• Journal of Korean Tunnelling and Underground Space Association
• /
• v.11 no.2
• /
• pp.189-198
• /
• 2009

Recently the concern about the construction of underground structures such as oil and food storage caverns is increasing in Korea and abroad. The stability of those underground caverns is greatly influenced by shape factor and the size of excavation area as well as the joint conditions. In this study, therefore, the effect of the shape factor of an underground cavern on its stability was analyzed in terms of safety factor. To this end, four different shape factors of a cavern excavated in good rock conditions were investigated and sensitivity analyses were performed based on overburden, lateral earth pressure coefficient, joint spacing, properties, and orientation. The stability of a cavern is evaluated in terms of safety factor estimated numerically based on the shear strength reduction technique. In future, this study is expected to be helpful in designing and evaluating the stability of caverns excavated in discontinuous rock masses.

• Geomechanics and Engineering
• /
• v.16 no.4
• /
• pp.399-413
• /
• 2018

This paper addresses the issue of field measurement of excavation damage zone (EDZ) and its numerical simulation method considering both excavation unloading and blasting load effects. Firstly, a 2000 m-deep rock cavern in China is focused. A detailed analysis is conducted on the field measurement data regarding the mechanical response of rock masses subjected to excavation and blasting operation. The extent of EDZ is revealed 3.6 m-4.0 m, accounting for 28.6% of the cavern span, so it is significantly larger than rock caverns at conventional overburden depth. The rock mass mechanical response subjected to excavation and blasting is time-independent. Afterwards, based on findings of the field measurement data, a numerical evaluation method for EDZ determination considering both excavation unloading and blasting load effects is presented. The basic idea and general procedures are illustrated. It features a calibration operation of damage constant, which is defined in an elasto-plastic damage constitutive model, and a regression process of blasting load using field blasting vibration monitoring data. The numerical simulation results are basically consistent with the field measurement results. Further, some issues regarding the blasting loads, applicability of proposed numerical method, and some other factors are discussed. In conclusion, the field measurement data collected from the 2000 m-deep rock cavern and the corresponding findings will broaden the understanding of tunnel behavior subjected to excavation and blasting at great depth. Meanwhile, the presented numerical simulation method for EDZ determination considering both excavation unloading and blasting load effects can be used to evaluate rock caverns with similar characteristics.

• Tunnel and Underground Space
• /
• v.2 no.1
• /
• pp.95-101
• /
• 1992

Norwegian technology related to preinvestigations, planning, design and construction of large underground caverns is wellknown worldwide. However, so far this technology is only slightly verified through scientiffic reports and documentation. The "Rock cavern stadium" research program is an interdisciplinary program related to the ongoing building and future use of Gjovik Olympic Subsite which is the largest cavern in the world for public purposes with a span of 61 meters and a height of 25 meters. The estimated budget for this program is about USD 4 million which is made possible through grants from The Royal Norwegian Council for Scientific and Industrial Research as well as through contributions from Norwegian and Swedish companies that are participating. The program is carried out in collaboration with The Foundation for Scientific and Industrial Research at the Norwegian Institute of Technology. The Norwegian Geotechnical Institute and The Eastern Norway Research Center. The research program will continue until the end of 1994 to ensure that input comes from a full period of use in this stadium with different activities like exhibitions, conferences, concerts etc being included as verification through full-scale measurements and observations. The research program has five subtasks. Three of these are related to subjects like Energy consumption. HVAC installations. Fire safety design, Engineering geology and Rock mechanics, Environmental aspects. The fourth subtask is concerned with the collection of basic data, results and experience from these three subtasks to provide a basis for national Norwegian guidelines related to this interdisciplinary subject area. The guidelines will first be presented as a manual for planning and engineering purposes. The realization of this research program is a unique opportunity to enhance the expertise that has been acquired from this cavern stadium. By involving research in this extraordinary project from the excavation and building phase to its subsequent use. this will give the participants know-how and expertise which is very much in demand internationally. The coordination of the international activities between the participants as well as preparation of participations and presentations in international conferences and symposium are included in the fifth task of this national research program.

• The Journal of Engineering Geology
• /
• v.1 no.1
• /
• pp.68-84
• /
• 1991

A numerical analysis using Universal Distinct Element Code program for the nuclear waste disposal cavern has been performed for a typical Korean crystalline rock condition with same geometry of Swedish low and intermediate nuclear waste disposal repository(S.F.R). The stress concentration, displacement and safety factor for the typical single cross section of cavern, 5 caverns and a silo are analyzed.

• Tunnel and Underground Space
• /
• v.21 no.5
• /
• pp.394-405
• /
• 2011

In this paper, we applied coupled non-isothermal, multiphase fluid flow and geomechanical numerical modeling using TOUGH-FLAC coupled analysis to study the complex thermodynamic and geomechanical performance of underground lined rock caverns (LRC) for compressed air energy storage (CAES). Mechanical stress in concrete linings as well as pressure and temperature within a storage cavern were examined during initial and long-term operation of the storage cavern for CAES. Our geomechanical analysis showed that effective stresses could decrease due to air penetration pressure, and tangential tensile stress could develop in the linings as a result of the air pressure exerted on the inner surface of the lining, which would result in tensile fracturing. According to the simulation in which the tensile tangential stresses resulted in radial cracks, increment of linings' permeability and air leakage though the linings, tensile fracturing occurred at the top and at the side wall of the cavern, and the permeability could increase to $5.0{\times}10^{-13}m^2$ from initially prescribed $10{\times}10^{-20}m^2$. However, this air leakage was minor (about 0.02% of the daily air injection rate) and did not significantly impact the overall storage pressure that was kept constant thanks to sufficiently air tight surrounding rocks, which supports the validity of the concrete-lined underground caverns for CAES.

• The Journal of Engineering Geology
• /
• v.10 no.1
• /
• pp.79-93
• /
• 2000

When caverns are excavated, it is very important to understand the distribution and charateristics of geological structures because the structures have an significant effect on grouting, rock reinforcement, and groundwater flow, etc. The main water bearing fractures have an orientation of N50~60W and these fractures are known as tension fractures. Their orientation coincides with a long elliptical axis ofpumping test, and they cross the tension fractures of N10~30E. They have typical fracture systems ofrhombic type in this area.

• Geotechnical Engineering
• /
• v.12 no.3
• /
• pp.83-98
• /
• 1996

In this paper, the results of back analysis based on, the inverse method are presented. Using the field measurements obtained from the two different underground storage caverns in Korea during their construction, the deformation modulus and the initial in-situ stresses of the rock masses around the access tunnels are calculated. The finite element analysis is carried out by usinB these results as input parameters. The calculated displacements are compared with the measured ones.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.10a
• /
• pp.287-294
• /
• 2002

CAES which is called as a compressed air energy storage was firstly developed at Huntorf, German in 1978. The capacity of that system was 290MW, and it can be treated as a first commercial power plant. CAES has a lot of merits, such as saving the unit price of power generation, averaging the peak demand, improvement of maintenance, enlarging the benefit of dynamic use. According to the literature survey, the unlined rock cavern should be proposed to be a reasonable storing style as a method of compressed air storage in Korea. We decided the hill of the Korea Institute of Geoscience and Mineral Resources as CAES site. If we construct the underground spaces in this site, the demand for electricity nearby Taejon should be considered. So we could determine the capacity of the power plant as a 350MW, This capacity needs a underground space of 200,000㎥, and we can conclude 4 parallel tunnels 550m deep from the surface through the numerical studies, Design parameters were achieved from 300m depth boring job and image processing job.

• Tunnel and Underground Space
• /
• v.5 no.2
• /
• pp.123-133
• /
• 1995

A two dimensional visco-plastic finite element model capable of handling the multistep excavaton was developed for investigating the effect of excavation-support sequences on the behaviour of underground openings in the jointed rock mass. Ubiquitous joint pattern was considered in the model and joint properties in each set were assumed to be identical. Passive, fully-grouted rockbolts were considered in the model. Visco-plastic deformations of joints and rockbolts were assumed to be governed by Mohr-Coulomb and von Mises yield criteria, respectively. With the ability of removing elements, the model can von Mises yield criteria, respectively. With the ability of removing elements, the model can simulate the multi-step excavation-support sequences. The reliability of the model to the stability analysis for the underground excavation in practice was checked by simulating the behavior of underground crude oil storage caverns under construction.

• Tunnel and Underground Space
• /
• v.21 no.6
• /
• pp.450-459
• /
• 2011

For the purpose of evaluating the safety of rock structures such as underground caverns, tunnels and slopes, rock displacement measurement is carried out to identify the behavior of rock masses. Tapes, levels, and total stations are usually applied to the displacement measurement. These tools, however, are weighed down by many disadvantages. In this study, a new displacement measurement system by precise vision metrology was proposed for the observational design and construction method of rock structures, and then applied to a tunnel under construction. Comparisons and investigations of the measurement of the tunnel have confirmed the effectiveness and applicability of the developed measurement system.