• Nuclear Engineering and Technology
• /
• v.51 no.2
• /
• pp.345-355
• /
• 2019

Use of the reconstructed fuel assemblies from partially burnt nuclear fuel pins is analyzed. This reutilization option is a potential candidate technique to make better use of the nuclear resources. Standard two step method is used to calculate node i.e. fuel assembly average burnup and then pin by pin ${\eta}$ values are reconstructed to ascertain the residual reactivity in the used fuel pins. Fuel pins with ${\eta}$ > 1:0 are used to reconstruct to-be-reused fuel assemblies. These reconstructed fuel assemblies are burnt during the cycle 3, 4, 5 and 6 of a 1000 MW PWR core by replacing fresh, once burnt and twice burnt fuel assemblies of the reference core configurations. It is concluded that using reconstructed fuel assemblies for the fresh fuel affect dearly on the cycle length (>50 EFPD) when more than 16 fresh fuel assemblies are replaced. However, this loss is less than 20 days if the number of fresh fuel assemblies is less than eight. For the case of replacing twice burned fuel, cycle length could be increased slightly (10 days or so) provided burnt fuel pins from other reactors were also available. Reactor safety parameters, like axial off set (< ${\pm}10%$), Doppler temperature coefficient (<0), moderator temperature coefficient at HFP (<0) are always satisfied. Though, 2D and 3D pin peaking factors are satisfied (<1:55) and (<2:52) respectively, for the cases using eight or less reconstructed fuel assemblies only.

• Nuclear Engineering and Technology
• /
• v.53 no.3
• /
• pp.812-824
• /
• 2021

In order to reduce risks from the Steam Generator Tube Rupture (SGTR) accident and to meet safety targets, various measures have been analyzed to minimize the amount of fission product (FP) release. In this paper, we propose an introduction of a Containment Filtered Venting System (CFVS) connected to the steam generator secondary side, which can reduce the amount of FP release while minimizing adverse effects identified in the previous studies. In order to compare the effect of new equipment with the existing strategy, accident simulations using MELCOR were performed. As a result of simulations, it is confirmed that CFVS operation lowers FP release into the environment, and the release fractions are lower (minimum 0.6% of the initial inventory for Cs) than that of the strategy which intends to depressurize the primary system directly (minimum 15.2% for Cs). The sensitivity analyses identify that refill of the CFVS vessel is a dominant contributor reducing the amount of FP released. As the new strategy has the possibility of hydrogen combustion and detonation in CFVS, the installation of an igniter inside the CFVS vessel may be considered in reducing such hydrogen risk.

• East Asian Journal of Business Economics (EAJBE)
• /
• v.11 no.1
• /
• pp.41-51
• /
• 2023

Purpose - The prior literature has shown that there is a lack of a complete assessment of the key decisions in cold chain logistics. Such a study is required to offer recommendations for research in this expanding but under-researched topic with potentially significant management ramifications. Research design, Data, and methodology - The current researcher accumulated peer-reviewed sources from databases to augment each chosen study's validity. Selection varied between seminal works and much of the existing literature. The selection process was consistent with using a content checklist that established the inclusion and exclusion criteria. Result - The research findings indicate total five solutions regarding better decision in Cold Chain Logistics (CCL), such as (1) Pricing Decision in Cold Chain Logistics, (2) Decision on Temperature Control Decision in Cold Chain Logistics, (3) Supply Chain Network Design in Cold Chain Logistics, (4) Decision on Minimizing Inventory in Cold Chain Logistics, (5) Decision on Logistics Distribution. Conclusion - Stability of a cold chain should be maintained from manufacture or via logistical components and cold logistics products are susceptible to several variables, such as temperature, and degradation can easily harm food supply, product prices, and human health. Product safety infractions substantially impact human health, among other losses linked with a functioning CCL.

• The Journal of Korean Medicine
• /
• v.44 no.4
• /
• pp.193-207
• /
• 2023

Objectives: The purpose of this study was to evaluate the effectiveness and safety of traditional herbal medicine as a stand-alone treatment group through major English databases due to the lack of RCTs in Korea, and to provide a review of the herbal interventions used. Methods: Using four databases (Pubmed, EMBASE, OASIS, RISS), combination of words such as "Coronavirus" "RCT" "Herb" "Decoction" "TCM" were used. RCTs using herbal medicines to treat coronavirus were searched. Final 4 studies were selected by two authors according to inclusion and exclusion criteria. Results: A total of 1,435 patients were studied. The Chinese herbs used in the treatment group were Shengmai Yin, JingYinGuBiao granules, Jinhua Qinggan granules, and Bufei Huoxue capsules. The intervention group showed greater attenuation of pneumonia lesions on CT. Also, improvement in 6-min walk distance (6MWD), and negative conversion rate in treatment group were reported. Furthermore, scores on the Fatigue Assessment Inventory (FAI) were lower in the herbal group than in the placebo group. The median time to recovery of COVID-19 related symptoms was shorter in TCM group compared to the control group. Reported adverse effects were diarrhea, liver dysfunction, and excessive menstruation, and two papers did not mention side effects in detail. Conclusion: Herbal medicine alone can increase the conversion rate of viral negativity and relieve COVID-19 related symptoms without significant adverse effects.

• Journal of the Korean Society of Safety
• /
• v.30 no.1
• /
• pp.72-78
• /
• 2015

According to the report of the WHO, workers have been exposed to much job strain such as job load, responsibility, role, interpersonal conflict etc. In Korea, studies on job strain started to become active from 1990s and now hundreds of studies are actively under going or publishing so that the studies are contributing to development and improvement of job strain. Representative measurement models of job strain are Job Strain Model of Karasek, Job Stress Model of NOISH, Korea Occupational Stress Scale, JSQ(Job Stress Questionnaire), K-OSI(Korea Version of Occupational Stress Inventory) etc. (Lee Kwan-Suk, 2012 ; KOSHA, 2003). Among them, Job Strain Model of Karasek had been loved by many researchers of job strain before Korea Occupational Stress Scale was developed. Job Strain Model of Karasek had been fitted to Korean style and then, used to analyze job strain of Korean people so that this Scale highly contributed to seeking relationship with cardiovascular disease, musculoskeletal disease caused by job, smoking, drug, alcohol poisoning, and pulse(Lee Kwan-Suk, 2012). But as this Model was studied and developed based on foreign culture and life pattern, a model fit to Korea was developed to measure job strain for Korean people, which is Korea Occupational Stress Scale now most frequently used in measuring job strain. Accordingly, after this study made questionnaire survey about same population using the two methods used most frequently in measuring job strain, the study investigated what features appeared, what correlations appear between two models, and comparatively analyzed characteristics each independent and dependent variable. Based on this, the study aimed to exactly express job strain of Korean people. The subjects of the study were a population of 233, and Karasek's Questionnaire and KOSS's Questionnaire were surveyed at the same time. The results were analyzed by statistical program to obtain significant difference between two models. Four particular groups were divided with Job Strain Model of Karasek and the four particular groups were measured with Korea Occupational Stress Scale. And job strain come from combination of two models was measured, with which new comparative analysis method was suggested.

• Korean Journal of Biological Psychiatry
• /
• v.20 no.1
• /
• pp.12-20
• /
• 2013

Objectives We investigated the tolerability, safety, and treatment response to flexible-dose paliperidone ER in patients with non-acute schizophrenia in whom previous antipsychotic drugs were ineffective. Methods This 24-week interim analysis of the 48-week multicenter, prospective, open-label study assessed effectiveness using the Positive and Negative Syndrome Scale (PANSS), Clinical Global Impression-Schizophrenia-Severity (CGI-SCH-S) Scale, Personal and Social Performance (PSP) and Drug Attitude Inventory (DAI). Safety and tolerability were assessed using the Drug-Induced Extrapyramidal Symptoms Scale (DIEPSS) and Liverpool University Neuroleptic Side Effect Rating Scale (LUNSERS). Results Effectiveness was assessed in 169 patients. Significant improvement in the PANSS total score was observed by week-1 and continued until week-24. The response rate was 33%. The CGI-SCH-S and PSP total scores significantly improved during 24 weeks ; however, no change occurred in the total DAI. Fifty-nine percent of patients reported adverse events, of which extrapyramidal symptoms were the most frequent (19.0%). The DIEPSS and LUNSERS scores were improved after 24 week. Conclusions Switching to the flexible-dose paliperidone ER from an ineffective antipsychotic drug was safe, tolerable, and showed a good treatment response in Korean patients with schizophrenia.

• Nuclear Engineering and Technology
• /
• v.27 no.4
• /
• pp.470-482
• /
• 1995

The Ulchin 3&4, which are 2825 MWt PWRs, adopted Safety Depressurization System (SDS) to mitigate the beyond design basis event of Total Less of Feedwater(TLOFW). In this study the results and methodology of the analyses for the determination of SDS bleed capacity are discussed. The SDS design bleed capacity has been determined from the CEFLASH-4AS/REM simulation according to the following design criteria : 1) Each SDS flow path, in conjunction with one of two High Pressure Safety Injection (HPSI) pumps, is designed to have a sufficient capacity to prevent core uncovery if one SDS path is opened simultaneously with the opening of the Pressurizer Safety Valves (PSVs). 2) Both SDS bleed paths are designed to have sufficient total capacity with both HPSI pumps operating to prevent core uncovery if the Feed and Bleed (F&B) initiation is delayed up to thirty minutes from the time of the PSVs lift. To verify the results of CEFLASH-4AS/REM simulation a comparative analysis kas also been per-formed by more sophisticated computer code, RELAP5/MOD3. The TLOFW event without operator recovery and TLOFW event with F&B are analyzed. The predictions by the CEFLASH-4AS/REM of the transient too phase system behavior are in good qualitative and quantitative agreement with those by the RELAP5/MOD3 simulation. Both of the results of analyses by CEFLASH-4AS/REM and RELAP5/MOD3 have demonstrated that decay heat removal and core inventory make-up can be successfully accomplished by F&B operation during now event for the Ulchin 3&4.

• Korean Journal of Occupational Health Nursing
• /
• v.7 no.1
• /
• pp.65-82
• /
• 1998

This study was carried out in order to confirm the reliability and validity of the commitment inventory developed by Meyer and Allen, and to investigate commitment level of health manager, to compare two different professionals of health manager such as industrial health nurse and industrial hygienist to find out some characteristics that have effect on commitment. This survey was done by self-administered questionnaire to 227 respondents as the trainees of Industrial Safety Training Center, KISCO from June to December 1996. Authors classified commitment into two categories ; professional commitment and organizational commitment, and these two types of commitments have three different aspects ; affective, continuance, and normative commitment based on Meyer's inventory. The results were as follows; 1. Items of whole scales of the both type of commitments have three factors that represent three aspects of commitment ; affective, continuance, and normative commitment. This means that each type of commitment was reliable to use as measurement tool of three different aspects of commitment. Classification of items by factor analysis was more consistent in professional commitment than organizational commitment. Among 16 items of organizational commitment, four items were classified into different aspects of commitment with similar factor loading. 2. Commitment level of industrial health nurse was higher than that of industrial hygienist in affective, continuance professional commitment controlled by other characteristics. These differences can be due to other characteristics of specific task and background of health managers that were not used in this study. 3. The level of affective professional commitment was statistically different in age, sex, educational level, and that of organizational commitment was statistically different in only two variables such as age, and job tenure. The level of continuance professional and organizational commitments were different in sex group, but past history of employment have effect on continuance organizational commitment. The level of normative organizational commitment was affected by only age. As the above results, the tools of measurement of commitment developed by Meyer and Allen can be useful to measure the level of commitment of health manager. Three aspects of two types of commitments were influenced by different characteristics of health manager. Authors suggested future study on the affecting variables to the commitment such as background, task of health manager and organizational characteristics.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.3
• /
• pp.145-154
• /
• 2014

The road network becomes more complex and extensive. Therefore, the inconveniences are caused in accordance with the time delay of the restoration of damaged roads, demands for excessive costs on information collection, and limitations on acquisition of damage information of the roads. Recently, road centric spatial information is gathered using mobile multi sensor system for road inventory. But expensive MMS(Mobile Mapping System) equipments require high maintenance costs from beginning and takes a lot of time in the data processing. So research is needed for continuous maintenance by collecting and displaying the damaged information on a digital map using low cost mobile camera system. In this research we aim to develop the techniques for mosaic with a regular ground sample distance using successive image from oblique camera on a vehicle. For doing this, mosaic image is generated by estimating the homography of high resolution oblique image, and the ground sample distance and appropriate overlap are analyzed using high resolution aerial oblique images which contain resolution target. Based on this we have proposed the appropriate overlap and exposure interval for mobile road inventory system.

• Korean Journal of Acupuncture
• /
• v.28 no.4
• /
• pp.1-15
• /
• 2011

Objectives : The purpose of this study is to evaluate the feasibility of massive clinical research and to make a basic analysis on the effectiveness and safety of moxibustion treatment on knee osteoarthritis compared to usual care. Methods and Results : This study is a protocol for a pilot randomized controlled trial. Forty participants are assigned to the moxibustion group (n=20) and usual care group (n=20). Participants assigned to the moxibustion group receive moxibustion treatment on the affected knee(s) at six standard acupuncture points (ST36, ST35, ST34, SP9, Ex-LE04 and SP10) three times per week for four weeks (total of 12 sessions). Participants in the usual care group don't receive moxibustion treatment during the study period and follow-up are made on the 5th, 9th and 13th weeks after random allocation. Both groups are allowed to use any kind of treatment, including surgery, conventional medication, physical treatment, acupuncture, herbal medicine, over-the-counter drugs and other active treatments. Education material that explains knee osteoarthritis and current management options and self-exercise is provided for each group. The pain scale of the Korean Western Ontario and McMaster Universities Questionnaire (K-WOMAC) is the primary outcome measurement used in this study. Other subscales of the K-WOMAC, the Short-Form 36 Health Survey (SF-36), Beck Depression Inventory (BDI), Physical Function test, Patient Global Assessment, and Pain Numeric Rating Scale (NRS) are used as outcome variables to evaluate the effectiveness of acupuncture. Safety is assessed at every visit. Conclusions : The result of this trial will provide a basis for the effectiveness and safety of acupuncture treatment for knee osteoarthritis.