• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.5
• /
• pp.857-864
• /
• 2006

This paper describes a design of low-power/small-area arithmetic circuits which are vector processing unit powering nit, divider unit and square-root unit for mobile 3D graphic accelerator. To achieve area-efficient and low-power implementation that is an essential consideration for mobile environment, the fixed-point f[mat of 16.16 is adopted instead of conventional floating-point format. The vector processing unit is designed using redundant binary(RB) arithmetic. As a result, it can operate 30% faster and obtained gate count reduction of 10%, compared to the conventional methods which consist of four multipliers and three adders. The powering nit, divider unit and square-root nit are based on logarithm number system. The binary-to-logarithm converter is designed using combinational logic based on six-region approximation method. So, the powering mit, divider unit and square-root unit reduce gate count when compared with lookup table implementation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.5
• /
• pp.1303-1315
• /
• 2012

In the draft of the IEEE 802.11s standard, a tree topology is established by the proactive tree-building mode of the Hybrid Wireless Mesh Protocol (HWMP). It is used for cases in which the root station (e.g., gateway) is an end point of the majority of the data connections. In the tree topology, the root or central stations (e.g., parent stations) are connected to the other stations (e.g., leaves) that are one level lower than the central station. Such mesh stations are likely to suffer heavily from contention in bottleneck links when the network has a high traffic load. Moreover, the dependence of the network on such stations is a point of vulnerability. A failure of the central station (e.g., a crash or simply going into sleep mode to save energy) can cripple the whole network in the tree topology. This causes performance degradation for end-to-end transmissions. In a connected mesh topology where the stations having two or more radio links between them are connected in such a way that if a failure subsists in any of the links, the other link could provide the redundancy to the network. We propose a scheme to utilize this characteristic by organizing the network into concentric tiers around the root mesh station. The tier structure facilitates path recovery and congestion control. The resulting mode is referred to as Tier-based Proactive Path Selection Mode (TPPSM). The performance of TPPSM is compared with the proactive tree mode of HWMP. Simulation results show that TPPSM has better performance.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.895-898
• /
• 2005

This paper describes a design of LNS-based divider and square-root circuits which are key arithmetic units in graphic processor and digital signal processor. To achive area-efficient and low-power that is an essential consideration for mobile environment, a fixed-point format of 16.16 is adopted instead of conventional floating-point format. The designed divider and square-root units consist of binary-to-logarithm converter, subtractor, logarithm-to-binary converter. The binary to logarithm converter is designed using combinational logic based on six regions approximation method. As a result, gate count reduction is obtained when compared with conventional lookup approack. The designed units is 3,130 gate count and 1,280 gate count. To minimize average percent error 3.8% and 4.2%. error compensation method is employed.

• Journal of Sericultural and Entomological Science
• /
• v.3
• /
• pp.37-43
• /
• 1963

This experimental work was carried out to know the best method in producing the root stock effectively. The major experimental work was carried out by using Kairyo-Nezumigaeshi, and the comparative works were carried out by using Ichi-Hei, Kairyo-Nezumigaeshi, Ro-Soh, Yongchon-Chuwoo and Suwon No. 4. Results obtained from the test are as follows. 1. The larger size of the branch burried, the better live ratio and the quality of the sapling was found, and there was no significant difference between the top part and bottom part of the branch from the point of view of the ratio, but it was found that the top part showed better live ratio and quality. Mean time there was no difference in live ratio between the two sprouts root-stock type and the three sprouts root-stock type. 2. When the live ratio and sapling quality was compared from the aspect of the new root development, the heavy and medium developed root type showed better result than the poor developed one. 3. For the ambushing depth test of the root-stock, the root-stock which was painted with paraffin on the top and exposed in the air was found to have best live ratio. Mean time, even though paraffin was not painted all the top of the root-stock, the one which was exposed the top of it or the one ambushed with thin soil layer, showed better live ratio than the one deep ambushed. 4. There was difference for the live ratio between the perpendicularly ambushed root-stock and the lied ambushed mot-stock, but the former method showed better sapling quality. 5. The soil nature did not show any difference for the live ratio between the sand loam and clay loam, but the former one showed better sapling quality. 6. There was no difference live ratio between the mulberry varieties, but Yongchon-Chuwoo showed best sapling quality. 7. The grafted sapling production cost was 2.30 won and cattage sapling cost was 1.61 won.

• Restorative Dentistry and Endodontics
• /
• v.28 no.1
• /
• pp.80-88
• /
• 2003

Object The purpose of this study were to evaluate the microtensile bond strength of resin fiber reinforced post to radicular dentin using resin cement according to various dentin surface treatment and to observe the inter face between post and root dentin under SEM Material and Method A total 16 extracted human single rooted teeth were used. A lingual access was made using a #245 carbide bur in a high-speed handpiece with copious air water spray. The post space was mechanically enlarged using H-file(up to #60) and Gates Glidden bures(#3). This was followed by refining of the canal space using the calbrating drill set provided in ER Dentinpost(GEBR, BRASSELER GmbH&Co. KG). The 16 teeth were randomly distributed into 4 group of 4 teeth. Group 1 teeth had their post space prepared using 10% phosphoric acid as root canal surface treatment agent during 20s. The canal was then rinsed with saline and dried with paper point. Group 2 teeth had their post space prepared using 3% NaOCl as root canal surface treatment agent during 30min. The canal was then rinsed with saline and dried with paper point. Group 3 teeth had their post space prepared using 17% EDTA as root canal surface treatment agent during 1min. The canal was then rinsed with saline and dried with paper point. Group 4 teeth had their post space prepared using 17% EDTA as root canal surface treatment agent during 1min. After rinsing with saline, the canal was rinced 10m1 of 3% NaOCl for 30min. After drying with paper point, the post(ER Dentinpost, GEBR, BRASSELER GmbH&Co. KG) was placed in the treated canals using resin cement. Once the canal was filled with resin cement(Super bond C&B sunmedical co. Ltd.), a lentulo was inserted to the depth of the canal to ensure proper coating of the root canal wall. After 24 hours, acrylic resin blocks($10{\cdot}10{\cdot}50mm$) were made. The resin block was serially sectioned vertically into stick of $1{\cdot}1mm$. Twenty sticks were prepared from each group. After that, tensile bond strengths for each stick was measured with Microtensile Tester. Failure pattern of the specimen at the interface between post and dentin were observed under SEM. Results 1. Tensile bond strengths(meen{\pm}SD$) ) were expressed with ascending order as follows group 4, $12.52{\pm}6.60$ ; group 1, $7.63{\pm}5.83$ ; group 2, $4.13{\pm}2.31$ ; group 3, $3.31{\pm}1.44$. 2. Tensile bond strengths of Group 4 treated with 17% EDTA +3%NaOCl were significant higher than those of group 1, 2 and 3 (p<0.05). 3. Tensile bond strengths of Group 1 treated with 10% phosphoric acid were significant higher than those of group 2 (p<0.05). Tensile bond strengths of Group 4 treated with 17% EDTA +3% NaOCl was significant higher than those of other groups.

• Journal of Acupuncture Research
• /
• v.15 no.2
• /
• pp.29-41
• /
• 1998

The effect of Cervi Cornu Parvum aqua-acupuncture on serum levels of sex hormone was investigated in ovariectomized rats. Water extract of Cervi Cornu Parvum was daily injected for 30 days at points in rats corresponding to bilateral Taixi (Ki. 3) points of human and non-point at root of tail after ovariectomy, respectively. Serum levels of estradiol, testosterone, progesterone, LH and FSH were measured at 2 and 4 weeks after aqua-acupuncture treatment, respectively. Compared with ovariectomized rats, significant increase of estradiol and progesterone and significant decrease of FSH and LH were elicited at 2 and 4 weeks after aqua-acupuncture treatment. Aqua-acupuncture treatment at non-point did not produce any remarkable effect. These findings suggest aqua-acupuncture may restore dysfunction of hypothalamic-pituitary-ovarian axis, associated with a significant increase of serum estradiol level in ovariectomized rats.

• Journal of the Korean Mathematical Society
• /
• v.55 no.6
• /
• pp.1529-1540
• /
• 2018

The matrix equation $X^p+A^*XA=Q$ has been studied to find the positive definite solution in several researches. In this paper, we consider fixed-point iteration and Newton's method for finding the matrix p-th root. From these two considerations, we will use the Newton-Schulz algorithm (N.S.A). We will show the residual relation and the local convergence of the fixed-point iteration. The local convergence guarantees the convergence of N.S.A. We also show numerical experiments and easily check that the N.S. algorithm reduce the CPU-time significantly.

• Restorative Dentistry and Endodontics
• /
• v.16 no.1
• /
• pp.74-86
• /
• 1991

The purpose of this study was to evaluate the resulting root canal angulation and shape change after using various enlarging instruments. The mesial canals (120) of extracted human mandibular 1st and 2nd molars were randomly divided into 6 groups; Control, K-type me, Heliapical me, Canal Master me, sonic and ultrasonic instrumentation group. Vertical angulation of each canal was determined by a straight line through the long axis of canal and another straight line through the apical foramen to intersect at the point where the canal began to leave the long axis of the tooth. By recording and comparing the measured angles of the each set of pre-and postinstrumentation. Then, the roots were sectioned horizontally in the apical, middle, coronal thirds and the canal shapes examined, as was the mesiodistal canal diameter as it relates to the external root surface. The results were as follows: 1. Instrumentation using K-type me group resulted in the highest mean change in angulation ($9.900^{\circ}$) (p < 0.005), while Sonic Air MM 3000 group resulted in the least degree of straightening canals ($8.250^{\circ}$) (p < 0.005). 2. Canal Master file group resulted in the best canal shape at the three levels (P < 0.005). 3. Measured minimal mesial root width produced Heliapical me group at the apical 1/3 level, Sonic Air MM 3000 group at the middle 1/3 level, Heliapical me group at the coronal 1/3 level (P < 0.005). 4. Measured minimal distal root width produced Sonic Air MM 3000 group at the apical 1/3 level (P < 0.05), Heliapical me group at the middle 1/3 level (P < 0.005), Canal Master me group at the coronal 1/3 level (P < 0.005). 5. HeIiapical me group produced more increased canal diameter than any other groups (P < 0.005).

• Journal of Periodontal and Implant Science
• /
• v.28 no.2
• /
• pp.193-203
• /
• 1998

20 Subjects with clinical diagnosis of adult periodontitis with sites having average pocket depth of 4mm were selected for the study. After scaling and root planing of those sites, 30% minocycline-HCI contained in biodegradable device were inserted in one group, scaling and root planing was carried out in another group and the last group was without any periodontal treatment. the difference between the group was detemined by pocket dept, bleeding on prbing, attachment level, distribution of subgingval plaque bacteria. Conclusion was made for the comparisons between baseline and 4 week and the groups. 1. In analysis of pocket depth, there was significant sifference in scaling and root planing group only. 2. Both the scaling and root planing group and minocycline group showed significant decrease in bleeding on probing. 3. There was significant increase in the attachment level in scaling and root planing group, but no difference was foundbetween the groups. 4. There was significant decrease in the total number of subgingival bacteria in all groups and the number of motile bacteria decreased significantly in the minocycline group. These result indicate that insertion of Minocycline-HCI at the base of periodntal pocket was useful as an additional aid of mechanical trarment at the point of periodontal pocket, bleeding on probing, attachment level, microbial distribution.

• Journal of the East Asian Society of Dietary Life
• /
• v.24 no.4
• /
• pp.503-513
• /
• 2014

This study investigated the effects of dietary consciousness of gender and generation on food intake frequency in Daegu, Sangju, Kimchen and Gumi. There was a total of 359 subjects, which consisted of elementary students, college students, and adults. The survey period was from March to May 2011, and it was a self-questionnaire by convenience sampling. The results were as follows: 1. A 9 point scale on intake frequency of 59 kinds foods was classified into 17 groups. Gender had significant differences on intake frequency of meats, beans, root vegetables, tuber vegetables, fruit vegetables, mushrooms, nuts, liquors, and cola. Sixteen food groups, except for fats, showed significant differences in intake frequency by generation. 2. Dietary consciousness consisted of 15 items, and it was divided into nutritional consciousness and meal consciousness. Meal consciousness was significantly higher in females than in males, as well as college students and adults than in elementary students. 3. Nutritional consciousness had significant effects on intake frequencies of grains, leaf vegetables, root vegetables, fruit vegetables, milk and milk products, fat and fatty oils. Meal consciousness had effects on intake of grain, leaf vegetables, root vegetables, seaweeds, teas and coffee. 4. Meal consciousness of males had significant effects on intake frequencies of grains, leaf vegetables, root vegetables, seaweeds, teas, and coffee. Elementary students showed significant effects on grains, leaf vegetables, root vegetables and seaweeds.