• Journal of Intelligence and Information Systems
• /
• v.22 no.1
• /
• pp.107-118
• /
• 2016

The advent of 5G mobile communications, which is expected in 2020, will provide many services such as Internet of Things (IoT) and vehicle-to-infra/vehicle/nomadic (V2X) communication. There are many requirements to realizing these services: reduced latency, high data rate and reliability, and real-time service. In particular, a high level of reliability and delay sensitivity with an increased data rate are very important for M2M, IoT, and Factory 4.0. Around the world, 5G standardization organizations have considered these services and grouped them to finally derive the technical requirements and service scenarios. The first scenario is broadcast services that use a high data rate for multiple cases of sporting events or emergencies. The second scenario is as support for e-Health, car reliability, etc.; the third scenario is related to VR games with delay sensitivity and real-time techniques. Recently, these groups have been forming agreements on the requirements for such scenarios and the target level. Various techniques are being studied to satisfy such requirements and are being discussed in the context of software-defined networking (SDN) as the next-generation network architecture. SDN is being used to standardize ONF and basically refers to a structure that separates signals for the control plane from the packets for the data plane. One of the best examples for low latency and high reliability is an intelligent traffic system (ITS) using V2X. Because a car passes a small cell of the 5G network very rapidly, the messages to be delivered in the event of an emergency have to be transported in a very short time. This is a typical example requiring high delay sensitivity. 5G has to support a high reliability and delay sensitivity requirements for V2X in the field of traffic control. For these reasons, V2X is a major application of critical delay. V2X (vehicle-to-infra/vehicle/nomadic) represents all types of communication methods applicable to road and vehicles. It refers to a connected or networked vehicle. V2X can be divided into three kinds of communications. First is the communication between a vehicle and infrastructure (vehicle-to-infrastructure; V2I). Second is the communication between a vehicle and another vehicle (vehicle-to-vehicle; V2V). Third is the communication between a vehicle and mobile equipment (vehicle-to-nomadic devices; V2N). This will be added in the future in various fields. Because the SDN structure is under consideration as the next-generation network architecture, the SDN architecture is significant. However, the centralized architecture of SDN can be considered as an unfavorable structure for delay-sensitive services because a centralized architecture is needed to communicate with many nodes and provide processing power. Therefore, in the case of emergency V2X communications, delay-related control functions require a tree supporting structure. For such a scenario, the architecture of the network processing the vehicle information is a major variable affecting delay. Because it is difficult to meet the desired level of delay sensitivity with a typical fully centralized SDN structure, research on the optimal size of an SDN for processing information is needed. This study examined the SDN architecture considering the V2X emergency delay requirements of a 5G network in the worst-case scenario and performed a system-level simulation on the speed of the car, radius, and cell tier to derive a range of cells for information transfer in SDN network. In the simulation, because 5G provides a sufficiently high data rate, the information for neighboring vehicle support to the car was assumed to be without errors. Furthermore, the 5G small cell was assumed to have a cell radius of 50-100 m, and the maximum speed of the vehicle was considered to be 30-200 km/h in order to examine the network architecture to minimize the delay.

• International Journal of Highway Engineering
• /
• v.13 no.3
• /
• pp.131-137
• /
• 2011

The development of underground space essentially leads to increase in construction cost and installation of a large structure also acts as a factor deteriorating fine sight of the city. Accordingly, there recently is a trend to make city center structures light and small if possible. In this study, for efficient development of underground space, we analyzed the change in the average delay time in comparison to the existing underpass and the influence thereof using a microscopic simulation software VISSIM 5.20 after controlling heavy vehicles not to use the underpass and to detour using the intersection above the underpass, and gradually increasing the ratio of heavy vehicles in accordance with v/c of the access road in order to examine efficiency of introducing an underpass exclusive to small cars at an underground road installed and being operated in a city road area, and presented installation standard for underpass exclusive to small vehicles adequate to the traffic characteristics. Considering the findings of the study, introduction of underpass exclusive to small cars judged to be beneficial in the aspects of reduction in the economic loss resulting from land purchase, environmental damage due to construction of large traffic structures and environment-friendly green traffic.

• Journal of Korean Society of Transportation
• /
• v.32 no.1
• /
• pp.1-12
• /
• 2014

The tier 3 methodology used in estimation of greenhouse gas emissions from road sectors is based on mileage data. However, such data can neither accurately represent the mileage of regional unit nor have sufficient integrated data reflecting the characteristics by region, vehicle type, fuel type and road type. Such estimation of greenhouse gas emissions is not reliable. Accordingly, the purpose of this study is, firstly to accumulate activity data based on distance traveled which enables us to accurately estimate the amount of green gas emitted by regional unit(emission point), and secondly, to develop a methodology for estimation of greenhouse gas emissions using these data. To do this, the study utilizes the mileage data of Korea Transportation Safety Authority(TS), statistics of registered motor vehicles, statistical yearbook of traffic volume from the Ministry of Land, Infrastructure and Transport(MLIT), the Korea Transport Database of the Korea Transport Institute(KOTI), and average road speed by local government. Methodology for estimation by local government level(emission point) is meaningful, because it reflects traffic pattern data including flow in and out and internal traffics. Finally, to verify the methodology presented in this study, it is applied to Seoul. Both greenhouse gas estimates, one by multiplying the average mileage and the number of registered vehicles and the other by multiplying traffic volume and road extension, are less than the amount estimated by the methodology presented in this study.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.17 no.3
• /
• pp.18-31
• /
• 2018

Since accidents of hazardous material transport vehicle on roadways cause severe damage in the form of disaster, foreign countries have long been engaged in systematic management and establishment of relevant laws and policies for the road safety. Recently, over 10-kilometer long tunnel, such as Inje-Yangyang Tunnel and Geumjeongsan Tunnel, has been opened on the expressway and the production of various hazardous materials is increasing with the development of chemical technology. However, road laws related to the safe operation of hazardous materials transport vehicles are still lacking, and policy measures for managing them have not been specified. It is an important task to recognize the risk of accidents of hazardous material transport vehicles and to secure road safety by establishing a management plan for road managers. Therefore, this study analyzed the feasibility of the traffic regulation of expressway tunnel in South Korea and suggested a direction for management. The results of this study can be utilized as the primary data for the revision of law related to hazardous materials transport vehicles on roadways and the derivation of optimal route of hazardous materials transport vehicles.

• Journal of Korean Society for Atmospheric Environment
• /
• v.32 no.6
• /
• pp.575-582
• /
• 2016

Seoul city has high population density as well as high traffic congestion, which are vulnerable to exposure of environmental pollutions caused by car traffic. However, recent studies are only on local regions about road traffic and air pollution or health effect of road traffic on residents. Thus, comprehensive study data are needed in terms of overall Seoul regions. In this study utilized the nitrogen dioxide concentration through the national air pollution monitoring network data, 2012 to 2013. It also divided regions into high and low exposure districts via the Origin destination data developed by the Korea transport institute to quantify and evaluate the effect of transport policies and analyzed a correlation of asthma symptoms with high and low exposure districts through raw data of community health survey from the Korea centers for disease control and prevention. Based on the collected data, the pearson's correlation analysis was conducted between air pollution substance concentration and high exposure district and multiple logistic regression analysis was conducted to determine the effect of traffic environment and factors on asthma symptoms of residents. Accordingly, the following results were derived. First, the high exposure district was higher concentrations of nitrogen dioxide ($NO_2$) as per time compared to those of the low exposure district (p<0.01). Second, analysis on correlation between average daily environmental concentration in the air pollution monitoring network and road traffic showed that nitrogen dioxide had a significant positive correlation (p<0.01) with car traffic and total traffic as well as with truck traffic (p<0.05) statistically. Third, an adjusted odds ratio about asthma doctor's diagnosis in the high and low exposure districts was analyzed through the logistic regression analysis. With regard to an adjusted model 2 (adjusted gender, age, health behavior characteristics, and demographic characteristics) odds ratio of asthma doctor's diagnosis in the high exposure district was 1.624 (95% CI: 1.269~2.077) compared to that of the low exposure district, which was significant statistically (p<0.001).

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.2
• /
• pp.116-127
• /
• 2017

A fog on road is known as a weather factor that affects traffic flow. The method in order to solve the problem, recently, Variable Speed Limit(VSL) which provide reasonable speed limit by road and weather conditions in real time is introduced. However, if drivers do not comply with VSL, the road safety more decrease than without VSL because individual vehicle's speed deviation is larger than without VSL. Therefore, this paper aims to analyze to speed limit compliance and traffic characteristics under foggy conditions with and without VSL. A test using driving simulator divides into normal and foggy condition with visibilities are 200m, 150, 50~100m. The test results showed that 70 subjects's average speed mostly obeyed speed limit, but speed deviation generally declined with VSL. Especially, the speed deviation more reduced under foggy conditions. According to this study, compliance of VSL clearly rose in low visibility and VSL helped improve road safety due to reduction of speed deviation. The results of this study are expected to make use of reasonable speed limit for reference.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.25 no.2
• /
• pp.42-53
• /
• 2020

In this study, heavy metal in road-deposited sediments (RDS) and marine sediment around Gwangyang Bay area have been investigated to assess the pollution status of metals and to understand the environmental impact of RDS as a potential source of metal pollution. Zn concentration for <63 ㎛ size fraction was the highest (2,982 mg/kg), followed by Cr, Ni, Pb, Cu, As, Cd, and Hg. Metal concentrations in RDS increased with decreasing particle size and relatively higher concentrations were observed around the metal waste and recycling facilities. For particle size in RDS smaller than 125 ㎛, EF values indicated that Zn was very high enrichment and Cr, Cd, Pb were significant enrichment. The concentrations of metals in marine sediments were mostly below the TEL value of sediment quality guidelines of Korea. However, the Zn concentrations has increased by 30~40% compared to 2010 year. The amounts of Zn, Cd and Pb in less than 125 ㎛ fraction where heavy metals can be easily transported by stormwater runoff accounted for 54% of the total RDS. The study area was greatly affected by Zn pollution due to corrosion of Zn plating materials by traffic activity as well as artificial activities related to the container logistics at Gwangyang container terminal. The fine particles of RDS are not only easily resuspended by wind and vehicle movement, but are also transported to the surrounding environments by runoff. Therefore, further research is needed on the adverse effects on the environment and ecosystem.

• Tunnel and Underground Space
• /
• v.27 no.1
• /
• pp.50-57
• /
• 2017

In this study, the experiment for determining shock loss at the branch is conducted for the design of network double-deck road tunnel ventilation. The shock loss coefficient that determines the quantity of shock loss has been considered only regarding the constant aspect ratio of circular or rectangular section. However the suggestion of shock loss coefficient is needed since the aspect ratio of double-deck road tunnel for small vehicle is considered around 1:3 with the low height in Korea. The experiment model was made with the scale of around 1:23 applying Reynolds similarity law, so that the shock loss coefficient on the branch of the large aspect ratio was measured. The result of the study showed that shock loss coefficients of both split branch and straight branch were measured two to three times higher than those calculated from the theoretical equation or design values of previous studies. Therefore the study resulted the effect of large aspect ratio on shock loss coefficient was huge, and it is expected that precise design value can be suggested for the design of network double-deck tunnel ventilation.

• International Journal of Highway Engineering
• /
• v.10 no.4
• /
• pp.235-245
• /
• 2008

Since rapidly increase of tunnel with increasing of expressway, the study on safety improvement of safety device at entrance of expressway tunnels is necessary. The existence of tunnel occurs more speed reduction than an upward slope by itself, the collision accident of tunnel entrance causes heavier damage than that of general accident on the road. So, many kinds of safety devices such as poly-ethylene barrier, guard-rail are placed on the road side. But these devices affect the drivers as an obstacle. Although there are various safety devices that are placed at tunnel entrance, this study is related to following 2-cases. One is that the poly-ethylene barrier is placed and the other is that a safety devices is not placed. The reason that these two cases are selected, is that poly-ethylene barrier is usually placed at many tunnel entrances and safety devices can affect the drivers as an obstacle. This study is related to the difference of right-hand side clearance between inside tunnel and outside tunnel, too. The average difference observed car speed and VDS(vehicle detect system) speed nearby the tunnel is analysed. Through the statistical analysis of the average difference, this study suggests an alternatives on safety improvement of safety devices at entrance of expressway tunnels. It is concluded that the small difference of right-hand side clearance is desirable to drivers when a poly-ethylene barrier is placed. And when the difference of right-hand side clearance is large, no safety devices is desirable, and when the difference of right-hand side clearance is small, poly-ethylene barrier should be placed to improve safety.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.3
• /
• pp.145-154
• /
• 2014

The road network becomes more complex and extensive. Therefore, the inconveniences are caused in accordance with the time delay of the restoration of damaged roads, demands for excessive costs on information collection, and limitations on acquisition of damage information of the roads. Recently, road centric spatial information is gathered using mobile multi sensor system for road inventory. But expensive MMS(Mobile Mapping System) equipments require high maintenance costs from beginning and takes a lot of time in the data processing. So research is needed for continuous maintenance by collecting and displaying the damaged information on a digital map using low cost mobile camera system. In this research we aim to develop the techniques for mosaic with a regular ground sample distance using successive image from oblique camera on a vehicle. For doing this, mosaic image is generated by estimating the homography of high resolution oblique image, and the ground sample distance and appropriate overlap are analyzed using high resolution aerial oblique images which contain resolution target. Based on this we have proposed the appropriate overlap and exposure interval for mobile road inventory system.