• Journal of Electrical Engineering and Technology
• /
• v.8 no.4
• /
• pp.719-728
• /
• 2013

Probabilistic assessment of voltage stability margin (VSM) with existence of correlated wind speeds is investigated. Nataf transformation is adopted to establish wind speed correlation (WSC) model. Based on the saddle-node bifurcation transversality condition equations and Monte Carlo simulation technique, probability distribution of VSM is determined. With correlation coefficients range low to high value, the effect of WSC on VSM is studied. In addition, two risk indexes are proposed and the possible threat caused by WSC is evaluated from the viewpoint of risk analysis. Experimental results show that the presence of correlated wind speeds is harmful to safe and stable operation of a power system as far as voltage stability is concerned. The achievement of this paper gives a detailed elaboration about the influence of WSC on voltage stability and provides a potentially effective analytical tool for modern power system with large-scale wind power sources integration.

• Journal of the Korean Society of Safety
• /
• v.20 no.3 s.71
• /
• pp.71-77
• /
• 2005

This study aims to find the safe vent area to prevent a destruction of building by gas explosion in a building. Explosion vessel which used in this experiment is 1/5 scale down model of simple livingroom and its dimension is 100cm in length 60cm in width and 45cm in height. Liquified petroleum gas(LPG) was injected to the vessel to the concentration of 4.5vol%, and injection rate were varied in 1L/min or 4L/min. Gas mixture was ignited by the 10kV electric spark. For analysis the characteristics of vented explosion pressure according to the vent size and vent shape, its size and shape were varied. From the experiment, it was found that explosion pressure in the vented explosion :in affected by the gas injection rate, vent area and vent shape. And the vent area to volume ratio(S/V) to prevent the building destruction by explosion pressure, it is recommended that the design of vent area happened by the explosion should be above 1/500cm in S/V. And if the vent area has complicate structure in same area, vented explosion pressure will be higher than a single vent, and possibility of building destruction will increase. Therefore to effectively vent the explosion pressure for protect a building and residents from the gas explosion hazards, the same vent area should have a singular and constant shape in the cross-sectional area of the vessel.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.19 no.8
• /
• pp.24-32
• /
• 2005

Micro-source units having power ratings in thousands of watts can provide power quality with higher reliability and efficiency than the conventional large scale units. Since these units are small and easy to install, they are clustered with loads creating micro-grid services to customer sites such as office buildings, industrial parks and homes. Micro-sources adopt voltage source inverter to ensure the power quality of sensitive loads. This paper deals with the connection of micro-sources into the system grid EMTDC modeling of the grid connected micro-sources at the power frequency range are proposed and the characteristics of the control system parameters are investigated. Simulation results show that the micro-grid system with two micro-sources has good dynamic characteristics.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.8
• /
• pp.83-89
• /
• 2015

This study suggests the methodology to decide the number and adequate capacity of substation transformer in a large-scale offshore wind farm (OWF). The recent trend in transformer capacity of offshore substation is analyzed in many European offshore wind farm sites prior to entering the studies. In order to carry out the economic evaluation for the transformer capacity we present the cost models which consist of investment, operation, and expected energy not supplied (EENS) cost as well as the probabilistic wind power model of wind energy that combines the wind speed with wind turbine output characteristics for a exact calculation of energy loss cost. Economic assessment includes sensitivity analysis of parameters which could impact the 400-MW OWF: average wind speed, availability, discount rate, energy cost, and life-cycle.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 1999.10a
• /
• pp.333-344
• /
• 1999

Currently many studies on the unmanned gantry crane for the automated container terminal are accomplished. This is needed for the development of large scale, automation, high speed, unmanned system and information system in port facility. In order to do efficient container handling job in port yard, the automated handling system is well adapted to the job environments and all-season weather, In order to realize the automatic and unmanned system for container handling job, the required functions and main structure system are studied. The major problems of operation of the conventional gantry crane are that the vibration of gantry structure body is occurred by operation and that high-speed and precision position-velocity control and the capability to dope to the external disturbances caused by the wind, rain, fog and job environments. In this paper, the fundamental study for establishment of the concept and the dynamic modelling of the major sub system of the unmanned gantry crane is presented. These studies are useful for design and manufacturing of the new concept model of the unmanned gantry crane for efficient operation of the automated container terminal.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.7 no.3
• /
• pp.147-156
• /
• 2003

In this paper, a damage detection method using mode shapes of truss structures is presented. The theory is formulated based on the changes in the modal strain energy in a truss type structures due to damage. To examine the feasibility, the theory is applied to an experimental data of a 1:6 scale model of a typical hexagonal truss structure. The experiment consists of 17 damage scenarios subjected to three different types of damage. The damage evaluation results show that the proposed method detects successfully damage in truss elements and also show that the performance of proposed method can be significantly impacted by the noise in the measurement data for small damage.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.33 no.6
• /
• pp.505-509
• /
• 2020

The development of diesel power generation is predominantly geared toward island areas or ships because diesel exhibits weak scale-merit characteristics and power quality problems, which are associated with environmental pollution. However, a new energy paradigm, distribution energy resource (DER), has been emerging as a renewable energy source due to the existing structural problems in waste disposal and complex factors such as the conversion technology of waste emulsified oil (WDF). By combining extended producer responsibility (EPR) support and renewable energy certificates (REC), including waste energy REC 0.25 for other bioenergy and REC 1.0 for power transactions, an adequate profit model can be built through self-energetic power generation, thereby drawing keen attention from related industries. Therefore, if WDF is used appropriately as a high-quality engine fuel, it can lead to the development of various fields such as novel renewable energy sectors, waste management, and EPR-related industries. This study is intended to produce WDF using plastic waste by using it as engine-generator fuel. Moreover, we investigate ways to improve the quality and suitability of WDF as an engine fuel.

• Journal of Korean Society of Rural Planning
• /
• v.15 no.3
• /
• pp.99-106
• /
• 2009

In the rural communities in less-favored areas (mainly hilly and mountainous areas) in Japan, the number of settlements which cannot maintain the community functions by themselves has been increasing because of the progress of depopulation and aging, so the necessity for achieving mutual supplementation of the community function by the settlement reorganization has been increasing. This paper consists of the following three points. 1) General view of settlement reorganization policy in Japan. 2) Case study of the T district in Japan. 3) Possibility of the settlement reorganization by the policy measures which obligate community members to work together. Main results are as follows. 1) There are several settlement reorganization policy measures, but many are still the model project stage, and not yet spread, so it is necessary to wait and see how these measures will develop. 2) The number of the residents of small-scale aging settlements who do not hope for the reorganization, nor feel the necessity of reorganization shall not be few. This will make great difficulty in the settlement reorganization process. 3) A local area activity promotion conference which derives from a former administrative unit like a former village has many functions to the settlement reorganization. 4) In the rural communities in less-favored areas, the policy measures which obligate community members to work together have widely spread. These are expected to play the supplemental role for the settlement reorganization. It is necessary to discuss among residents the activation plan and the future vision of the community, as well as to discuss the settlement reorganization.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.1255-1257
• /
• 2003

This study proposes a single-channel satellite remote sensing algorithm for retrieving aerosol optical thickness over global ocean using FY-1C/1D data. An efficient lookup table (LUT)method is adopted in this algorithm to generate apparent reflectance in channel 1 and channel 2 of FY-1C/1D over ocean. The algorithm scale the apparent reflectance in cloud-free conditions to aerosol optical thickness using a state-of-art radiative transfer model 6S with input of the relative spectral response of channel 1 and 2 of FY-1C/1D. Monthly mean composite maps of the aerosol optical thickness have been obtained from FY-1C/1D global area coverage data between 2001 and 2003. Aerosol optical thickness maps can show the major aerosol source which are located off the west coast of northern and southern Africa, Arabian Sea and India Ocean. These result is very similar to other satellite sensors such as AVHRR and MODIS in the location area of heavy aerosol optical thickness over global ocean. The algorithm have been used to FY-1D operational performance and it is the first operational aerosol remote sensing product in China.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.138-140
• /
• 2003

The aim of this study is to evaluate the effect of spatial resolutions on the accuracy to landslide susceptibility mapping. For this, landslide locations were identified in the Boun, Korea from interpretation of aerial photographs and field surveys. The topographic, soil, forest, geologic, linearment and land use data were collected, processed and constructed into a spatial database using GIS and remote sensing data. The 15 factors that influence landslide occurrence were extracted and calculated from the spatial database with 5m, 10m, 30m, 100m and 200m spatial resolutions. Landslide hazardous area were analysed and mapped using the landslide-occurrence factors by probability model, likelihood ratio, for the five cases spatial resolutions. The results of the analysis were verified using the landslide location data. In the cases of spatial resolution 5m, 10m and 30m, the verification results was similar, but in the cases of 100m and 200m the results worse than the others. Because the scale of input data was 1:5,000 ? 1:50,000, so the cases of 5m, 10m and 30m have similar accuracy but the cases of 100m and 200m have the lower accuracy. From this, there is an effect of spatial resolutions on accuracy and landslide susceptibility mapping the result is dependent on input map.