorphism. One form of the C-band at this region is relatively small ("a" form); an alternative form is much larger ("b" form). To identify the transmission patterns, all possible matings were made between birds with karyotype a/a, a/b, and b/b. The outcome from all crosses are entirely consistent with the expectation from simple Mendelian transmission. No evidence was found for segregation distortion or gametic selection. This dimorphism, therefore, is a reliable marker.

• Proceedings of the KIEE Conference
• /
• 2005.11b
• /
• pp.27-29
• /
• 2005

Overhead transmission line design supporting program using high spatial resolution satellite imagery has been developed recently by Korea Power Engineering Company, The developed program, ITSS(Interactive Tower Spotting System) is purposed to improve the application of satellite imagery with the route selection of overhead transmission line. It is composed of spotting the tower position and designing the tower type and height with DEM(Digital Elevation Model) overlaid with satellite Imagery. To review and confirm the function and work efficiency, ITSS was applied to the pilot project of overhead transmission line design.