• Journal of Biosystems Engineering
• /
• v.15 no.3
• /
• pp.219-229
• /
• 1990

The compression creep behavior of grains when loaded depends not only on load but also on duration of load application. The most common methods of studying the load-time characteristics of agricultural products is by employing rheological models such as Burger's model. However it is sometimes not sufficient to describe the viscoelastic behavior of grains to be Burger's model. For this reason, this study was conducted to develop the rheological model which represented the creep compliance response of the rough rice kernel and was a function of initial stress applied and time. The effects of the initial stress applied and the moisture content on the compression creep behavior of the rough rice kernel were analyzed. The results were obtained from the study as follows: 1. Since the viscoelastic behavior of the rough rice kernel was nonlinear, the transient and steady state creep compliance was satisfactorily modelled as follows: $$J({\sigma},t)=A{\sigma}^B[C+Dt-exp(-Ft)]$$ But, for the every stress applied, the compression creep behavior of the samples tested can be well described by Burger's model respectively. 2. The creep compliance, the instantaneous elastic strain, the retarded elastic strain and the viscous strain of the sample tested generally increased in magnitude with increasing the applied initial stress and the moisture content used in the tests. At low moisture content, the creep compliance for the Japonica-type rough rice kernel Was a little higher than those for Indica-type and at high moisture content, vice versa at high moisture content. 3. The retardation times of the samples had not an uniform tendency by the initial stress and the moisture content. The retardation times ranged from 0.66 to 6.76 seconds, and the creep progressed from transient to steady state at a relatively high rate. 4. The less viscous strain than the instantaneous elastic strain for the samples tested indicated that rough rice kernel behaved as a viscoelastic body characterized by elasticity than viscosity.

• Journal of the Korean Wood Science and Technology
• /
• v.14 no.4
• /
• pp.29-39
• /
• 1986

To investigate the effect of presurfacing, both 25mm rough and pre surfaced oak boards (Quercus grosseserrata BI.) were dried in the same dry kiln condition. Drying curves, drying strains and drying defects of rough and presurfaced boards were compared. The results obatained are as follows. 1. Average drying rate of rough and presurfaced boards from green to 10% M.C. was 0.276%/hr. and 0.284%/hr., respectively. 2. At the early stage of drying, in case of rough boards, maximum tensile strain of outer slices was $-24.2{\times}10^{-4}$mm/mm and maximum compressive strain of innermost slices was $13.0{\times}10^{-4}$mm/mm, and in case of pre surfaced boards, maximum tensile strain of outer slices was $-14.5{\times}10^{-4}$mm/mm and maximum compressive strain of innermost slices was $28.1{\times}10^{-4}$mm/mm. And in both cases, stress reversal occurred at about 40% M.C.. 3. Maximum surface checking appeared at about 40% M.C.. Of the 10 rough boards. 6 hoards contained surface checks, but presurfaced boards did not contained surface checks after drying. And the results of end checking were similar to those of surface checking. But, honeycomb was not found in both cases. 4. Board shrinkage. warp and casehardening of presurfaced boards were similar to those of rough boards. But, collapse of prsurfaced boards was less than that of rough boards.

• Korean journal of applied entomology
• /
• v.16 no.1 s.30
• /
• pp.21-31
• /
• 1977

The study has been carried out to compare the pathogenicity, physiological characteristics and genetic reliability between rough colony type strain and smooth colony type strains of Pseudomonas mori (Boyer et Lambert) Stevens which were isolated from diseased plant parts in 5 different areas throughout country. The results are summarized as follow. 1. The rough colony type strain showed more agressive reactions to tested host plant varieties than smooth colony type strains though there was no differences in the appearence of lesion types caused by both strains. 2. Both colony types were differentiated morphologically in that the rough colony type strain was having more than 200r long filamentous body without flagella where as the smooth colony type strains have short rods with one or several polar flagella. 3. The colony of smooth type strains was circular, entire, smooth and opaque, while the rough type strain shelved endulated, irregular margin, rough and wrinkled colony on nutrient agar media. 4. There were no differences between both colony types in the physiological and serological test. 5. Both of smooth and rough colony type strains showed genetic reliability through more than 100 succeeding cultures on the media, and were stable to various chemicals such as 1 to 3 percent of NaCl, 5 kinds of organic acid and 4 kinds of antibiotics.

• Journal of Biosystems Engineering
• /
• v.15 no.3
• /
• pp.207-218
• /
• 1990

Grains display characteristics of both elastic bodies and viscous fluids when they are subjected to mechanical treatments in harvesting, handling, and processing. This viscoelastic behavior of grains when mechanically stressed must be fully understood to establish maximum machine efficiency and have a minimum degree of grain damage and the highest quality of the final product. The studies were conducted to examine the effect of the moisture content, the loading rate and the initial deformation on the stress relaxation behavior of whole kernel of rough rice, and develop the rheological model to represent its stress relaxation behavior. The following results were obtained from the study. 1. Moisture content had the greatest influence on the initial portion of the relaxation curve. With elapsing time the lower moisture content resulted in the lower residual stress for the Japonica-type rough rice and vice versa for the Indica-type rough rice. But within the ranges of moisture content tested, the degree of stress relaxation per unit strain on the Indica-type rough rice was a little higher than those on the Japonica-type rough rice. 2. The slower loading rate resulted in less initial stress. The decreasing trend of residual stress for all the samples tested with increasing loading rate was shown. 3. The higher initial deformation for all the samples resulted in less initial stress. The increasing of amount of stress relaxation per unit strain with increase of initial stress indicated that viscoelastic properties of rough rice depended not only upon duration of load applied but also initial stress applied. This means that rough rice is nonlinear viscoelastic material. 4. The compression stress relaxation properties of rough rice kernel can be described by a generalized Maxwell model representing by the Maxwell elements.

• Journal of Biosystems Engineering
• /
• v.17 no.1
• /
• pp.79-90
• /
• 1992

Viscoelastic characteristics of agricultural products may be determined through three basic tests ; stress relaxation, creep, and dynamic test. Considering the changeability of living materials, dynamic test in which information is derived in a relatively short time appears to be highly desirable, in which either cyclic stress or cyclic strain is imposed and the remaining quantity (strain or stress) is measured. The periodically varying stress will also result in periodically varying strain which in a viscoelastic material should theoretically be out of phase with the stress, because part of the energy subjected to sample is stored in the material as potential energy and part is dissipated as heat. This behavior results in a complex frequency-dependent compliance denoted by J($i{\omega}$). The complex compliance and therefore the storage compliance, the loss compliance, the phase angle, and percent energy loss for the sample should be obtainable with a given static viscoelastic property of the material under static load. The complex compliance of the rough rice kernel were computed from the Burger's model describing creep behavior of the material which were obtained in the previous study. Also, the effects of cyclic load and moisture content of grain on the dynamic viscoelastic behavior of the samples were analyized. The results obtained from this study were summarized as follows ; 1. The storage compliance of the rough rice kernel slightly decreased with the frequency applied but at above the frequency of 0.1 Hz it was nearly constant with the frequency, and the loss compliance of the sample very rapidly decreased with increase in the frequency on those frequency ranges. 2. It was shown that the storage compliance and the loss compliance of the sample increased with increase in grain moisture content. Effect of grain moisture content on the storage compliance of the sample was highly significant than effect of the frequency applied, but effect of the frequency on the loss compliance of the sample was more significant than effect of grain moisture content. 3. In low moisture content, the percent energy loss of Japonica-type rough rice was much higher than that of Indica-type rough rice, but, in high moisture content, vice versa.

• Korean Journal of Veterinary Research
• /
• v.55 no.4
• /
• pp.241-246
• /
• 2015

To develop a live vaccine strain against fowl typhoid and paratyphoid caused by Salmonella serovar Gallinarum biovar Gallinarum (Salmonella Gallinarum) and Salmonella serovar Enteritidis (Salmonella Enteritidis), respectively, several nalidixic acid resistant mutants were selected from lipopolysaccharide (LPS) rough strains of Salmonella Gallinarum that escaped from fatal infection of a LPS-binding lytic bacteriophage. A non-virulent and immunogenic vaccine strain of Salmonella Gallinarum, SR2-N6, was established through in vivo pathogenicity and protection efficacy tests. SR2-N6 was highly protective against Salmonella Gallinarum and Salmonella Enteritidis and safer than Salmonella Gallinarum vaccine strain SG 9R in the condition of protein-energy malnutrition. Thus, SR2-N6 may be a safe and efficacious vaccine strain to prevent both fowl typhoid and paratyphoid.

• Journal of Microbiology and Biotechnology
• /
• v.13 no.4
• /
• pp.564-570
• /
• 2003

The antibacterial mechanism of enterobacter Salmonella typhimurium was studied. The rfa (Waa) gene cluster of S. typhimurium encodes the core oligosaccharide biosynthesis of lipopolysaccharide (LPS). Among the rfa gene cluster, we recently cloned the rfaE gene, which is involved in ADP-L-glycero-D-manno-heptose biosynthesis. The rfaE mutant synthesizes heptose-deficient LPS, which consists of only lipid A and 3-deoxy-D-manno-octulosonic acid (KDO), thus making an incomplete LPS and a rough phenotype mutant. S. typhimurium deep-rough mutants with the heptose region of the inner core show a reduced growth rate, sensitivity to high temperature, and hypersensitivity to hydrophobic antibiotics such as baicalin isolated from the medicinal herb of Scutellaria baicalensis Georgi. Thus, in this study, the cloned rfaE gene was added to the S. typhimurium rfaE mutant strain SL1102 (rfaE543), which makes heptose-deficient LPS and has a deep-rough phenotype. The complementation created a smooth phenotype in the SL1102 strain. The sensitivity of SL1102 to bacteriophages was also recovered to that of wild-type strain, indicating that LPS is used as the receptor for bacteriophage infection. The permeability barrier of SL1102 to hydrophobic antibiotics such as novobiocin and baicalin was restored to that of the wild-type, suggesting that antibiotic resistance of the wild-type strain is highly correlated with their LPS. Through an agar diffusion assay, the growth-inhibition activity of baicalin was fully observed in the mutant SL1102 strain. However, only a half of the inhibitory activity was detected in the rfaE complemented SL1102 strain. Furthermore, the LPS produced by the rfaE-complemented SL1102 strain was indistinguishable from LPS biosynthesis of smooth strains.

• Journal of the Korean Society for Precision Engineering
• /
• v.16 no.2 s.95
• /
• pp.5-14
• /
• 1999

The necessity of six axis force-torque sensors is well recognized in the fields of automatic fine assembly, deburring polishing, and automatic fish processing using robotic manipulators. The paper proposes a simple and compact elastic structure of the force-torque sensor which senses externally applied three force and three torque components. Rough surface strain distribution of the elastic structure is examined analytically, and then more accurate surface strain are obtained from finite element analysis. The compliance matrix which is a linear relationship between force components and strain measurements is obtained for the proposed sensor. Some basic principles of measuring 3 force and torque components are also presented.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2007.10a
• /
• pp.96-99
• /
• 2007

The microstructure with fine and uniform AGS(austenite grain size) along thickness direction over no recrystallization temperature is strongly required for production of the high strength steels. The previous AGS prediction only based on the average strain improves to find the rolling conditions for accomplishment of the fine grain, but cannot find those for uniform grain. In this paper, an integrated mathematical model for prediction of the strain distribution along thickness direction is developed by carrying out finite element simulation for a series of rolling conditions. Also, the AGS distribution after rough rolling is predicted by applying the proposed model with AGS prediction model.

• IMMUNE NETWORK
• /
• v.14 no.6
• /
• pp.307-320
• /
• 2014

Mycobacterium scrofulaceum is an environmental and slow-growing atypical mycobacterium. Emerging evidence suggests that M. scrofulaceum infection is associated with cervical lymphadenitis in children and pulmonary or systemic infections in immunocompromised adults. However, the nature of host innate immune responses to M. scrofulaceum remains unclear. In this study, we examined the innate immune responses in murine bone marrow-derived macrophages (BMDMs) infected with different M. scrofulaceum strains including ATCC type strains and two clinically isolated strains (rough and smooth types). All three strains resulted in the production of proinflammatory cytokines in BMDMs mediated through toll-like receptor-2 and the adaptor MyD88. Activation of MAPKs (extracellular signal-regulated kinase 1/2, and p38, and c-Jun N-terminal kinase) and nuclear receptor (NF)-${\kappa}B$ together with intracellular reactive oxygen species generation were required for the expression of proinflammatory cytokines in BMDMs. In addition, the rough morphotypes of M. scrofulaceum clinical strains induced higher levels of proinflammatory cytokines, MAPK and NF-${\kappa}B$ activation, and ROS production than other strains. When mice were infected with different M. scrofulaceum strains, those infected with the rough strain showed the greatest hepatosplenomegaly, granulomatous lesions, and immune cell infiltration in the lungs. Notably, the bacterial load was higher in mice infected with rough colonies than in mice infected with ATCC or smooth strains. Collectively, these data indicate that rough M. scrofulaceum induces higher inflammatory responses and virulence than ATCC or smooth strains.