• Speech Sciences
• /
• v.10 no.2
• /
• pp.249-258
• /
• 2003

This study attempted to examine a speaker identification method using difference sum and correlation coefficient determined from a pair of intensity level matrices of band-pass-filtered numeric sounds produced by ten female speakers of similar age and height. Subjects recorded three digit numbers at a quiet room at a sampling rate of 22 kHz on a personal computer. Collected data were band-pass-filtered at five different band ranges. Then, matrices of five intensity levels at 100 proportional time points were obtained. Pearson correlation coefficients and the sum of absolute intensity differences between a pair of given matrices were determined within and across the speakers. Results showed that very high correlation coefficient and small difference sum generally occurred within each speaker but some individual variation was also observed. Thus, the matrix pair with a higher coefficient and a smaller difference sum was averaged to form each individual's model. Comparison among the speakers yielded generally low coefficients and large differences, which suggests successful speaker identification, but among them there were a few cases with very high coefficients and small differences. Future studies will focus on finer band ranges and additional spectral parameters at some peak points of the intensity contour at a low frequency band.

• Ocean and Polar Research
• /
• v.31 no.2
• /
• pp.189-198
• /
• 2009

Passive air samplers with polyurethane foam (PUF) disks were employed to determine seasonal gas phase variation of polycyclic aromatic hydrocarbons (PAHs) in ambient air on Anmyeon island from March 2007 to January 2008. Sum of 13 PAHs ranged between $3.5\;ng/m^3$ and $27.6\;ng/m^3$. Total PAHs during the heating season was 6.2 times higher than non-heating season. The dominant PAHs components during sampling periods were low and middle molecular weight PAHs including phenanthrene, fluoranthene, pyrene and chrysene. Gas exchange fluxes of PAHs across the air-water interface of the Yellow Sea were calculated using a modified two-film exchange model. PAHs fluxes ranged from $196\;ng/m^2/d$ net volatilization during summer to $3830\;ng/m^2/d$ net absorption during winter. Passive air sampler provides a convenient and cost-effective tool for measuring averaged gas phase PAHs, which was successfully used for calculation of gas exchange flux of PAHs in the Yellow Sea.

• Korean Journal of Ecology and Environment
• /
• v.37 no.4 s.109
• /
• pp.378-384
• /
• 2004

We investigated the variations of epilithic diatom community and assessed water quality of the water system of Ulleung Island by DAIpo in April, May, July, August, October, and November of 2003, and January and February of 2004. Samples were collected from four sampling stations. Total 95 taxa were identified from this study and dominant species were Nitzschia inconspicua, Achnanthes minutissima, Gomphonema angustum and Cocconeis placentuja var. lineata. The variation of DAIpo values was ranged from 51.14 to 77.77 and the water quality by DAIpo was estimated between ${\alpha}-oligosaprobic$ and ${\beta}- oligosaprobic$ states.

• Journal of Welding and Joining
• /
• v.18 no.4
• /
• pp.70-75
• /
• 2000

The weld seam tracking system for arc welding process uses various kinds of sensors such as arc sensor, vision sensor, laser displacement and so on. Among the variety of sensors available, electro-magnetic sensor is one of the most useful methods especially in sheet metal butt-joint arc welding, primarily because it is hardly affected by the intense arc light and fume generated during the welding process, and also by the surface condition of weldments. In this study, a dual-electromagnetic sensor, which utilizes the induced current variation in the sensing coil due to the eddy current variation of the metal near the sensor, was developed for arc welding of sheet metal butt-joints. The dual-electromagnetic sensor thus detects the offset displacement of weld line from the center of sensor head even though there's no clearance in the joint. A set of design variables of the sensor were determined for the maximum sensing capability through the repeated experiments. Seam tracking is performed by correcting the position of sensor to the amount of offset displacement every sampling period. From the experimental results, the developed sensor showed the excellent capability of weld seam detection when the sensor to workpiece distance is near less than 5 mm, and it was revealed that the system has excellent seam tracking ability for the butt-joint of sheet metal.

• Ocean and Polar Research
• /
• v.28 no.3
• /
• pp.215-224
• /
• 2006

Spatial variation of heavy metal accumulation was investigated in Manila clam Ruditapes philippinarum collected from several tidal flats. Sediment metal levels varied highly among the sites, which was attributed primarily to differences in Fe and organic carbon contents and in part to gain size. Significant differences in metal concentrations also were found in the clam tissue among the different sampling sites. However, except for a few metals (Mn, Zn, Pb), which showed some elevation, the variations in the clam tissue were not related to the variations in the sediment. This is likely because most metals in filter-feeding herbivores such as R. philippinarum accumulated as a result of feeding on suspended particles such as phytoplankton and organic detritus in the water column, not in bottom sediment. In addition, tissue weight for a specific shell size varied significantly among the sites, and increased tissue mass indicating a good nutritive condition likely caused a subsequent dilution of body metals leading to reduced weight-specific concentrations of some metals (Cd, Zn, Cu, Co).

• The Korean Journal of Applied Statistics
• /
• v.18 no.1
• /
• pp.129-135
• /
• 2005

Representative observations are useful to express explicitly the distributional variation of the data by a few selected observations corresponding to the quantiles in the univariate situation. Jones and Rice(1992) extended it to the multidimensional case by the principal component based method. This study introduces a modified version of Jones and Rice exploiting the self-consistency of principal components in expressing the chosen observation vectors. Compared to that of Jones and Rice, the suggested method tends to provide with less susceptible representative observations to the sampling variation of the data and the resulted vectors benefits from the self-consistency.

• Journal of Korean Society for Atmospheric Environment
• /
• v.14 no.2
• /
• pp.95-106
• /
• 1998

Volatile organic compounds (VOCs) from Ca to C9 were investigated with nine ambient air samples collected in April 26, August 17, 1996 and January 23, 1997 in a Seoul site. On each sampling day, three 2-hr integrated canister samples were collected in early morning, early afternoon and late afternoon, respectively to study temporal . variation of VOCs. Most of VOC species showed diurnal variation with higher concentrations in the early morning and lower concentrations in the afternoon. The concentrations of light alkanes were high, probably due to the emission from liquefied petroleum gas (LPG) and evaporation of gasoline. Especially, the concentration of propane was the highest in the morning samples. The concentrations of propane, ethylene, acetylene, and toluene were prominent in their hydrocarbon groups, respectively. These components were the main source of car exhaust, gasoline evaporization, LPG, or solvent usage.

• Journal of the Korean Solar Energy Society
• /
• v.29 no.2
• /
• pp.70-75
• /
• 2009

In this experiment, we did sampling 6 kinds of photovoltaic modules and analyzed the discrepancy of measurement results between l laboratory and 4 PV makers to have performance repeatability at Standard Test Condition(STC) condition. From the KIER's results, Korea's standard test laboratory, other laboratory showed -10% measurement variation. The causes came from correction of reference cell, test condition and the state of skill. Form the comparison test, we analyzed the problems. But three PV maker reduced measurement variation, other one PV maker and one test laboratory didn't improve the problems of correction of reference cell, test condition and the state of skill. Also, High Efficiency Module had a big discrepancy of -10.0$\sim$-6.2% among 3 laboratories which have a less than 10msec light pulse duration time. This made low spectrum response speed so the Fill Factor decreased maximum output power under 10msec light pulse duration time

• Nuclear Engineering and Technology
• /
• v.27 no.5
• /
• pp.730-742
• /
• 1995

The steam generator feedwater and level control system is designed by two steps of the feedwater control design and the feedback loop controller design. The feedwater sen system is designed by the optimal LQR/LQG approach and then is modified by the LTR method to recover the robustness. The plant characteristics are subject to change with the power variation and these dynamic properties are considered in the design of the feedback controller. All the designs are made in the continuous domain and are digitalized by applying the proper sampling period. The system is simulated for the two cases of power increase and decrease. From the results of simulation, it is found that the controller constants would rather be invariable during the power increase, while for the case of power decrease they should be changed with the power variation to keep the system stability.

• Journal of Species Research
• /
• v.1 no.2
• /
• pp.224-231
• /
• 2012

To assess the genetic diversity of Aconitum coreanum (Ranunculaceae) populations in Korea, we have amplified and sequenced eight organellar marker regions, and developed and analyzed microsatellite markers. No sequence variation was detected from the eight organellar markers. Ten microsatellites were developed using Next Generation Sequencing and two microsatellite markers, AK_CA03 and AK_CT07, were identified polymorphic and applied for 143 individuals of twelve A. coreanum populations. Four and five alleles were detected for the two microsatellite loci, respectively, and number of migrants ($N_m$) was estimated as 1.12586. Two microsatellite marker loci showed $F_{ST}$ of 0.205 and 0.275, respectively. The heterozygosity deficit, low level of among-population differentiation, small size of gene flow, and lack of sequence variation of the organellar markers suggest that A. coreanum is reproductively isolated from other Aconitum species and there has been continuous gene flow among the populations of A. coreanum or it has dispersed relatively recently after speciation. Though population pairwise $F_{ST}$'s presented significant geographic structure, further sampling and study will be necessary to confirm this.